Description : Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect of free convection over a vertical flat plate as (A) Gr0.25, Gr (B) Gr0.25, Gr0.33 (C) Gr, Gr0.25 (D) Gr0.33, Gr0.25
Last Answer : Option A
Description : The Sieder-Tate correlation for heat transfer in turbulent flow in pipe gives Nu α Re 0.8 , where, Nu is the Nusselt number and Re is the Reynolds number for the flow. Assuming that this relation is valid, the heat transfer co-efficient ... pipe diameter (D) as (A) D-1.8 (B) D-0.2 (C) D0.2 (D) D1.8
Last Answer : (B) D-0.2
Description : Critical value of the __________ number governs the transition from laminar to turbulent flow in free convection heat transfer. (A) Grashoff (B) Reynolds (C) Both 'a' & 'b' (D) Prandtl & Grashoff
Last Answer : (D) Prandtl & Grashoff
Description : When the pipe Reynold's number is 6000, the flow is generally (A) Viscous (B) Laminar (C) Turbulent (D) Transition
Last Answer : (C) Turbulent
Description : In turbulent flow, a rough pipe has the same friction factor as a smooth pipe (A) In the zone of complete turbulence (B) When the roughness projections are much smaller than the thickness of ... ) Everywhere in the transition zone (D) When the friction factor is independent of the Reynold's number
Last Answer : (B) When the roughness projections are much smaller than the thickness of the laminar film
Description : Transition from laminar to turbulent zone in free convection heat transfer is governed by the critical value of (A) Grashoff number (B) Grashoff number & Reynolds number (C) Reynolds number (D) Grashoff number & Prandtl number
Last Answer : Option D
Description : For turbulent mass transfer in pipes, the Sherwood number depends on the Reynolds number as (A) Re 0.33 (B) Re 0.53 (C) Re 0.83 (D) Re
Last Answer : (C) Re 0.83
Description : Nusselt number for full developed, laminar, constant property flow in a pipe at uniform heat flux is (A) 0.72 (B) 4.364 (C) 18 (D) 83
Last Answer : (B) 4.364
Description : The laminar boundary layer thickness in zero pressure gradient flow over a flat plate along the x-direction varies as x0.5 while the thickness of turbulent boundary layer varies as (where, x = distance from the leading edge) (A) x1.5 (B) x0.8 (C) x-1.5 (D) x-0.8
Last Answer : (B) x0.8
Description : The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe whose surface temperature remains constant is (A) 1.66 (B) 88.66 (C) 3.66 (D) Dependent on NRe only
Last Answer : (C) 3.66
Description : The Nusselt number for fully developed (both thermally and hydrodynamically) laminar flow through a circular pipe, where the wall heat flux is constant, is (A) 2.36 (B) 4.36 (C) 120.36 (D) Dependent on NRe only
Last Answer : (B) 4.36
Description : Fanning friction factor for laminar flow of fluid in a circular pipe is (A) Not a function of the roughness of pipe wall (B) Inversely proportional to Reynolds number (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : Pick out the wrong statement: (A) Greater is the kinematic viscosity of the liquid, greater is the thickness of the boundary layer (B) Blowers develop a maximum pressure of 2 atmospheres ( ... factor in case of turbulent flow of liquids in pipe depends upon relative roughness & Reynolds number
Last Answer : (C) Friction losses in pipe fittings are generally expressed in terms of velocity heads
Description : Isothermal turbulent flow of a fluid results in decrease of its pressure, which depends on the (A) Wall roughness (B) Reynolds number (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Convective heat transfer co-efficient in case of fluid flowing in tubes is not affected by the tube length/diameter ratio, if the flow is in the __________ zone. (A) Laminar (B) Transition (C) Both 'a' & 'b' (D) Highly turbulent
Last Answer : (D) Highly turbulent
Description : Transition from laminar flow to turbulent flow is aided by the (A) Surface roughness and curvature (i.e. sharp corners) (B) Vibration (C) Pressure gradient and the compressibility of the flowing medium (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : The distribution of shear stress in a stream of fluid in a circular tube is (A) Linear with radius for turbulent flow only (B) Linear with radius for laminar flow only (C) Linear with radius for both laminar & turbulent flow (D) Parabolic with radius for both laminar & turbulent flow
