Description : Along column is one whose ratio of effective length to its least lateral dimension exceeds (a) 5 (b) 10 (c) 12 (d) 20
Last Answer : (c) 12
Description : When the ratio of the effective length of the rectangular columns to its lateral dimension exceeds12, then the column is said to be [ A ] Short column [ B ] Slender column [ C ] Biaxial column [ D ] All the above
Last Answer : [ B ] Slender column
Description : According to IS: 4561978, the column or the strut is the member whose effective length is greater than (A) The least lateral dimension (B) 2 times the least lateral dimension (C) 3 times the least lateral dimension (D) 4 times the least lateral dimension
Last Answer : Answer: Option C
Description : In rapid sand filters the ratio of length and diameter of the lateral, should not be greater than (A) 10 (B) 15 (C) 20 (D) 25
Last Answer : (C) 20
Description : Slenderness ratio of the column is the ratio of [ A ] the effective length to width of column [ B ] the effective length to depth of column [ C ] the effective length to least lateral design [ D ] none of the above
Last Answer : [ C ] the effective length to least lateral design
Description : The spacing of transverse reinforcement of column is decided by the following consideration. (A) The least lateral dimension of the column (B) Sixteen times the diameter of the smallest longitudinal ... column (C) Forty-eight times the diameter of transverse reinforcement (D) All the above
Last Answer : Answer: Option D
Description : Minimum pitch of transverse reinforcement in a column is (A) The least lateral dimension of the member (B) Sixteen times the smallest diameter of longitudinal reinforcement bar to be tied (C) Forty-eight times the diameter of transverse reinforcement (D) Lesser of the above three values
Description : A short column (30 cm 20 cm) carries a load P1 at 4 cm on one side and another load P2at 8 cm on the other side along a principal section parallel to longer dimension. If the extreme intensity on either side is same, the ... to P2 will be (A) 2/3 (B) 3/2 (C) 8/5 (D) 5/8
Last Answer : (C) 8/5
Description : Pick up the correct statement from the following: (A) The structural member subjected to compression and whose dimensions are small as compared to its length, is called a stmt (B) The ... in lateral direction of a long column, is generally known as buckling (D) All the above
Last Answer : (D) All the above
Description : The statement, regarding the size of stones used at the wearing surface. "The size of a stone used on a road must be in due proportion to the space occupied by a wheel of ordinary dimensions on a smooth ... dimension is mischievous" was made by (A) Telford (B) Macadam (C) Tresguet (D) Sully
Last Answer : Answer: Option B
Description : For the design of a simply supported T-beam the ratio of the effective span to the overall depth of the beam is limited to (A) 10 (B) 15 (C) 20 (D) 25
Description : For Unbraced column, the ratio of the clear height of the column to the minimum dimension of the column shall not exceed [ A ] 30 [ B ] 40 [ C ] 50 [ D ] 60
Last Answer : [ A ] 30
Description : Expansion joints are provided if the length of concrete structures exceeds (A) 10 m (B) 15 m (C) 15 m (D) 45 m
Description : Along horizontal curves, if centrifugal force exceeds lateral friction, vehicles may (A) Skid (B) Slip (C) Not be affected (D) None of these
Last Answer : Answer: Option A
Description : The Effective length of braced column generally varies…………the unsupported length of the column [ A ] 0.25 to 0.50 times [ B ] 0.50 to 1.00 times [ C ] 1.00 to 1.50 times [ D ] 2.00 to 2.50 times
Last Answer : [ B ] 0.50 to 1.00 times
Description : Expansion joints in masonry walls are provided if length exceeds (A) 10 m (B) 20 m (C) 30 m (D) 40 m
Description : A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is (A) 20 cm (B) 25 cm (C) 30 cm (D) 35 cm
