Description : A 1 Mhz carrier is amplitude modulated by a pure 200-Hz audio test tone. Which of the following combinations of frequencies represent the total content of the AM signal? A. 1 MHz and 200 Hz B. 1 MHz and 1000.2 kHz C. 999.8 kHz, 1000 kHz, and 1000.2 kHz D. 999.8 kHz and 1000.2 kHz
Last Answer : C. 999.8 kHz, 1000 kHz, and 1000.2 kHz
Description : Extra-terrestrial noise is observable at frequencies from A. 0 to 20 KHz B. Above 2 GHz C. 8 to 1.43 GHz D. 5 to 8 GHz
Last Answer : C. 8 to 1.43 GHz
Description : The length of a Marconi antenna to operate with 985 kHz is ______. A. 200 ft B. 500 ft C. 250 ft D. 999 ft
Last Answer : C. 250 ft
Description : Industrial noise frequency is between _________. A. 200 to 3000 Mhz B. 15 to 160 Mhz C. 0 to 10 Khz D. 20 Ghz
Last Answer : B. 15 to 160 Mhz
Description : Atmospheric noise becomes less severe at frequencies A. above 30 MHz B. below 30 MHz C. above 3000 kHz D. below 3000kHz
Last Answer : A. above 30 MHz
Description : Which of the following frequencies is normally used for distress and safety communications? A. 4209.5 kHz B. 490 kHz C. 518 kHz D. 2174.5 kHz
Last Answer : D. 2174.5 kHz
Description : What is the channel spacing for SITOR frequencies? A. 500 Hz B. 170 Hz C. 300 Hz D. 3 kHz
Last Answer : A. 500 Hz
Description : What is the channel spacing for MF-HF voice frequencies? A. 2.8 kHz B. 500 Hz C. 3.5 kHz D. 3 kHz
Last Answer : D. 3 kHz
Description : The band of frequencies least susceptible to atmospheric noise and interference is: A. 30 – 300 kHz B. 300 – 3000 kHz C. 3 – 30 MHz D. 300 – 3000 MHz
Last Answer : D. 300 – 3000 MHz
Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone
Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz
Description : What range of frequencies are usually referred to as audio frequencies for humans? w) 0 to 20 Hertz x) 20 to 20,000 Hertz y) 200 to 200,000 Hertz z) 10,000 to 30,000 Hertz
Last Answer : ANSWER: X -- 20 TO 20,000 HERTZ
Description : The international radio consultative committee is referred to in international radio communication as ______. A. IRCC B. ITU C. IRR D. CCIR
Last Answer : D. CCIR
Description : Fiber optic cable operates near _______ frequencies. A. 800 THz B. 20 MHz C. 200 MHz D. 2 GHz
Last Answer : A. 800 THz
Description : Industrial noise frequency is between _____. A. 0 to 10 KHz B. 160 MHz to 200 MHz C. 15 to 160 MHz D. 200 to 3000 MHz
Last Answer : C. 15 to 160 MHz
Description : What is the approximate bandwidth of an FM system with 10 kHz of modulating frequency and a 150 kHz of frequency deviation? A. 300 kHz B. 320 kHz C. 150 kHz D. 200 kHz
Last Answer : B. 320 kHz
Description : kilohertz (kHz) is a unit which measures? A. Power used by a current of one ampere B. Electromagnetic radio wave frequencies (Answer) C. Voltage D. Electric resistance
Last Answer : B. Electromagnetic radio wave frequencies (Answer)
Description : The extremely high frequency (EHF) band is in the radio spectrum range of _______. A. 30 to 300 kHz B. 30 to 300 GHz C. 3 to 30 MHz D. 3 to 30 GHz
Last Answer : B. 30 to 300 GHz
Description : High quality music only needs frequencies up to A. 10 Hz B. 15 Hz C. 20 kHz D. 15 kHz
Last Answer : D. 15 kHz
Description : An amplifier operating over the frequency range of 455 to 460 kHz has a 200 kΩ input resistor. What is the RMS noise voltage at the input to this amplifier if the ambient temperature is 17˚C ? A. 40 µV B. 4.0 µV C. 400 µV
Last Answer : B. 4.0 µV
Description : In acoustics, if the volume of the room is 200 m3 then at what frequency the coefficient of absorption is measured? A. 120 kHz B. 120 Hz C. 100 Hz D. 150 Hz
Last Answer : B. 120 Hz
Description : What is the typical frequency used for communicating to submerged submarines? A. 100 Hz B. 500 Hz C. 4 kHz D. 200 Hz
Last Answer : A. 100 Hz
Description : How wide is the spectrum bandwidth of a single GSM carrier? A. 100 kHz B. 200 kHz C. 50 kHz D. 16 kHz
Last Answer : B. 200 kHz
Description : The Federal Communications Commission (FCC) allows ______ kHz for each FM station. A) 20 B) 100 C) 200 D) none of the above
Last Answer : 100
Description : For a sample rate of 40 kHz, determine the maximum analog input frequency A. 30 kHz B. 40 kHz C. 20 kHz D. 10 kHz
Last Answer : C. 20 kHz
Description : In cellular system, _____ defines the geographic distance that is required between cells using identical frequencies in order to avoid interference between the radio transmissions at these cells. A. frequency-reuse ratio B. distance-to-reuse ratio (D/R) C. reuse format plan ratio D. reuse factor
Last Answer : B. distance-to-reuse ratio (D/R)
Description : What device measures the angle between two radio frequencies and also the direction of propagation of a wave? A. Densimeter B. Absorption wavemeter C. Goniometer D. Ergometer
Last Answer : C. Goniometer
