A hand pump is usually fitted:
a. For ground servicing purposes
b. Lowering the landing gear in an emergency
c. Pressurising the oleo struts in the air
d. Retracting the gear after take-off

1 Answer

Answer :

a. For ground servicing purposes

Related questions

Description : A hand pump is usually fitted: a. For ground servicing purposes b. Lowering the landing gear in an emergency c. Pressurising the oleo struts in the air d. Retracting the gear after take-off

Last Answer : a. For ground servicing purposes

Description : A hand pump is usually fitted:

Last Answer : A. for ground servicing purposes

Description : What does three green lights represents when the landing gear is selected down

Last Answer : B. The gear is down and locked.

Description : What do three green lights represent when the landing gear is selected down? a. The gear is down b. The gear is down and locked c. The gear and doors are down and locked d. The gear is travelling between up and down

Last Answer : b. The gear is down and locked

Description : A nose wheel control system a. Prevents the nosewheel from castering at all times b. Allows the nosewheel to caster within preset limits about the neutral position c. Allows the nosewheel to caster freely at all times d. Prevents the nose gear from lowering if the nosewheels are not centralised

Last Answer : b. Allows the nosewheel to caster within preset limits about the neutral position

Description : Given: DOM 33,510kt; Traffic load 7,600kg; Trip fuel 2040kg; Final reserve 983kg Alternative fuel 1100kg; Contingency 5% of trip fuel Which of the following is correct? a. Estimated landing mass ... destination 43,295kg c. Estimated take-off mass 43,295kg d. Estimated take-off mass 45,233kg

Last Answer : b. Estimated landing mass at destination 43,295kg

Description : What is the Total Elapsed Time on a VFR flight plan? a. From take-off to overhead destination b. From take-off to overhead destination + 15 mins c. From take-off to landing d. From taxi to arrival on the gate

Last Answer : a. From take-off to overhead destination

Description : When does the first segment of the take-off climb begin? a. When V2 is reached b. When 35 feet is reached c. When flaps are up d. When gear and flaps are up

Last Answer : c. The estimated off-block time

Description : Which action shall be taken by an aircraft in the traffic pattern of an aerodrome experiencing radio failure to indicate difficulties which compel it to land without requiring immediate assistance? a. ... off four times the navigation lights d. Switching on and off four times the landing lights

Last Answer : b. The repeated switching on and off of the landing lights

Description : You make a diversion from the route given in the flight plan and land at an uncontrolled airfield. Within what time after landing should you inform ATC? a. 10 mins b. 20 mins c. 30 mins d. 45 mins

Last Answer : c. 30 mins

Description : When does the engine High Pressure fuel shut off valve close? a. After a booster pump failure b. When the engine fuel switch is selected ‘ON’ during engine start c. When flight idle is selected d. When the engine fuel switch is selected ‘OFF’ during engine shut-down

Last Answer : d. When the engine fuel switch is selected ‘OFF’ during engine shut-down

Description : To minimize the risk of hydroplaning during the landing the pilot of a modern airliner should:

Last Answer : make a “positive” landing and apply maximum reverse thrust and brakes as quickly as possible.

Description : Refer to CAP697 MRJT1 Fig. 4.3.6 Given: Distance to alternate 400nm Landing mass at alternate 50,000kg Headwind component 25kt The alternate fuel required is: a. 2550kg b. 2800kg c. 2900kg d. 2650kg

Last Answer : b. 2800kg

Description : When approaching a wet runway, with the risk of hydroplaning, what technique should the pilot adapt? a. Positive touchdown, full reverse and brakes as soon as possible b. Smoothest possible ... touchdown, full reverse and only brakes below VP d. Normal landing, full reverse brakes at VP

Last Answer : c. Positive touchdown, full reverse and only brakes below VP

Description : When an aircraft subjected to unlawful interference has landed in a Contracting State, it shall notify by the most expeditious means of the State of Registry and the State of the Operator of the landing and, ... be on board only d. ICAO and each State whose citizens were known to be on board only

Last Answer : a. Each State whose citizens suffered fatalities or injuries, each State whose citizens were detained as hostages, each State whose citizens were known to be on board and ICAO

