Dynamic friction as compared to static friction is
(A) Same
(B) More
(C) Less
(D) May be less of more depending on nature of surfaces and velocity
Description : Dynamic friction as compared to static friction is?
Last Answer : Dynamic friction is less compared to static friction.
Description : Which one of the following is not the law of dry friction? a.If friction is neglected, the reactions are always normal to the surfaces on contact b.Friction always acts to oppose the relative motion of ... its maximum value d.The force of friction is always normal to the surface e.All of the above
Last Answer : d. The force of friction is always normal to the surface
Description : Static friction is always a.greater than the dynamic driction b.either greater or more than the dynamic friction c.less than the dynamic friction d.107 dynes e.equal to the dynamic friction
Last Answer : a. greater than the dynamic driction
Description : The coefficient of friction depends upon (A) Nature of surfaces (B) Area of contact (C) Shape of the surfaces (D) All of the above
Last Answer : (A) Nature of surfaces
Description : The coefficient of friction depends on (A) Area of contact (B) Shape of surfaces (C) Strength of surfaces (D) Nature of surface
Last Answer : (D) Nature of surface
Description : Pick up wrong statement about friction force for dry surfaces. Friction force is (A) Proportional to normal load between the surfaces (B) Dependent on the materials of contact surface (C) Proportional to velocity of sliding (D) Independent of the area of contact surfaces
Last Answer : (C) Proportional to velocity of sliding
Description : The condensing pressure due to the presence of non-condensable gases, as compared to that actually required forcondensing temperatures without non-condensable gases, (a) will be higher (b) will be ... remain unaffected (d) may be higher or lower depending upon the nature of non-condensable gases
Last Answer : Ans: a
Description : The surface tension of mercury at normal temperature compared to that of water is (A) More (B) Less (C) Same (D) More or less depending on size of glass tube
Last Answer : Answer: Option A
Description : The air requirement of a petrol engine during starting compared to theoretical air required for complete combustion is a. more b. less c. same d. may be more or less depending on engine capacity
Last Answer : ANSWER b. less
Description : Conversion of dynamic velocity head into static pressure head in a centrifugal pump is the result of : (a) Increasing area of flow between adjacent vanes from inlet to outlet (b) Difference in pressure between suction and delivery ends (c) Radial thrust in pumps (d) Stuffing Box
Last Answer : (b) Difference in pressure between suction and delivery ends
Description : A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of friction between the cylinder and the surface is a. ... c.Indeterminate d.Determinate but depends on the acceleration of the cylinder e.None of the above
Last Answer : c. Indeterminate
Description : A uniform cylinder of weight W is rolling while slipping on a rough horizontal surface under the influence of a horizontal force. The force of friction between the cylinder and the surface is a. ... on the acceleration of the cylinder d.107 dynes e.Proportional to the coefficient of static friction
Last Answer : c. Determinate but depends on the acceleration of the cylinder
Description : Friction can be reduced by changing over from _____. A. Sliding to rolling B. Dynamic to static C. Potential energy to kinetic energy D. Rolling to sliding
Last Answer : ANSWER: A
Description : A piezometer provided in the pipe measures (A) Friction factor (B) Static pressure (C) Dynamic pressure (D) None of these
Last Answer : (B) Static pressure
Description : The nature of loading at various locations and other surfaces conditions called a.friction b.traction c.boundary condition d.surfacing
Last Answer : c.boundary condition
Description : Which of the following statements are TRUE for damped vibrations? (P) . For a system having critical damping, the value of the damping ratio is unity and system does not undergo a vibratory motion. (Q) . Logarithmic decrement method ... Q only (B) P and S only (C) P, Q and R only (D) Q and S only
Last Answer : (C) P, Q and R only
