Please Log in or Register for more.


82 views

1 Answer

Answer :

A transmission line is protected by distance protection, time graded and current graded overcurrent protection.

Like 0 like

Please log in or register to answer this question.

Related Questions


Transmission efficiency of a transmission line increases with the
Last Answer : Transmission efficiency of a transmission line increases with the increase in power factor and voltage

Show More

88 views 1 answer








Last Answer : Reactance relay is preferred for phase fault on short transmission line.

Show More

110 views 1 answer








Last Answer : When a wave propagates on a transmission line, it suffers reflection several times at sending and other end.

Show More

130 views 1 answer








Last Answer : The interaction between a transmission line and communication line is minimized by transposing transmission as well as communication lines, increasing the height of the transmission line tower, increasing the distance between the two lines.

Show More

168 views 1 answer








Last Answer : When a transmission line is energized, the wave that propagates on it is current wave and voltage wave.

Show More

125 views 1 answer








Last Answer : Large internal faults are protected by merz price percentage differential protection.

Show More

154 views 1 answer







State the limitations of EHVAC transmission line. 
Last Answer : Following are the Limitations of EHVAC Transmission:   1. Insulation cost increases as voltage increases 2. Skin effect is more 3. Proximity effect is more. 4. Corona loss increases. 5. Radio ... 18. EHVAC is economical only for bulk amount of power is to be transmitted over long distance. 

Show More

322 views 1 answer







State line parameters of transmission line. 
Last Answer : Following are the of Line parameters of transmission line:  1. Resistance  2. Inductance  3. Capacitance

Show More

70 views 1 answer







State the impact of inductance and resistance on transmission line performance
Last Answer : Impact of inductance on transmission line: 1) It causes IXL drop in transmission line which affects regulation. 2) It is the only parameter which decides power transmission capacity of line i. ... is very small, it causes losses, temperature rise& poor voltage regulation so it cannot be neglected

Show More

189 views 1 answer







effect of inductance and capacitance on performance of transmission line.
Last Answer : Following are the effect on performance of transmission line:  1. Due to inductance (L) voltage drop in transmission line produces.  2. Capacitor (C) draws charging current ... , transmission line efficiency, voltage regulation & also power factor of transmission line gets affected. 

Show More

136 views 1 answer







While calculating performance of medium transmission line, what assumptions are made in case of (i) Nominal 'T' Method (ii) Nominal 'TT' Method. 
Last Answer : (i) Assumptions are made in case of Nominal 'T' Method:  a. It is assume that line capacitance is connected at center of transmission line. b. It is assume that half ... assumed that transmission line resistance & reactance per phase is connected in between two half transmission line capacitance 

Show More

172 views 1 answer







HVDC transmission line in India: 
Last Answer : HVDC transmission line in India:  S.N .  From To  Voltage 1 Rihand (U.P) (from 1990) Dadri +- 500 KV (bipolar) 2 Talcher- is the biggest ... (Chandrapur) Western Region  140KV   8 Connecting Southern region(Vizag- Gajuwaka) Eastern Region 140KV 

Show More

102 views 1 answer







effect of line parameter on performance of transmission line. 
Last Answer : Following are the effect of line parameter on performance of transmission line:  1. Due to resistance (R), voltage drop in transmission line & copper losses in transmission line ... transmission line efficiency, voltage regulation & also power factor of transmission line gets affected. 

Show More

76 views 1 answer







Why is transmission line 11kV, 33kV 66kV Not Is 10kV, 20kV, 30kV ?
Last Answer : 10kv plus to compensate losses in olden days 1kv were added and transmitted. Since all equipment used for transmission have a multiple of 11 from olden days, still that is being followed even though the losses are ... voltages, multiples of 11 is eazy for winding ratios.. i.e. 11kv to 33kv is 1:3.

