Can condensate control in a reboiler cause water hammer problems?

1 Answer

Answer :

This topic was recently discussed in our online forum. The short answer to this specific question is…”not  very often”. It is very common to control reboilers on distillation columns via this method. This is not to  say that this control method is the best for any heat exchanger using steam for heating. For example, if  there is an appreciable degree of subcooling of the condensate, the incoming steam can experience  “collapse” (or thermal water hammer) when it is exposed to the cool condensate. In reboilers, the  process fluid is simply being vaporized so little or no subcooling of the condensate takes place. This  makes for a good opportunity for condensate level control in a vertically oriented shell and tube  reboiler. The level controller is typically placed on a vessel that is installed in conjunction with the shell  side of the reboiler. This will allow for full condensate drainage (if necessary) and there is no need to  weld on the shell of the exchanger. (See graphic below) Reference: Cheresources Message Board

Related questions

Description : Pick out the wrong statement. (A) Different solids have different equilibrium moisture curves (B) Total condenser or reboiler is considered equivalent to one theoretical plate in McCabe-Thiele method of ... (D) Even a forced draft cooling tower cannot cool water below the wet bulb temperature

Last Answer : (C) Heat removal load on cooler remains constant, even with increase of the reflux ratio in a distillation column

Description : When a multistage tray tower uses a minimum reflux ratio, it implies (A) Infinite trays and maximum reboiler heat load (B) Infinite trays and minimum reboiler heat load (C) Minimum trays and minimum reboiler heat load (D) Minimum trays and maximum reboiler heat load

Last Answer : (A) Infinite trays and maximum reboiler heat load

Description : Total reflux in a distillation operation requires minimum (A) Reboiler load (B) Number of plates (C) Condenser load (D) All (A), (B) and (C)

Last Answer : (B) Number of plates

Description : Pick out the wrong statement: (A) Reboiler is not used in open steam distillation (B) The separation of solutes of different molecular sizes in a liquid solution by use of a ... is used for calculating theoretical number of plates in a distillation column at normal operating reflux condition

Last Answer : (D) Fenske-Underwood equation is used for calculating theoretical number of plates in a distillation column at normal operating reflux condition

Description : A distillation column with N plates is being operated under normal conditions. At some point of time, the operation is shifted to total reflux condition (i.e., no product and residue are ... and without total reflux (D) The top and bottom compositions correspond to the maximum enrichment available

Last Answer : (D) The top and bottom compositions correspond to the maximum enrichment available

Description : On moving the feed line (q-line) from saturated liquid feed (vertical position) to saturated vapor feed (horizontal feed), if the slope of both the operating lines are to be increased, then it will result in (A) Greater degree of separation with a fixed number of trays (B) Increased reboiler load

Last Answer : (C) Increased reflux ratio

Description : In case of binary distillation, increasing the reflux ratio above optimum does not result in the increase of (A) Area between operating line and 45° diagonal x-y diagram (B) Condenser and reboiler surfaces (C) Tower cross-section (D) None of these

Last Answer : (A) Area between operating line and 45° diagonal x-y diagram

Description : . In a distillation column, with increase in the reflux ratio, the heat removed in the cooler (A) Increases (B) Decreases (C) Remains unaffected (D) And the heat required in reboiler decreases

Last Answer : (A) Increases

Description : Which of the following is considered equivalent to one theoretical stage in Mc-Cabe Thiele's method? (A) Partial condenser (B) Total condenser (C) Reboiler (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Minimum reflux ratio in a distillation column results in (A) Optimum number of trays (B) Minimum reboiler size (C) Maximum condenser size (D) Minimum number of trays

Last Answer : (C) Maximum condenser size

Description : Reboiler is considered as one theoretical plate, because (A) Of the assumption that vapour and liquid leaving the reboiler are in equilibrium (B) Vapour is recycled to the column (C) Reboiler itself contains one plate (D) None of these

Last Answer : (A) Of the assumption that vapour and liquid leaving the reboiler are in equilibrium

Description : What are some of the consequences of an undersized kettle type reboiler?

