In AM wave, useful power is carried by - - -

by

1 Answer

Answer :

In AM wave, useful power is carried by Side bands

by

Related questions

Filters with the ___ characteristic are useful when a rapid roll-off is required because it provides a roll-off rate...

Description : Filters with the ___ characteristic are useful when a rapid roll-off is required because it provides a roll-off rate greater than –20/dB/decade/pole:  (1) Butterworth (2) Chebyshev (3) Bessel (4) Elliptical 

Last Answer : Filters with the Chebyshev characteristic are useful when a rapid roll-off is required because it provides a roll-off rate greater than –20/dB/decade/pole.

An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to

Description :  An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

Last Answer :  An AC supply of 230 V is applied to a half-wave rectifier circuit through a transformer having primary to secondary turn’s ratio 12:1. The peak inverse voltage is A) 8.62 V B) 12 V C) 19.17 V D) 27.11 V 

An elliptically (arbitrarily polarized wave c an be broken up into

Description : An elliptically (arbitrarily polarized wave c an be broken up into  a) Two circularly polarized components rotating in same direction b) Two circularly polarized components rotating in opposite directions c) Two stationary circularly polarized components d) None of these

Last Answer : An elliptically (arbitrarily polarized wave c an be broken up into Two circularly polarized components rotating in opposite directions 

In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is:

Description : In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is: (1) 50 Hz (2) 100 Hz (3) 150 Hz (4) 200 Hz

Last Answer : In a full wave rectifier with input frequency of 50 Hz, the frequency of the output is: 100 Hz

In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary

Description : In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is: (1) 30 V (2) 60 V (3) 15 V (4) 10 V

Last Answer : In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is: 60 V

The phase angle corresponding to λ/4 in a standing– wave pattern is:

Description : The phase angle corresponding to λ/4 in a standing– wave pattern is: (1) 30° (2) 90° (3) 135° (4) 180°

Last Answer : The phase angle corresponding to λ/4 in a standing– wave pattern is: 90°

A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its

Description : A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its Brewster angle is: (1) 0° (2) 30° (3) 45° (4) 60°

Last Answer : A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its Brewster angle is:60°

The transient current in lossless L-C circuit when excited from an AC source is, sine wave

Description : The transient current in lossless L-C circuit when excited from an AC source is, sine wave  (a) Critically damped (b) Underdamped (c) Overdamped (d) Undamped

Last Answer : The transient current in lossless L-C circuit when excited from an AC source is, sine wave Undamped

The ripple voltage in the output of a single phase half wave rectifier with 10 V rectified dc

Description : The ripple voltage in the output of a single phase half wave rectifier with 10 V rectified dc voltage with resistive load and without filter will be • 12.1 volt • 1.21 volt • 0.482 volt • 4.82 volt

Last Answer : The ripple voltage in the output of a single phase half wave rectifier with 10 V rectified dc voltage with resistive load and without filter will be 12.1 volt

In a half-wave rectifier, if an a.c supply is 60 Hz. Then what is the a.c ripple at output?

Description : In a half-wave rectifier, if an a.c supply is 60 Hz. Then what is the a.c ripple at output? (A) 30 Hz (B) 60 Hz (C) 20 Hz (D) 15 Hz

Last Answer : In a half-wave rectifier, if an a.c supply is 60 Hz. Then what is the a.c ripple at output? (A) 30 Hz (B) 60 Hz (C) 20 Hz (D) 15 Hz

A quarter wave line open circuited at far end behaves as:

Description : A quarter wave line open circuited at far end behaves as:  (1) Inductance (2) L and C in parallel (3) Capacitance (4) L and C in series

Last Answer : A quarter wave line open circuited at far end behaves as: L and C in series.

Rectification efficiency of a full wave rectifier without filter is nearly equals to:

Description : Rectification efficiency of a full wave rectifier without filter is nearly equals to:  (1) 51% (2) 61% (3) 71% (4) 81%

Last Answer : Rectification efficiency of a fullwave rectifier without filter is nearly equals to: 81%

The phase velocity of wave propagating in a hollow metal wave guide is:...

