Description : The snow on the mountains does not melt all at once when it is heated by the sun because _____ A. It becomes very hard It B. It reflects most of the heat from the sun C. It has a low specific heat capacity D. It has a high latent heat of fusion
Last Answer : ANSWER: B
Description : The snow on the mountains does NOT melt all at once when it is heated by the sum because: (1) It becomes very hard (2) It reflects most of the heat from the sum (3) it has a low specific heat capacity (4) it has a high latent heat of fusion
Last Answer : (2) It reflects most of the heat from the sum Explanation: Newly formed snow reflects about 90 per cent of the sunlight that falls upon it. This means that the sun is powerless to melt clean snow. And when ... on a spring day because of the sun's heat. It melts because of the warm air from the sea.
Description : Steam at 100°C causes more severe burns than water at 100° C because – (1) steam has no specific heat capacity (2) steam has latent heat of vaporization (3) water has no specific heat capacity (4) water has latent heat of fusion
Last Answer : (2) steam has latent heat of vaporization Explanation: It is because steam releases its latent heat as it condenses, which is substantial. The heat of vaporization of steam is over 2000 J per gram. And when it releases that it's then 100 degree water, the same as boiling water.
Description : Steam at 1000C causes more severe burns than water at 100° C because (1) steam has no specific heat capacity (2) steam has latent heat of vaporisation (3) water has no specific heat capacity (4) water has latent heat of fusion
Last Answer : steam has latent heat of vaporisation
Description : The ______ of a substance is the amount of heat that must be added or removed from a unit mass of the substance to change its temperature by one degree. A. Latent heat of fusion B. Molar heat C. Specific heat capacity D. Specific heat
Last Answer : Specific heat capacity
Description : What is defined as the energy required to raise the temperature of a unit mass of a substance by one degree? A. Latent heat of fusion B. Molar heat C. Specific heat capacity D. Specific heat
Last Answer : Specific heat
Description : Water is not suitable as a calorimetric substance because it – (1) has high specific heat (2) is a good conductor (3) has high boiling point (4) low latent heat of vaporization
Last Answer : (1) has high specific heat Explanation: The specific heat of water is higher than all other common substances. Hence, water is used for heating purposes (as in hot water bottles) and for cooling ... the liquids, mercury has the lowest specific heat due to which it is used as a thermometric liquid.
Description : Water is not suitable as a calorimetric substance because it : (1) has high specific heat (2) is a good conductor (3) has high boiling point (4) low latent heat of vapourization
Last Answer : has high specific heat
Description : The energy required to melt one mole of a solid at its melting point is called one of the following. w) the molar heat of fusion x) the molar hear of vaporization y) the molar heat of capacity z) the melting point
Last Answer : ANSWER: W -- THE MOLAR HEAT OF FUSION
Description : Which of the following cannot be measured by a thermometer? a. Latent Heat b. Sensible Heat c. Specific Heat d. Heat of Fusion
Last Answer : Latent Heat
Description : Heat which causes a change in temperature of a substance. a. Latent heat b. Sensible heat c. Specific heat d. Heat of Fusion
Last Answer : Sensible heat
Description : Water is used in car radiator because of its – (1) low density (2) easy availability (3) high specific heat capacity (4) low boiling point
Last Answer : (3) high specific heat capacity Explanation: Water is used in car radiators because the Specific heat capacity of water is high as a result of which it takes away the heat from engine better compared to ... coolant used in the radiator. If the radiator was to overheat the car would come to a stop.
Description : Water is used in car radiator because of its (1) low density (2) easy availability (3) high specific heat capacity (4) low boiling point
Last Answer : high specific heat capacity
Description : The heat Q per unit mass per degree change in temperature that must be supplied or removed to change the temperature of a substance. a. Specific Heat Capacity b. Latent Heat c. Heat of Transformation d. Internal Heat
Last Answer : Specific Heat Capacity
Description : What is the heat capacity of one gram of a substance? A. Molecular heat B. Specific heat C. Latent heat D. Molar heat
Description : What is the heat capacity of one mole of substance? A. Molecular heat B. Specific heat C. Latent heat D. Molar heat
Last Answer : Molar heat
Description : What refers to the amount of heat needed to raise the temperature of an object by one degree Celsius or 1K? A. Heat capacity B. Specific heat C. Latent heat D. Molar heat
Last Answer : Heat capacity
Description : The quantity of heat required to raise the temperature of a given substance by 1 oC is known as: a) sensible heat b) specific heat c) heat capacity d) latent heat
Last Answer : specific heat specific heat is the quantity of heat required to raise the temperature of 1 gram substance by 1 oC is
Description : The filament of an electric lamp becomes white hot but the lead-in wires holding the filament are only slightly heated because they (a) have smaller current passing through them (b) have very low resistance (c) have higher melting point (d) are made of black iron
Last Answer : Ans:(b)
Description : Air over the oceans is colder in summer and warmer in winter compared with air over the continental regions. This is because (a) Water is translucent and has a relatively high heat capacity compared ... B are true (e) The effect is due to the changes in circulation between continents and oceans
Last Answer : (d) Both A and B are true
Description : Define latent heat of fusion. Also write its SI unit. -Maths 9th
Last Answer : The SI unit of latent heat is Joule. ... Latent heat is defined as the heat required for converting solid into a liquid or to vapour without any change in the temperature.