Show More

186 views 3 answers







A 50Ω transmission line is terminated in an impedance of 20-j50. What will be the reflection coefficient? A) 0.69 B) 1.69 C) 6.9 D) 16.9 
Last Answer : A 50Ω transmission line is terminated in an impedance of 20-j50. What will be the reflection coefficient? A) 0.69 B) 1.69 C) 6.9 D) 16.9 

Show More

294 views 1 answer







Stability of a transmission line can be increased by
Last Answer : Stability of a transmission line can be increased by Shunt capacitor, Series capacitor

Show More

363 views 1 answer







The sag of a transmission line is least affected by (A) Self weight of the conductor. (B) Temperature of the surrounding air. (C) Current through the conductor. (D) Ice deposited on the conductor.
Last Answer : The sag of a transmission line is least affected by Current through the conductor.

Show More

153 views 1 answer







In a transmission line if booster transformers are to be used, preferred location will be  (A) At the receiving end (B) At the sending end (C) At the intermediate point (D) Anywhere in the line 
Last Answer : In a transmission line if booster transformers are to be used, preferred location will be At the intermediate point

Show More

346 views 1 answer







A transmission line has 1 P.0 impedance on a base of 11 KV, 100 MVA. On a base of 55 KV. it will have a P.0 impedance of
Last Answer : A transmission line has 1 P.0 impedance on a base of 11 KV, 100 MVA. On a base of 55 KV. it will have a P.0 impedance of 0.02 P.U

Show More

453 views 1 answer







For a short transmission line with r/x ratio of is 1.0, the regulation will be zero when the load power factor is
Last Answer : For a short transmission line with r/x ratio of is 1.0, the regulation will be zero when the load power factor is 0.707 lead

Show More

309 views 1 answer







A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km
Last Answer : A transmission line of 200 km has a certain A, B, C and D parameters. If the length is reduced to 60 km A increases, B decreases

Show More

163 views 1 answer







Series capacitive compensation in EHV transmission line is used to
Last Answer : To maintain voltage stability 

Show More

466 views 2 answers







The sending end and receiving end voltages of a three-phase transmission line are 10 kV/ph and 9.5 kV/ph, respectively. If the resistance drop is 150 V/ph and receiving end power factor is 0.8, the sending end power factor is (A) 0.745 lagging (B) 0.775 lagging (C) 0.8 lagging (D) 0.85 lagging
Last Answer : Vscos¢s-Vrcos¢r=IR

Show More

3.0k views 2 answers







What are the losses in a transmission line?

Show More

61 views 0 answers







what is mean by medium transmission line ?
Last Answer : The transmission line which have length between 80 km to 250 km is known as medium transmission line.

Show More

109 views 1 answer







what is mean by short transmission line ?
Last Answer : The transmission lines which have length less than 80 km is known as short transmission lines.

Show More

104 views 1 answer







what is mean by long transmission line ?
Last Answer : The transmission line which have length more than 250 km are known as long transmission lines.

Show More

88 views 1 answer







Thyristor can be protected from over voltages by using
Last Answer : Thyristor can be protected from over voltages by using Voltage clamping device

Show More

108 views 1 answer







The surge impedance for over head line is taken as  (1) 10-20 ohms (2) 50-60 ohms (3) 100-200 ohms (4) 1000-2000 ohms
Last Answer : The surge impedance for over head line is taken as 100-200 ohms

Show More

108 views 1 answer







A lightening arrester connected between the line and earth in a power system  (1) protects the terminal equipment against travelling surges (2) protects the transmission line against direct ... suppresses high frequency oscillations in the line (4) reflects back the travelling wave approaching it
Last Answer : A lightening arrester connected between the line and earth in a power system protects the terminal equipment against travelling surges

Show More

365 views 1 answer







The reactive power transfer over a line mainly depends on
Last Answer : The reactive power transfer over a line mainly depends on lVsl- lVRl

Show More

411 views 1 answer







lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has reached the far end, then the far end of the line is
Last Answer : lf a travelling-wave travelling along a loss-less overhead line does not result in any reflection after it has reached the far end, then the far end of the line is terminated into a resistance equal to surge impedance of the line

Show More

105 views 1 answer








Last Answer : The inductive interference between power and communication line can be minimized by transposition of the power line, transposition of the communication line.

Show More

175 views 1 answer








Last Answer : Impedance relays are used for phase faults on long line.

