Other than the type of cell used, what is the major  difference between the construction of the leadacid and nicad  battery?

1 Answer

Answer :

The cells in the nicad battery can be replaced.

Related questions

Description : At what voltage is a NICAD battery considered to be fully discharged?

Last Answer : At 1.1 volts.

Description : From the standpoint of safety, you should never allow salt water to enter a leadacid storage battery or come in contact with sulfuric acid because ______________. A. the resulting gas is ... peroxide D. combining salt water with lead-acid creates an invisible gas resulting in severe corrosion

Last Answer : Answer: B

Description : One Difference Between A NiMH Battery And A NiCad Battery?

Last Answer : A nickel metal hydride (NiMH) battery is one of the more recent evolutions in rechargeable batteries. It is superior to a nickel cadmium (NiCad) battery in almost every way except one. NiMH ... quicker than a NiCad battery. In general use, however, NiMH batteries last longer than NiCad batteries.

Description : The plates of a NiCad storage battery are made of ________. A. potassium hydroxide with a small amount of sulfuric acid B. lead and lead peroxide C. silver oxide and lead sulfate D. combinations of nickel powder and nickel & cadmium salts

Last Answer : Answer: D

Description : Rechargeable Batteries: The Difference Between NIMH and NICad?

Last Answer : GP nickel metal hydride batteries are a great choice for a rechargeable battery. Unlike the nickel cadmium alternative, NIMH batteries tend to have a longer life span. They do not need to be fully ... Priced less than the competition, the NIMH battery is great for any item that is used often.

Description : What is the major difference in grid construction between power pentodes and conventional pentodes?

Last Answer : Conventional pentodes have a staggered grid arrangement, while power pentodes have a shielded grid arrangement.

Description : What is a major advantage of modular construction?

Last Answer : Rapid repair of systems and improved efficiency

Description : What is the main difference in construction between normal PN junction diodes and tunnel diodes?

Last Answer : The amount of doping.

Description : What is the primary difference in construction between the basic magnetron and the negativeresistance magnetron?

Last Answer : The negative-resistance magnetron has a split plate

Description : What type of material is used in the construction of bolometers and thermistors?

Last Answer : Temperature-sensitive material that exhibits a large negative temperature coefficient.

Description : Other than their physical differences, what is the major difference between a TDX and a TDR?

Last Answer : Their application: a TDX has one electrical and one mechanical input with an electrical output.

Description : Besides eliminating the emitter-base battery, what other advantages can different biasing methods offer?

Last Answer : Compensation for slight variations in transistor characteristics and changes in transistor conduction because of temperature variations.

Description : How is the type of battery most easily determined?

Last Answer : By looking at the nameplate data.

Description : What kind of material must be used in the construction of waveguides?

Last Answer : Conductive material.

Description : How do the two types of monolithic IC construction differ?

Last Answer : Diffusion penetrates substrate; epitaxial does not

Description : Name the two types of monolithic IC construction discussed.

Last Answer : Diffusion; epitaxial growth

Description : The way a magnetic head will be used determines how it is constructed. Name three factors that determine the final construction of a magnetic head.

Last Answer : a. Type of head (record, reproduce, or erase). b. Frequencies it will record or reproduce. c. Whether it will be used on a single or multitrack recorder.

Description : How can loss be reduced during construction (or fabrication) of optical fibers?

Last Answer : By removing the impurities from optical fiber.

Description : Why will a meter indicate more voltage at the battery terminal when the battery is out of a circuit than when the battery is in a circuit?

Last Answer : The internal (source) resistance of the battery will drop some of the voltage

Description : What is the major difference between the electronics dry-air branch and the vital service lp air main?

Last Answer : Degree of dehydration.

Description : What is the major difference between direct reproduce electronics and FM reproduce electronics?

Last Answer : FM record electronics must use a limiter and demodulator circuit (figure 5-5) to demodulate the signal intelligence from the carrier frequency.

Description : What is the primary difference between the major and minor lobes of a radiation pattern?

Last Answer : Major lobes have the greatest amount of radiation.

Description : What is the major difference between a two-phase and a three-phase stator?

Last Answer : Number and location of field poles.

Description : In order to reverse bias in a PN junction, what terminal of a battery is connected to the P material?

Last Answer : Negative.

Description : . A battery uses what method to produce a voltage?

Last Answer : Chemical.

Description : What is the advantage of using a battery test set versus a voltmeter to test batteries?

Last Answer : A battery test set will test batteries under load conditions.

Description : What is the voltage drop across the resistor in an RC charging circuit when the charge on the capacitor is equal to the battery voltage?

Last Answer : Zero.

Description : If violent gassing occurs during a battery charge, what action should be taken?

Last Answer : .Reduce the charging rate.

Description : Can a battery be recharged by adding more electrolytes?

Last Answer : No, a current must be passed through the battery.

Description : What does the term battery normally refer to?

Last Answer : A voltage source in a single container made from one or more cells.

Description : What does the term battery normally refer to?

Last Answer : voltage source in a single container made from one or more cells.

Description : Describe the construction & working of a Lead storage battery.

Last Answer : Ans : Lead Storage Battery : Lead storage battery is used in automobiles. It is a secondary battery & is a reversible cell which can be restored to it original condition. The battery could be ... are made up of red lead dioxide(PbO2). The electrolyte is dilute sulphuric acid having concentration.

Description : Is there really any difference between the major battery brands?

Last Answer : The difference is in the products themselves.All makers make a line of products with a range of properties.You've got to make sure you get the ones that meet your needs.

Description : What is a major advantage of the crimped terminal over the soldered terminal?

Last Answer : Requires relatively little operator skill to install.

Description : What is the major factor that limits the high-frequency response of an amplifier circuits?

Last Answer : The capacitance of the circuit.

Description : What are the two major components of a synchro?

Last Answer : The rotor and the stator.

Description : What was the major factor that led to the development of the full-wave rectifier?

Last Answer : The fact that the full-wave rectifier uses the full output, both half cycles, of the transformer.

Description : What are two major differences between velocity servos and position servos?

Last Answer : Velocity loop senses velocity rather than position. When velocity loop is nulled, an error signal is still present and the load continues to move.

Description : What is one of the major reasons for the fading of radio waves which have been reflected from a surface?

Last Answer : Shifting in the phase relationships of the wave.

Description : How many major lobes are produced by a paraboloid reflector?

Last Answer : One.

Description : Leads are formed approximately how many degrees from their major axis?

Last Answer : 90 degrees

Description : How many major lobes are radiated by a parabolic reflector?

Last Answer : One

Description : What is one of the major disadvantages of multilayer printed circuit boards?

Last Answer : Difficulty of repair of internal connections.

Description : What is the major disadvantage of printed circuit boards?

Last Answer : Components soldered in place.

Description : List the major advantages of printed circuit boards.

Last Answer : Eliminate heavy chassis and point-to-point wiring

Description : There are two types of tape transport configurations, open loop capstan drive and closed-loop capstan drive. What are two major disadvantages of open-loop capstan drive tape transports?

Last Answer : a. Only operates in one direction. b. The tape tension and head-to-tape contact can vary.

Description : What was the major operational limitation of early communications satellites?

Last Answer : The lack of suitable power sources.

Description : What is the major disadvantage of an fm signal as compared to an AM signal?

Last Answer : Wide bandpass.

Description : What are the major differences between magnetic tape units?

Last Answer : The speed at which the tape is moved past the read/write head and the density of the recorded information.

Description : What are the major differences between magnetic tape units?

Last Answer : The speed at which the tape is moved past the read/write head and the density of the recorded information.