Description : The coefficient of friction depends upon (A) Nature of surfaces (B) Area of contact (C) Shape of the surfaces (D) All of the above
Last Answer : (A) Nature of surfaces
Description : Pick up wrong statement about friction force for dry surfaces. Friction force is (A) Proportional to normal load between the surfaces (B) Dependent on the materials of contact surface (C) Proportional to velocity of sliding (D) Independent of the area of contact surfaces
Last Answer : (C) Proportional to velocity of sliding
Description : Which of the following statements is/are true for coulomb damping? 1. Coulomb damping occurs due to friction between two lubricated surfaces2. Damping force is opposite to the direction of motion of vibrating body ... 2, 3 and statement 4 c. Only statement 2 d. All the above statements are true
Last Answer : c. Only statement 2
Description : Incorrect statement for co-efficient of friction could be that A. The coefficient of friction is denoted by the Greek letter µ. B. The coefficient of friction is directly proportional to ... D. The coefficient of friction is inversely proportional to the force pressing the surfaces together
Last Answer : The coefficient of friction is constant even in the conditions of fast slipping and high contact pressure
Description : The ideal angle of banking provided on roads a.Depends on (velocity)2 of vehicle b.Depends on the nature of road surface c.Depend on coefficient of friction between the road and the vehicle cantact point d.Depends on weight of the vehicle e.All above
Last Answer : a. Depends on (velocity)2 of vehicle
Description : Which one of the following is not the law of dry friction? a.If friction is neglected, the reactions are always normal to the surfaces on contact b.Friction always acts to oppose the relative motion of ... its maximum value d.The force of friction is always normal to the surface e.All of the above
Last Answer : d. The force of friction is always normal to the surface
Description : The strength and quality of concrete depends upon (i)Grading of aggregates (ii)Shape of aggregates (iii)Surface area of aggregates (iv)Surface texture of aggregates [ A ] i, ii and iv [ B ] ii, iii and iv [ C ] i, iii and iv [ D ] i, ii, iii and iv
Last Answer : [ D ] i, ii, iii and iv
Description : Dynamic friction as compared to static friction is (A) Same (B) More (C) Less (D) May be less of more depending on nature of surfaces and velocity
Last Answer : (C) Less
Description : A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of friction between the cylinder and the surface is a. ... c.Indeterminate d.Determinate but depends on the acceleration of the cylinder e.None of the above
Last Answer : c. Indeterminate
Description : A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of friction between the cylinder and the surface is a. ... on the acceleration of the cylinder d.107 dynes e.Proportional to the coefficient of static friction
Last Answer : c. Determinate but depends on the acceleration of the cylinder
Description : The angle of contact in case of a liquid depends upon (A) The nature of the liquid and the solid (B) The material which exists above the free surface of the liquid (C) Both of die above (D) Any one of the above
Last Answer : Answer: Option C
Description : The nature of loading at various locations and other surfaces conditions called a.friction b.traction c.boundary condition d.surfacing
Last Answer : c.boundary condition
Description : Which one of the following statements is true for Mohr-Coulomb envelope? (A) Coulomb suggests that the relationship between shear strength and normal stress, is adequately represented by the straight line ... exists among the principal stress and the angle of internal friction (D) All the above
Last Answer : Answer: Option D
Description : If the coefficient of friction on the road surface is 0.15 and a maximum super-elevation 1 in 15 is provided, the maximum speed of the vehicles on a curve of 100 metre radius, is (A) 32.44 km/hour (B) 42.44 kg/hour (C) 52.44 km/hour (D) 62.44 km/hour
Description : When primary molars are prepared for stainless steel crowns, should the depth for reduction of the proximal surface be similar to the depth of the buccal and lingual surfaces? A. Yes; reduction ... can be seated E. No, because of lateral constriction, the lingual surface needs greatest reduction
Last Answer : B. No, proximal reduction is greater to allow the crown to pass the contact area
Description : Name two factors on which the coefficient of friction depends.
