The type of roof which slopes in two directions with a break in the slope on each side is known as
(A) Gable roof
(B) Hip roof
(C) Gambrel roof
(D) Mansard roof

1 Answer

Answer :

Option C

Related questions

Description : Mansard roof is a roof which slopes in (A) Two directions without break in the slope on each side (B) Two directions with break in the slope on each side (C) Four directions without break in the slope on each side (D) Four directions with break in the slope on each side

Last Answer : Answer: Option D

Description : A roof which slopes in four directions, is called (A) Shed roof (B) Gable end roof (C) Hipped roof (D) Gambrel roo

Last Answer : Answer: Option C

Description : In high mountainous region, the type of roof generally recommended for buildings, is (A) Shed type (B) Gable type (C) Gambrel type (D) Mansard type

Last Answer : Option C

Description : The lower edge of the pitched roof, from where the rain water of the roof surface drops down, is known as (A) Hip (B) Gable (C) Ridge (D) Eaves

Last Answer : Answer: Option D

Description : Best side slope for most economical trapezoidal section in open channel flow, wherein side slopes are defined by : X horizontal to 1 vertical, is when X equals : (a) 0.404 (b) 0.500 (c) 0.577 (d) 0.673

Last Answer : (c) 0.577

Description : The highest line of sloping roof, where two opposite slopes meet, is known as (A) Rafter (B) Ridge (C) Crown (D) Eave

Last Answer : Answer: Option B

Description : The line of intersection of two surfaces of a sloping roof forming an internal angle less than 180°, is known as (A) Ridge (B) Hip (C) Valley (D) None of these

Last Answer : Answer: Option C

Description : Two different channels, M and N, in two different sites are designed based on Lacey's theory, to carry same quantum of discharge. But the bed material of M is found to be finer than that of N. a) ... slope c) Channels M and N can have same longitudinal slopes d) Silting is more in M than in N

Last Answer : b) Channel N will have steeper longitudinal slope

Description : Stability of hill slopes depends upon (A) Nature of the slope (B) Angle of the slope (C) Geological conditions (D) All the above

Last Answer : Answer: Option D

Description : You are asked to design and supervise a truss for a factory to have spans 6 m to 9 m. The type of the truss you will use, is (A) Mansard truss (B) Queen post truss (C) King post truss (D) Collar truss

Last Answer : Answer: Option C

Description : The line of intersection of the surfaces of a sloping roof forming an external angle exceeding 180°, is (A) Ridge (B) Hip (C) Valley (D) None of these

Last Answer : Answer: Option B

Description : The horizontal timber piece provided at the apex of a roof truss which supports the common rafter is called (A) Ridge board (B) Hip rafter (C) Eaves board (D) Valley rafte

Last Answer : Answer: Option A

Description : The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as (A) Sloping drain (B) Catch-water drain (C) Side drain (D) Cross drain

Last Answer : Answer: Option B

Description : An R.C.C. roof slab is designed as a two way slab if (A) It supports live loads in both directions (B) The ratio of spans in two directions is less than 2 (C) The slab is continuous over two supports (D) The slab is discontinuous at edges

Last Answer : Answer: Option B

Description : The rain water harvesting shown here is A. Recharge Pit. B. Recharge Trench. C. Roof top rain water harvesting. D. Bunds of slopes.

Last Answer : B. Recharge Trench.

Description : _______ is more prevalent in analog signals that have steep slopes or whose amplitudes vary rapidly. A. Peak limiting B. Quantization noise C. Granular noise D. Slope overload

Last Answer : D. Slope overload

Description : In time-cost optimization of a project, crashing is done. (A) On all the activities (B) On all the activities lying on the critical path (C) Only on activities lying on the ... critical activities and those that become critical at any stage of crashing in the order of ascending cost slope

Last Answer : D

Description : In flat roof of reinforced cement concrete, the recommended angle of slope, is (A) Zero (B) A few degrees (C) 10° (D) 200

Last Answer : Answer: Option B

Description : For effective drainage, the finished surface of flat roof should have a minimum slope of (A) 1 in 20 (B) 1 to 50 (C) 1 in 10 (D) 1 in 5

Last Answer : Answer: Option A

Description : Pick up the incorrect statement from the following. The width of the right-of-way is decided so as to accommodate (A) Formation width (B) Side slopes (C) Horizontal curve (D) Vertical curve

Last Answer : Answer: Option D

Description : The ground surface slopes 1 in 50 along a proposed railway embankment 150 m in length. The height of the embankment at zero chainage is 0.5 m, the width is 11 m and side slopes 2:1. If the falling gradient ... calculated by Prismoidal formula, is (A) 3250 m3 (B) 3225 m3 (C) 3275 m3 (D) 3300 m3

Last Answer : (B) 3225 m3

Description : A portion of an embankment having a uniform up-gradient 1 in 500 is circular with radius 1000 m of the centre line. It subtends 180° at the centre. If the height of the bank is 1 m at the lower end, and side slopes 2 ... earth work involved. (A) 26,000 m3 (B) 26,500 m3 (C) 27,000 m3 (D) 27,500 m

Last Answer : (D) 27,500 m3

Description : Do I need to install a gable vent on every gable?

Last Answer : Vent the highest point of the house. No need to do every gable if the roof is open (attic). If you ever re-roof then consider ridge vents. Can’t get any higher than ridge vents.

Description : How Gable boxes were invented what's their history is?

Last Answer : Appealing, strong, and sturdy, that is the thing that printed peak sacks are.Their prevalence and request are expanding each day all around the world. They are adaptable as they can be isolated ... Get Fully Customized Gable Boxes, Visit the Link Below:"thecustomboxes.co.uk/gift-boxes/gable-boxes/"

Description : Which company is best to buy Custom Gable Boxes at wholesale?

