Description : What is the average voltage (Eavg) Output of a full-wave rectifier with an output of 100 volts peak?
Last Answer : 63.7 volts.
Description : If the output of a half-wave rectifier is 50-volts peak, what is the average voltage
Last Answer : 15.9 volts.
Description : What is the average voltage (Eavg) output of a full-wave rectifier that has an output of 100 volts peak?
Last Answer : 63.6 volts.
Description : If the source voltage for the voltage divider in question 50 supplies 150 volts, what is the total current through the voltage divider?
Last Answer : 495 mA.
Description : A circuit has a source voltage of 100 volts and two 50-ohm resistors connected in series. If the reference point for this circuit is placed between the two resistors, what would be the voltage at the reference point?
Last Answer : 50 volts.
Description : Why the peak voltage not exactly equal to the alternating peak voltage?
Last Answer : Need answer
Description : Alternating current measured in a transmission line will be a) Peak value b) Average value c) RMS value d) Zero
Last Answer : c) RMS value
Description : What is the device called that will separate alternating current from direct current, or that will separate alternating current of one frequency from other alternating currents of different frequencies?
Last Answer : A filter.
Description : What is a nonrotating device that produces alternating current?
Last Answer : Oscillator.
Description : Define alternating current.
Last Answer : An electrical current which is constantly varying in amplitude, and which changes direction at regular intervals.
Description : How would the compass react if the alternating current through the conductor was a high frequency?
Last Answer : The compass needle would vibrate rapidly around the zero current point ac meter (magnetic north).
Description : How would a compass react when placed close to a conductor carrying alternating current at a low frequency?
Last Answer : The compass needle would swing back and forth as the current changed from positive to negative.
Description : A sinusoidally alternating current of frequency 60 Hz has a maximum value of 15 A. Find the value of current after 1/200 second
Last Answer : A sinusoidally alternating current of frequency 60 Hz has a maximum value of 15 A. Find the value of current after 1/200 second
Description : What type of bias (positive or negative) is added to a negative damper for the most positive extremity of the wave shape to be clamped above 0 volts?
Last Answer : Positive bias.
Description : A negative damper damps which extremity of the output waveshape to 0 volts?
Last Answer : Most positive.
Description : A positive damper clamps which extremity of the output signal to 0 volts?
Last Answer : Most negative.
Description : What would be the output of a negative clamper with a bias potential of −5 volts and an input voltage swing from +50 to −50 volts?
Last Answer : -5 volts.
Description : What precaution should you take when you use 115 volts to zero a differential?
Last Answer : Never leave the circuit energized for more than 2 minutes.
Description : Which breakdown theory explains the action that takes place in a heavily doped PN-junction with a reverse bias of less than 5 volts?
Last Answer : Zener effect.
Description : If a power supply produces 20 volts with no load and 15 volts under full load, what is the percent of regulation?
Last Answer : 33.33%
Description : What is the effect upon an electron that enters the buncher gap when the potential across the grids is at 0 volts?
Last Answer : There is no effect
Description : Express the following in more simple terms. (a) 250,000 volts, (b) 25,000,000 microvolts, (c) 0.001 millivolt.
Last Answer : (a) 250 kV, (b) 25 V, (c) 1µV
Description : Convert 2.1 kV to volts.
Last Answer : 2100 volts.
Description : A tube has a transconductance of 800 mhos and a load resistor of 50 kohms. When control grid voltage varies by 6 volts, the plate voltage will vary by what amount?
Last Answer : 240 volts.
Description : If the mu of a tube is 85 and the signal at the control grid is 4 volts ac, the plate voltage will vary by what amount?
Last Answer : 340 volts.
Description : The plate voltage of a tube will vary 126 volts when a 3-volt ac signal is applied to the control grid. What is the gain of this tube?
Last Answer : 42.
Description : Using the graph in figure 3-7, what is the approximate value of current when the voltage is 12.5 volts?
Last Answer : 1.25 amperes.
Description : If Eeff is 130 volts and Ieff is 3 amperes, what is the total resistance (RT) in the circuit?
Last Answer : 43.3 ohms.
Description : a. Define the term "working voltage" of a capacitor. b. What should be the working voltage of a capacitor in a circuit that is operating at 600 volts?
Last Answer : a. It is the maximum voltage the capacitor can work without risk of damage. b. 900 volts.
