Description : Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is __________. a. 400 bps b. 800 bps c. 1600 bps d. 3200 bps
Last Answer : d. 3200 bps
Description : In TDM, the transmissionrate of the multiplexed path isusually_______ thesum of thetransmission rates of thesignal sources. A) greater than B) less than C) equal to D) not related to
Last Answer : greater than
Description : ____ system transmits frequency-division-multiplexed voice band signals over a coaxial cable for distances up to 4000 miles. A. T carrier B. X carrier C. L carrier D. F carrier
Last Answer : C. L carrier
Description : Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is ............... (A) 400 bps (B) 800 bps (C) 1600 bps (D) 3200 bps
Last Answer : (D) 3200 bps Answer: D Explanation: The multiplexer is shown in the Figure. Each frame carries 1 byte from each channel; the size of each frame, therefore, is 4 bytes, or 32 bits. Because each ... channel, the frame rate must be 100 frames per second. The bit rate is 100 32 = 3200 bps.
Description : ………………...is a minimal protocol that allows isolated hosts to link via TCP/IP over the telephone network and ………………..uses a proposed international standard for transmitting HDLC over asynchronous lines. A. LCP, PPP B. PPP, LCP C. SLIP, PPP D. PPP, SLIP
Last Answer : C. SLIP, PPP
Description : _____ isa digitalprocess that allows several connections to share thehighbandwidth ofa link. A) FDM B) TDM C) WDM D) None of the above
Last Answer : TDM
Description : In a ________ connection, three or more devices share a link. A) multipoint B) point-to-point C) (a) and(b) D) none of the above
Last Answer : multipoint
Description : In a _______ connection, more thantwo devices can share asingle link. A) point-to-point B) multipoint C) primary D) secondary
Description : Three or more devices share a link in ________ connection. a) Unipoint b) Multipoint c) Point to point d) Simplex
Last Answer : b) Multipoint
Description : The Token Ring implementation works on the __ mode. A. Contention B. Reservation C. Round Robin D. None
Last Answer : C. Round Robin
Description : The types of Unguided transmission channel or media used for LAN are __. A. Twisted Pair Cables B. Coaxial Cables C. Radio Waves D. All the above
Last Answer : C. Radio Waves
Description : In a time multiplexed space switching system, one speech sample appears every (A) 125 micro sec (B) 20 msec (C) 125 msec (D) 1 sec
Last Answer : (A) 125 micro sec
Description : At the tissue site where partial pressure of `CO_(2)` is (a)____ due to (b)____, `CO_(2)` diffuse into blood and form (c)_____ and (d)__
Last Answer : At the tissue site where partial pressure of `CO_(2)` is (a)____ due to (b)____, `CO_(2)` diffuse into blood and form (c)_____ and (d)__
Description : ____ be nimble, __ be quick change one letter?
Last Answer : This is what I’m looking for to do so Now CAN you give ME the ANSWER
Description : Project planning involves three processes:____ review, and __
Last Answer : Ans. Identification, analysis
Description : 8096 write-protected mode, no code can write to memory address between __. a) 2020 to 3FFFH b) 8000 to FFFFH c) 2000 to 3FFFH d) 2020 to 202FH 17. If the __ pin is ___ , then we have the option ... b) EA, low, internal, external c) EA, high, external, internal d) EA, low, external, internal
Last Answer : c) EA, high, external, internal
Description : If the __ pin is ___ , then we have the option of using the ____ ROM or EPROM together with _____ memory and devices. a) EA, high, internal, external b) EA, low, internal, external c) EA, high, external, internal d) EA, low, external, internal
Last Answer : a) EA, high, internal, external
Description : In 8255, under the I/O mode of operation we have __ modes. Under which mode will have the following features i) A 5 bit control port is available. ii) Three I/O lines are available at Port C. a) 3, Mode2 b) 2, Mode 2 c) 4, Mode 3 d) 3, Mode 2
Last Answer : a) 3, Mode2
Description : Crosstalk due to incomplete suppression of sidebands or to intermodulation of two or more frequency-multiplexed channels which is unintelligible is classified as A. Impulse noise B. Thermal noise C. Quantizing noise D. Miscellaneous noise
Last Answer : D. Miscellaneous noise
Description : What is time multiplexed space switching? With a neat diagram explain its operation.
Last Answer : Time division switches where an inlet or an outlet corresponded to a single subscriber line with one speech sample appearing every 125 µs on the line. Such switches are used in local exchanges. We now ... / Mt , Where t is the switching time including memory access time per inlet-outlet pair.
Description : Analog signals can be ________by combining them with a carrier frequency (A) Carried (B) Transported (C) Multiplexed (D) Mixed
Last Answer : (C) Multiplexed
Description : Pulse – amplitude modulation signals are multiplexed by using
Last Answer : FET switches
Description : Used for transmission of PCM encoded time – division multiplexed digital signal.
