How to detect damp electrodes?

1 Answer

Answer :

Pre dry unusually damp electrodes for 30 - 45 minutes before final drying to minimize cracking of the coating that format.

Related questions

Description : How to dry out a damp carpet without a heater?

Last Answer : Do you have a large fan? And I wouldn’t reccomend salt. Maybe baking soda? Then carpet steam wash it.

Description : High finish walnut table has white marks from damp fruit bowl. Any suggestions on how to remove them?

Last Answer : Oddly, one trick is to cut a walnut in half and rub over the white ring. It can be used for woods other than walnut. Another trick is to find a crayon that matches finish and rub in, then buff. Neither will have a high finish but might make table look better.

Description : What is more wet? Damp or Moist?

Last Answer : answer:MOIST.

Description : i have a area in flower bed that stays damp, what grows well in this area?

Last Answer : Need Answer

Description : my fuschia is becomming dry and brittle but soil is damp and it hangs in shade

Last Answer : Need Answer

Description : houseplant that likes damp soil

Last Answer : Need Answer

Description : Can I pick green when the plants are damp or does that cause the vine to rust?

Last Answer : We don't handle the plants when they are wet.....they leaves turn....and they die off up here.

Description : My first is high, My second damp, My whole a tie, A writer's cramp. What am I? -Riddles

Last Answer : Hyphen. The first two lines yield high-fen. A hyphen is used by a writer to tie (or cramp) two words together.

Description : What to do if wet feet fall on dry place of urine ? My niece who is 02 years old. Pisses on the floor of the house. I wiped the place well with a damp cloth twice and then dried in the fan ... I have prayed without washing my feet. Has my prayer been valid ? Was it important to wash your feet ?

Last Answer : : In the case in question, your prayer is valid. Wet feet do not make your feet unclean. This is because after wiping the floor, it dries up and the effects of impurity disappear. (Musannaf Ibn Abi Shaybah 1/431 ; Nasbur Raya 1/26 ; Elaus Sunan 1/398 ; Fatawa Khaniya 1/25 ; Khulasatul Fatawa 1/42)

Description : I have a lot of wood for the stove but it is very wet. Is it possible to drown with him?

Last Answer : I would split dry wood and then add damp.

Description : Why is it difficult to build a fire with damp of wood?

Last Answer : The water has a tendency to evaporate if heated; this willquickly absorb any heat, and thus reduce the fire.

Description : What kind of protist is the mildew that commonly grows is damp areas?

Last Answer : slime mold

Description : What are the best metal storage get in a damp garage that do not rust?

Last Answer : The best metal storage involves a product with a tight lid and multiple containers. [email protected]

Description : Transpiration increases in – (1) Hot, thy and windy condition (2) Hot, damp and windy condition (3) Cool, damp and windy condition (4) Cool, dry and still condition

Last Answer : (1) Hot, thy and windy condition

Description : Damp clothes are dried in spin dryers by the action of – (1) centripetal forces (2) centrifugal forces (3) central forces (4) non central forces

Last Answer : (2) centrifugal forces Explanation: The spin dryer is probably the most familiar centrifuge. The spin dryer of a washing machine removes excess water from the clothing by rotating at a high speed. ... pulled to the outside of the spinning portion of the washing machine and away from the clothes.

Description : Damp armature windings in a D.C. motor may lead to ____________. A. reduced voltage B. reduced current C. increased resistance D. overheating

Last Answer : Answer: D

Description : Critical humidity of a solid salt means the humidity (A) Above which it will always become damp (B) Below which it will always stay dry (C) Both (A) and (B) (D) Above Which it will always become dry and below which it will always stay damp

Last Answer : (C) Both (A) and (B)

Description : The capacity of welded structures to damp vibrations is quite good. a) True b) False

Last Answer : b) False

Description : Pick out the wrong statement. (A) Bubble size increases with the dynamic viscosity of the liquid in case of nucleate pool boiling (B) Thermal conductivity of a dry material is more than ... in kg/hr in an evaporator (D) Vaporisation of organic substances in evaporator mostly causes foam formation

Last Answer : (B) Thermal conductivity of a dry material is more than that of the damp material

Description : Bryophytes are amphibians because (a) they require a layer of water for carrying out sexual reproduction (b) they occur in damp places (c) they are mostly aquatic (d) all the above.