Last Answer : Name two factors on which the coefficient of friction depends.
Description : Consider tile following statements: [IES-1993; 2002; 2006] Radius of friction circle for a journal bearing depends upon 1. Coefficient of friction 2. Radius of the journal 3. Angular speed of rotation of the shaft Which of the ... ) 1,2 and 3 (b) Only 1 and 2 (c) Only 2 and 3 (d) Only 1 and 3
Last Answer : (b) Only 1 and 2
Description : Enlist any two factors on which friction coefficient ‘F’ depends.
Last Answer : i. Diameter of pipe ii.Velocity of flow iii. Reynold’s number of the flow iv.Roughness condition of the pipe surface
Description : The coefficient of friction depends on?
Last Answer : The coefficient of friction depends on nature of surface.
Description : Coulomb friction is a.Friction between solids and liquids b.Friction between electrically charged bodies c.Friction between lubricated surface d.Friction between dry surfaces e.Friction between bodies having relative motion
Last Answer : d. Friction between dry surfaces
Description : A sliding contact bearing is operating under stable condition. The pressure developed in oil film is p when the journal rotates at N rpm. The dynamic viscosity of lubricant is μ and effective coefficient of ... to p and f) (d) f is directly proportional to μ and inversely proportional to N
Last Answer : (b) f is directly proportional to μ and N
Description : A structure is erected on an impervious clay whose thickness is 12 m. Drainage is possible both at upper and lower surfaces. Coefficient of consolidation is 0.015 cm2 per minute. For attaining 50% consolidation with a ... 20, the number of days required (A) 3233 (B) 3123 (C) 33331 (D) 3313
Description : Which one of the following surfaces will give highest coefficient of traction while using crawler track tractors? (A) Ice (B) Concrete (C) Loose sand (D) Earth
Last Answer : (D) Earth
Description : Coulomb friction is the friction between (A) Bodies having relative motion (B) Two dry surfaces (C) Two lubricated surfaces (D) Solids and liquids
Last Answer : (A) Bodies having relative motion
Description : The strength and quality of concrete, depend upon: (A) Grading of aggregates (B) Surface area of aggregates (C) Shape of aggregates (D) All the above
Description : The shearing strength of a cohesion-less soil depends upon (A) Dry density (B) Rate of loading (C) Confining pressure (D) Nature of loading
Description : A wire loop is moved parallel to a uniform magnetic field. The induced emf in the loop: a. depends on the shape b. depends on area c. depends on nature of loop d. zero
Last Answer : d. zero
Description : Deformation drag, which is caused by widespread deformation of fluid around the immersed body (A) Occurs when NRe is very small (B) Is primarily a friction drag (C) Is independent of body length (D) Depends mainly on cross-sectional shape
Last Answer : (A) Occurs when NRe is very small
Description : It is easier to roll a barrel than to pull it because (a) the full weight of the barrel comes into play when it is pulled (b) rolling friction is much less than sliding friction (c) the surface ... in contact with the road is more in the case of pulling (d) of a reason other than those mentioned
Last Answer : Ans:(b)
Description : The coefficient of discharge for an external mouthpiece depends upon (A) Velocity of liquid (B) Pressure of liquid (C) Area of mouthpiece (D) Length of mouthpiece
Description : Which of the following is not depends on shear strength of the material? (A) Cohesion (B) Internal friction (C) Normal stress (D) Mass of the material
Last Answer : (D) Mass of the material
Description : A block of mass m is pulled along a surface as shown. The coefficient of kinetic friction between the block and the surface is m and the tension in the rope is T. The acceleration of the block is (a) a = T cos q/mg (b) a = T cos q/mgm (c) a = T cos q/m + mmg (d) None of the above
Last Answer : Ans:(d)
Description : The shear resistance of a soil is constituted basically of the following component. (A) The frictional resistance to translocation between the individual soil particles at their contact point (B) To the ... (C) Cohesion and adhesion between the surfaces of the soil particles (D) All the above
