Description : Operation of blast furnace stove is based on the principles of a __________ furnace. (A) Regenerative (B) Recuperative (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (A) Regenerative
Description : Tank furnace used for melting of glass is made of (A) Mild steel (B) Cast iron (C) Refractory blocks (D) Stainless steel
Last Answer : (C) Refractory blocks
Description : Salt is the basic raw material for the manufacture of (A) Cement (B) Glass (C) Potteries (D) Caustic soda
Last Answer : (D) Caustic soda
Description : Large tonnage of refractory bricks are dried in a (A) Shaft furnace (B) Rotary hearth furnace (C) Tunnel kiln (D) Muffle furnace
Last Answer : (C) Tunnel kiln
Description : Refractory bricks having high thermal conductivity is desirable, when it is to be used in the (A) L.D. converter (B) Blast furnace (C) Rotary kiln (D) Recuperator
Last Answer : (D) Recuperator
Description : Types of waste heat exchanger are: a) Regenerative and recuperative burners b) Economizers c) Waste heat boilers d) All of the above
Last Answer : All of the above
Description : Which of the following is the most widely used heat insulating material for pipelines carrying steam? (A) Tar dolomite bricks followed by asbestos (B) Fireclay refractory followed by aluminium sheet (C) Cotton followed by aluminium foil (D) 85% magnesia cement and glass wool
Last Answer : (D) 85% magnesia cement and glass wool
Description : Rotary driers are generally made of (A) Cast iron (B) Mild steel (C) High silicon iron (14% Si) (D) Tin lined with refractory bricks
Last Answer : (B) Mild steel
Description : Sulphuric acid is mixed with ground phosphate rock (to produce phosphoric acid) in a steel digestor lined with (A) Acidic refractory (B) Rubber (C) Karbate (D) Lead or acid proof bricks
Last Answer : (A) Acidic refractory
Description : Sulphuric acid is mixed with ground phosphate rock (to produce phosphoric acid) in a steel digestor lined with (A) Acidic refractory (B) Rubber (C) Karbate (D) Lead or acid-proof bricks
Last Answer : (D) Lead or acid-proof bricks
Description : An example of recuperative furnace is the (A) Soaking pit (B) Open hearth furnace (C) Coke ovens (D) None of these
Last Answer : (A) Soaking pit
Description : Which of the following is not a recuperative furnace? (A) Soaking pit (B) Reheating furnace (C) Steam boiler (D) Coke oven
Last Answer : (D) Coke oven
Description : Urea autoclave is made of (A) Cast iron (B) Refractory blocks (C) Stainless steel (D) Lead lined steel
Last Answer : (C) Stainless steel
Description : SO3 is absorbed using H2SO4 in a (A) Cast iron packed tower (B) Stainless steel plate tower (C) Packed steel tower lined with acid proof bricks (D) None of these
Last Answer : (C) Packed steel tower lined with acid proof bricks
Description : In regenerative air preheater (as practised in heating of coke ovens), the heat is transferred (A) Through a metallic wall (B) By direct contact of hot flue gas with air (C) By ... material (like chequor bricks) and then heating the air from this hot material (D) None of these
Last Answer : (C) By heating an intermediate material (like chequor bricks) and then heating the air from this hot material
Description : Refractory bricks are usually dried in a __________ dryer. (A) Tray (B) Tunnel (C) Conveyor (D) Festoon
Last Answer : (B) Tunnel
Description : Absorptivity of a perfect black body is unity. Which of the following has maximum absorptivity? (A) Aluminium foil (B) Refractory bricks (C) Iron plate (D) Coke breeze
Last Answer : (D) Coke breeze
Description : Which of the following has the minimum absorptivity? (A) Aluminium foil (B) Coal dust (C) Refractory bricks (D) Iron plates
Last Answer : (A) Aluminium foil
Description : Highly porous refractory bricks are (A) Less susceptible to chemical attack by molten fluxes and gases etc (B) Very strong (C) Having very high thermal conductivity (D) None of these
Last Answer : (D) None of these
Description : Refractory bricks burnt at very high temperature have got (A) Greater resistance to corrosion by slags (B) Less resistance to corrosion by slags (C) High spalling tendency (D) None of these
Last Answer : (A) Greater resistance to corrosion by slags
Description : Pebble mills are tumbling mills widely used for grinding in the manufacture of paints & pigments and cosmetic industries, where iron contamination in the product is highly objectionable. Pebbles used in pebble mill are made of (A) Bronze (B) Stainless steel (C) Flint or porcelain (D) Concrete
Last Answer : (C) Flint or porcelain
Description : In the Contact process of sulphuric acid manufacture, 98% acid cooler is made of (A) Stainless steel (B) Cast iron (C) Lead lined steel (D) Rubber lined steel
Last Answer : (B) Cast iron
Description : In the Kraft (sulphate) process for the paper manufacture, the digestor is made of (A) Cast iron (B) Stainless steel (C) Karbate carbon (D) Wrought iron
Last Answer : (B) Stainless steel
Description : Refractory bricks are used for (A) Retaining walls (B) Columns (C) Piers (D) Combustion chambers
Last Answer : Answer: Option D
Description : Refractory bricks are (A) Neutral refractory bricks (B) Acid refractory bricks (C) Basic refractory bricks (D) All the above
Description : Refractory bricks resist (A) High temperature (B) Chemical action (C) Dampness (D) All the above
Last Answer : Answer: Option A
Description : Which of the following bricks are used for lining of furnaces? (A) Over-burnt bricks (B) Under-burnt bricks (C) Refractory bricks (D) First class bricks
Last Answer : Answer: Option C
Description : Which is a regenerative furnace? (A) Coke oven heating chamber (B) Open hearth furnace (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) and (B)
Description : Out of the following, maximum temperature drop for a given heat flow & for the same thickness will be in the case of (A) Steel (B) Glass wood (C) Copper (D) Fireclay bricks
Last Answer : B) Glass wood
Description : Is it safe to use a stainless steel pot if I boiled water until it was dry and left it on the burner for a while?
