When compared to incandescent lamps, what is the power  requirement of an LED?

1 Answer

Answer :

Very low.

Related questions

Description : Can I use an incandescent dimmer with LED lamps?

Last Answer : answer:The answer is . It depends. Some of the newer LED bulbs can be used with dimmers. They have circuits specifically designed to sense the reduced voltage and convert it to a pulse width modulated signal at the ... try it. If it does not work there I am sure you can find another place to put it.

Description : Incandescent lamps are classified according to __________. A. shape of bulb and type of service B. size and style of base C. operating voltage and wattage D. all of the above

Last Answer : Answer: D

Description : The LED lamps of a typical logic probe are normally in what state?

Last Answer : DIM.

Description : Can I replace a 60 watt incandescent light bulb with a fluorescent or LED bulb that puts out more light than the incandescent?

Last Answer : Light output is measured in lumens, and yes, you can find a fluorescent bulb in lumen output equal to or greater than an incandescent 75 or 100 watt bulb.And it won’t be anywhere near 60 watts, so you are safe.

Description : New LED light bulbs: do they emit more or less heat than standard incandescent?

Last Answer : answer:I could not guarantee accuracy, but from what I know LED is cooler. You can find out for sure if you buy one of each, and take turns standing in from of each one.

Description : What is the equivalent of 100 watt incandescent light bulbs in LED light bulbs?

Last Answer : That is a very good question, so I ended up doing a little research on the internet to find the information. It appears in order to match the intensity of a 100watt light bulb, you'll need 15watts of LED light bulbs.

Description : Can I get an LED light installed into my incandescent downlight cans?

Last Answer : Yes, absolutely. As long as the LED bulb and incandescent bulb have the same base they will both fit the socket. The LED bulb will also run much cooler than the original incandescent bulb.

Description : What are the benefits of using LED lights over incandescent lights?

Last Answer : From what I could find in my research LED lights seem to be brighter and easier on your cars charging system. They are placed inside the headlamp against a silver backing that also helps make them brighter.

Description : Which light emitter is preferred for high-speed data in a fiber-optic system? ∙ A. incandescent ∙ B. LED ∙ C. neon ∙ D. laser

Last Answer : D. laser

Description : Which light emitter is preferred for high speed data in a fiber-optic system ∙ a. Incandescent ∙ b. LED ∙ c. Neon ∙ d. Laser

Last Answer : ∙ d. Laser

Description : Assume CO2 equivalent emissions by the use of a 60 W incandescent lamp are of the order of 60 g/hr. If it is replaced by a 5 W LED lamp then the equivalent CO2 emissions will be a) nil b) 5 g/hr c) 12 g/hr d) 300 g/hr

Last Answer : b) 5 g/hr

Description : Hey, I want to try switching from classic UV lamps to LED lamps, because I get a lot of recommendations that it will last a little longer for LED gel. But as an ignorant person in the field of ... not like some low-quality, but not extremely expensive. I will be happy for any response - Thanks;)

Last Answer : When I was looking for it I came across www.uvlampynanehty.cz at the beginning it solves the difference there, but I think UV is better overall

Description : Labeling is voluntary on a) Solid State inverters c) LED retrofit lamps b)Diesel Generator d) all of above.

Last Answer : ALL OF ABOVE

Description : What are the advantages of LED lamps?

Last Answer : What are the advantages of LED lamps? LED lamps have an advantage over fluorescent lamps in the first place in terms of environmental friendliness. Another reason for using LED lamps is ... advantages. Today, such lamps are used in everyday life, for industrial lighting and street lighting.

Description : Capacity & power requirement for an air compressor working at high altitude compared to sea-level will be (A) More (B) Less (C) Same (D) Either more or less; depends on the climatic conditions

Last Answer : (B) Less

Description : Which semiconductor sources (LD or LED) emit more focused light and are capable of launching sufficient optical power into both single mode and multimode fibers?

Last Answer : LDs.

Description : What basic requirement of a closed-loop system (not present in open-loops) enables present load position to be sensed?

Last Answer : Feedback.

Description : State one requirement of an electron tube, which does not exist for semiconductors, that makes the tube less efficient than the semiconductor.

Last Answer : The electron tube requires filament or heater voltage, whereas the semiconductor device does not; consequently, no power input is spent by the semiconductor for conduction.

Description : What special requirement is the pulse counting accelerometer designed for?

Last Answer : When digital data is required from an accelerometer.

Description : If the load requirement consists of both positive and negative voltages, what technique is used in the voltage divider to supply the loads from a single voltage source?

Last Answer : The ground (reference point) is placed in the proper point in the voltage divider so that positive and negative voltages are supplied

Description : The air requirement of a petrol engine during starting compared to the theoretical air requirement for complete combustion is A. more B.unpredictable C. same D. less

Last Answer : ANSWER : D

Description : The air requirement of a petrol engine during starting compared to theoretical air required for complete combustion is a. more b. less c. same d. may be more or less depending on engine capacity

Last Answer : ANSWER b. less

Description : The calorie requirement of the body increases in winter as compared to summer because ore calories are necessary to

Last Answer : Sustain body temperature

Description : The draft requirement in MB plough compared to disc plough for same depth of ploughing is: a) Less c) More b) Equal d) None of these

Last Answer : More

Description : Have you found any of the new 'non-incandescent' lights to your liking?

Last Answer : answer:I've used the curly compact fluorescents for many years. Whatever are the cheap ones at Lowe's or Home Depot. I see a box here that says Ecosmart brand Soft White. On the ... work in photography and we had to pay careful attention to lighting, fluorescent tubes presented a few difficulties.

