Description : What condition must exist on both the limiter and quadrature grids for current to flow in a gated-beam detector?
Last Answer : Both grids must be positively biased
Description : What will be the effect upon an electron traveling in the opposite direction to the lines of force in an electrostatic field?
Last Answer : The electron will be accelerated.
Description : What would be the output of a negative clamper with a bias potential of −5 volts and an input voltage swing from +50 to −50 volts?
Last Answer : -5 volts.
Description : The potential difference across a 4 ohm resistor is 20 volts. What is the current in the resistor?
Last Answer : ANSWER: 5 AMPS
Description : The potential difference across a 4 ohm resistor is 20 volts. Assuming that all of the energy dissipated by this resistor is in the form of heat, how many joules of heat are radiated in 10 seconds?
Last Answer : ANSWER: 1000 JOULES
Description : The constant potential difference across a 2 ohm resistor is 20 volts. How many watts of power are dissipated by this resistor?
Last Answer : ANSWER: 200 WATTS
Description : The potential difference across the gap of a spark plug ranges between a) 10-20 mV b) 10-20 V c) 10-20 kV d) 10-20 MV
Last Answer : ans a
Description : The electron beam in a CRT is made to sweep from left to right across the screen. What tube element causes this sweeping motion?
Last Answer : The horizontal-deflection plate.
Description : When troubleshooting most electronic circuits, 'loading effect' can be minimized by using a voltmeter with a/an ___________________. A. input impedance much greater than the impedance across which the voltage ... sensitivity of less than 1000 ohms/volt D. sensitivity of more than 1000 volts/ohm
Last Answer : Answer: A
Description : When the repealer potential is constant, what property of the electron determines how long it will remain in the drift space of the reflex klystron?
Last Answer : Velocity.
Description : According to electron theory, an electric current flows from what potential to what potential?
Last Answer : Electron theory assumes that electron flow is from negative to positive.
Description : How do we Shade some of the grids to show that 2 ones is the same as 20 tenths?
Last Answer : Need answer
Description : Coordinate grids?
Last Answer : zdjhcxjhvjcczxnbcxzjkhjhjkcxzkhjzxczcxmcmzcxbbkjxx nkZSCXHKzcxmbxcnjzxcjhkADSkuzxc
Description : A natural draft cooling tower is filled with wooden grids, which covers about __________ percent of the tower height. (A) 10-15 (B) 30-40 (C) 70-80 (D) 90-100
Last Answer : (A) 10-15
Description : Which ofthe following materials is used in the manufacture of resistance grids to be used in the starters of large motors ? (a) Copper (b) Aluminium (c) Steel (d) Cast-iron
Last Answer : (d) Cast-iron
Description : _______ electric power is the most common method used by electrical grids to transfer power. (A) One-phase (B) Two-phase (C) Three-phase (D) None of the above
Last Answer : Three-phase electric power is the most common method used by electrical grids to transfer power.
Description : What type of bias (positive or negative) is added to a negative damper for the most positive extremity of the wave shape to be clamped above 0 volts?
Last Answer : Positive bias.
Description : A negative damper damps which extremity of the output waveshape to 0 volts?
Last Answer : Most positive.
Description : A positive damper clamps which extremity of the output signal to 0 volts?
Last Answer : Most negative.
Description : Express the following in more simple terms. (a) 250,000 volts, (b) 25,000,000 microvolts, (c) 0.001 millivolt.
Last Answer : (a) 250 kV, (b) 25 V, (c) 1µV
Description : What effect does closer spacing of plates have on the electron beam?
Last Answer : A greater deflection angle.
Description : What effect do longer deflection plates have on the electron beam?
Description : Debunching of the electron bunches in the higher modes of a reflex klystron has what effect on output power?
Last Answer : Power is reduced.
Description : Why does the grid have a greater effect than the plate on electron flo
Last Answer : Because it is closer to the cathode.
Description : If the total source voltage of the three-wire distribution system shown in the illustration is 240 volts, what is the voltage across load L5? [ NOTE: Kirchhoff's voltage and current laws apply ] EL-0075 A. 110.4 volts B. 112.2 volts C. 113.0 volts D. 114.8 volts
Last Answer : Answer: D
Description : The distance between a generator and its load is 100 feet. What would be the approximate total voltage drop across a two wire supply cable if the current were 5.5 amperes and the resistance of the wire were 2.525 ohms per 1,000 feet? A. 0.5 volts B. 1.38 volts C. 1.90 volts D. 2.77 volts
Description : If the total source voltage of the three-wire distribution system shown in the illustration is 240 volts, what is the voltage across load L2? [NOTE: Kirchhoff's voltage and current laws apply.] EL-0075 A. 110.4 volts B. 112.2 volts C. 113.0 volts D. 114.8 volts
Last Answer : Answer: C
Description : If the total source voltage of the three-wire distribution system shown in the illustration is 240 volts, what is the voltage across load L3? [NOTE: Kirchhoff's voltage and current laws apply.] EL-0075 A. 110.4 volts B. 112.2 volts C. 113.0 volts D. 114.8 volts
Last Answer : Answer: B
Description : If the total source voltage of the three-wire distribution system shown in the illustration is 240 volts, what is the voltage across load L4? EL-0075 A. 110.4 volts B. 112.2 volts C. 113.0 volts D. 114.8 volts
Description : An ammeter has a full-scale deflection current of 100mA. If the same ammeter is used to measure a full-scale current of 1.0ampere, what is the value of the shunt resistor in ohms if the voltage across the meter is 9.0 volts?
