Description : Percentage of pozzolanic material containing clay upto 80% used for the manufacture of pozzolana cement, is (A) 30 % (B) 40 % (C) 50 % (D) 60 %
Last Answer : (A) 30 %
Description : The percentage of alumina in a good brick earth lies between (A) 5 to 10 % (B) 20 to 30 % (C) 50 to 60 % (D) 70 to 80 %
Last Answer : Answer: Option B
Description : Percentage of silica in a good brick earth lies between (A) 5 to 10 % (B) 20 to 30 % (C) 50 to 60 % (D) 70 to 80
Last Answer : Answer: Option C
Description : To be designated as Clay soil, A soil must contain at least — % clay separates. a. 40 b. 15 c. 35 d. 75
Last Answer : c. 35
Description : The specific retention is least in case of (A) Clay (B) Sand (C) Silt (D) Coarse gravel
Last Answer : (D) Coarse gravel
Description : Pick up the correct statement from the following: (A) Sandy clayloam contains highest percentage of sand (B) Silty clayloam contains highest percentage of silt (C) Stiff boulder clay offers maximum shear strength (D) Soft chalk carries least safe load
Description : If voids ratio is 0.67, water content is 0.188 and specific gravity is 2.68, the degree of saturation of the soil, is (A) 25 % (B) 40 % (C) 60 % (D) 75 %
Last Answer : Answer: Option D
Description : A 1st class brick immersed in water for 24 hours, should not absorb water (by weight) more than (A) 10 % (B) 15 % (C) 20 % (D) 25 %
Description : A first class brick when immersed in cold water for 24 hours should not absorb water more than (A) 15 % (B) 20 % (C) 22 % (D) 25 %
Description : A well is considered to be good if it is sunk into (A) Clay (B) Sand (C) Coarse gravel (D) Silt
Last Answer : (C) Coarse gravel
Description : Turbidity of water may be caused due to (A) Suspended clay (B) Suspended silt (C) Finely divided organic material (D) All the above
Last Answer : (D) All the above
Description : The soil which contains finest grain particles, is (A) Coarse sand (B) Fine sand (C) Silt (D) Clay
Last Answer : (D) Clay
Description : Which of the following soils has more plasticity index? (A) Sand (B) Silt (C) Clay (D) Gravel
Last Answer : (C) Clay
Description : If the permeability of a soil is 0.8 mm/sec, the type of soil is (A) Gravel (B) Sand (C) Silt (D) Clay
Last Answer : (B) Sand
Description : the plasticity index of a soil mass is zero, the soil is (A) Sand (B) Silt (C) Clay (D) Clayey silt
Last Answer : (A) Sand
Description : Cohesionless soil is (A) Sand (B) Silt (C) Clay (D) Clay and silt
Description : The admixture of coarser particles like sand or silt to clay causes (A) Decrease in liquid limit and increase in plasticity index (B) Decrease in liquid limit and no change in plasticity index ... in both liquid limit and plasticity index (D) Increase in both liquid limit and plasticity index
Description : Pick up the correct statement from the following: (A) Sand obtained from pits, is washed to remove clay and silt (B) Sand obtained from flooded pits, need not be washed before use (C) The ... shore sand and shingle may cause corrosion of reinforcement if the concrete is porous (D) All the above
Description : The percentage of the aggregate of F.M. 2.6 to be combined with coarse aggregate of F.M. 6.8 for obtaining the aggregates of F.M. 5.4, is (A) 30 % (B) 40 % (C) 50 % (D) 60 %
Last Answer : (C) 50 %
Description : The minimum TSS content in RTS beverage is — % a. 10 b. 20 c. 30 d. 40
Last Answer : a. 10
Description : In mixed farming at least — % gross income contributed by livestocks. a. 10 b. 20 c. 30 d. 40
Description : The strength of brick masonry in 1:6 cement mortar, is (A) 20 tonnes/m2 (B) 40 tonnes/m2 (C) 50 tonnes/m2 (D) 60 tonnes/m
Description : What is the name of the soil that is 60 silt 20 sand and 20 clay?
Last Answer : Need answer
Description : What is a type of soil that has significant amounts of sand silt and clay.?
Last Answer : Loamy Soil.
Description : Which of the following is the correct order of increasing size of the grains of soil particles? 1. Clay 2. Silt 3. Sand 4. Gravel (a) BCDA (b) ABCD (c) DCBA (d) ADCB
Last Answer : Ans: (b)
Description : The soil which is a mixture of sand, clay and silt is known as: (a) loamy soil (b) sandy soil (c) clayey soil (d) desert soil
Last Answer : Ans: (a)
Description : Match the following : A. Chernozems 1. Rich in calcium carbonate B. Black soil 2. Contains aluminium compound C. Laterite 3. Richest soils in the world D. Terra Rosa 4. Formed in limestone E. Alluvial soil 5. It is a mixture of clay, sand and ... 1 2 3 4 5 (b) 3 1 2 4 5 (c) 4 5 3 1 2 (d) 3 4 5 2 1
Description : Which of the following are the components of loamy soils? 1. Red soil 2. Clay soil 3. Alluvial soil 4. Silt soil 5. Sandy soil In d i a n So i l , Se a s o n s a n d N a t u r a l Ve g e t a t i o n (a) I and II (b) I, III and IV (c) II and V (d) II, III and V
Last Answer : Ans: (c)
Description : The relative proportion of sand, silt and clay is termed as
Last Answer : Ans. Soil texture
Description : Deep black soil is productive due to high proportion of (a) sand and zinc (b) gravel and calcium (c) clay and humus (d) silt and earthworm.