Last Answer : It should be fine. If your roommate is really that worried, though, put one cup of water and one cup of vinegar into the pot, boil the mixture for about 15 minutes, then wash the pot thoroughly ... quite unnecessary if there isn't any residue, but it will get rid of anything you may have overlooked.
Description : Where can I buy a stainless steel stock pot in Spokane, Washington?
Last Answer : You can always look online, but if you need it right now then try the local Target. Walmart is another place to find a cheap stock pot that may last for about a year. The best bet is the Williams- ... it may cost a little more then you wanted to spend, but you will receive great results out of it.
Description : What's the best way to clean a stainless steel crock pot?
Last Answer : The best way to clean a stainless steel crock pot is to just hand wash it with dish soap and a soft cloth. You can soak it in bleach to make sure all of germs are out of it, but make sure you wrinse it off with water afterwards.
Description : The substances used in the manufacture of stainless steel are 1. Chromium 2. Iron 3. Copper 4. Steel The correct answers are: (a) 1 and 4 (b) 1, 2, 3 and 4 (c) 2, 3 and 4 (d) 1, 2 and 4
Last Answer : Ans:(a)
Description : For the manufacture of stainless steel, steel is mixed with (A) Chromium (B) Nickel (C) Tungsten (D) None of these
Description : The steel used for the manufacture of rails, is (A) Bessemer steel (B) Mild steel (C) Cast steel (D) Stainless steel
Description : Which of the following are alloying materials used the manufacture of stainless steel? w) Limestone and carbon x) Calcium oxide and oxygen y) Oxygen and sulfur dioxide z) Chromium and nickel
Last Answer : ANSWER: Z -- CHROMIUM AND NICKEL
Description : Inhalation of silica dust by human being during hand drilling in mica mining, lead & zinc mining, silica refractory manufacture and in foundries causes (A) Asphyxiation (suffocation) (B) Shortness of breath (C) Tuberculosis (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : A refractory wall separating the stock and the source of heat is provided in a (A) Updraft kiln (B) Muffle furnace (C) Continuous furnace (D) None of these
Last Answer : (B) Muffle furnace
Description : Ceramic coating material for furnace refractory, which increases itsemissivity and thus the radiation heat transfer rate in the furnace, comprises of (A) Graphite powder (B) Thoria (C) Zircon powder (D) Beryllium
Last Answer : (C) Zircon powder
Description : Heat transfer rate to the charge/stock in a furnace does not depend upon the (A) Type of fuels viz. solid, liquid or gaseous (B) Flue gas temperature (C) Emissivity of refractory walls (D) Initial temperature of the charged stock
Last Answer : (A) Type of fuels viz. solid, liquid or gaseous
Description : Heat transfer rate to the stock/charge in the furnace does not depend upon the (A) Emissivity of the refractory walls (B) Size of the furnace (C) Use of waste heat recovery equipments (D) Thickness of the stock
Last Answer : (C) Use of waste heat recovery equipments
Description : Test specimen for determination of refractoriness under load (RUL) of a refractory is heated in a (A) Furnace employing neutral atmosphere (B) Carbon resistance furnace (C) Reducing atmosphere (D) Furnace employing negative pressure
Last Answer : (B) Carbon resistance furnace
Description : A coal with high ash content is undesirable, as (A) It is abrasive to the coal pulveriser (i.e. ball mill) and the combustion chamber (B) The ash in molten condition gets absorbed in the pores of the ... and stick to the boiler tubes thereby reducing the heat transfer (D) All (A), (B) and (C)
Description : A furnace is made of a refractory brick wall of thickness 0.5 metre and thermal conductivity 0.7 W/m.°K For the same temperature drop and heat loss, this refractory wall can be replaced by a layer of diatomaceous earth of ... and thickness __________ metre. (A) 0.01 (B) 0.1 (C) 0.25 (D) 0.5
Last Answer : (B) 0.1
Description : Most of the phosphorous present in the blast furnace burden enters into (A) Hot metal (B) Flue gases (C) Slag (D) Refractory lining
Last Answer : (A) Hot metal
Description : The refractory lining of the bottom in a basic electric arc furnace is made of (A) Silica (B) Alumina (C) Magnesia (D) Fireclay
Last Answer : Option C
Description : Ceramics are produced from silicates or clayish materials: Which of the following is not a ceramic material? (A) Slag cement (B) Glasses (C) Porcelain/Potteries (D) Teflon
Last Answer : (D) Teflon
Description : DDT is shipped in (A) Stainless steel containers (B) Paper bags (C) Fibre drums (D) Either (B) or (C
Last Answer : (D) Either (B) or (C
Description : Which of the following is not used as a filter medium in case of corrosive liquids? (A) Nylon (B) Glass cloth (C) Metal cloth of monel or stainless steel (D) Cotton fabric
Last Answer : (D) Cotton fabric
Description : H2SO4 (< 50% concentration) is corrosive to (A) Aluminium, mild steel, stainless steel, concrete & tin (B) Copper, cast iron & high silicon iron (14% Si) (C) Rubber (butyl and hard), silicone rubber & Teflon (D) Glass, graphite, porcelain & stoneware
Last Answer : (A) Aluminium, mild steel, stainless steel, concrete & tin