Description : 32 With S2 closed and S1 open, the current waveform in the delta winding will be [GATE 2009] A. a sinusoidal at fundamental frequency B. flat-topped with third harmonic C. only third-harmonic D. none of these
Last Answer : C. Only third harmonic
Description : [31] With both S1 and S2 open, the core flux waveform will be [GATE 2009] A. a sinusoidal at fundamental frequency B. flat-topped with third harmonic C. peaky with third-harmonic D. none of these
Last Answer : B. Flat topped with third harmonic
Description : It is known that WWV operates on a frequency of 10 megahertz. What is the wavelength of WWV?
Last Answer : 30 meters.
Description : At frequencies above 100 megahertz, the intrinsic (i) region causes a pin diode to act as what?
Last Answer : Variable resistance.
Description : When using frequencies above 30 megahertz, you are normally limited to using what range?
Last Answer : Line of sight.
Description : What type of polarization should be used if an antenna is mounted on a moving vehicle at frequencies below 50 megahertz?
Last Answer : Vertical polarization.
Description : A recorder’s harmonic-distortion specification reads 2% third harmonic of a 100-kHz signal at 60 ips. What does this mean?
Last Answer : The recorder has 2% third-harmonic distortion of a 100-kHz signal at 60 ips.
Description : The lowest frequency produced by an instrument. A. Harmonic B. Fundamental C. Midrange D. 0 Hz
Last Answer : B. Fundamental
Description : Lowest frequency produced by a musical instrument. A. Fundamental B. Midrange C. Period D. Harmonic
Last Answer : A. Fundamental
Description : A node having twice the frequency of the fundamental is called A. half harmonic B. harmonic C. double harmonic D. triple harmonic
Last Answer : harmonic
Description : What is the WAVELENGTH of the carrier wave, in meters, of a radio station which is broadcasting at a frequency of 100 megahertz?
Last Answer : ANSWER: 3 METERS
Description : When measuring harmonic distortion, you set the signal generator to input a 15-kHz test signal. To what frequency should you set the wave analyzer?
Last Answer : 45 kHz.
Description : An open pipe is suddenly closed at one end with the result that the frequency of third harmonic of he closed pipe is found to be higher by 100 Hx than
Last Answer : An open pipe is suddenly closed at one end with the result that the frequency of third harmonic of he closed pipe ... 300 Hz` C. `240 Hz` D. `480 Hz`
Description : A Hertz antenna is operating on a frequency of 2182 kHz and consists of a horizontal wire that is hanged between two towers. What is the frequency of its third harmonic? A. 727 kHz B. 6546 kHz C. 436 kHz D. 6.546 kHz
Last Answer : B. 6546 kHz
Description : The time period of third harmonic of power supply frequency, in milliseconds, is (A) 20 (B) 3.33 (C) 6.66 (D) 60
Last Answer : The time period of third harmonic of power supply frequency, in milliseconds, is 6.66
Description : What is the frequency that is twice the fundamental frequency?
Last Answer : Second harmonic.
Description : The value of the normalized frequency parameter (V) relates the core size with mode propagation. When single mode fibers propagate only the fundamental mode, what is the value of V?
Last Answer : V≤2.405.
Description : What range of frequencies are usually referred to as the UHF Band? w) 3 to 30 Megahertz x) 30 to 300 Megahertz y) 300 to 3,000 Megahertz z) 30,000 to 300,000 Megahertz
Last Answer : ANSWER: Y -- 300 TO 3,000 MEGAHERTZ
Description : What number harmonic is the primary harmonic distortion in magnetic tape recorders?
Last Answer : Third-order harmonic.
Description : What is a harmonic?
Last Answer : It is an exact multiple of the basic or fundamental frequency.
Description : In single pulse modulation of PWM inverters, third harmonic can be eliminated if pulse width is equal to (a) 30o (b) 60o (c) 120o (d) 150o
Last Answer : In single pulse modulation of PWM inverters, third harmonic can be eliminated if pulse width is equal to 120o
Description : A body is executing simple harmonic motion of amplitude 1 cm. Its velocitywhile passing through the central point is 10 mm/sec. Its frequency will be a.2.99 rps b.2.22 rps c.1 rps d.1.59 rps e.1.77 rps
Last Answer : c. 1 rps
Description : A body is vibrating with simple harmonic motion of aplitude 5 cm frequency 10 vibrations per second. The maximum value of velocity in cm/s will be a.3.14 cm/s b.314 cm/s c.3140 cm/s d.31.4 cm/s e.31400 cm/s
Last Answer : b. 314 cm/s
Description : A source frequency f gives t beats when sounded with a frequency 200Hz. The second harmonic of same source gives 10 beats when sounded with a source o
Last Answer : A source frequency f gives t beats when sounded with a frequency 200Hz. The second harmonic of same source gives 10 ... Hz` C. `205 Hz` D. `195 Hz`
Description : In modulation technique, which of the following is referred to audible pitch? A. Width B. Frequency C. Harmonic D. Amplitude
Last Answer : B. Frequency
Description : For an under damped harmonic oscillator, resonance A Occurs when excitation frequency is greater than undamped natural frequency B Occurs when excitation frequency is less than undamped natural frequency C Occurs when excitation frequency is equal to undamped natural frequency D Never occurs
Last Answer : C Occurs when excitation frequency is equal to undamped natural frequency
Description : The motion of a system executing harmonic motion with one natural frequency is known as _______ A. principal mode of vibration B. natural mode of vibration C. both a. and b. D. none of the above
Last Answer : C. both a. and b.