Description : How does the latent heat of fusion measure?
Last Answer : The energy required to melt a substance
Description : What is the latent of heat fusion?
Last Answer : The amount of energy it takes to boil a substance
Description : If the vapour pressure at two temperatures of a solid phase in equilibrium with its liquid phase are known, then the latent heat of fusion can be calculated by the (A) Maxwell's equation (B) Clausius-Clapeyron Equation (C) Van Laar equation (D) Nernst Heat Theorem
Last Answer : B) Clausius-Clapeyron Equation
Description : The heat absorbed by a unit mass of a material at its holding point in order to convert the material into a gas at the same temperature. a. Latent Heat of Sublimation b. Latent Heat of Vaporization c. Latent Heat of Fusion d. Latent Heat Of Condensation
Last Answer : Latent Heat of Vaporization
Description : What is the latent heat of fusion of water at 1 atm? A. 331.1 kJ/kg B. 332.6 kJ/kg C. 333.7 kJ/kg D. 330.7 kJ/kg
Last Answer : 333.7 kJ/kg
Description : 2000 kJ of heat is supplied to 500 kg of ice at 0oC. If the latent heat of fusion of ice is 335 kJ/kg then the amount of ice in kg melted will be a) 1.49 b) 83.75 c) 5.97 d) None of the above
Last Answer : c) 5.97
Description : When hot liquid is poured into a thick glass tumbler, it cracks because glass – (1) is a bad conductor of heat so only inner surface expands (2) has high temperature coefficient of expansion (3) has a very low specific heat (4) has low temperature coefficient of expansion
Last Answer : (1) is a bad conductor of heat so only inner surface expands Explanation: When hot liquid is poured into a thick glass tumbler, it cracks because glass is a bad conductor of heat so only inner surface expands.
Description : When hot liquid is poured into a thick glass tumbler, it cracks because glass : (1) is a bad conductor of heat so only inner surface expands (2) has high temperature coefficient of expansion (3) has a very low specific heat (4) has low temperature coefficient of expansion
Last Answer : is a bad conductor of heat so only inner surface expands
Description : Heat stored in water vapour is – (1) specific heat (2) latent heat (3) absolute heat (4) relative heat
Last Answer : (2) latent heat Explanation: Latent heat is the heat released or absorbed by a body or a thermodynamic system during a process that occurs without a change in temperature. A typical example is a ... the boiling of water. So water vapor which is the end product of evaporated water has latent heat.
Description : Heat stored in water vapour is (1) specific heat (2) latent heat (3) absolute heat (4) relative heat
Last Answer : latent heat
Description : On a cold day when the room temperature is 15°C, the metallic cap of a pen becomes much colder than its plastic body, though both are at the same temperature of 15°C, because - (1) metals ... metals (3) metals are good conductors of heat (4) plastics have a higher thermal conductivity than metals
Last Answer : (3) metals are good conductors of heat Explanation: On a chilly day, the room temperature is lower than our body temperature. Since metals have a higher coefficient of thermal conductivity than plastic, they ... from our fingers will flow to the metal cap much more quickly than to the plastic body.
Description : On a cold day when the room temperature is 15°C, the metallic cap of a pen becomes much colder than its plastic body, though both are at the same temperature of 15°C, because : (1) metals ... metals (3) metals are good conductors of heat (4) plastics have a higher thermal conductivity than metals
Last Answer : metals are good conductors of heat
Description : The solvent used in liquid extraction should not have high latent heat of vaporisation, because (A) The pressure drop and hence the pumping cost will be very high (B) It cannot ... by distillation may be prohibitively high (D) It will decompose while recovering by distillation
Last Answer : (C) Its recovery cost by distillation may be prohibitively high
Description : In order to find the specific heat capacity of an unknown material a 50 g piece is heated to 80 degrees Celsius and fully immersed in a well insulated calorimeter filled with 100 g of water at 10 degr?