Description : Which of the following statements is/are true for coulomb damping? 1. Coulomb damping occurs due to friction between two lubricated surfaces2. Damping force is opposite to the direction of motion of vibrating body ... 2, 3 and statement 4 c. Only statement 2 d. All the above statements are true
Last Answer : c. Only statement 2
Description : Second ionization energy: A. is always less than first ionization energy B. is always greater than first ionization energy (Answer) C. is equal to the first ionization energy D. may be greater or less than the first ionization energy depending on the nature of the element
Last Answer : B. is always greater than first ionization energy (Answer)
Description : The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is (a) same (b) more (c) less (d) more or less depending on ambient conditions
Last Answer : Ans: c
Description : At triple point (for one component system), vapour pressure of solid as compared to that of liquid will be (A) More (B) Less (C) Same (D) More or less; depending on the system
Last Answer : (C) Same
Description : The work done in isothermal compression compared to that in adiabatic compression will be (A) Less (B) More (C) Same (D) More or less depending upon the extent of work done
Last Answer : (B) More
Description : Coulomb friction is the friction between (A) Bodies having relative motion (B) Two dry surfaces (C) Two lubricated surfaces (D) Solids and liquids
Last Answer : (A) Bodies having relative motion
Description : The simple Pitot tube does not measure the (A) Static pressure (B) Dynamic pressure (C) Velocity at the stagnation point (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : The __________ is measured by a piezometric opening. (A) Dynamic pressure (B) Static pressure (C) Total pressure (D) Point velocity
Last Answer : (C) Total pressure
Description : As compared to crest of the normal portion of the weir, the crest of the under sluice portion of weir is kept at (A) Lower level (B) Higher level (C) Same level (D) Any of the above depending on the design
Description : Center of pressure compared to e.g. is (A) Above it (B) Below it (C) At same point (D) Above or below depending on area of body
Last Answer : Answer: Option B
Description : Which one of the following statements is correct ? a) For water at 100o Celsius at sea level, the vapour pressure is equal to atmospheric pressure b) Surface energy (or tension) is caused by ... it both in static and in dynamic conditions d) Air is 50,000 times more compressible than water
Last Answer : c) Viscosity of a fluid is the property exhibited by it both in static and in dynamic conditions
Description : For motion of spherical particles in a stationary fluid, the drag coefficient in hindered settling compared to that in free settling is (A) More (B) Less (C) Equal (D) More or less, depending on the type of particle
Last Answer : (A) More
Description : Consider the following statements regarding Coulomb's theory of earth pressure: 1. It is based on wedge theory of earth pressure. 2. It assumes the wall surface to be rough. 3. It may or may not satisfy the static equilibrium condition ... 1, 2 & 3 (b) 1 & 2 only (c) 2 & 3 only (d) 1 & 3 only
Last Answer : (b) 1 & 2 only
Description : Friction factor for a hydraulically smooth pipe at NRe = 2100 is f1 . If the pipe is further smoothened (i.e., roughness is reduced), the friction factor at the same value of NRe , will (A) Increase (B) Decrease (C) Remain unchanged (D) Increase or decrease depending on the pipe material
Last Answer : (A) Increase
Description : Frictional force encountered after commencement of motion is called (A) Post friction (B) Limiting friction (C) Kinematic friction (D) Dynamic friction
Last Answer : (D) Dynamic friction
Description : 11. The D-Alembert's principle is used for changing the dynamic equilibrium of a fluid mass, into a static equilibrium. A) Agree B) Disagree
Last Answer : A
Description : The bearing capacity of piles is determined by (A) Dynamic formula (B) Static formula (C) Pile load tests (D) All the above
Last Answer : Answer: Option D
Description : When does the heat generated by fluid friction becomes appreciable compared to the heat transferred between the fluids? (A) At high fluid velocity (B) At low velocity (C) When fluid flows past a smooth surface (D) None of these
Last Answer : (A) At high fluid velocity