Last Answer : The effect will be a decrease in the boiling coefficient. A boiling coefficient depends on a nucleate boiling component and a two-phase component that depends on the recirculation rate. An ... entrainment or even a two-phase mixture going back to the tower. Source: Gulley Computer Associates

Description : What factors go into designing the vapor space of kettle type reboiler?

Last Answer : The size of the kettle is determined by several factors. One factor is to provide enough space to slow the vapor velocity down enough for nearly all the liquid droplets to fall back down by ... is typically 8 inches. It is higher for high heat flux kettles. Source: Gulley Computer Associates

Description : Coast Guard Regulations (46 CFR), require that an indicating light at the propulsion control station will operate if overloading or overheating occurs in a _______________. A. forced draft blower motor B. steering gear motor C. fuel pump motor D. condensate pump motor

Last Answer : Answer: B

Description : An overload in which of the listed motors will result in the illumination of an indicating light at the propulsion control station alarm panel? A. Fuel pump motor B. Steering motor C. Condensate pump motor D. Forced draft blower motor

Last Answer : Answer: B

Description : Steam condensate is recovered by steam traps and recycled for use as boiler feed water, because of its low (A) Hardness (B) Dissolved solids content (C) Suspended solids content (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : In a gas-liquid shell and tube heat exchanger, the (A) Presence of a non-condensable gas decreases the condensing film co￾efficient (B) Gases under high pressure are routed through the tube side, because high pressure ... water or steam condensate remain localised to the tubes (D) All 'a', 'b' & 'c'

Last Answer : (D) All 'a', 'b' & 'c'

Description : . The condensate obtained on compression of wet natural gas is termed as (A) Liquefied natural gasoline (B) Natural gasoline (C) Liquid natural gas (D) None of these

Last Answer : (B) Natural gasoline

Description : Condensing film co-efficient for steam on horizontal tubes ranges from 5000 to 15000 Kcal/hr.m2 .°C. Condensation of vapor is carried out inside the tube in a shell and tube heat ... drop through the exchanger is desired (D) Temperature of the incoming vapor is very high

Last Answer : (B) Supersaturated

Description : Pick out the wrong statement. (A) The condensing film co-efficient is about 3 times lower for vertical condenser as compared to the equivalent horizontal condenser for identical situation ( ... in a heat exchanger is controlled by the value of the film co-efficient, which is higher

Last Answer : (D) Overall heat transfer co-efficient in a heat exchanger is controlled by the value of the film co-efficient, which is higher

Description : The steam ejector is used to (A) Remove condensate from the steam pipelines (B) Create vacuum (C) Superheat the steam (D) None of these

Last Answer : (B) Create vacuum

Description : Steam traps are provided in steam carrying pipelines to (A) Condense steam (B) Release excess steam pressure by bleeding steam (C) Remove condensate and inert gases (D) None of these

Last Answer : (C) Remove condensate and inert gases

Description : A process stream of dilute aqueous solution flowing at the rate of10 Kg.s -1 is to be heated. Steam condensate at 95°C is available for heating purpose, also at a rate of 10 Kg.s -1 . A 1 ... side (C) Parallel flow with process stream on shell side (D) Parallel flow with process stream on tube side

Last Answer : (A) Counter flow with process stream on shell side

Description : Trap is used to remove __________ from steam pipe lines. (A) Steam (B) Condensate (C) Non-condensable (D) None of these

Last Answer : (B) Condensate

Description : Corrosiveness of steam condensate is due to the presence of (A) CO2 (B) Dissolved O2 (C) Both (A) & (B) (D) Neither (A) nor (B)

Last Answer : (C) Both (A) & (B)

Description : The thickness of condensate layer in filmwise condensation depends on the (A) Condensation rate (B) Surface configuration (C) Liquid flow rate from the surface (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : The film co-efficient between condensing vapour and metal wall increases with (A) Increasing temperature of the vapour (B) Decreasing temperature of the vapour (C) Increasing viscosity of the film of condensate (D) Increasing temperature drop

Last Answer : (A) Increasing temperature of the vapour

Description : An ejector is used to (A) Increase pressure (B) Increase temperature (C) Remove condensate (D) None of these

Last Answer : (D) None of these

Description : What is condensate lift?

