Description : In Stop-and-Wait ARQ, we use sequence numbers to number the frames. The sequence numbers are based on __________arithmetic. A) modulo-2 B) modulo-4 C) modulo-m D) none of the above
Last Answer : modulo-2
Description : In modulo-2 arithmetic, we use only ______. A) 1and 2 B) 0and 2 C) 0and 1 D) none of the above
Last Answer : 0and 1
Description : In modulo-11 arithmetic, we use only the integers inthe range ______, inclusive. A) 1to 10 B) 1to 11 C) 0to 10 D) none of the above
Last Answer : 0to 10
Description : In modulo-2 arithmetic, we use the______ operationfor bothaddition and subtraction. A) XOR B) OR C) AND D) none of the above
Last Answer : XOR
Description : In modulo-2 arithmetic, __________give the sameresults. A) addition and multiplication B) addition and division C) addition and subtraction D) none of the above
Last Answer : addition and subtractio
Description : Help with math problem involving roots of a modulo operation?
Last Answer : Question: if x doesn’t divide N, what does “N (mod N/x)” mean?
Description : The number of flip-flops required to design a modulo-272 counter is: (A) 8 (B) 9 (C) 27 (D) 11
Last Answer : 9
Description : Which of the following is/ are the drawbacks of Ring Topology? A) Failure of one computer, can affect the whole network B) Adding or removing the computers disturbs the network activity. C) If the central hub fails, the whole network fails to operate. D) Both of A and B
Last Answer : D) Both of A and B
Description : In Ethernet addressing, if the least significant bit of the firstbyte is 0, the address is _________. A) unicast B) multicast C) broadcast D) none of the above
Last Answer : unicast
Description : The Hamming distance between equal codewords is _________. A) 1 B) n C) 0 D) none of the above
Last Answer : 0
Description : You can _________ the number of bounce rate by adding more images at the bottom. A. increase B. reduce C. does not depends on image D. Can not say
Last Answer : B. reduce
Description : In Bluetooth, multiple ________ form a network called a _________. A) scatternet; piconets B) piconets: scatternet C) piconets:bluenet D) bluenet; scatternet
Last Answer : piconets: scatternet
Description : The IEEE 802.11g, uses _________. A) FHSS B) DSSS C) OFDM D) either (a)or (b)
Last Answer : OFDM
Description : The IEEE 802.11b, uses _________. A) FHSS B) DSSS C) OFDM D) either (a)or (b)
Last Answer : DSSS
Description : The IEEE 802.11a, uses _________. A) FHSS B) DSSS C) OFDM D) either (a)or (b)
Description : The original IEEE 802.11,uses _________. A) FHSS B) DSSS C) OFDM D) either (a)or (b)
Last Answer : either (a)or (b)
Description : In IEEE 802.11, the access method used in the DCF sublayer is _________. A) ALOHA B) CSMA/CA C) CSMA/CD D) none of the above
Last Answer : CSMA/CA
Description : In IEEE 802.11, a BSS without an AP is called an _________. A) an ad hocarchitecture B) an infrastructurenetwork C) either (a) or (b) D) neither (a) nor (b)
Last Answer : an ad hocarchitecture
Description : Inthe _________ method, a special packet called a ______ circulates through the ring. A) reservation: control frame B) polling: poll request C) token passing: token D) none of the above
Last Answer : token passing: token
Description : Inthe _________ method, after the station finds the lineidle, it sends its frame immediately. If the line isnot idle, it continuously senses theline until it finds it idle. A) nonpersistent B) 1-persistent C) p-persistent D) none of the above
Last Answer : 1-persistent
Description : 1000Base-SX, 1000Base-LX, and 1000Base-CX use _________ block coding and ________ line coding. A) 4B/5B; NRZ B) 8B/10B; NRZ C) 4B/5B; MLT-3 D) 8B/10B; NRZ
Last Answer : 8B/10B; NRZ
Description : In Ethernet addressing, ifall the bits are 1s, the address is _________. A) unicast B) multicast C) broadcast D) none of the above
Last Answer : broadcast
Description : In Ethernet addressing, if the least significant bit of the firstbyte is 1, the address is _________. A) unicast B) multicast C) broadcast D) none of the above
Last Answer : multicast
Description : _________ uses four twisted pairs. A) 1000Base-SX B) 1000Base-LX C) 1000Base-T D) none of the above
Last Answer : 1000Base-T
Description : In _________, autonegotiation allows two devices to negotiate the mode or datarate of operation. A) Standard B) Fast Ethernet C) Gigabit Ethernet D) Ten-Gigabit Ethernet
Last Answer : Fast Ethernet