Description : The phase velocity of wave propagating in a hollow metal wave guide is:  (1) Greater than the velocity of the light in free space (2) Less than the velocity of the light in free space (3) Equal to the velocity of the light in free space (4) Equal to the group velocity

Last Answer : The phase velocity of wave propagating in a hollow metal wave guide is Greater than the velocity of the light in free space.

Ripple factor for a half wave rectifier is ....

Description : Ripple factor for a half wave rectifier is  a. 1.65 b. 1.45 c. 1 d. 1.21 

Last Answer : Ripple factor for a half wave rectifier is 1.21

The polarization required in ground wave propagation is

Last Answer : The polarization required in ground wave propagation is vertical (linear).

A circuit that generates square wave is called - - -

Last Answer :  A circuit that generates square wave is called Multi vibrators

The velocity of the wave as it passes from air into ionosphere

Last Answer : The velocity of the wave as it passes from air into ionosphere Increases.

Poynting vector for an electron Magnetic wave is equal to

Last Answer : Poynting vector for an electron Magnetic wave is equal to E x H.

It is useful to refer to an isotropic radiator. A. when comparing the gains of directional antennas B. when testing a transmission line for standing wave ratio C. when (in the northern hemisphere) directing the transmission D. when using a dummy load to tune a transmitter

Description : It is useful to refer to an isotropic radiator. A. when comparing the gains of directional antennas B. when testing a transmission line for standing wave ratio C. when (in the northern hemisphere) directing the transmission D. when using a dummy load to tune a transmitter

Last Answer : A. when comparing the gains of directional antennas

When is it useful to refer to an isotropic radiator? A. When comparing the gains of directional antennas B. When testing a transmission line for standing wave ratio C. When (in the northern hemisphere) directing the transmission in a southerly direction D. When using a dummy load to tune a transmitter

Description : When is it useful to refer to an isotropic radiator? A. When comparing the gains of directional antennas B. When testing a transmission line for standing wave ratio C. When (in the northern ... ) directing the transmission in a southerly direction D. When using a dummy load to tune a transmitter

Last Answer : A. When comparing the gains of directional antennas

A _________ sine wave is not useful in data communications; we need to send a _______signal. A) composite; single-frequency B) single-frequency; composite C) single-frequency;double-frequency D) none of the above

Description : A _________ sine wave is not useful in data communications; we need to send a _______signal. A) composite; single-frequency B) single-frequency; composite C) single-frequency;double-frequency D) none of the above

Last Answer : single-frequency; composite

The total power of an AM transmitter having a carrier power of 50 W and the percentage of modulation at

Description : The total power of an AM transmitter having a carrier power of 50 W and the percentage of modulation at 80% is A) 50 W B) 66 W C) 68 W D) 70 W 

Last Answer : The total power of an AM transmitter having a carrier power of 50 W and the percentage of modulation at 80% is 66 W

If the radiated power of AM transmitter is 10 KW, the power in the carrier for modulation index of 0.6 is...

Description : If the radiated power of AM transmitter is 10 KW, the power in the carrier for modulation index of 0.6 is nearly:  (1) 8.24 KW (2) 9.26 KW (3) 8.47 KW (4) 9.6 KW

Last Answer : If the radiated power of AM transmitter is 10 KW, the power in the carrier for modulation index of 0.6 is nearly: 8.47 KW.

I like to roam but I'll always stay home,I leave a silver track,If you carried what I could carry with the way I moved,You'd break your neck and back.What am I? -Riddles

Description : I like to roam but I'll always stay home,I leave a silver track,If you carried what I could carry with the way I moved,You'd break your neck and back.What am I? -Riddles

Last Answer : A Snail.

If a man carried my burden He would break his back. I am not rich, but leave silver in my track.What am I? -Riddles

Description : If a man carried my burden He would break his back. I am not rich, but leave silver in my track.What am I? -Riddles

Last Answer : A snail.

If a man carried my burden he would break his back. I am not big but leave silver in my tracks. What am I? -Riddles

Description : If a man carried my burden he would break his back. I am not big but leave silver in my tracks. What am I? -Riddles

Last Answer : A snail.