Last Answer : This is a term that is usually used to indicate how much pressure is required to lift' condensate from a steam trap or other device to it's destination at a condensate return line or ... steam trap with a separation vessel and a condensate pump to push the condensate to the return line.

Description : The purpose of a surge tank is (A) To control the pressure variations due to rapid changes in the pipe line flow (B) To eliminate water hammer possibilities (C) To regulate flow of water to turbines by providing necessary retarding head of water (D) All of the above

Last Answer : Answer: Option D

Description : Water that is fed back to the boiler by the pump is called? a. Absorber b. Absolute c. Compressor d. Condensate

Last Answer : d. Condensate

Description : The _______ system includes anywhere that the steam condenses to form liquid water. a. Loop b. Power c. Liquid d. Condensate

Last Answer : d. Condensate

Description : A __________ is a type of heat exchange system where water is heated to its' boiling point via combustion of a fuel blown through a tube submerged in water. a. Condensate loop b. Hyperbolic cooling tower c. Steam boiler d. All of above

Last Answer : c. Steam boiler

Description : What is a Bose-Einstein condensate?

Last Answer : A Bose-Einstein condensate is a state of matter that occurs at extremely low temperatures, in which a large number of bosons, a type of subatomic particle, occupy the same quantum state, and it exhibits unique quantum mechanical properties.

Description : Describe the Bose-Einstein Condensate. -Space

Last Answer : In condensed matter physics, a Bose-Einstein condensate (BEC) is a state of matter (also called the fifth state of matter) which is typically formed when a gas of bosons at low densities is cooled ... (about one-hundred-thousandth (1/100,000) the density of normal air) to ultra-low temperatures.

Description : How do I go about a company report about a newly discovered gas condensate field?

Last Answer : A company report (business report) should be clear and conciseand formatted to follow a logical sequence.An informal report can be in the form ... as follows:Title (what the report is about)Content ListSummaryIntroductionProcedure/MethodologyFindingsConclusionsRecommendationsAppendices/Attachments

Description : Before working on an electric cargo winch master switch or controller, you should _____________. A. spray the gasket surface with a solvent B. drain condensate from the box C. open the circuit breaker in the power supply and tag D. heat the switch box to remove any moisture

Last Answer : Answer: C

Description : Bose Einstein condensate was first pre- dicted by?

Last Answer : Sathyendra Nath Bose and Albert Einstein

Description : _______ cooling towers use a process similar to the one found in small evaporative cooling units. a. Hyperboloid b. Tower c. Condensate loop d. None

Last Answer : a. Hyperboloid

Description : Once the condensate reaches the _____ , it becomes available to the boiler for recycling. • Condenser • Turbine • Boiler • Generator

Last Answer : • Boiler

Description : A steam and condensate system represents a _____ loop. • Discontinuous • Continuous • None of the above • All of the above

Last Answer : • Continuous

Description : when steam is condensate volume is drastically……. a) reduces b) increase c) both a) & b) d) None of above

Last Answer : a) reduces

Description : A device known as a _______ is used to release condensate from the pipework whilst preventing the steam from escaping from the system. a. Steam traps b. Steam pipes c. Boiler nose d. Release valve

Last Answer : a. Steam traps

Description : Condensate is the liquid formed when steam passes from the ________ to the ______ state. a. Vapor, solid b. Solid, liquid c. Vapor, liquid d. None

Last Answer : c. Vapor, liquid

Description : The back pressure created by lift is approximately ______PSIG for every 2 feet of condensate lift. a. 1 PSIG b. 3PSIG c. 1PSGI d. 3PSGI

Last Answer : a. 1 PSIG

Description : Which cooling Towers use a process similar to the one found in small evaporation active cooling units a) hyperbolic b) Tower c) condensate loop d) none of these

Last Answer : a) hyperbolic

Description : ____________is used to release condensate in pipe work a) steam trap b) valves c) power generators d) none of above

Last Answer : b) valves

Description : What happens when air dissolves in condensate? a) non corrosive b) temperature of air increases c) corrosive d) none of above

Last Answer : c) corrosive