Description : The ratio of the effective length of a column and minimum radius of gyration of its cross-sectional area, is known (A) Buckling factor (B) Slenderness ratio (C) Crippling factor (D) None of these
Last Answer : (B) Slenderness ratio
Description : If the effective length of a 32 cm diameter R.C.C. column is 4.40 m, its slenderness ratio, is (A) 40 (B) 45 (C) 50 (D) 55
Description : Columns may be made of plain concrete if their unsupported lengths do not exceed their least lateral dimension (A) Two times (B) Three times (C) Four times (D) Five times
Description : The spacing of stirrups in doubly reinforced beams should be least of the following (i)Least Lateral dimension (ii)Sixteen times the diameter of longitudinal steel (iii)Forty eight times the diameter of transverse reinforcement [ A ] i [ B ] i and ii [ C ] i and iii [ D ] i, ii and iii
Last Answer : [ D ] i, ii and iii
Description : Minimum clear cover (in mm) to the main steel bars in slab, beam, column and footing respectively, are (a) 10, 15, 20 and 25 (b) 15, 25, 40 and 75 (c ) 20, 25, 30 and 40 (d) 20, 35, 40 and 75
Last Answer : (b) 15, 25, 40 and 75
Description : An aggregate which passes through 25 mm I.S. sieve and is retained on 20 mm sieve, is said to be flaky if its least dimension is less than (A) 22.5 mm (B) 18.5 mm (C) 16.5 mm (D) 13.5 mm
Description : The best compromise between the increase of the length of a highway and reduction in its load carrying capacity, is the ruling gradient (A) 1 in 10 (B) 1 in 15 (C) 1 in 20 (D) 1 in 25
Description : If the radius of a simple curve is R, the length of the chord for calculating offsets by the method of chords produced, should not exceed. (A) R/10 (B) R/15 (C) R/20 (D) R/25
Last Answer : (C) R/20
Description : Keeping the instrument height as 1.5 m, length of staff 4 m, the slope of the ground as 1 in 10, the sight on the down-slope, must be less than (A) 30 m (B) 25 m (C) 20 m (D) 15 m
Last Answer : (B) 25 m
Description : Metric chains are generally available in (A) 10 m and 20 m length (B) 15 m and 20 m length (C) 20 m and 30 m length (D) 25 m and 100 m length
Last Answer : (C) 20 m and 30 m length
Description : A cylinder is said to be thin if the ratio of its thickness and diameter, is less than (A) 1/25 (B) 1/20 (C) 1/15 (D) 1/10
Last Answer : (D) 1/10
Description : For normal cases, stiffness of a simply supported beam is satisfied if the ratio of its span to its overall depth does not exceed (A) 10 (B) 15 (C) 20 (D) 25
Description : The ratio of the effective length of a column and minimum radius of gyration of its cross sectionalarea, is known (a) Buckling factor (b) Slenderness ratio (c) Crippling factor (d) None of these
Last Answer : (b) Slenderness ratio
Description : The stresses developed in concrete and steel in reinforced concrete beam 25 cm width and 70 cm effective depth, are 62.5 kg/cm2 and 250 kg/cm2 respectively. If m = 15, the depth of its neutral axis is (A) 20 cm (B) 25 cm (C) 30 cm (D) 35 cm
Description : The preliminary test is repeated if the difference of compressive strength of three test specimens, exceeds (A) 5 kg/cm2 (B) 8 kg/cm2 (C) 10 kg/cm2 (D) 15 kg/cm2
Description : For a comfortable travel on Highways, the centrifugal ratio should not exceed (A) 0.10 (B) 0.15 (C) 0.20 (D) 0.25
Description : A raft foundation is provided if its area exceeds the plan area of the building by (A) 10 % (B) 20 % (C) 40 % (D) 50 %
Description : If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than (A) 4 mm (B) 5 mm (C) 6 mm (D) 8 mm
Description : The purpose of lateral ties in short R.C. columns is to (a) Increase the load carrying capacity of column (b) Facilitate compaction of concrete (c) Facilitate construction (d) Avoid buckling of longitudinal bars
Last Answer : (d) Avoid buckling of longitudinal bars
Description : Slenderness ratio of a long column, is (A) Area of cross-section divided by radius of gyration (B) Area of cross-section divided by least radius of gyration (C) Radius of gyration divided by area of cross-section (D) Length of column divided by least radius of gyration