Description : _________ uses thin coaxial cable. A) 10Base5 B) 10Base2 C) 10Base-T D) 10Base-F
Last Answer : 10Base2
Description : The IEEE 802.3 Standard defines _________ CSMA/CD as the access method for first-generation 10-Mbps Ethernet. A) 1-persistent B) p-persistent C) non-persistent D) none of the above
Description : Membership in a VLAN can be based on _________. A) port numbers B) MAC addresses C) IP addresses D) all of theabove
Last Answer : all of theabove
Description : A virtual local areanetwork (VLAN) is configured by _________. A) software B) physical wiring C) hardware D) none of the abov
Last Answer : software
Description : Inthe _________ protocol weavoid unnecessary transmissionby sending only frames that are corrupted. A) Stop-and-Wait ARQ B) Go-Back-N ARQ C) Selective-Repeat ARQ D) none of the above
Last Answer : Selective-Repeat ARQ
Description : The divisor in a cyclic code is normally called the _________. A) degree B) generator C) redundancy D) none of the above
Last Answer : generator
Description : We addr redundant bits toeach block to make thelength n = k + r. The resultingn-bit blocksare called _________. A) datawords B) blockwords C) codewords D) none of the above
Last Answer : codewords
Description : Touse a cable network for data transmission, we needtwo keydevices:a ______ and a _________ A) CM; CMS B) CT; CMTS C) CM; CMTS D) none of the above
Last Answer : CM; CMS
Description : The secondgeneration of cable networks is called a(n) _________ network. A) HFC B) HCF C) CFH D) none of the above
Last Answer : HFC
Description : The most popular technology in time-division switching is called the _________. A) STI B) ITS C) TSI D) none of the above
Last Answer : TSI
Description : A _________ network is across between a circuit-switchednetworkand a datagram network. It has some characteristics ofboth. A) virtual-circuit B) packet-switched C) frame-switched D) none of the above
Last Answer : virtual-circui
Description : In _________, resources areallocatedon demand. A) datagram switching B) circuit switching C) frame switching D) none of the above
Last Answer : datagram switching
Description : In _________, thereis no resource allocation for a packet. A) datagram switching B) circuit switching C) frame switching D) none of the above
Description : Radio waves are _________. A) omnidirectional B) unidirectional C) bidirectional D) none of the above
Last Answer : omnidirectional
Description : _________ media transportelectromagnetic waves without the use ofa physical conductor. A) Guided B) Unguided C) Either (a) or (b) D) None of the above
Last Answer : Unguided
Description : _________ utilization is the useof availablebandwidthto achieve specificgoals. A) Frequency B) Bandwidth C) Amplitude D) None of the abov
Last Answer : Bandwidth
Description : A _________ digital signal includes timing informationin the data beingtransmitted. A) self-synchronizing B) self-modulated C) self-transmitted D) none of the above
Last Answer : self-synchronizing
Description : The _________ product defines the number ofbits that can fill the link. A) bandwidth-period B) frequency-amplitude C) bandwidth-delay D) delay-amplitude
Last Answer : bandwidth-delay
Description : A(n)_________ signal is a composite analogsignal with an infinite bandwidth. A) digital B) analog C) either (a)or (b) D) neither (a) nor (b
Last Answer : digital
Description : A _________ sine wave is not useful in data communications; we need to send a _______signal. A) composite; single-frequency B) single-frequency; composite C) single-frequency;double-frequency D) none of the above
Last Answer : single-frequency; composite
Description : A ring SONET network can be _________. A) unidirectional B) bidirectional. C) either (a) or (b) D) neither (a) nor (b)
Last Answer : bidirectional.
Description : A SONET system can use _________. A) STS multiplexers B) regenerators C) add/drop multiplexers D) all of theabove
Last Answer : add/drop multiplexers
Description : In ATM,a virtual connection is definedby _________. A) VPI B) VCI C) DLCI D) acombination of (a) and (b)
Last Answer : acombination of (a) and (b)
Description : To handleframesarrivingfrom other protocols, Frame Relay uses adevice calleda _________. A) VOFR B) FRAD C) MUX D) none of the above
Last Answer : FRAD
Description : An IPv6address is _________ bits long. A) 32 B) 64 C) 128 D) none of the above
Last Answer : 128