Last Answer : T carriers
Description : Ten signals, each requiring 3000 Hz, are multiplexed on to a single channel using FDM. How much minimum bandwidth is required for the multiplexed channel ? Assume that the guard bands are 300 Hz wide. (A) 30,000 (B) 32,700 (C) 33,000 (D) None of the above
Last Answer : (B) 32,700
Description : In ________ routing, we assume that there is one node (or more) ineach autonomous system that acts on behalf of the entire autonomous system. A) distant vector B) path vector C) link state D) none of the above
Last Answer : path vector
Description : Which layers of the OSI determines the interface often system with the user? A) Network B) Application C) Data link D) Session
Last Answer : B) Application
Description : In a telephone system, the customer’s telephone directory numbering is from 000 to 999, what is the capacity of the system? A. 1000 lines B. 100,000 lines C. 10,000 lines D. 100 lines
Last Answer : A. 1000 lines
Description : The interactive transmission of data within a time sharing system may be best suited to a. simplex lines b. half-duplex lines c. full duplex lines d. biflex-lines
Last Answer : half-duplex lines
Description : The RTS and CTS frames in CSMA/CA ____ solvethe hidden stationproblem. The RTS and CTS frames in CSMA/CA ____ solve the exposed station problem. A) can; cannot B) cannot; can C) can; can D) cannot; cannot
Last Answer : can; cannot
Description : A generator that contains afactor of ____ can detectall odd-numberederrors. A) x B) x + 1 C) 1 D) none of the above
Last Answer : x
Description : We candivide today's networks into ____ broad categories. A) four B) three C) five D) two
Last Answer : three
Description : We candivide ____ into two different schemes: synchronousor statistical. A) FDM B) TDM C) WDM D) none of the above
Description : ____ is designed to use thehigh bandwidthcapabilityof fiber-optic cable. A) FDM B) TDM C) WDM D) None of the above
Last Answer : WDM
Description : The signal rate is sometimes called the ____ rate. A) baud B) bit C) signal D) none of the above
Last Answer : baud
Description : ______ finds the value of thesignal amplitudefor eachsample; ____ finds the change from the previous sample. A) DM; PCM B) PCM; DM C) DM; CM D) none of the abov
Last Answer : PCM; DM
Description : In IPv6,____ address defines a groupof computers with addresses that have thesame prefix. A) aunicast B) a multicast C) an anycast D) none of the above
Last Answer : an anycast
Description : RPF guarantees that eachnetwork receives only ____ of the multicast packet. A) one copy B) two copies C) a or b D) none of the above
Last Answer : none of the above
Description : ____ are special-interest groups that quickly test, evaluate, andstandardize new technologies. A) Forums B) Regulatory agencies C) Standards organizations D) All of theabove
Last Answer : Forums
Description : Application layer protocol defines ____ a.types of messages exchanged b.message format, syntax and semantics c.rules for when and how processes send and respond to messages d.all of the mentioned
Last Answer : d.all of the mentioned
Description : The ____ layer establishes, maintains, and synchronizes the interaction between communicating systems. a. network b. transport c. session d. presentation
Last Answer : c. session
Description : The ____ layer is the network dialog controller. a. network b. transport c. session d. presentation
Description : User datagram protocol is called connectionless because _____________ a. all UDP packets are treated independently by transport layer b. it sends data as a stream of related packets c. it is received ... order d. it sends data very quickly Answer: Option(a) 4. Transmission control protocol ____
Last Answer : a. all UDP packets are treated independently by transport layer
Description : The client code recognizes the SSL request and establishes a connection through TCP port ____ to the SSL code on the server A. 1023 B. 402 C. 443 D. 8080
Last Answer : C. 443
Description : The ____ namespace is based on a hierarchical and logical tree structure A. DNS B. Address C. table D. both a and b
Last Answer : A. DNS
Description : The sender SMTP establishes a TCP connection with the destination SMTP and then waits for the server to send a ____ Service ready message.. A. 420 B. 320 C. 220 D. 120
Last Answer : C. 220
Description : In FTP, the well-known port ____ is used for the control connection and the well-known port ________ for the data connection A. 21; 22 B. 21; 20 C. 20; 21 D. none of the above
Last Answer : B. 21; 20
Description : What is the minimum number of wires needed to send data over a serial communication link layer? a. 1 b. 2 c. 4 d. 6 e. none of above
Last Answer : 2
Description : Which data communication method is used to transmit the data over a serial communication link? a. simplex b. half-duplex c. full-duplex d. b and c e. None of above
Last Answer : full-duplex