Description : A tube has a transconductance of 800 mhos and a load resistor of 50 kohms. When control grid voltage varies by 6 volts, the plate voltage will vary by what amount?
Last Answer : 240 volts.
Description : What are three ways of controlling the amount of transmitter-generated emi?
Last Answer : (a) filtering and shielding of the transmitter (b) limiting bandwidth (c) cutting the antenna to the
Description : A series circuit consists of two resistors in series. R1 = 25 ohms and R2 = 30 ohms. The circuit current is 6 amps. What is the (a) source voltage, (b) voltage dropped by each resistor, (c) total power, and (d) power used by each resistor?
Last Answer : (a) 330 volts. (b) E1 = 150 volts. E2 = 180 volts. (c) 1.98 kilowatts. (d) P1 = 900 watts. P2 = 1.08 kilowatts component but in a parallel circuit total current divides among the available paths.
Description : If the current was increased to 4 amps, what would be the voltage drop across each resistor in the circuit described in question 17?
Last Answer : E1 = 80 volts. E2 = 240 volts. E3 = 320 volts
Description : What is the power used in a circuit that has 10 amperes of current through a 10-ohm resistor?
Last Answer : 1 kilowatt.
Description : When a wide band of frequencies is transmitted simultaneously, each frequency will vary in the amount of fading. What is this variable fading called?
Last Answer : Selective fading.
Description : The arrow drawn through the resistor shown in the illustration indicates that it is _____________. EL-0086 A. for use in low power applications B. a carbon composition type C. a wire-wound type D. one whose resistance is variable
Last Answer : Answer: D
Description : What type resistor should be used to overcome the disadvantages of the carbon resistor?
Last Answer : The wirewound resistor.
Description : What type of resistor should be used in the circuit described in question 12?
Last Answer : A wirewound resistor.
Description : The amount of current in a resistor needs to be changed from 120 mA to 160 mA by changing the 24 V source, the new voltage will be: A. 8 V B. 320 V C. 3.2 V D. 32 V
Last Answer : The amount of current in a resistor needs to be changed from 120 mA to 160 mA by changing the 24 V source, the new voltage will be: 32 V
Description : The component used for tuning a radio is basically a variable – (1) Resistor (2) Condenser (3) Inductor (4) Transformer
Last Answer : (2) Condenser Explanation: A tuning capacitor or tuning condenser is a variable capacitor used in an electronic circuit of a radio. It usually connects in parallel to a loop antenna and its capacitance may be intentionally and repeatedly changed mechanically or electronically.
Description : What is represented by the electric symbol figure 'D' in the illustration? EL-0005 A. Fuse B. Plug-in contact resistor C. Variable capacitor D. Electrolytic capacitor
Last Answer : Answer: A
Description : Which of the listed devices may be used as a digital device? A. variable resistor B. diode C. strain gauge D. thermistor
Last Answer : Answer: B
Description : In the illustration, the component VR2 on the A1 AMPLIFIER MODULE is _________. EL-0060 A. a zener diode to regulate the +9 volt power supply from common B. a variable resistor diode to control the output to terminal ... 2 at 9.1 volts DC D. a tunnel diode with a breakdown voltage of 6.6 Volts DC
Last Answer : Answer: C
Description : In the illustration, the component VR1 on the A1 AMPLIFIER MODULE is _________. EL-0060 A. a zener diode to regulate the +9 volt power supply from common B. a variable resistor diode to control the output to ... terminal 9 at 6.6 volts DC D. a tunnel diode with a breakdown voltage of 6.6 Volts DC
Description : In the illustration, the component VR1 on the A1A1 PCB is _________. EL-0060 A. a zener diode to regulate the +9 volt power supply B. a variable resistor diode to control the output to terminal 9 that controls ... terminal 9 at 6.6 volts DC D. a tunnel diode with a breakdown voltage of 6.6 Volts DC
Description : The advantage(s) of the method of D.C. motor speed control shown in the illustration is/are ______________. EL-0101 A. elimination of armature starting resistor losses B. elimination of speed instability with variable loads C. the ease of reversing motor direction D. all of the above
Description : To carry out an insulation resistance test, one terminal of the megohmmeter should be connected to the winding, with the other terminal being connected to the ____________________. A. power supply B. variable resistor C. frame of the machine D. armature
Description : An adjustable resistor, whose resistance can be changed without opening the circuit in which it is connected, is called a _____________. A. bleeder resistor B. rheostat C. bridge D. variable shunt strip
Description : Draw the symbol of i) Iron core inductor ii) variable capacitor iii) resistor iv) Ferrite core inductor
Last Answer : Iron core inductor: Ferrite core inductor:
Description : The component used for tuning a radio is basically a variable (1) Resistor (2) Condenser (3) Inductor (4) Transformer
Last Answer : Condenser
Description : Define resistor and draw symbol of variable resistor.