Last Answer : (D) Length of column divided by least radius of gyration
Description : The effective length of a R.C column continuing through two storeys, properly restrained at both ends in position and direction, is (a) 0.50 L (b) 0.75 L (c) L (d) 2 L
Last Answer : (b) 0.75 L
Description : The Effective length of a column is defined as the [ A ] length between the fixed joints [ B ] length between the points of contra flexure [ C ] unsupported length of the column [ D ] Both (a) and (c)
Last Answer : [ B ] length between the points of contra flexure
Description : The batting average for 20 innings of a cricketer is 25 runs. His highest score exceeds his lowest score by 86 runs. If these two innings are excluded, the average of the remaining 18 innings is 22runs. Find out the highest score of the player. A) 85 B) 90 C) 95 D) 100
Last Answer : C) Total runs scored by the player in 20 innings = 20*25 Total runs scored by the player in 18 innings after excluding two innings = 18 22 Sum of the scores of the excluded innings = 20 25 - 18 22 = 104 Given that ... Now x + 86 + x = 104 => 2x = 18 then x = 9 Highest score = 9+ 86 = 95
Description : A batsman average for 20 innings is 25 runs. His highest score exceeds his lowest score by 64 runs. If these 2 innings are excluded, the average of the remaining 18 innings is 24 runs. The highest score of the player is. A) 66 B) 72 C) 77 D) 88
Last Answer : A) Let the highest score be ‘x’ Then lowest score = x-64 Then (25 *20)- 18 * 24 = 432 X+X-64=68 X=66
Description : If the radius of a simple curve is 600 m, the maximum length of the chord for calculating offsets, is taken (A) 15 m (B) 20 m (C) 25 m (D) 30 m
Last Answer : (D) 30 m
Description : Two columns 50 cm 50 cm and 60 cm 60 cm carry 80 tonnes and 120 tonnes of loads respectively. The centre to centre distance between columns is 5.00 metres. The permissible bearing capacity of the soil is 20 t ... the foundation slab = 7.00 m (C) Area of footing slab = 11.00 m2 (D) All the above
Last Answer : Option D
Description : The diameter of the column head support a flat slab, is generally kept (A) 0.25 times the span length (B) 0.25 times the diameter of the column (C) 4.0 cm larger than the diameter of the column (D) 5.0 cm larger than the diameter of the column
Last Answer : Option A
Description : For a non-spherical particle, the sphericity (A) Is defined as the ratio of surface area of a sphere having the same volume as the particle to the actual surface area of the particle (B) Has ... of volume of a sphere having the same surface area as the particle to the actual volume of the particle
Last Answer : (A) Is defined as the ratio of surface area of a sphere having the same volume as the particle to the actual surface area of the particle
Description : For a given material Young's modulus is 200 GN/m2 and modulus of rigidity is 80 GN/m2 . The value of Poisson's ratio is (A) 0.15 (B) 0.20 (C) 0.25 (D) 0.30
Last Answer : (C) 0.25
Description : When a column is supported throughout its length either by masonry walls or by construction on all the sides, then its slenderness ratio is (a) Infinite (b) Zero (c ) Reasonably high (d) Low
Last Answer : (b) Zero
Description : The eccentricity (e) of a hollow circular column, external diameter 25 cm, internal diameter 15 cm for an eccentric load 100 t for non-development of tension, is (A) 2.75 cm (B) 3.00 cm (C) 3.50 cm (D) 4.25 cm
Last Answer : (D) 4.25 cm
Description : The height of a water column equivalent to a pressure of 0.15 MPa is (A) 15.3 m (B) 25.3 m (C) 35.3 m (D) 45.3 m
Last Answer : The height of a water column equivalent to a pressure of 0.15 MPa can be calculated using the hydrostatic equation: Pressure (P) = Density of water (rho) * Acceleration due to gravity (g) * Height (h) ... s^2) = 0.15 m Therefore, the height of the water column would be approximately 0.15 meters.