Last Answer : Many companies provide gable boxes in the USA. But here is the company which provides the premium quality packaging boxes including gable boxes at the lowest price with free shipping next to your doorsteps. Visit: halfpricepackaging .com

Description : Water may not contain much impurity if its source is  (A) Reservoirs  (B) Stream flowing in plains  (C) Lakes in lower regions  (D) Spring along hill slopes

Last Answer : (D) Spring along hill slopes

Description : For slopes of limited extent the surface of slippage, is usually along (A) A parabolic arc (B) An elliptical arc (C) A straight line (D) A circular arc

Last Answer : (D) A circular arc

Description : The method of the slices is applicable to (A) Homogenous soils (B) Stratified soils (C) Saturated soils (D) Non-uniform slopes

Last Answer : Answer: Option A

Description : Failure of the stability of slopes, generally occurs along (A) Slip plane (B) A horizontal surface (C) A curved surface (D) All the surfaces

Last Answer : Answer: Option C

Description : Gradient resistance of moving vehicles along down slopes, is (A) + 7 kg/tonne (B) + 9 kg/tonne (C) - 9 kg/tonne (D) - 7 kg/tonne

Last Answer : Answer: Option C

Description : If B is the width of formation, d is the height of the embankment, side slope S : 1, for a highway with no transverse slope, the area of cross-section is (A) B + d + Sd (B) Bd + Sd2 (C) B × d - Sd1/2 (D) ½ (Bd + Sd2

Last Answer : (B) Bd + Sd2

Description : Pick up the correct statement from the following: (A) If the bed level is above N.S.L. the canal is called fully in baking and the berms are designed as 3 d where d is full supply depth of water ... and partly in filling and berms are designed as 2d where d is full supply depth (D) All the above

Last Answer : (D) All the above

Description : According to I.S. : 456, slabs which span in two directions with corners held down, are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip, is ... (C) Three-fourth of the width of the slab (D) Four-fifth of the width of the slab

Last Answer : Answer: Option C

Description : Give a geographical reason for each of the following : (i) Tea is cultivated on hill slopes. -Geography

Last Answer : Geographical reasons for the following are : (i) Port cities have their own oil refineries because two thirds of the petroleum is imported. The crude oil is imported from Gulf countries ... the production of chemicals, dyes, fertilizers, paints, synthetics, explosive apart from source of energy.

Description : Pick up the correct statement from the following: (A) The distance of the eccentric axial load from the C.G. beyond which tension develops, is known as kern distance (B) In visco ... (C) An orthotropic material has different properties in three mutually perpendicular directions (D) All the above

Last Answer : (D) All the above

Description : What are the side effects of hip enlargement creams?

Last Answer : To know the side effects of the cream, you need to know the components in it. These creams contain active components that increase the deposition of fat in the applied area. The most effective ... . Personally, I feel the best way to achieve bigger hips is regular prescribed exercise and diet.

Description : What types of exercise are plantar flexions hip extension knee flexion and side leg raises?

Last Answer : You lift the weight on your shoulder, behind the neck. Lift yourself by planer flexing the feet. You put the chest expander on thewall and press them downwards with your heels, when you ... separatethe straight legs apart. Alternately fix some weight to your footand do the side leg rise exercise.

Description : The window which is provided in flat roof of a room, is known (A) Dormer window (B) Lantern window (C) Louvered window (D) Sky window

Last Answer : Answer: Option B

Description : What type of volcano forms as lava spreads over a long distance and then cools and forms a hill that slopes gently?

Last Answer : What is the answer ?

Description : If the failure of a finite slope occurs through the toe, it is known as (A) Slope failure (B) Face failure (C) Base failure (D) Toe failure

Last Answer : (D) Toe failure

Description : A plane inclined at an angle to the horizontal at which the soil is expected to stay in the absence of any lateral support, is known as (A) Natural slope line (B) Repose line (C) The line (D) All the above

Last Answer : Answer: Option D

Description : If the elevations along a road increase, the slope of the road along the longitudinal direction, is known as (A) Gradient (B) Grade (C) Positive grade (D) Negative grade

Last Answer : Answer: Option A

Description : The type of roof suitable in plains where rainfall is meagre and temperature is high is (A) Pitched and sloping roof (B) Flat roof (C) Shell roof (D) none of these

Last Answer : Answer: Option B

Description : What is the best cream to use for tattoo removal I have one on each of my feet that I want to get rid of and a very dark one on my hip.?

Last Answer : TAT B GONE (TAB) Is the best cream available,as they are FDA regulated lad product. when applied to the tattooed part it enters the dermis layer of the skin and help fade away by attacking the ink. More darker the tattoo the more time it takes to fade,however TBG will fetch you a good result.

Description : What forms the roof and upper side of skull?

Last Answer : Temporal bone.

Description : A radiating source that radiates energy equally in all directions is known as what type of radiator?

Last Answer : Isotropic radiator.

Description : Have you known a senior with a hip replacement who walks normally after rehab?

Last Answer : Yes, several.

Description : A number of forces acting at a point will be in equilibrium if (A) Their total sum is zero (B) Two resolved parts in two directions at right angles are equal (C) Sum of resolved parts in any two perpendicular directions are both zero (D) All of them are inclined equally

Last Answer : (C) Sum of resolved parts in any two perpendicular directions are both zero

Description : If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span ... (L + 2D/3)² (C) WL/10 (L - 2D/3)² (D) WL/12 (L - D/3)²

Last Answer : Answer: Option C

Description : If the sides of a slab simply supported on edges and spanning in two directions are equal, the maximum bending moment is multiplied by (A) 0.2 (B) 0.3 (C) 0.4 (D) 0.5

Last Answer : Answer: Option D