Description : A weight of 50 N is suspended from a spring of stiffness 4000N/m and subjected to a harmonic force of magnitude 60N and frequency 60 Hz. what will be the static displacement of the spring due to maximum applied force A. 0.015m B. 0.15 m C. 15 m D. 150m
Last Answer : B. 0.15 m
Description : When a body moves with simple harmonic motion, the product of its periodic time and frequency is equal to A. Zero B. One C. π/2 D. 2π
Last Answer : B. One
Description : A single degree of freedom spring-mass system is subjected to a harmonic force of constant amplitude. For an excitation frequency of √3k/m , the ratio of the amplitude of steady state response to the static deflection of the spring is __________ A. 0.2 B. 0.5 C. 0.8 D. None of the above
Last Answer : B. 0.5
Description : The motion of a system executing harmonic motion with one natural frequency is known as _______ A) principal mode of vibration B) natural mode of vibration C) both a. and b. D)none of the above
Last Answer : C) both a. and b.
Description : If frequency of excitation of a forced vibration system with negligible damping is very close to natural frequency of the system, then the system will A) Execute harmonic motion of large amplitude B) Beat with a very high peak amplitude C) Perform aperiodic motion D) None of the above
Last Answer : A) Execute harmonic motion of large amplitude
Description : If the amplitude of harmonic motion is large, its frequency A) Will always be high B) Will always be less C) Can have any value D) Will be zero
Last Answer : C) Can have any value
Description : If harmonic motion of same frequency and same phase are superimposed in two perpendicular directions ( x and y) then, the resultant motion will be, A) circle B) An ellipse C) An square D) An rectangle
Last Answer : C) An square
Description : When a two-degree-of-freedom system is subjected to a harmonic force, the system vibrates at the a. frequency of applied force b. smaller natural frequency c. larger natural frequency d. None of the above
Last Answer : a. frequency of applied force
Description : For an under damped harmonic oscillator, resonance a) occurs when excitation frequency is greater than undamped natural frequency b) occurs when excitation frequency is less than undamped natural frequency c) occurs when excitation frequency is equal to undamped natural frequency d) never occurs
Last Answer : c) occurs when excitation frequency is equal to undamped natural frequency
Description : For an underdamped harmonic oscillator, resonance ______. (A) occurs when excitation frequency is greater than the undamped natural frequency (B) occurs when excitation frequency is less than the ... ) occurs when excitation frequency is equal to the undamped natural frequency (D) never occurs
Last Answer : (C) occurs when excitation frequency is equal to the undamped natural frequency
Description : Which distortion is least objectionable in case of audio amplifers? A) Phase distortion B) Frequency distortion C) Harmonic distortion D) Inter modulation distortion.
Last Answer : A) Phase distortion
Description : The period of oscillation of a particle undergoing simple harmonic motion is: w) independent of the amplitude of the motion x) directly proportional to the frequency of oscillation y) independent of the frequency of oscillation z) none of the above
Last Answer : ANSWER: W -- INDEPENDENT OF THE AMPLITUDE OF THE MOTION
Description : What is the fundamental difference between the phase relationship of the harmonics of the square wave as compared to the harmonics of a peaked wave?
Last Answer : All the odd harmonics are in phase with the fundamental in the square wave. This is not true of the odd harmonics in the peaked wave.
Description : What is the fundamental element in program preparation?
Last Answer : The instruction.
Description : What are the three fundamental quantities involved in radar displays?
Last Answer : Range, bearing, and elevation.
Description : What happens to the fundamental mode as the operating wavelength becomes longer than the single mode cutoff wavelength?
Last Answer : The fundamental mode becomes increasingly lossy.
Description : What is the fundamental difference between analog and digital computers?
Last Answer : Digital computers deal with discrete quantities, while analog computers deal with continuous physical variables.
Description : What are the three fundamental requirements of a military communications system?
Last Answer : Reliability, security, and speed.
Description : State two fundamental properties of insulating materials.
Last Answer : Insulation resistance and dielectric strength.
Description : Fundamental principle of refrigeration is based on the __________ law of thermodynamics. (A) Zeroth (B) First (C) Second (D) Third
Last Answer : C) Second
Description : If the alternating source in Q41 is changed to 200 volts peak-to-peak, what is Iavg?
Last Answer : Iavg = 0.636 × Imax = 1.41 amperes.
Description : A circuit is to be designed in which a capacitor must charge to 40 percent of the maximum charging voltage in 200 microseconds. The resistor to be used has a resistance of 40,000 ohms. What size capacitor must be used?
Last Answer : 0.1 microfarads 40% from the graph = 0.5