Last Answer : Resistor: A resistor is an electrical component that limits or regulates the flow of electrical current in an electronic circuit. Symbol of variable resistor:
Description : A two-terminal variable resistor is known as a? A.potentiometer B.thermistor C.rheostat D.wiper
Last Answer : A two-terminal variable resistor is known as a? A.potentiometer B.thermistor C.rheostat D.wiper
Description : Which of the following statement(s) is/are true concerning the physiology of the microvascular system? a. Filtration of capillary fluid into the interstitial and the subsequent reabsorption is ... the arteriolar level d. Adrenergic vasoconstriction can arrest blood flow to an entire capillary bed
Last Answer : Answer: a, c, d Exchange of material between the vascular space and the cell of various tissues via the interstitial space is essential for organ viability and occurs at the ... contractions are potent enough that blood flow to entire capillary beds can be arrested by adrenergic vasoconstriction
Description : The experimental method is Options: A) A method for verifying a hypothesis B) A method deriving inferences C) A variable controlling method D) None of the above
Last Answer : A) A method for verifying a hypothesis
Description : A Project control system: 1. Monitors and controls the project's schedule, costs, scope, budgets etc 2. Is a mechanism which reacts to the current project status in order to endure ... 4. Is a system for controlling and executing project documentation in an uniform and timely manner
Last Answer : 1. Monitors and controls the project's schedule, costs, scope, budgets etc
Description : What name is given to a resistor used to replace the normal load in a circuit?
Last Answer : Dummy load or dummy antenna.
Description : A resistor is handed to you for identification with the following color code: the first band is blue, followed by gray, green, gold, and brown. What is the resistor’s value?
Last Answer : 6,800,000 ohms (6.8 mega ohms), with 5% tolerance, and a 1% reliability level.
Description : The same resistor mentioned in question 63 has a yellow fifth band. What does this signify?
Last Answer : The resistor’s chance of failure is 0.001 percent for 1000 hours of operation.
Description : A carbon resistor has the following color bands: The first band is yellow, followed by violet, yellow, and silver. What is the ohmic value of the resistor?
Last Answer : 470,000 ohms (470 kilo ohms).
Description : A carbon resistor has a resistance of 50 ohms, and a tolerance of 5 percent. What are the colors of bands one, two, three, and four, respectively?
Last Answer : The bands are green, black, black, and gold.
Description : What does the wattage rating of a resistor indicate?
Last Answer : Its ability to dissipate heat
Description : If the load in question 50 requires a voltage of +90 V, what should be the value of the bleeder resistor?
Last Answer : 2 kΩ
Description : What term identifies a single resistor that represents total resistance of a complex circuit?
Last Answer : Equivalent resistor or Req.
Description : Four equal resistors are connected in parallel, each resistor has an ohmic value of 100 ohms, what is the equivalent resistance?
Last Answer : 25 ohms
Description : What is the voltage dropped by each resistor of the circuit described in question 17?
Last Answer : E1 = 60 volts. E2 = 180 volts. E3 = 240 volts.
Description : What is the time constant of the resistor and capacitor in a peak detector for pam?
Last Answer : At least 10 times the interpulse period.
Description : A circuit is to be designed in which a capacitor must charge to 40 percent of the maximum charging voltage in 200 microseconds. The resistor to be used has a resistance of 40,000 ohms. What size capacitor must be used?
Last Answer : 0.1 microfarads 40% from the graph = 0.5
Description : What is the RC time constant of a series RC circuit that contains a 12-megohm resistor and a 12-microfarad capacitor?
Last Answer : 144 seconds (t=R x C)
Description : What is the voltage drop across the resistor in an RC charging circuit when the charge on the capacitor is equal to the battery voltage?
Last Answer : Zero.
Description : At what instant does the greatest voltage appear across the resistor in a series RC circuit when the capacitor is charging?
Last Answer : At the instant of the initiation of the action.
Description : What factors determine the value of the multiplier resistor?
Last Answer : The current required for full-scale deflection, and the range of the voltage to be measured.
Description : What are three ways of controlling radiated emi during transmission?
Last Answer : a) physical separation of the antenna (b) limiting bandwidth of the antenna (c) use of directional antennas
Description : List the four factors you should use to select wire for a specified current rating.
Last Answer : Conductor size, the material it is made of the location of the wiren in a circuit, and the type of insulation used.
Description : When a project manager starts to plan a new project budget, the cost of which project management process group is expected to be lowest? Select one: a. Initiating b. Executing c. Monitoring and controlling d. Closing e. Planning
Last Answer : d. Closing
Description : What is common to all of them? Select the most appropriate name. A. Soil erosion controlling methods. B. Traditional water harvesting methods. C. Modern methods of irrigation. D. All of them.
Last Answer : B. Traditional water harvesting methods.
Description : What are the advantages of fertigation in agriculture? 1. Controlling the alkalinity of irrigation water is possible. 2. Efficient application of Rock Phosphate and all other phosphatic fertilizers is possible. 3. Increased availability of ... 1, 2 and 4 only c) 1, 3 and 4 only d) 2, 3 and 4 only
Last Answer : c) 1, 3 and 4 only
Description : How can the amount of current be changed in a circuit?
Last Answer : By changing the circuit resistance or the voltage of the power source.
Description : If the amount of current in the conductor changes, what happens to the magnetic field around the conductor?
Last Answer : If the current increases the magnetic field increases; if the current decreases the magnetic field decreases.
Description : What is the limiting factor as to the amount of current an electrodynamometer meter movement can handle?
Last Answer : Size of spiral conducting.