If a man carried my burden He would break his back. I am not rich, But leave silver in my track. -Riddles

Description : If a man carried my burden He would break his back. I am not rich, But leave silver in my track. -Riddles

Last Answer : I am a Snail.

I was carried into a dark room, and set on fire. I wept, and then my head was cut off. What am I? -Riddles

Description : I was carried into a dark room, and set on fire. I wept, and then my head was cut off. What am I? -Riddles

Last Answer : A Candle.

If the carrier of a 100 percent modulated AM wave is suppressed, the percentage power saving will be

Description : If the carrier of a 100 percent modulated AM wave is suppressed, the percentage power saving will be

Last Answer : 50

A 400 W carrier is amplitude modulated to a depth of 75%.Calculate the total power in AM wave. (i) Explain the types of noise in a communication system. (ii) Compare simplex and duplex mode of communication.

Description : A 400 W carrier is amplitude modulated to a depth of 75%.Calculate the total power in AM wave. (i) Explain the types of noise in a communication system. (ii) Compare simplex and duplex mode of communication.

Last Answer : (i) Noise: Noise is any spurious or undesired disturbances that mask the received signal in a communication system. a) Atmospheric Noise: Atmospheric Noise is also known as static noise which is the ... remote control ExamplesWalkytalky,telephone,mobile,Radar, FAX,Pager 4

In a power plant, coal is carried from storage place to boilers generally by means of (A) bucket (B) V-belts (C) trolleys (D) manually.

Description : In a power plant, coal is carried from storage place to boilers generally by means of (A) bucket (B) V-belts (C) trolleys (D) manually.

Last Answer : Ans: B

Operation carried out in Thermal power station?

Description : Operation carried out in Thermal power station?

Last Answer : The water is obtained in the boiler and the coal is burnt so that steam is obtained this steam is allowed to hit the turbine; the turbine which is coupled with the generator generates the electricity

What are the operation carried out in Thermal power station?

Description : What are the operation carried out in Thermal power station?

Last Answer : A: The water is obtained in the boiler and the coal is burnt so that steam is obtained this steam is allowed to hit the turbine, the turbine which is coupled with the generator generates the electricity

Operation Carried Out In Thermal Power Stations?

Description : Operation Carried Out In Thermal Power Stations?

Last Answer : The water is obtained in the boiler and the coal is burnt so that steam is obtained this steam is allowed to hit the turbine , the turbine which is coupled with the generator generates the electricity.

Describe the operation carried out in Thermal power stations?

Description : Describe the operation carried out in Thermal power stations?

Last Answer : A:The water is boiled in the boiler with the help of coal. This generates steam. This steam is allowed to hit the turbine hence the turbine rotates. The turbine is coupled with generator. So the mechanical energy of turbine is converted to electrical energy by Generator.

What are the tests to be carried out during DC high voltage test on power cables?

Description : What are the tests to be carried out during DC high voltage test on power cables? 

Last Answer : DC high voltage testing. During DC high voltage testing flow of following currents will take place. a. Capacitance charging current. b. Dielectric absorption current. c. Surface leakage current. d. Partial discharge current (corona). e. Volumetric leakage current. 

In a power plant, coal is carried from storage place to boilers generally by means of (A) Bucket (B) V-belts (C) Trolleys (D) Manually.

Description : In a power plant, coal is carried from storage place to boilers generally by means of (A) Bucket (B) V-belts (C) Trolleys (D) Manually.

Last Answer : V-belts

The size of a conductor used in power cables depends on the (A) operating voltage. (B) power factor. (C) current to be carried. (D) type of insulation used.

Description : The size of a conductor used in power cables depends on the (A) operating voltage. (B) power factor. (C) current to be carried. (D) type of insulation used.

Last Answer : (C) current to be carried.

Transient stability studies of a power system are usually carried out over a time period of

Description : Transient stability studies of a power system are usually carried out over a time period of (A) two or more seconds (B) several time swings (C) time interval of first swing (D) sustained oscillations

Last Answer : Transient stability studies of a power system are usually carried out over a time period of several time swings