Last Answer : (c) clay and humus
Description : The relative proportion of sand, silt and clay is called (A) Soil texture (B) Soil aggregation (C) Soil structure (D) Soil taxonomy
Last Answer : (A) Soil texture
Description : performance of naphthalic anhydride against EPTC was marginal in which type of soils a).clay b). clay loam c). loamy d). sandy silt
Last Answer : d). sandy silt
Description : The recommended value of modular ratio for reinforced brick work is (A) 18 (B) 30 (C) 40 (D) 58
Last Answer : (C) 40
Description : The process of mixing clay, water and other ingredients to make brick is known as (A) Kneading (B) Moulding (C) Pugging (D) Drying
Last Answer : Answer: Option A
Description : The moisture content of sludge is reduced from 90% to 80% in a sludge digestion tank. The percentage decrease in the volume of sludge, is A. 25 % B. 50 % C. 10 % D. 5 %
Last Answer : ANS: B
Description : High carbon steel having carbon content about (A) 0.25 % (B) 0.25 – 0.50 % (C) 0.50 – 1.5 % (D) 2.5 - 4.5 %
Last Answer : (C) 0.50 – 1.5 %
Description : Medium Carbon steel was carbon content about (A) 0.25 % (B) 0.25 – 0.50 % (C) 0.50 – 1.5 % (D) 2.5 – 4.5 %
Last Answer : (B) 0.25 – 0.50 %
Description : Carbon content in the cast iron is (A) 2.5 – 4.5 % (B) 0 – 0.25 % (C) 0.25 – 0.50 % (D) 0.50 – 1.5 %
Last Answer : (B) 0 – 0.25 %
Description : If the degree of saturation of a partially saturated soil is 60%, then air content of the soil is (A) 40 % (B) 60 % (C) 80 % (D) 100 %
Last Answer : (A) 40 %
Description : Pick up the correct statement about silt soil from the following: (A) The silt soil has particle size from 0.02 mm to 0.06 mm (B) In organic fine grained silt soil possesses no ... The least plastic type normally consists of more or less equidimensional grains of quartz (D) All the above
Description : The expected out turn of brick work in cement mortar in foundation and plinth per mason per day, is (A) 1.00 m3 (B) 1.25 m3 (C) 1.50 m3 (D) 1.75 m3
Last Answer : (B) 1.25 m3
Description : The weight of a good quality brick when immersed in water for a period of 16 hours should not exceed the weight of dry brick (A) 20 % (B) 15 % (C) 10 % (D) None of these
Description : Brass is an alloy of copper and zinc having the relative percentage (A) 60-70% Cu and 30-40% Zn (B) 50-60% Cu and 40-50% Zn (C) 40-50 % Cu and 60-50% Zn (D) 30-40 % Cu and 60-70% Zn
Last Answer : A) 60-70% Cu and 30-40% Zn
Description : For determining the moisture content of a soil sample, the following data is available Weight of container = 260 g, Weight of soil sample and = 320 g container, Weight of soil sample (dried) and = 310 g container. The moisture content of the soil sample, is (A) 15 % (B) 18 % (C) 20 % (D) 25 %
Last Answer : (C) 20 %
Description : The practical limit of moisture content achieved in air drying of timber is (A) 5 % (B) 15 % (C) 25 % (D) 35 %
Description : By what number must the given number be multiplied to increase the number by 25 %. a) 25 b) 60 c) 50 d) None e) 98
Last Answer : Answer: A Let the number be m Increase in its value = 25 % of m = 25/100 × m = m/4 Therefore, increase value = m + m/4 = (4m + m)/4 = 5m/4 Therefore, the given number must be multiplied by 5/4 to increase the number by 25 %.
Description : The percentage of voids in cement is approximately (A) 25 % (B) 40 % (C) 60 % (D) 80 %
Last Answer : (B) 40
Description : According to IS : 456-2000, clause 39.4, stirrups should be provided for a shear of [ A ] at least 75% [ B ] at least 50% [ C ] at least 25 % [ D ] none of the above.
Last Answer : [ B ] at least 50%
Description : Degree of saturation of a natural soil deposit having water content 15%, specific gravity 2.50 and void ratio 0.5, is (A) 50 % (B) 60 % (C) 75 % (D) 80 %
Last Answer : (C) 75 %