How to Build a Ballista
A ballista is an ancient type of crossbow which was used by the Greeks and Romans to fire heavy darts or stones.
Materials Needed
If you are planning to construct your very own ballista, you initially need the following materials:
A block of wood around 12 inches by 24 inches by 12 inches. This would serve as the stand of your ballista (the size may depend on how big you want it to be)
1 piece of wood about 12 inches by 3 inches 3 inches
1 piece of wood about 24 inches by 2 inches by 2 inches
2 pieces of wood about 12 inches by 2 inches (a bit thicker than a ruler)
2 small blocks of wood about 2 inches by 2 inches by 2 inches
2 pieces of pencil-like wood
2 wooden cylindrical pieces of wood or 2 cut pieces of PVC pipesabout 2 inches
2 washers
2 metal poles of about 2 inches in length
2 hoop hooks
thin rope
strong nylon or rubber
nails
Building the Ballista
Now, you can start assembling the base. First, you would need to nail the second piece of wood (12″x 3″x 3″) to the edge of the block of wood (align it to the 12″ side). Now turn it so that the block of wood would be on top of the smaller wood. This would create a raised position for one side of the block of wood.
At this point, nail the third piece of wood (24″x 2″x 2″) to the center of the top portion of the big block of wood.
Then, nail one of the ruler-like pieces of wood to the wood in the center of the block. This would now make it look like a letter “T”.
Now, put the two small blocks in between the horizontal part of the “T” (these should be placed about three inches from where you have nailed it a while ago). Then, place the other ruler-like wood on top of these blocks. Now connect these pieces of wood by driving a nail through the first ruler like wood, then through the blocks, then to the other ruler like wood. (Note: from the top view, this should also still look like a “T”
After this, attach the two cylindrical pieces of wood (two inches) in between the horizontal part of the “T”, on both ends.
Then, place the two washers on the top portion of the horizontal part of the “T” (about three inches from both ends). Drill two holes through the washers straight down through the wood. (Drill a hole on both sides of the horizontal part of the “T”.) Secure the washers by screwing or nailing them.
Inside the horizontal part of the “T”, attach the hoop hooks (between the block of wood and the cylindrical wood, one on each side). From each hoop hook, insert the rope, and then start twisting the said rope. Halfway through, insert the pencil-like piece of wood (through the twist, make sure you secure the pencil like wood). Continue twisting until you reach the washer portion.
At this point, insert the rope through the wood and into the washer. Next, place the metal pole on top of the washer holes in a horizontal position. The ropes should now be tied and secured to the poles. Cut the excess of the rope.
Take the nylon or rubber strings and tie each of its ends to the pencil like wood. (You may tape it to make it more secure.) If you enjoyed reading this article, learn more on how to make a catapult.
Now you have your own home-made ballista!