Last Answer : (C) Linear with radius for both laminar & turbulent flow
Description : . In case of turbulent flow of fluid through a circular pipe, the (A) Mean flow velocity is about 0.5 times the maximum velocity (B) Velocity profile becomes flatter and flatter with ... , shear stresses, random orientation of fluid particles and slope of velocity profile at the wall are more
Last Answer : (D) Skin friction drag, shear stresses, random orientation of fluid particles and slope of velocity profile at the wall are more
Description : Nusselt number (for forced convection heat transfer) is a function of the __________ number. (A) Prandtl (B) Reynolds (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : jH factor for heat transfer is not a function of the __________ number. (A) Reynolds (B) Nusselt (C) Grashoff (D) Both (B) & (C)
Last Answer : (D) Both (B) & (C)
Description : Pick out the correct statement pertaining to transition/ entrance length in fluid flow. (A) The length of entrance region of pipe, in which full development of fluid flow takes place such that velocity profile does not change ... pipe of diameter 'd' is equal to 50 D (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : Heat transfer co-efficient equation for forced convection, Nu = 0.023 Re 0.8 . Pr n , is not valid, if the value of (A) n = 0.4 is used for heating (B) n = 0.3 is used for cooling (C) Reynolds number for the flow involved is > 10000 (D) Reynolds number for the flow involved is < 2100
Last Answer : (D) Reynolds number for the flow involved is < 2100
Description : The Graetz number is concerned with the (A) Mass transfer between a gas and a liquid (B) Absorption with chemical reaction (C) Heat transfer in turbulent flow (D) Heat transfer in laminar flow
Last Answer : (D) Heat transfer in laminar flow
Description : Dittus-Boelter equation used for the determination of heat transfer coefficient is valid (A) For fluids in laminar flow (B) For fluids in turbulent flow (C) When Grashoff number is very important (D) For liquid metals
Last Answer : (B) For fluids in turbulent flow
Description : Laminar flow region is said to exist during agitation of a liquid in an agitator, when the value of Reynolds number is (A) > 10 (B) < 10 (C) > 100 (D) < 100
Last Answer : (B) < 10
Description : Laminar flow of a Newtonian fluid ceases to exist, when the Reynolds number exceeds (A) 4000 (B) 2100 (C) 1500 (D) 3000
Last Answer : (B) 2100
Description : The friction factor for turbulent flow in a hydraulically smooth pipe (A) Depends only on Reynolds number (B) Does not depend on Reynolds number (C) Depends on the roughness (D) None of these
Last Answer : (A) Depends only on Reynolds number
Description : For the Stoke's law to be valid in the case of a falling sphere in a fluid, the (A) Reynolds number (based on sphere diameter) should be < 1 (B) Flow around the sphere should be in turbulent region (C) Sphere must be metallic (D) Fluid density should be constant
Last Answer : (C) Sphere must be metallic
Description : In case of a plate and frame filter press, filtrate flow through the cake follows __________ flow. (A) Plug (B) Turbulent (C) Laminar (D) None of these
Last Answer : (C) Laminar
Description : A straight line is obtained on plotting reciprocal of filtration rate vs. the volume of filtrate for __________ flow of filtrate. (A) Compressible cakes and laminar (B) Incompressible cake and laminar (C) Compressible cake and turbulent (D) Incompressible cake and turbulent
Last Answer : (B) Incompressible cake and laminar
Description : Maximum heat transfer rate is achieved in __________ flow. (A) Co-current (B) Counter-current (C) Turbulent (D) Laminar
Last Answer : (C) Turbulen
Description : Maximum heat transfer rate is obtained in __________ flow. (A) Laminar (B) Turbulent (C) Creeping (D) Transition region
Last Answer : (B) Turbulent
Description : Bernoulli's equation describes the (A) Mechanical energy balance in potential flow (B) Kinetic energy balance in laminar flow (C) Mechanical energy balance in turbulent flow (D) Mechanical energy balance in boundary layer
Last Answer : (A) Mechanical energy balance in potential flow
Description : Fanning equation is given by (∆P/ρ) = 4f (L/D) (v 2 /2gc ). It is applicable to __________ region flow. (A) Transition (B) Laminar (C) Turbulent (D) Both (B) and (C)
