Description : The maximum thickness of concrete floor of a cement warehouse, is (A) 10 cm (B) 15 cm (C) 20 cm (D) 25 cm
Last Answer : (D) 25 cm
Description : Minimum thickness of the base of a flexible pavement, is (A) 10 cm (B) 15 cm (C) 20 cm (D) 25 cm
Last Answer : Answer: Option A
Description : Brick walls are measured in sq. m if the thickness of the wall is (A) 10 cm (B) 15 cm (C) 20 cm (D) None of these
Last Answer : (A) 10 cm
Description : For plastering the exposed brick walls, the cement sand mortar should be (A) 1 : 2 (B) 1 : 3 (C) 1 : 4 (D) 1 : 6
Last Answer : Answer: Option C
Description : Consider the following statements: Maximum slenderness ratio of load-bearing masonry walls for a dwelling having more than two storeys shall not exceed. 1. 12, if lime mortar is used 2. 18, if cement-lime mortar 1:2:9 is used 3. 24, ... ? (a) 1 and 2 only b) 2 and 3 only c) 1 and 3 only d)1, 2 and 3
Last Answer : b) 2 and 3 only
Description : Pick up the incorrect statement from the following: (A) The built up covered area at the floor level of any storey of a building is called plinth area (B) The usable covered area of the rooms of ... , pantry, store, lavatory, bath room and glazed veranda, is called floor area (D) None of thes
Last Answer : (D) None of thes
Description : The difference in the reservoir level and the lowest point of the water mains is 180 m. The expected pressure due to water hammer is 7.5 kg/cm2 in a pressure conduit of diameter 1 m. Assuming the efficiency of the ... , is (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Last Answer : (C) 20 mm
Description : For determining the ultimate bearing capacity of soil, the recommended size of a square bearing plate to be used in load plate test should be 30 to 75 cm square with a minimum thickness of (A) 5 mm (B) 10 mm (C) 15 mm (D) 25 mm
Last Answer : Answer: Option D
Description : If height of the first storey of a building is 3.2 m and riser is 13 cm, the number of treads required, is (A) 12 (B) 18 (C) 24 (D) 2
Description : Pick up the incorrect statement from the following. For performing compressive strength test of cement (A) Cement and standard sand mortar are used in the ratio of 1 : 3 (B) Water is added at the ... cm 10 cm is used (D) The prepared moulds are kept in a atmosphere of 50% relative humidity
Description : The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Description : The raft slab is projected beyond the outer walls of the structure by (A) 5 to 10 cm (B) 15 to 20 cm (C) 25 to 30 cm (D) 30 to 45 cm
Description : The strength of brick masonry in 1:6 cement mortar, is (A) 20 tonnes/m2 (B) 40 tonnes/m2 (C) 50 tonnes/m2 (D) 60 tonnes/m
Description : The nominal thickness of an expansion joint in brick walls, is kept more than (A) 5 mm (B) 10 mm (C) 15 mm (D) 20 mm
Description : The expected out turn of brick work in cement mortar in foundation and plinth per mason per day, is (A) 1.00 m3 (B) 1.25 m3 (C) 1.50 m3 (D) 1.75 m3
Last Answer : (B) 1.25 m3
Description : Maximum slenderness ratio for load-bearing masonry wall in cement mortar, as per IS code, shall not exceed. (a) 13 (b) 20 (c) 27 (d) 30
Last Answer : (c) 27
Description : For maximum strength and durability minimum percentage of cement, by weight is (A) 15 % (B) 20 % (C) 25 % (D) 30 %
Description : Price -Rite Carpets is located out -of- town, in a large, low -cost single storey building with no window displays and takes a minimilist approach to store ambiance and customer service. The Price - ... an example of a: A)discount shed. B)warehouse club. C)speciality store. D)convenience store.
Last Answer : A)discount shed
Description : To prevent movement of moisture from sub-grade to road pavement on embankments about 0.6 m to 1 m higher than water table, the thickness of cut off layer of coarse sand used, is (A) 15 cm (B) 20 cm (C) 30 cm (D) None of these
Description : In horizontal D.P.C, thickness of cement concrete (1 : 2 : 4) is (A) 2 cm (B) 4 cm (C) 6 cm (D) 8 cm
Last Answer : Answer: Option B
Description : According to I.S.: 456, 1978 the thickness of reinforced concrete footing on piles at its edges, is kept less than (A) 5 cm (B) 10 cm (C) 15 cm (D) 20 cm
Description : For a poorly graded sub-grade soil, thickness of sub-base, is (A) 10 cm (B) 15 cm (C) 20 cm (D) 30 cm
Description : The thickness of a reinforced brick partition wall, is generally kept (A) 5 cm (B) 10 cm (C) 15 cm (D) 20 cm
Description : In the event of an earthquake and you're in a 20 storey building, Is your chance of survival higher at a the higher floors or lower floors.
Last Answer : answer:Naturally the lower you are the more likely you are going to be crushed. In the 1989 San Francisco quake, many houses pancaked into the street. Meaning the top floor crushed the lower floor ... comes toppling down, you'll have some sort or frame around you to prevent you from being crushed.
