Is thyristor a DC switch?

by

2 Answers

Answer :

Yes, Thyristor is a DC switch.

by

Answer :

Yes ,it is one of the main advantage using thristors as a  switch in DC  circuit ,it has a high current gain
by

Related questions

How is a thyristor used to convert AC to DC?

Description : How is a thyristor used to convert AC to DC?

Last Answer : thyristor

Thyristor can be protected from over voltages by using

Description : Thyristor can be protected from over voltages by using

Last Answer : Thyristor can be protected from over voltages by using Voltage clamping device

Leakage current flows through the thyristor in

Description : Leakage current flows through the thyristor in

Last Answer : Leakage current flows through the thyristor in Forward blocking mode and Reverse blocking mode.

What is meant by firing angle of thyristor?

Description : What is meant by firing angle of thyristor?

Last Answer : The point at which SCR is triggered is known as firings angle of thyristor.

Is a SCR a thyristor?

Description : Is a SCR a thyristor?

Last Answer : Yes, SCR is a thyristor. Thyristor is the family and SCR is the member of that family but SCR is universally known as thyristor.

Explain thyristor gate drive circuit.

Description : Explain thyristor gate drive circuit.

Last Answer : Thyristor Gate Drive Circuit: The thyristor can be turned on by pulse voltage signal at gate terminal and it does not require continuous drive signal like the transistor. The gate ... circuit provide required minimum gate voltage and gate current then the thyristor conducts properly.

parallel operation of mosfet can be done more easily as compared to thyristor. why?

Description : parallel operation of MOSFET can be done more easily as compared to thyristor. why?

Last Answer : Parallel operation of MOSFET can be done more easily as compared to thyristor because the resistance of MOSFET is increases with increase in temperature. MOSFET have the positive temperature coefficient. In ... the parallel operation of MOSFET can be done more easily as compared to the thyristor.

what are the disadvantages of thyristor?

Description : what are the disadvantages of thyristor?

Last Answer : Disadvantages of thyristor The silicon controlled rectifier (SCR) is unidirectional devices, so it can control power only in DC power during positive half cycle of AC supply. Thus only DC power is ... cycle. It cannot be used at higher frequencies. The gate current cannot be negative

write short notes on thyristor CSI .

Description : write short notes on thyristor CSI .

Last Answer : Current-source inverter (CSI) is an inverter with a DC current input. Current source inverters are most commonly used in very high power AC motor drives.

what is gate turn off thyristor (GTO)?

Description : Draw the structural diagram of GTO. Explain briefly the switching behavior of GTO with the help of appropriate voltage and current waveform.

Last Answer : Gate Turn Off Thyristor (GTO) Conventional Thyristor can be turned on with gate terminal but can not turn off from gate terminal. But in case of Gate Turn Off Thyristor (GTO), we can turn it on and off ... subdivided as storage period (Ts), fall period (Tp) and tail period (Tt).

The device which allows reverse power flow and withstands highest switch frequency is

Description : The device which allows reverse power flow and withstands highest switch frequency is (A) GTO (B) MOSFET (C) IGBT (D) Inverter grade SCR

Last Answer : The device which allows reverse power flow and withstands highest switch frequency is MOSFET

Is SCR unidirectional switch?

Last Answer : Yes, SCR is a unidirectional switch.

What are the desirable characteristics of ideal switch?

Description : What are the desirable characteristics of ideal switch?

Last Answer : Desirable characteristics of the ideal switch: It is desirable to have power switches characteristics closer to ideal switch. The ideal switch should have the following characteristics. Zero resistance when ... . 100% efficiency. Able to control power flow with zero power dissipation.

why IGBT is preferred as a power switch over both power BJT and MOSFET?

Last Answer : Because it has a higher switching frequency and heat tolerance.

Describe the working principle of Thyristor operated dimmer with the help of circuit diagram.

Description : Describe the working principle of Thyristor operated dimmer with the help of circuit diagram.