Description : Three audio waves with 100,200 and 300 volts amplitude respectively, simultaneously modulate a 450 volts carrier. What is the total percent of modulation of the AM wave? A. 69 % B. 115.5 % C. 50% D. 83%
Last Answer : D. 83%
Description : How many volts it take to charge an electric car? 1. 140 2. 150 3. 120 4. 200
Last Answer : 3. 120
Description : An LED is operated on a 12 volt automobile circuit. The voltage drop across the LED is 2 volts and the current must be limited to 50 milliamps to prevent its overheating and destruction. What size resistor must be used? w) 60 ohms x) 100 ohms y) 120 ohms z) 200 ohms
Last Answer : ANSWER: Z -- 200 OHMS
Description : A capacitor of capacitance 50 micro farads is charged to a potential difference of 200 Volts. Find out energy stored in the condenser?
Last Answer : A capacitor of capacitance 50 micro farads is charged to a potential difference of 200 Volts. Find out energy stored in the condenser? 1 joule
Description : A certain transformer has 200 turns in the primary winding, 50 turns in the secondary winding and 120 volts applied to the primary. What is the voltage across the secondary? (A) 30 Volts (B) 480 Volts (C) 120 Volts (D) 60 Volts
Last Answer : A certain transformer has 200 turns in the primary winding, 50 turns in the secondary winding and 120 volts applied to the primary. What is the voltage across the secondary? (A) 30 Volts (B) 480 Volts (C) 120 Volts (D) 60 Volts
Description : A 400/200 volts transformer has pu impedance of 0.05. The HV side voltage required to circulate full load current during short circuit test is
Last Answer : A 400/200 volts transformer has pu impedance of 0.05. The HV side voltage required to circulate full load current during short circuit test is 20 V
Description : Two bulbs marked 200 watt-250 volts and 100 watt-250 volts are joined in series to 250 volts supply. Power consumed in circuit is
Last Answer : Two bulbs marked 200 watt-250 volts and 100 watt-250 volts are joined in series to 250 volts supply. Power consumed in circuit is 67 watt.
Description : In the inverting configuration, what is the voltage (for all practical purposes) at the inverting input to the operational amplifier if the input signal is a 1-volt, peak-to-peak sine wave?
Last Answer : 0 volts.
Description : If the input signals are 180 degrees out of phase with each other, what will be the peak-to-peak amplitude of the output signals?
Last Answer : Each output signal will be 100 millivolts.
Description : If the input signals are in phase, what will be the peak-to peak amplitude of the output signals?
Last Answer : 0 volts (the input signals will "cancel out").
Description : If the single-input, differential-output, differential amplifier has an output signal taken between the two output terminals, what will the peak-to-peak amplitude of this combined output be?
Last Answer : 200 millivolts. A-18. a. Differential amplifier
Description : The peak power of a radar depends on the interrelationship of what other factors?
Last Answer : Average power, pulse width, and prt.
Description : How can a peak detector for pam be modified to detect pdm?
Last Answer : By making the time constant for charging the capacitor at least 10 times the maximum received pulse width.
Description : What is the time constant of the resistor and capacitor in a peak detector for pam?
Last Answer : At least 10 times the interpulse period.
Description : What characteristic of a pulse does a peak detector sample?
Last Answer : Pulse amplitude or pulse duration
Description : Consider the following statements: 1. When a nerve fibre is stimulated, a profound change is produced in the electrical properties of surface membrane and in steady potential. 2. Upon excitation, the resting potentialis suddenly changed. 3. It is due ... 1, 2, 3 (b) 2, 3 (c) 1, 2, 3, 4 (d) 1, 2, 4
Last Answer : Ans:(d)
Description : (3) checking the penetration of ultra-violet rays to the earth Explanation: Ozone in the ozone layer filters out sunlight wavelengths from about 200 nm UV rays to 315 nm, with ozone peak absorption at about 250 nm. This ... the lower UV-C (200 nm-280 nm) and the entire UV-B band (280 nm-315 nm).
Last Answer : The advantage of detergents over soaps is – (1) Detergents are soluble in water (2) Detergents could not give much lather (3) Detergents give lather even with hard water (4) Soaps give lather with only soft water
Description : An SSB transmitter produces a peak-to-peak voltage of 200 V across a 100 Ω antenna load. What is the Peak Envelope Power? A) 49.98 W B) 79.98 W C) 99.96 W D) 199.93 W
Last Answer : An SSB transmitter produces a peak-to-peak voltage of 200 V across a 100 Ω antenna load. What is the Peak Envelope Power? A) 49.98 W B) 79.98 W C) 99.96 W D) 199.93 W
Last Answer : e
Description : If the total source voltage of the three-wire distribution system shown in the illustration is 240 volts, what is the voltage across load L5? [ NOTE: Kirchhoff's voltage and current laws apply ] EL-0075 A. 110.4 volts B. 112.2 volts C. 113.0 volts D. 114.8 volts
Last Answer : Answer: D