Description : For each storey of a building, the depth of exploration should be (A) 1 metre (B) 2 metres (C) 3 metres (D) 4 metres
Last Answer : Option C
Description : The expected out turn of 12 mm plastering with cement mortar is (A) 2.5 sq m (B) 4.0 sq m (C) 6.0 sq m (D) 8.0 sq m
Last Answer : (D) 8.0 sq m
Description : For testing compressive and tensile strength of cement, the cement mortar is made by mixing cement and standard sand in the proportions of (A) 1 : 2 (B) 1 : 3 (C) 1 : 4 (D) 1 : 6
Description : Pick up the correct statement from the following: (A) Lime mortar with cement in the ratio of in 10 is cheaper and better for outside plaster (B) For very cold or very hot climate, a compact and closed ... (C) On the sea coast, an exposed and open house is generally preferred (D) All the above
Description : The concrete under water minimum grade of cement recommended by IS code a) M 10 b) M 15 c) M 20* d) M 25
Last Answer : c) M 20*
Description : A cylinder is said to be thin if the ratio of its thickness and diameter, is less than (A) 1/25 (B) 1/20 (C) 1/15 (D) 1/10
Last Answer : (D) 1/10
Description : If the storey height is equal to length of RCC wall, the percentage increase in strength is (A) 0 (B) 10 (C) 20 (D) 30
Last Answer : Option B
Description : To prevent movement of moisture from sub-grade to road pavement at the same level as that of water-table, thickness of a cut off layer of coarse sand, is (A) 15 cm (B) 20 cm (C) 30 cm (D) 45 cm
Description : Pick up the incorrect statement from the following: (A) Space between the exterior walls of a warehouse and bag piles should be 30 cm (B) Cement bags should preferably be piled on wooden planks (C) Width and height of the pile should not exceed 3 m and 2.70 m respectively (D) None of these
Description : In a mortar, the binding material is (A) Cement (B) Sand (C) Surkhi (D) Cinder
Description : The mortar in which both cement and lime are used as binding materials, is called (A) Cement mortar (B) Lime mortar (C) Fire resistant mortar (D) Gauged mortar
Description : Brick nogging type of partition wall, is constructed by (A) Laying bricks as stretchers in cement mortar (B) Laying bricks as headers in cement mortar (C) Reinforcing brick wall with iron straps (D) Constructing brick work within a wooden framework
Description : The minimum diameter of a sewer is kept A. 10 cm B. 15 cm C. 20 cm D. 25 cm
Last Answer : ANS: B
Description : How is the rate of a cooling of a building affected by the thickness and the thermal conductivity of its walls?
Last Answer : Generally thicker walls slow down the transfer of heat, and if the material is a good thermal conductor that will increase the rate of transfer.
Description : The thickness of the topping of a ribbed slab, varies between (A) 3 cm to 5 cm (B) 5 cm to 8 cm (C) 8 cm to 10 cm (D) 12 cm to 15 cm
Description : Thickness of broken line markings on multi-lane road for lanes is generally kept (A) 10 cm (B) 12 cm (C) 15 cm (D) 18 cm
Description : Thickness of broken centre line markings for a four lane road, is generally kept (A) 10 cm (B) 12 cm (C) 15 cm (D) 18 cm
Description : Where will you land if you jump off a two storey building? -Riddles
Last Answer : In the hospital.
Description : The width of the hollow space between two walls of a cavity wall should not exceed (A) 5 cm (B) 7.5 cm (C) 10 cm (D) 15 cm
Description : If the width of a pavement slab is 7.5 m, thickness 20 cm and working stress 1400 kg/cm2 , spacing of 10 mm tie bars for the longitudinal joint, is (A) 10 cm (B) 20 cm (C) 30 cm (D) 40 cm
Description : The external length, breadth and height of a closed box are 10cm, 9cm and 7cm respectively. The total inner surface area of the box is 262 sq.cm. If the walls of the box are of uniform thickness “t” cm, then “t” equals a) 1cm b) 23/3 cm c) 28/9 cm d) 42.5 cm
Last Answer : a) 1cm
Description : Minimum thickness of a layer of fine sand required to cut off capillary rise of water completely, should be (A) 40 cm (B) 52 cm (C) 64 cm (D) 76 cm
Description : If 50 m point of a 100 m tape is 50 cm off line, and 50 m sections are straight, an error is generated equal to (A) 1/10,000 (B) 1/15,000 (C) 1/20,000 (D) 1/25,000
Last Answer : (C) 1/20,000
Description : A rectangular beam 20 cm wide is subjected to a maximum shearing force of 10,000 kg, the corresponding maximum shearing stress being 30 kg/cm2 . The depth of the beam is (A) 15 cm (B) 20 cm (C) 25 cm (D) 30 cm
Last Answer : (C) 25 cm
Description : Dimensions of a beam need be changed if the shear stress is more than (A) 10 kg/cm2 (B) 15 kg/cm2 (C) 20 kg/cm2 (D) 25 kg/cm
Description : In welded wire mesh, the longitudinal wire is placed at (A) 10 cm centres (B) 15 cm centres (C) 20 cm centres (D) 25 cm centres