Last Answer : 10 ohms
Description : An electron moving with a velocity of 5 10 3 m / s enters into a uniform electric field and acquires a uniform acceleration of 10 3 m / s 2 in the direction of initial velocity. i. ... which electron velocity will be doubled.? ii. How much distance electron would cover in this time.? -Science
Last Answer : Given u=5×103m/su=5×103m/s , a=103m/s2a=103m/s2, v=2u=104v=2u=104 m/s i.Using v=u+atv=u+at 104=5×103+103t104=5×103+103t or t=5 sec ii. Using s=ut+12at2s=ut+12at2 s=5×103×5+12×103×52s=5×103×5+12×103×52 =37.5×103m=37.5×103m
Description : A nonrelativistic electron enters a uniform magnetic field of 50 mT with a speed of `10^(6) m//s` at right angles to it and emerges from the field aft
Last Answer : A nonrelativistic electron enters a uniform magnetic field of 50 mT with a speed of `10^(6) m/ ... not depend on the initial speed of the electron.
Description : An ELECTRON moving horizontally along the +x axis enters a region of space with a horizontal uniform magnetic field pointing in the +y direction. The electron will be deflected: w) -y direction x) +y direction y) -z direction z) +z direction
Last Answer : ANSWER: Y -- -Z DIRECTION
Description : What happens to reflected energy that enters a directional coupler that is designed to sample incident energy?
Last Answer : . The reflected energy adds at the absorbent material and is absorbed.
Description : A light wave enters a sheet of glass at a perfect right angle to the surface. Is the majority of the wave reflected, refracted, transmitted, or absorbed?
Last Answer : Transmitted.
Description : Redox potential (EO volts) of cytochrome C, Fe3+/Fe2+ is (A) –0.29 (B) –0.27 (C) –0.08 (D) +0.22
Last Answer : Answer : D
Description : Redox potential (EO volts) of ubiquinone, ox/red system is (A) +0.03 (B) +0.08 (C) +0.10 (D) +0.29
Last Answer : Answer : C
Description : Redox potential (EO volts) of NAD+/NADH is (A) –0.67 (B) –0.32 (C) –0.12 (D) +0.03
Last Answer : Answer : B
Description : A three-phase alternator is operating at 450 volts, 250 amps at 0.6 power factor. If the power factor increases to 0.8, the kw load potential will increase by _____________. A. 38.525 kw B. 116.91 kw C. 155.88 kw D. 194.85 kw
Description : In a three-wire, 230/115 volt DC system, the potential between neutral and negative is _____________. A. 0 volts B. 115 volts C. 230 volts D. 460 volts
Description : ECE Board Exam March 1996 The potential difference between any exposed structured to ground in any electrical installation should not exceed _________ volts RMS. A. 10 B. 45 C. 0 D. 30
Last Answer : B. 45
Description : How many electron volts power the release of a large lightning bolt?
Last Answer : answer:Are electron volts the same as volts? I’ve had this question before too and it causes me to appreciate the forces of nature. It must take millions of volts to create an arc from clouds thousands of feet in the air to earth, given the resistance of air.
Description : An electron is moving with a velocity of `10^(7) m s^(-1)`. Find its energy in electron volts. (Mass of electron `=9.1xx10^(-31) kg` and charge of ele
Last Answer : An electron is moving with a velocity of `10^(7) m s^(-1)`. Find its energy in electron volts. (Mass ... ` and charge of electron `=1.6xx10^(-19) C`)
Description : A wavelength is commonly measured in which one of the following units? A. Radians B. Angstroms C. Electron volts D. Seconds
Last Answer : B. Angstroms
Description : A wavelength is commonly measured in which one of the following units? w) radians x) angstroms y) electron volts z) seconds
Last Answer : ANSWER: X -- ANGSTROMS
Description : In changing from an energy state of -1.51 electron-volts to -3.40 electron-volts, an atom emits a photon whose energy is: w) 1.51 electron-volts x) 1.89 electron-volts y) 3.40 electron-volts z) 4.91 electron-volts
Last Answer : ANSWER: X -- 1.89 ELECTRON-VOLTS
Description : Which of the following properties distinguish a material as conductor, insulator and semiconductor? a) Free electron charges b) Fermi level after doping c) Energy band gap d) Electron density
Last Answer : c) Energy band gap
Description : In order to generate electron-hole pairs, the maximum wavelength of radiation for Silicon (Band gap = 1.1 eV) is (a) 1.88 μm (b) 1.68 μm (c) 1.13 μm (d) 1.54 μm
Last Answer : In order to generate electron-hole pairs, the maximum wavelength of radiation for Silicon (Band gap = 1.1 eV) is 1.13 μm