Description : Flooding is also a……... algorithm, usually generates ………... of duplicate packets. A. Static, vast number B. dynamic , vast number C. Static, less number D. dynamic , less number
Last Answer : A. Static, vast number
Description : The ideal angle of banking provided on roads a.Depends on (velocity)2 of vehicle b.Depends on the nature of road surface c.Depend on coefficient of friction between the road and the vehicle cantact point d.Depends on weight of the vehicle e.All above
Last Answer : a. Depends on (velocity)2 of vehicle
Description : Coulomb friction is a.Friction between solids and liquids b.Friction between electrically charged bodies c.Friction between lubricated surface d.Friction between dry surfaces e.Friction between bodies having relative motion
Last Answer : d. Friction between dry surfaces
Description : Incorrect statement for co-efficient of friction could be that A. The coefficient of friction is denoted by the Greek letter µ. B. The coefficient of friction is directly proportional to ... D. The coefficient of friction is inversely proportional to the force pressing the surfaces together
Last Answer : The coefficient of friction is constant even in the conditions of fast slipping and high contact pressure
Description : Force ( including rolling resistance friction ) that acts upon the stabilising surfaces such landslide and sole of bottom are called a) Useful soil resistance b) Parasitic force d) Draft of implement. d) Pull of implement
Last Answer : b) Parasitic force
Description : What is the proper procedure for suppressing electrical noise in a mobile station? A. Apply shielding and filtering where necessary B. Insulate a all plain sheet metal surfaces from each other C. ... -static spray liberally to all nonmetallic D. Install filter capacitors in series with all dc wiring
Last Answer : A. Apply shielding and filtering where necessary
Description : ………………….. implies that all subnets obtained from the same subnet mask. A) Static subnetting B) Dynamic subnetting C) Variable length subnetting D) Both B and C
Last Answer : A) Static subnetting
Description : ........ implies that all subnets obtained from the same network use the subnet mask. A) Static subnetting B) Dynamic Subnetting C) Variable length subnetting D) Both B and C
Description : ............ implies that all subnets obtained from the same network use the subnet mask. A) Static subnetting B) Dynamic Subnetting C) Variable length subnetting D) Both B and C
Description : The work done by a friction force is: w) always positive x) always negative y) always zero z) either positive or negative depending upon the situation.
Last Answer : ANSWER: X -- ALWAYS NEGATIVE
Description : Consider the following statements: 1. Friction piles are also called floating piles 2. Minimum number of piles to qualify as a pile group is three. 3. The group efficiency of a pile group may be either less than 100% or more than 100%. ... ) 1, 2 & 3 (b) 1 & 2 only (c) 2 & 3 only (d) 1 & 3 only
Last Answer : (a) 1, 2 & 3
Description : In case of a super-cooled solution, which is on the verge of crystallisation, the free energy of the solution as compared to that of the solid is (A) More (B) Less (C) Same (D) More or less; depends on the nature of solution
Description : A ship whose hull length is 100 m is to travel at 10 m/sec. For dynamic similarity, at what velocity should a 1:25 model be towed through water? (A) 10 m/sec (B) 25 m/sec (C) 2 m/sec (D) 50 m/sec
Last Answer : Answer: Option C
Description : Which of the following pairs are correctly matched? 1. Piezometric head : Sum of datum head and pressure head 2. Dynamic head : Sum of datum head and velocity head 3. Stagnation head : Sum of Piezometric head and velocity head 4. Total head ... (b) 1, 3 & 4 only (c) 2, 3 & 4 only (d) 1, 2, 3 & 4
Last Answer : (b) 1, 3 & 4 only
Description : Which of the following statements refer to correct purpose as regards testing of concrete by ultrasonic pulse velocity method? 1. To assess the quality of concrete in-situ. 2. To determine the dynamic modulus of elasticity of concrete. 3 ... and 2 only (b) 1 and 3 only (c) 2 and 3 only (d)1, 2 and 3
Last Answer : (d)1, 2 and 3
Description : The line of intersection of two surfaces of a sloping roof forming an internal angle less than 180°, is known as (A) Ridge (B) Hip (C) Valley (D) None of these