Last Answer : Thyristor operated dimmer: A popular thyristor operated dimmer circuit employ TRIAC-DIAC phase control for low AC power control. During each half-cycle, the capacitor charges through (R1+VR1). When the ... time constant {C (R1+VR1)}. Thus by reducing VR1 the lamp brightness can be increased.

What is mean by forced commutation of thyristor?

Last Answer : By using some circuit the forward DC current of thyristor is forced to zero is called forced commutation.

What is mean by natural commutation of thyristor?

Last Answer : Natural commutation is also called as line Communication. The turning off of thyristor due to AC supply is called natural commutation or line commutation. If the thyristor is connected to AC supply ... connected to positive and anode terminal get connected to negative, this turns off the thyristor.

can we turn off thyristor using Gate?

Last Answer : No we cannot turn off normal thyristor using Gate.

when a thyristor conducts?

Last Answer : Thyristor conducts when the anode voltage is greater than cathode and when the current provided to Gate.

thyristor have how many terminals?

Last Answer : Thyristor have three terminals anode, cathode and Gate.

thyristor can be turned off by?

Description : thyristor can be turned off by?

Last Answer : Thyristor can be turned off by making anode potential equal to cathode potential or by making anode potential less than cathode potential.

what is thyristor commutation?

Last Answer : Thyristor commutation means turning off thyristor.

why thyristor is called semi controlled device?

Last Answer : Thyristor can only be turned on by small gate pulse but it cannot be turn off by using gate hence thyristor is called semi controlled device.

why thyristor is called latching device?

Last Answer : Thyristor can be turn on by positive gate pulse and the current will continue to flow through the device even when the gate voltage is low hence thyristor is called latching device.

Thyristor Switched Capacitor (TSC)

Description : Thyristor Switched Capacitor (TSC)

Last Answer : Thyristor Switched Capacitor (TSC)  TSC is a static compensator. TSC is use for compensating reactive power. Compensation is required for voltage regulation, increasing stability, ... compensating device like TCS phase angle between voltage and current can be maintain.

Should I switch to a credit union?

Description : Should I switch to a credit union?

Last Answer : I switched from a bank to a credit union a long time ago. Competitive interest rates, fewer fees, easier loan approvals, better customer service.

How to Replace a Light Switch

Description : How to Replace a Light Switch

Last Answer : How to Replace a Light Switch They say it only takes one idiot to change a light bulb, but to change a light switch requires the skill and carefulness of a handyman. If you have a malfunctioning or a ... doesn't have to be a hassle. Just remember these steps and switching a new switch will be easy.

How to Install a Timer Switch

Description : How to Install a Timer Switch

Last Answer : How to Install a Timer Switch A timer switch is a handy device that automatically turns off a switch after a fixed period of time. This is particularly useful when you have kids at home ... safety precautions when installing switches or anything that might put you in the direct path of electricity.

How To Install A Dimmer Switch

Description : How To Install A Dimmer Switch

Last Answer : How To Install A Dimmer Switch Having a room with a bright light is good, but there are instances when you need the lights to be lower than what you're accustomed. You need to have a dimmer switch, ... your home. Follow them properly, and you'll be able to fiddle with the light levels in your home.

How to Wire a Three-Way Switch ?

Description : How to Wire a Three-Way Switch ?

Last Answer : How to Wire a Three-Way Switch A three-way switch is the most common system installed in residential areas. This system is used to control a light and receptacle or more from two different switches ... wires for interior use. #14 wires are suggested to be used for protected circuits at 15 amperes.

Draw & explain touch plate switch using IC555.

Description : Draw & explain touch plate switch using IC555.

Last Answer : It is construct form monostable multivibrator , when metal plates touch by finger then voltage at pin number 2 goes to below 1/3 Vcc then output of lower comparator becomes high hence flip flop set and ... then output of timer goes low and it low till up to the metal plates touch by finger .

Give the function of fuse and switch.

Description : Give the function of fuse and switch.

Last Answer : Functions of fuse:  * To break the circuit under fault condition.  * To provide overcurrent protection to the circuit.  * To provide short circuit protection to the circuit.  * To provide ...  * To make the electric circuit manually.  * To break the electric circuit manually.