Last Answer : Assuming that the full question, which the questioner failed to post, is given in the Discussion, below.Taking the specific heat capacity of water as 4.2 Joules per gram per degree C, the metal has a specific heat capacity as approx 0.68 Joules/(g °C).
Description : 1000 Kg of liquid at 30°C in a well stirred vessel has to be heated to 120°C, using immersed coils carrying condensing steam at 150°C. The area of the steam coils is 1.2 m2 and the overall heat transfer co-efficient to the ... will be (A) 15 min (B) 22 min (C) 44 min (D) 51 min
Last Answer : (D) 51 min
Description : Water is a highly effective coolant for a car engine because _____ A. Water is good conductor of heat B. Water has very high specific heat capacity C. Water boils at a comparatively high temperature D. Evaporation of water produces lot of cooling
Last Answer : ANSWER: A
Description : Water is a highly effective coolant for a car engine because -----? A. Water is good conductor of heat B. Water has very high specific heat capacity (Answer) C. Water boils at a comparatively high temperature D. Evaporation of water produces lot of cooling
Last Answer : B. Water has very high specific heat capacity (Answer)
Description : Which one of the following reflects back more sunlight as compared to other three? (1) Sand desert (2) Land covered with fresh snow (3) Prairie land (4) Paddy crop land
Last Answer : (2) Land covered with fresh snow Explanation: Albedo is the fraction of solar energy (shortwave radiation) reflected from the Earth back into space. It is a measure of the reflectivity of the earth's surface. Ice, especially with snow on top of it on land, has the highest albedo.
Last Answer : Land covered with fresh snow
Description : In a cooling tower, water becomes cool by (A) Loosing sensible heat (B) Heat transfer to surroundings (C) Vaporisation due to heat loss to air (D) Loosing latent heat
Last Answer : (A) Loosing sensible heat
Description : The critical pressure at which the latent heat of vaporisation of steam becomes zero is __________ Kg/cm2. (A) 273.15 (B) 225.65 (C) 100.03 (D) 373.15
Last Answer : (B) 225.65
Description : When the solvent dissolves very little of solute, then (A) Solvent of low latent heat of vaporisation should be used (B) Solvent of low freezing point should be used (C) Large quantity of solvent is required to extract the solute (D) Very small quantity of solvent is required
Last Answer : (C) Large quantity of solvent is required to extract the solute
Description : The nurse teaches the patient who demonstrates herpes zoster (shingles) that a) the infection results from reactivation of the chickenpox virus. It is assumed that herpes zoster represents a ... is arrested if oral antiviral agents are administered within 24 hours of the initial eruption.
Last Answer : a) the infection results from reactivation of the chickenpox virus. It is assumed that herpes zoster represents a reactivation of latent varicella (chickenpox) virus and reflects lowered immunity.
Description : Vegetables are cooked in lesser time by adding a pinch of salt while cooking because (1) boiling point of water increases (2) latent heat of vaporization of water decreases (3) latent heat of vaporization of water increases (4) boiling point of water decreases
Last Answer : (1) boiling point of water increases Explanation: Adding salt raises the boiling point of water, which allows food to cook at higher temperature. The higher the temperature, the higher the rate of heat transfer between the food and water, thus it cooks more quickly.
Description : Burns caused by steam are much severe than those caused by boiling water because – (1) Steam pierces through the pores of body quickly (2) Steam has latent heat (3) Steam is gas and engulfs the body quickly (4) Temperature of steam is higher
Last Answer : (2) Steam has latent heat Explanation: When water changes into steam, it absorbs latent heat, and when steam condenses to form water, it gives out an equal amount of latent heat. Bums caused ... boiling water, simply because steam contains more heat (in the form of latent heat) than boiling water.
Last Answer : boiling point of water increases
Description : Burns caused by steam are much severe than those caused by boiling water because (1) Steam pierces through the pores of body quickly (2) Steam has latent heat (3) Steam is gas and engulfs the body quickly (4) Temperature of steam is higher
Last Answer : Steam has latent heat
Description : Which of the following terms refer to the amount of heat needed to raise the temperature of a unit mass of a substance through one degree? w) Heat of fusion x) Liquification heat y) Internal heat z) Specific heat
Last Answer : ANSWER: Z -- SPECIFIC HEAT