Description : Which one of the following statements is not correct? (A) The tangent of the angle of friction is equal to coefficient of friction (B) The angle of repose is equal to angle of ... coefficient of friction (D) The sine of the angle of repose is equal to coefficient to friction
Last Answer : (D) The sine of the angle of repose is equal to coefficient to friction
Description : Coefficient of friction is the (A) Angle between normal reaction and the resultant of normal reaction and the limiting friction (B) Ratio of limiting friction and normal reaction (C) The ... body is just about to move (D) The friction force acting when the body is in motion
Last Answer : (B) Ratio of limiting friction and normal reaction
Description : Tangent of angle of friction is equal to (A) Kinetic friction (B) Limiting friction (C) Angle of repose (D) Coefficient of friction
Last Answer : (D) Coefficient of friction
Description : The ratio of limiting friction and normal reaction is known as (A) Coefficient of friction (B) Angle of friction (C) Angle of repose (D) Sliding friction
Last Answer : (A) Coefficient of friction
Description : The coefficient of active earth pressure for a loose sand having an angle of internal friction of 30° is (A) 1/3 (B) 3 (C) 1 (D) 1/2
Last Answer : (A) 1/3
Description : According to Darcy's formula, the loss of head due to friction in the pipe is (where f = Darcy's coefficient, l = Length of pipe, v = Velocity of liquid in pipe, and d = Diameter of pipe) (A) flv²/2gd (B) flv²/gd (C) 3flv²/2gd (D) 4flv²/2gd
Description : In a braking test, a vehicle travelling at 36 km ph was stopped at a braking distance of 8.0 m. The average value of the vehicle's skid resistance (friction coefficient) is (A) 0.64 (B) 6.25 (C) 0.16 (D) None of these
Description : Dental caries of the proximal surfaces usually starts at, A. Somewhere between the ridge and the contact area B. Just gingival to contact areas C. Just about the gingival margin
Last Answer : B. Just gingival to contact areas
Description : Which of the following statements are TRUE for damped vibrations? (P) . For a system having critical damping, the value of the damping ratio is unity and system does not undergo a vibratory motion. (Q) . Logarithmic decrement method ... Q only (B) P and S only (C) P, Q and R only (D) Q and S only
Last Answer : (C) P, Q and R only
Description : Force ( including rolling resistance friction ) that acts upon the stabilising surfaces such landslide and sole of bottom are called a) Useful soil resistance b) Parasitic force d) Draft of implement. d) Pull of implement
Last Answer : b) Parasitic force
Description : Black body radiations depends upon a) The shape and nature of the body b) The velocity of radiations and colour of the body c) The temperature of the body d) All of the above
Last Answer : c) The temperature of the body
Description : Rate of cooling depends on the (1) Temperature difference between the body and the surroundings (2) Nature of the radiating surface (3) Area of the radiating surface (4) All of these
Last Answer : (4) All of these Explanation: Newton's Law of Cooling states that the rate of temperature of the body is proportional to the difference between the temperature of the body and that of the ... Specific heat of the radiating body; Temperature of radiating body and ♦ Temperature of the surrounding.
Description : Wavelength of radiation emitted by a body depends on the __________ of its surface. (A) Temperature (B) Area (C) Nature (D) All 'a', 'b' & 'c'
Last Answer : Option
Last Answer : All of these
Description : Rain drops acquire spherical shape due to - (1) viscosity (2) surface tension (3) friction (4) elasticity
Last Answer : (2) surface tension Explanation: The Surface tension pulls the surface of the drop equally at all points thus produces the spherical shape having the minimum surface area.
Description : ________ is a substance that can reduce the force of friction between the two surface in contact. a) lubricant b)paste c)water d)push
Last Answer : a) lubricant