Description : Which of the following is designated as the international distress, safety and calling frequency for radio telephony for stations of the maritime mobile service when using frequencies in the authorized bands between 156 and 174 MHz? A. 165.8 MHz B. 156.8 MHz C. 158.6 MHz D. 168.5 MHz
Last Answer : B. 156.8 MHz
Description : The frequency tolerance of an AM radio broadcast station A. 200 Hz B. 2000 Hz C. 20 Hz D. 2 Hz
Last Answer : C. 20 Hz
Description : The noise output of a resistor is amplified by a noiseless amplifier having a gain of 60 and a bandwidth of 20 kHz. A meter connected at the output of the amplifier reads 1mV RMS. If the bandwidth of the amplifier is reduced to ... does the meter read now? A. 0.5 mV B. 0.5 µV C. 5.0 mV D. 5.0 µV
Last Answer : A. 0.5 mV
Description : Nominal voice channel A. 20 to 20 KHz B. 16 to 16 KHz C. 3 to 3 KHz D. 4 KHz
Last Answer : D. 4 KHz
Description : Which of the following is referred to as a radio emission without sidebands A. Analog B. Carrier C. Data D. Voice
Last Answer : B. Carrier
Description : Referred to as the stage in the radio receiver that contributes most of the noise. A. IF amplifier B. Supply stage C. Speaker D. Mixer
Last Answer : D. Mixer
Description : Referred by radio regulation as the station in the mobile service not intended to be used while in motion. A. Fixed station B. Base station C. Land station D. Coast station
Last Answer : C. Land station
Description : Referred to as an average power from the radio transmitter supplied to the antenna transmission line taken during one radio frequency cycle under no modulation. A. Carrier power B. Rated power C. Peak envelop power D. Mean power
Last Answer : A. Carrier power
Description : This is referred to as a fixed radio station that broadcasts program material from studio to transmitter by radio link. A. Aural BC intercity relay B. Aural broadcast STL C. Shortwave station D. Remote-pickup
Last Answer : B. Aural broadcast STL
Description : Atmospheric noise or static is not a great problem A. at frequencies below 20 MHz B. at frequencies below 5 MHz C. at frequencies above 30 MHz D. at frequencies above 1 MHz
Last Answer : C. at frequencies above 30 MHz
Description : In amplitude modulation technique the unmodulated carrier is referred to as having ______. A. 100% modulation B. 0% modulation C. 50% modulated D. Over modulated
Last Answer : B. 0% modulation
Description : Modem is referred to as ______. A. Universal asynchronous Rx/Tx B. Data communication equipment C. Universal synchronous Rx/Tx D. Data terminal equipment
Last Answer : B. Data communication equipment
Description : What is the carrier frequency of supergroup 10? A. 2724 kHz B. 2356 kHz C. 2108 kHz D. 3100 kHz
Last Answer : D. 3100 kHz
Description : What frequency is 10 octaves above 30 Hz? A. 30.72 kHz B. 30 kHz C. 300 Hz D. 307.2 kHz
Last Answer : A. 30.72 kHz
Description : For AM, fc =500kHz , fm = 5 kHz Determine: (i) Upper and lower sideband frequencies (ii) Bandwidth
Last Answer : Given data fc = 500KHz , fm = 5KHz USB =fc+fm USB = 500+5 =505 KHz. LSB =fc – fm LSB = 500 – 5 =495 KHz Bandwidth = 2fm . = 2* 5 =10 KHz
Description : A radio station is broadcasting at 3750 khz (kilohertz). This station would be found in which radio band? w) 20 meter x) 40 meter y) 80 meter z) 160 meter
Last Answer : ANSWER: Y -- 80 METER
Description : The conversion of digital signal into analog for purposes of transmitting into the telephone line is done through ______. A. ISDN B. Radio C. RS232C D. Modem
Last Answer : D. Modem
Description : In radio regulation, the first symbol in the designation of radio emission is ______. A. Bandwidth B. Nature of signal(s) modulation the main carrier C. Type of modulation of the main carrier D. Type of information to be transmitted
Last Answer : C. Type of modulation of the main carrier
Description : In radio High frequency communications the higher the radio frequency the ______. A. Higher it can reach B. Shorter it can reach C. Effect is null D. Longer it can reach
Last Answer : D. Longer it can reach
Description : Atmospheric noise is less at severe frequencies above A. Audio level B. 30 MHz C. 10 GHz D. 1 GHz
Last Answer : B. 30 MHz
Description : A Hertz antenna is operating on a frequency of 2182 kHz and consists of a horizontal wire that is hanged between two towers. What is the frequency of its third harmonic? A. 727 kHz B. 6546 kHz C. 436 kHz D. 6.546 kHz
Last Answer : B. 6546 kHz
Description : At what power level does a 1 KHz tone cause zero interference (144 weighted)? A. 90 dB B. 90 dBm C. -90 dBm D. -90 dBm
Last Answer : D. -90 dBm
Description : What is the spectrum of stereophonic FM signal? A. 19 to 38 kHz B. 30 to 53 kHz C. 59.5 to 74.5 kHz D. 88 to 108 MHz
Last Answer : B. 30 to 53 kHz
Description : What is the spectrum range of U600 mastergroup? A. 60 – 108 kHz B. 564 – 3084 kHz C. 312 – 552 kHz D. 60 -2788 kHz
Last Answer : B. 564 – 3084 kHz