Last Answer : (D) Both (B) and (C)
Description : Pick out the correct statement. (A) A forced vortex occurs when fluid rotates as a solid about an axis (B) In laminar flow, Newton's law of viscosity does not apply (C) A free vortex occurs, when fluid rotates as a solid (D) In turbulent flow, there are neither cross-currents nor eddies
Last Answer : (A) A forced vortex occurs when fluid rotates as a solid about an axis
Description : Pick out the wrong statement. (A) The form drag is dependent upon the occurrence of a wake (B) The shear stress at any given cross-section of a pipe for steady flow (either laminar or turbulent ... of viscosity (D) Existence of the boundary layer in fluid flow is because of viscosity of the fluid
Last Answer : (C) An ideal fluid is the one, which has negligible surface tension and obeys the Newton's law of viscosity
Description : f = 16/NRe , is valid for (A) Turbulent flow (B) Laminar flow through an open channel (C) Steady flow (D) None of these
Last Answer : (D) None of these
Description : In turbulent flow, the (A) Fluid particles move in an orderly manner (B) Momentum transfer is on molecular scale only (C) Shear stress is caused more effectively by cohesion than momentum transfer (D) Shear stresses are generally larger than in a similar laminar flow
Last Answer : (D) Shear stresses are generally larger than in a similar laminar flow
Description : Pick out the wrong statement. (A) A fluid mass is free from shearing forces, when it is made to rotate with a uniform velocit (B) Newton's law of viscosity is not applicable to the ... types of bearings (D) Rise of water in capillary tubes reduces with the increasing diameter of capillary tubes
Last Answer : (B) Newton's law of viscosity is not applicable to the turbulent flow of fluid with linear velocity distribution
Description : Transition from laminar flow to turbulent flow in fluid flow through a pipe does not depend upon the (A) Length of the pipe (B) Diameter of the pipe (C) Density of the fluid (D) Velocity of the fluid
Last Answer : (A) Length of the pipe
Description : Experimental study of laminar fluid flow through a circular tube was conducted by (A) Reynolds (B) Hagen and Poiseuille (C) Pascal (D) Blake-Plummer
Last Answer : (B) Hagen and Poiseuille
Description : Which of the fluid forces are not considered in the Reynold's equation of flow? (A) Viscous forces (B) Turbulent forces (C) Pressure forces (D) Compressibility forces
Last Answer : (D) Compressibility forces
Description : A large Reynold number is indication of (A) Smooth and streamline flow (B) Laminar flow (C) Steady flow (D) Highly turbulent flow
Last Answer : Answer: Option D
Description : The flow in a pipe is neither laminar nor turbulent when Reynold number is (A) Less than 2000 (B) Between 2000 and 2800 (C) More than 2800 (D) None of these
Last Answer : Answer: Option B
Description : Pick out the wrong statement pertaining to the analogy between equations of heat and mass transfer operations. (A) Sherwood number in mass transfer is analogous to Nusselt number in heat transfer ... heat transfer (D) Reynolds number remains the same in both heat and mass transfer
Last Answer : (C) Reynolds number in mass transfer is analogous to Grashoff number in heat transfer
Description : jH factor for heat transfer depends upon the __________ number. (A) Biot (B) Nusselt (C) Reynolds (D) Prandtl
Last Answer : (C) Reynolds
Description : For pipes, laminar flow occurs when Reynolds number is (A) Less than 2000 (B) Between 2000 and 4000 (C) More than 4000 (D) Less than 4000
Last Answer : Answer: Option A
Description : For pipes, turbulent flow occurs when Reynolds number is (A) Less than 2000 (B) Between 2000 and 4000 (C) More than 4000 (D) Less than 4000
Last Answer : Answer: Option C
Description : Define. i) Streamline flow ii) Turbulent flow Give significance of Reynold’s number.
Last Answer : i) Streamline flow The flow of liquid in which every particle of liquid moves in the same direction of flow of liquid is called streamline flow. ii) Turbulent flow The flow of liquid in which every ... to 3000 liquid flow is unstable. (3)When R is greater than 3000 liquid flow is turbulent.
Description : A flow in which the viscosity of fluid is dominating over the inertia force is called (A) Steady flow (B) Unsteady flow (C) Laminar flow (D) Turbulent flow