Last Answer : (a) they require a layer of water for carrying out sexual reproduction

Description : Exposure to __________ accelerates the degradation of plastics. (A) Ultraviolet radiation (B) High atmospheric temperature (C) High ambient temperature (D) Damp atmosphere

Last Answer : A) Ultraviolet radiation

Description : The measurement is not made in square metres in case of (A) D.P.C. (Damp proof course) (B) Form works (C) Concrete Jeffries (D) R.C. Chhajja

Last Answer : (D) R.C. Chhajja

Description : Mastic asphalt is generally used for (A) Damp proof course (B) Water proof layer (C) Partition walls (D) Both (A) and (B

Last Answer : Answer: Option D

Description : Bitumen felt (A) Is used as water proofing material (B) Is used as damp proofing material (C) Is made from bitumen and hessian fibres (D) All the above

Last Answer : Answer: Option D

Description : Pick up the correct statement from the following: (A) The heating of a material to redness in contact with air, is known as calcination (B) The property of lime by which it sets or hardens in ... (C) The product that remains after calcination of limestone, is called lime (D) All the above

Last Answer : Answer: Option D

Description : Bitumen felt is used for (A) Water proofing (B) Damp proofing (C) Both (A) and (B) (D) Neither (A) nor (B)

Last Answer : Answer: Option C

Description : Pick up the incorrect statement from the following: (A) Horizontal D.P.C. is provided at plinth level in internal walls (B) D.P.C. is provided under door and verandah openings (C) Vertical D.P.C. is not provided in internal walls (D) Cement concrete is a rigid damp-proofing material

Last Answer : Answer: Option B

Description : In ordinary residential and public buildings, the damp proof course is generally provided at (A) Ground level (B) Plinth level (C) Water table level (D) Midway ground level and water-table level

Last Answer : Answer: Option B

Description : What are two methods used to damp a meter movement?

Last Answer : As the coil moves through the field of the permanent magnet, a current is induced in the coil opposing the movement of the coil; and a vane can be attached to the coil and placed in the airtight chamber so that the movement of the vane opposes the movement of the coil.

Description : Nurse Mercy is setting up for an emergency caesarian section. The linen packs were damp although these were just taken from the sterilizer. The nurse's appropriate action is A. Bring the linen packs back to the ... linen pack C. Open the linen pack and allow to dry D. Do not use the damp linen

Last Answer : D. Do not use the damp linen

Description : What is DPC? a) Damp proof course * b) weathering course c) Treatment the foundation d) Treatment over the roof

Last Answer : a) Damp proof course *

Description : State situations where sound insulating and damp proofing materials are used. 

Last Answer : Situations where sound insulating materials are used: 1) Glass, mineral wool mats, are used as sound insulators as solid inner layers underneath floors, 2) Wood fibre and asbestos cement slabs are used ... in toilet floors of upper story, so that no dampness will occur in slab below that floor.

Description : Transpiration increases in : (1) Hot, dry and windy condition (2) Hot, damp and windy condition (3) Cool, damp and windy condition (4) Cool, dry and still condition

Last Answer : Hot, dry and windy condition 

Description : Damp clothes are dried in spin dryers by the action of (1) centripetal forces (2) centrifugal forces (3) central forces (4) non central forces

Last Answer : centrifugal forces

Description : Suggest one type of materials for water proofing for the following situations. i. Rising dampness in building ii. Leakages in dam iii. Concrete continuously in wet or damp condition iv. Leakages in lavatory ,bathroom and kitchen floor v. Cracks on plastered surface vi. Cracks on roof surface

Last Answer : i. Flexible materials like butyl rubber, hot bitumen (asphalt), plastic sheets, bituminous felts, sheets of lead. ii. Liquid applied cementitious membranes iii. Liquid applied cementitious membranes ... v. Liquid applied cementitious membranes. vi. Brick bat coba, liquid applied bituminous membrane.