Show More

82 views 1 answer







The voltage of transmission can be regulated by  (A) Use of tap changing transformers (B) Switching in shunt capacitors at the receiving end during heavy loads (C) Use of capacitors to neutralize the effect of series reactance (D) Any of the above methods
Last Answer : The voltage of transmission can be regulated by  (A) Use of tap changing transformers (B) Switching in shunt capacitors at the receiving end during heavy loads (C) Use of capacitors to neutralize the effect of series reactance (D) Any of the above methods

Show More

104 views 1 answer








Last Answer : Ungrounded neutral transmission system is not recommended because of system insulation being overstressed due to over voltages, insulation overstress may lead to failure and subsequent phase to phase faults, being inadequately protected against ground fault.

Show More

69 views 1 answer













requirements or properties of the line supports used in transmission and distribution.  
Last Answer : Following are requirements or properties of the line supports used in transmission and distribution. 1. High mechanical strength:-  It should have high mechanical strength to withstand against - ... . 8. Appearance: It should have good appearance or They must be of pleasing shape

Show More

112 views 1 answer







What are the factors that limit the maximum power transfer capability in a transmission line?
Last Answer : Answer: Some of the factors which limits the maximum power transfer are: 1. Electrical phase shift 2. Voltage drop 3. Thermal effects in the line

Show More

39 views 1 answer







Which of the following characteristics should the line supports for transmission lines possess ? (a) Low cost (b) High mechanical strength (c) Longer life (d) All of the above
Last Answer : (d) All of the above

Show More

11 views 1 answer







Transmission line insulators are made of (a) glass (b) porcelain (c) iron (d) P.V.C.
Last Answer : B

Show More

16 views 1 answer







Which of the following is the demerit of a 'constant voltage transmission system' ? (a) Increase of short-circuit current of the system (b) Availability of steady voltage at all loads at ... of carrying increased power for a given conductor size in case of long-distance heavy power transmission
Last Answer : (a) Increase of short-circuit current of the system

Show More

20 views 1 answer







How many insulator disc used for 33 kV transmission voltage line?
Last Answer : 5,As 33kv is Vrms

Show More

157 views 1 answer







For the women: Does a mans chin and jaw line effect whether he's more attractive?
Last Answer : I like a nice strong chin but it’s not a deal-breaker by any means.

Show More

1 view 1 answer







How to Spool Line Onto a Reel
Last Answer : How to Spool Line Onto a Reel If you think of fishing as a sport or a hobby, you must always make sure that you have efficient fishing tools with you all the time. Your fishing rod must ... you'll always have good quality fishing line and an efficient fishing reel to use during your fishing trips.

Show More

5 views 1 answer







How to Replace Edge Trimmer Line
Last Answer : How to Replace Edge Trimmer Line An edge trimmer line is a very efficient equipment for any avid gardener. This small diameter line, usually made of plastic or other material, cuts various vegetation, ... your edge trimmer lines regularly. It'll save you time and give you a great-looking landcaping.

Show More

9 views 1 answer







How to Repair a Brake Line
Last Answer : How to Repair a Brake Line Vehicles that often travel to colder, up-north states often have their brake lines damaged, because of the salt that melts the ice on the roads. The salt corrodes the car' ... should be done as soon as possible. Otherwise, you might end up in worst brake problems later on.

Show More

4 views 1 answer







List the properties of line insulators in brief
Last Answer : Following are the properties of line insulators:  A) Electrical Properties of insulating material:- 1. It should have high resistance. 2. It should have high breakdown voltage. 3. It should have high ... of insulating material:- 1. It should have longer life. 2. It should have low cost

Show More

68 views 1 answer







State the meaning of Single line diagram.
Last Answer : Meaning of Single line diagram: The single line diagram of a power system is the network which shows the main connections and arrangement of the system components along with their data ( ... breakers, transformers, capacitors, bus bars, and conductors are shown by standardized schematic symbols. 

Show More

76 views 1 answer







Define line regulation and load regulation.
Last Answer : Load regulation is the ability of the power supply to maintain its specified output voltage over changes in the load. Line regulation is the ability of the power supply to maintain its specified output voltage over changes in the input line voltage.

Show More

329 views 3 answers






Show More⇦ PreviousNext ⇨