Description : The loading limitations shall include: a. All limiting mass and centre of gravity b. All limiting mass, centre of gravity position, mass distribution and floor landing c. All limiting mass, ... of gravity position and floor loading d. All limiting mass, mass distributions and centre of gravity

Last Answer : b. All limiting mass, centre of gravity position, mass distribution and floor landing

Description : An aircraft flying in the visual circuit at an aerodrome sees a series of red flashes from the control tower. What does this mean? a. Do not land b. Do not land because the aerodrome is unusable c. Give way to other aircraft d. Return for landing and await clearance to land

Last Answer : b. Do not land because the aerodrome is unusable

Description : What type of autoland system would be required for the landing to continue following a single failure below alert height? a. Fail soft b. Fail passive c. Fail operational or fail active d. Land 2 system

Last Answer : c. Fail operational or fail active

Description : Refer to CAP697 MRJT1 Fig. 4.2 & 4.5.3.2 Estimated take-off mass 57,000kg; ground distance 150nm; temperature ISA -10C; cruise at M0.74. What is the optimum cruise altitude and TAS? a. 25,000ft & 445kt b. 33,000ft & 420kt c. 25,000ft & 435kt d. 33,000ft & 430kt

Last Answer : c. 25,000ft & 435kt

Description : What minimum ground visibility is required to enable a SVFR flight to take off from an aerodrome in a CTR? a. 1000m b. 1500m c. 2000m d. 3000m

Last Answer : b. 1500m

Description : A shuttle valve will: a. Allow the accumulator to be emptied after engine shut down b. Reduce pump loading when normal system pressure is reached c. Automatically switched to a more appropriate source of hydraulic supply d. Operate on a rising pressure, higher than the Full Flow relief valve

Last Answer : c. Automatically switched to a more appropriate source of hydraulic supply

Description : The ATC message “DISTRESS TRAFFIC ENDED” signifies that: a. All traffic are to end their transmissions b. All aircraft on the frequency are to change to another frequency c. Normal ATC is resumed after an emergency d. ATC is shutting shop

Last Answer : c. Normal ATC is resumed after an emergency

Description : When smoke appears in the cockpit, after donning the oxygen mask the pilot should select: a. Normal b. 100% c. Diluter d. Emergency

Last Answer : d. Emergency

Description : Maximum Differential pressure: a. Is the maximum authorized pressure difference between the inside of the fuselage and the atmospheric ambient pressure b. Is the absolute pressure provided by the vacuum ... time limit d. Is the absolute pressure the cabin pressure ducting is designed to carry

Last Answer : a. Is the maximum authorized pressure difference between the inside of the fuselage and the atmospheric ambient pressure

Description : Decision making in emergency situations requires primarily

Last Answer : the distribution of tasks in crew coordination

Description : Which has priority to land? a. A hospital flight b. An emergency c. A military flight d. A VIP flight

Last Answer : b. An emergency

Description : The LED indicator on the emergency torch is flashing at 4 seconds intervals. This indicates: a. The battery is charging b. The torch is serviceable c. The battery needs replacing d. The filament is broken

Last Answer : b. The torch is serviceable

Description : When reporting a frequency the use of the word “DECIMAL” can be omitted: a. When there is no likelihood of confusion b. After the initial call c. Never d. By the ground station only

Last Answer : c. Never

Description : Continuous injection system usually has a) plunger pump b) rotary pump c) gear pump d) vane pump

Last Answer : Answer: b Explanation: In common use continuous injection system usually has rotary pump.