Description : When the sample of copper with the zinc impurity is to be purified by electrolysis, the appropriate electrodes are

Last Answer : When the sample of copper with the zinc impurity is to be purified by electrolysis, the appropriate electrodes ... "),("Pure Zinc","ImPure Zinc"):}`

Description : Brine is electrolysed by using inert electrodes. The reaction at anode is_______

Last Answer : Brine is electrolysed by using inert electrodes. The reaction at anode is_______ A. `Cl^(-)(aq.)rarr(1)/(2)Cl_(2) ... )H_(2)(g),E_("cell")^(o.)=0.00V`

Description : When the sample of Cu with Zn as impurity is to be purified by electrolysis, the appropriate electrodes are :

Last Answer : When the sample of Cu with Zn as impurity is to be purified by electrolysis, the appropriate electrodes are ... 4)","Impure zinc","Impure sample"):}`

Description : Brine is electrolysed by using inert electrodes. The reaction at anode is_______

Last Answer : Brine is electrolysed by using inert electrodes. The reaction at anode is_______ A. `Cl^(-)(aq)to(1)/(2)Cl_(2 ... 2)H_(2)(g), E_(Cell)^(otimes)=0.00V`

Description : In what situation might in be better to position the electrodes on the upper arm and the thighs rather than lower on the arms and legs?

Last Answer : Need answer

Description : What are the half-reactions for galvanic cell with Ni and Mg electrodes?

Last Answer : Ni2+(aq) + 2e- Ni(s) and Mg(s) Mg2+(aq) + 2e-

Description : What is oxidized in galvanic cell made with silver and nickel electrodes?

Last Answer : The nickel metal(apex)

Description : What is the voltage of an electrolytic cell copper and magnesium electrodes?

Last Answer : -2.71 V

Description : The movement of charged particles towards one of the electrodes under the influence of electrical current is (A) Gel filtration (B) Molecular sieving (C) Gas liquid chromatography (D) Electrophoresis

Last Answer : Answer : D

Description : Electrolysis of an aqueous solution of copper sulphate using copper electrodes gives (1) Copper at eathode and oxygen at anode. (2) Copper at anode and oxygen at cathode. (3) Copper at cathode and anodes dissolve to give copper. (4) Hydrogen at cathode and oxygen at anode.

Last Answer : (1) Copper at eathode and oxygen at anode. Explanation: Copper is deposited at the cathode and is dissolved at the anode. Consequently the concentration of copper ions in solution remains constant. This can be used as a method of purification of copper as only pure copper is deposited at the cathode

Description : Whic of the following pairs of materials serves as electrodes in chargeable batteries commonly used in devices such as torch lights, electric shavers, etc.? (1) Iron and cadmium (2) Nickel and cadmium (3) Lead peroxide and lead (4) Zinc and carbon

Last Answer : (2) Nickel and cadmium Explanation: A rechargeable battery, storage battery, or accumulator is a type of electrical battery. It comprises one or more electrochemical cells, and is a ... sizes, ranging from button cells to megawatt systems connected to stabilize an electrical distribution network.

Description : Substance used for making electrodes is?

Last Answer : Graphite

Description : Spark plugs, ignition tubes and electrodes are made of nickel __________ alloys. (A) Beryllium (B) Manganese (C) Copper (D) Iron

Last Answer : (B) Manganese

Description : What maintenance of earth electrodes should be done?

Last Answer : The neighbouring soil to the earth electrode shall be kept moist where necessary, by periodically pouring water through a pipe where fitted along with it or by pouring water in the immediate ... wherever available, shall be carried out to ensure their rigidity and other signs of deterioration.