Description : How do you feel about the demise of incandescent light bulbs?

Last Answer : I, personally, don't like the yellow light of incandescent bulbs; I never did, and I've always tried to find the daylight versions of bulbs with the bluish tint. I know many people don't like ... bright light), but all the newer bulbs seem to be equivalent to 60W or 100W bulbs in light intensity.

Description : Why can i only see dust motes in sunlight or incandescent lights?

Last Answer : what are dust motes?

Description : Are incandescent light bulbs being eliminated?

Last Answer : not sure, seems LEDs are the wave of the future, but then, LED traffic lights don’t get hot enough to melt off the snow that sticks to them. I wouldn’t worry about it too much yet, even with Obama in power, the tree huggers don’t have the sort of power to ban incandescents.

Description : Will the filament resistance of a bulb be higher at normal temperature or in incandescent condition ?

Last Answer : As the resistance increases with increasing temperature, the resistance of the filament of the bulb will be higher than the normal temperature.

Description : How many lumens in a 250 Watt incandescent lamp?

Last Answer : The actual amount of light (lumens) given off by a bulb depends on the how the bulb was made and with what materials. It depends on the filament material, its length and thickness, and the ... 3940 lumens at its highest setting.Philips 250 Watt 120 to 130V PAR38 Krypton Flood Bulb emits 3100 lumens

Description : What are the advantages to replaces regular incandescent light bulbs with CFL bulbs?

Last Answer : The CFL bulbs last for about 10,000 hours. The incandescent bulbs only last for about 1,500 hours. Most people won't go for the CFL because of the upfront costs but you'll save more money in the long run because they are also more energy efficient.

Description : Is it really illegal to use incandescent bulbs in some countries?

Last Answer : Australia has outlawed incandescent bulbs and other countries intend to.

Description : Are Incandescent bulbs going to be outlawed?

Last Answer : There is nothing that states incandescent light bulbs will one day be illegal or outlawed. Using them is an individuals option and right.

Description : How much money do you save by using a 20 Watt Compact Fluorescent over an incandescent bulb?

Last Answer : An Energy Star qualified compact fluorescent light bulb can save you around $30 over it's lifetime, paying for its self in about 6 months.

Description : Which is a better floor lamp - incandescent or fluorescent?

Last Answer : Incandescent floor lamps emit a lower ray of light, therefore you won't get as bright a light shine. A flourescnet light is much brighter. It really depends on where you will put the lamp.

Description : Office lighting - incandescent or fluorescent?

Last Answer : The fluorescent lighting is what is used in most offices. This lighting offers great efficiency as well as encourages productivity.

Description : Producer gas is obtained by  A. partial combustion of coal, coke, anthracite coal or charcoal in a mixed air steam blast  B. carbonisation of bituminous coal  C. passing steam over incandescent coke  D. passing air and a large amount of steam over waste coal at about 650°C

Last Answer : Answer: A

Description : Producer gas is obtained by  A. partial combustion of coal, coke, anthracite coal or charcoal in a mixed air steam blast  B. carbonisation of bituminous coal  C. passing steam over incandescent coke  D. passing air and a large amount of steam over waste coal at about 650°C

Last Answer : Answer: A

Description : A homeowner replaces a 65 watt incandescent bulb with a 15 watt compact fluorescent lamp. The light is on 2000 hours a year. If electricity cost 10 cents a kilowatt-hour, how much money is saved on the electric bill in one year? w) $50.00 x) $10.00 y) $5.00 z) $1.00 

Last Answer : ANSWER: X -- $10.00 

Description : Define the terms incandescent and incandescent lamp.

Last Answer : Incandescent is the phenomenon in which the object emits or creates light when it is heated. An incandescent lamp is a lamp in which the filament is heated by electrical current & light is created.

Description : Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then .  A) The bulbs together consume 100 W B) The bulbs together consume 50 W C) The 60 W bulb glows brighter D) The 40 W bulb glows brighter

Last Answer : Two incandescent light bulbs of 40 Wand 60 W rating are connected in series across the mains, then . The bulbs together consume 50 W 

Description : If an incandescent lamp of 80 ohms resistance takes a current of 0.75 ampere, what voltage is required to light it? A.45 volts B.60 volts c.23 volts D.None of these

Last Answer : V=IR    = 80*0.75     = 60 volts

Description : . In a common anode, seven-segment LED display, an individual LED will light if a negative voltage is applied to what element?

Last Answer : The cathode.

Description : What type of bias is required to cause an LED to produce light?

Last Answer : Forward bias.

Description : What was the major factor that led to the development of the full-wave rectifier?

Last Answer : The fact that the full-wave rectifier uses the full output, both half cycles, of the transformer.

Description : What led to the development of procedure oriented languages?

Last Answer : The development of mnemonic techniques and macroinstructions.

Description : Is the drive circuitry generally more complex for an LED or a laser diode? Why?

Last Answer : For a laser diode. The laser diode transmitter generally contains output power control circuitry and may contain a TE cooler and some circuitry associated with the TE cooler.

Description : What are the three basic LED types?

Last Answer : Surface-emitting LEDs (SLEDs), edge-emitting LEDs (ELEDs)

Description : What does a lighted LED indicate on a logic comparator?

Last Answer : A difference in logic states between the reference IC and the IC under test.

Description : A lighted LED on a logic clip represents what logic level?

Last Answer : A "1" state.