State the function of : i) MCCB ii) ELCB iii) MCB iv) Switch.

Description : State the function of : i) MCCB ii) ELCB iii) MCB iv) Switch. 

Last Answer : i) MCB: Provide short circuit protection & over load protection to electrical loads.  ii) ELCB: Provides protection by detecting the unsafe magnitudes leakage currents flowing to earth and disconnecting ... rating.  iv) Switch: Make and break the electrical connection to the load manually.

Transfer switch

Description : Transfer switch

Last Answer : .embed-container { position: relative; padding-bottom: 56.25%; height: 0; overflow: hidden; max-width: 100%; } .embed-container iframe, .embed-container object, .embed-container embed { position: absolute; top: 0; left: 0; width: 100%; height: 100%; }

How rating of main switch and cable is selected for Industrial Installation.

Description : How rating of main switch and cable is selected for Industrial Installation.

Last Answer : 1. Rating of Main Switch or Fuse Rating is decided in industrial installation: Rating of main switch or fuse is based up the starting current of motor. For calculating starting current is considered 2 ... take 1.5 times the rated current or full load current. & thus cable rating is decided.

Earthing switch is used for?

Description : Earthing switch is used for?  (A) Measuring of safety voltage (B) Protection of equipment from ground faults (C) Discharging residual energies (D) All of the above 

Last Answer : Earthing switch is used for?  (A) Measuring of safety voltage (B) Protection of equipment from ground faults (C) Discharging residual energies (D) All of the above 

A switch tail ring counter is made by using a single D-FF. The resulting circuit is

Description : A switch tail ring counter is made by using a single D-FF. The resulting circuit is (A) T-FF (B) D-FF (C) SR-FF (D) JK-FF

Last Answer : A switch tail ring counter is made by using a single D-FF. The resulting circuit is T-FF

A closed switch has a resistance of?

Description : A closed switch has a resistance of?

Last Answer : A closed switch has a resistance of zero.

The switch board instruments?

Last Answer : The switch board instruments should be mounted in vertical position.

If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then?

Last Answer : If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then Electrolytic capacitor will, in all probability, suffer break down.

Centrifugal switch disconnects the auxiliary winding of the motor at about what percent of synchronous speed?

Last Answer : Centrifugal switch disconnects the auxiliary winding of the motor at about 70 to 80 percent of synchronous speed.

In a single phase motor the centrifugal switch?

Last Answer : In a single phase motor the centrifugal switch disconnects auxiliary winding of the motor.

A centrifugal switch is used to disconnect starting winding when motor has?

Last Answer : A centrifugal switch is used to disconnect starting winding when motor has picked up about 50 to 70 per cent of rated speed.

A thermal protection switch can protect against?

Last Answer : A thermal protection switch can protect against overload.

What is the difference between a switch and a relay?

Description : What is the difference between a switch and a relay?

Last Answer : Switch is simply a mechanical contact mechanism and relay is a electromagnetic switch . Switch can be direct mechanically turn on and off but relay can be operated by energising coil .

in which region BJT act as a switch?

Last Answer : BJT act as switch in saturation and  cutoff region ( ON state in saturation region and OFF state in cut-off region )

A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while

Description : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2 ... 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease

Last Answer : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would increase to a maximum value at α = 0.5 and then decrease

A 3 -phase, fully controlled, converter is feeding power into a DC load at a constant current of 150 A, the rms

Description : A 3 -phase, fully controlled, converter is feeding power into a DC load at a constant current of 150 A, the rms value of the current flowing through each thyristor of the converter is

Last Answer : Please show the solution for this question

Explain DC coupled drive circuit with unipolar output.

Description : Explain DC coupled drive circuit with unipolar output.

Last Answer : DC coupled drive circuit with unipolar output: The figure shows the circuit and waveforms

Can transformer convert AC to DC?

Description : Can transformer convert AC to DC?

Last Answer : No, Transformer cannot convert AC to DC.