Description : Boiler feed water pump is usually a __________ pump. (A) Reciprocating (B) Gear (C) Multistage centrifugal (D) Diaphragm

Last Answer : (C) Multistage centrifugal

Description : The illusion that the aircraft is taxiing too fast can be caused by: a. Snow and a tailwind b. Snow and a headwind c. Rain and a headwind d. An unaccustomed high distance of the cockpit from the ground

Last Answer : c. Rain and a headwind

Description : The callsign of a station controlling surface vehicles in the manoeuvring area would be: a. TOWER b. CLEARANCE c. GROUND d. APRON

Last Answer : c. GROUND

Description : The callsign suffix of a station providing clearance delivery would be: a. CLEARANCE b. GROUND c. DELIVERY d. PRESTO

Last Answer : c. DELIVERY

Description : If so equipped, when should an aircraft display the anti-collision light? a. Only at night in flight, but not on the ground if being towed b. Whilst taxiing but not whilst being towed c. Only at night with engines running d. At all times on the ground when the engines are running

Last Answer : d. At all times on the ground when the engines are running

Description : When would the negative differential limits be reached/exceeded? a. Rapid descent when AC descends below cabin altitude b. During ground pressure testing c. Rapid ascent when aircraft climbs d. When changing to manual operation

Last Answer : a. Rapid descent when AC descends below cabin altitude

Description : Air vessel fitted to a reciprocating pump (A) Increases the work done (B) Decreases the work done (C) Causes cavitation (D) Results in non-uniform discharge

Last Answer : (B) Decreases the work done

Description : Consider the following statements: Air vessels are fitted on the suction and delivery sides of a reciprocating pump to 1. Achieve higher speed without separation. 2. Reduce work in overcoming frictional resistance. 3. Avoid excessive vibration ... 2 & 3 only (c) 2, 3 & 4 only (d) 1, 2, 3 & 4

Last Answer : (d) 1, 2, 3 & 4

Description : Lowering the flaps during a landing approach: a. Increases the angle of descent without increasing the airspeed b. Decreases the angle of descent without increasing power c. Eliminates floating d. Permits approaches at a higher indicated airspeed

Last Answer : a. Increases the angle of descent without increasing the airspeed

Description : With regard to RVR and Met vis:  a. Met vis is usually less than RVR  b. Met vis is usually greater than RVR  c. RVR is usually less than met vis  d. Met vis and RVR are usually the same

Last Answer : a. Met vis is usually less than RVR

Description : TAFs are usually valid for:  a. For the period indicated in the TAF itself  b. For 18 hours  c. For 24 hours  d. For 8 hours

Last Answer : a. For the period indicated in the TAF itself

Description : tractors are generally fitted with: A)sliding mesh gear box B)constant mesh gear box C)both (a) & (b) D)synchromesh gear box

Last Answer : A)sliding mesh gear box

Description : A flight is to depart from an airport with runway 09 and 27. Surface wind is 270/05; an  inversion is reported at 300 feet with turbulence and wind shear. The wind just above the  ... throttle during the passage through the inversion  d. Depart runway 27 with as steep an ascent as possible

Last Answer : b. Depart on runway 09 with a tailwind

Description : When does the first segment of the take-off climb begin?

Last Answer : When 35 feet is reached

Description : The first segment of the take-off flight path ends:

Last Answer : at completion of gear retraction

Description : For take-off performance calculations, what is taken into account? a. OAT, pressure altitude, wind, weight b. Standard temperature, altitude, wind, weight c. Standard altitude, standard temperature, wind, weight d. Standard temperature, pressure altitude, wind, weight

Last Answer : a. OAT, pressure altitude, wind, weight

Description : If a jet engine fails during take-off before V1: a. The take-off can be continued or aborted b. The take-off should be aborted c. The take-off should be continued d. The take-off may be continued if the aircraft speed is above VMCG and lies between VGO and VSTOP

Last Answer : b. The take-off should be aborted

Description : The instruction from ATC to an aircraft to abandon its take off includes the phrase:

Last Answer : STOP IMMEDIATELY

Description : When is spark plug fouling most likely to occur? a. In the climb if you have not adjusted the mixture b. Cruise power c. In the descent if you have not adjusted the mixture d. Max take-off power

Last Answer : a. In the climb if you have not adjusted the mixture

Description : What do three green lights represent when the landing gear is selected down? a. The gear is down b. The gear is down and locked c. The gear and doors are down and locked d. The gear is travelling between up and down

Last Answer : b. The gear is down and locked

Description : What are the initial and final torque values for A321 main landing gear wheels?

Last Answer : The initial or bearing setting torque value for A321 main landing gear wheel is 310 ft.-lbs. and the final torque value is 160 ft.-lbs.