CS stands for:
a. Cable select
b. Chip select
c. Control select
d. Cable system

1 Answer

Answer :

b. Chip select

Related questions

Description : When CS _____ the chip is not selected at all hence D7 to D0 are driven to high impedance state: a. High b. Low c. Medium d. Stand by

Last Answer : a. High

Description : Which statement is wrong according to linear decoding : a. Address map is not contiguous. b. Confects occur if two of the select lines become active at the same time c. If all unused address lines are not used as chip selectors then these unused lines become don’t cares d. None of these

Last Answer : d. None of these

Description : The ALU and control unit of most of the microcomputers are combined and manufacture on a single silicon chip. What is it called? a. monochip b. microprocessor c. ALU d. control unit

Last Answer : b. microprocessor

Description : In 8279 Status Word, data is read when ________ pins are low, and write to the display RAM with ____________ are low. a) A0, CS, RD & A0, WR, CS. b) CS, WR, A0 & A0, CS, RD c) A0, RD & WR, CS d) CS, RD & A0, CS.

Last Answer : c) A0, RD & WR, CS

Description : In 8279, a scanned sensor matrix mode, if a sensor changes its state, the ___ line goes ____ to interrupt the CPU. a) CS, high b) A0, high c) IRQ, high d) STB, high

Last Answer : c) IRQ, high

Description : MOS stands for: a. Metal oxide semiconductor b. Memory oxide semiconductor c. Metal oxide select d. None of these

Last Answer : a. Metal oxide semiconductor

Description : The DMA controllers are special hardware embedded into the chip in modern integrate processor that ____and_____ to the system; a. Data transfer b. arbitrate access c. Both A and B d. None of these

Last Answer : c. Both A and B

Description : How many address lines in a 4096 x 8 EPROM CHIP?

Last Answer : 12 address lines.

Description : The growth of SSI up to____: a. 100 device on a chip b. 200 device on a chip c. 300 device on a chip d. 400 device on a chip

Last Answer : a. 100 device on a chip

Description : Microprocessor is fabricated on single chip using: a. MOS b. ALU c. CPU d. All of these

Last Answer : a. MOS

Description : How many address lines are needed to address each memory locations in a 2048 x 4 memory chip? a. 10 b. 11 c. 8 d. 12

Last Answer : b. 11

Description : Where does a computer add and compare data? a. Hard disk b. Floppy disk c. CPU chip d. Memory chip

Last Answer : c. CPU chip

Description : What generation chip is the Pentium 4 for the Intel central processing units? A. Seventh generation B.Eighth generation

Last Answer : A. Seventh generation

Description : An integrated circuit is a. A complicated circuit b. An integrating device c. Much costlier than a single transistor d. Fabricated on a tiny silicon chip

Last Answer : d. Fabricated on a tiny silicon chip

Description : How many address lines are needed to address each memory location in a 2048 x 4 memory chip? a. 10 b. 11 c. 8 d. 12

Last Answer : b. 11

Description : A plastic card similar to a credit card but having some memory and a microprocessor embedded within it is a. Punched paper tape b. Chip card c. Card punch

Last Answer : a. Punched paper tape

Description : An error in computer data is called a. Chip b. Bug c. CPU d. Storage device

Last Answer : b. Bug

Description : The two major types of computer chips are a. External memory chip b. Primary memory chip c. Microprocessor chip d. Both b and c

Last Answer : d. Both b and c

Description : What was the name of the first commercially available microprocessor chip? a. Intel 308 b. Intel 33 c. Intel 4004 d. Motorola 639

Last Answer : c. Intel 4004

Description : In which year was chip used inside the computer for the first time? a. 1964 b. 1975 c. 1999 d. 1944

Last Answer : b. 1975

Description : The magnetic storage chip used to provide non-volatile direct access storage of data and that have no moving parts are known as a. Magnetic core memory b. Magnetic tape memory c. Magnetic disk memory d. Magnetic bubble memory

Last Answer : a. Magnetic core memory

Description : The instructions for starting the computer are house on a. Random access memory b. CD-Rom c. Read only memory chip

Last Answer : c. Read only memory chip

Description : An integrated circuit is a. A complicated circuit b. An integrating device c. Much costlier than a single transistor d. Fabricated on a tiny silicon chip

Last Answer : d. Fabricated on a tiny silicon chip

Description : how many address lines are needed to address each machine location in a 2048 x 4 memory chip? a. 10 b. 11 c. 8 d. 12

Last Answer : b. 11

Description : The external device is connected to a pin called the ______ pin on the processor chip. a. Interrupt b. Transfer c. Both d. None of these

Last Answer : a. Interrupt

Description : The capacity of this chip is 1KB they are organized in the form of 1024 words with 8 bit word The what is the site of address bus: a. 8 bit b. 10 bit c. 12 bit d. 16 bit

Last Answer : b. 10 bit

Description : _____ a subsystem that transfer data between computer components inside a computer or between computer: a. Chip b. Register c. Processor d. Bus

Last Answer : d. Bus

Description : Which technology using the microprocessor is fabricated on a single chip: a. POS b. MOS c. ALU d. ABM

Last Answer : b. MOS

Description : The SP is of ___ wide register. And this may be defined anywhere in the ______. a) 8 byte, on-chip 128 byte RAM. b) 8 bit, on chip 256 byte RAM. c) 16 bit,

Last Answer : a) 8 byte, on-chip 128 byte RAM.

Description : ROM d) 8 bit, on chip 128 byte RAM. 3. After reset, SP register is initialized to address________. a) 8H b) 9H c) 7H d) 6H

Last Answer : c) 7H

Description : A microprocessor is a _______ chip integrating all the functions of a CPU of a computer.  A. multiple B. single C. double D. triple

Last Answer : A microprocessor is a single chip integrating all the functions of a CPU of a computer.

Description : In 8096, CCB bit 3 is ____. a) write strobe mode select b) address valid strobe select c) bus width select d) Internal read control mode

Last Answer : c) bus width select

Description : In 8096, CCB bit 3 is ____. a) write strobe mode select b) address valid strobe select c) bus width select d) Internal read control mode

Last Answer : b) address valid strobe select

Description : RISC stands for: a. Reduced Instruction Set Computer b. Reduced Intergraded Set Computer c. Resource Instruction Set Computer d. Resource Instruction System Computer

Last Answer : a. Reduced Instruction Set Computer

Description : CISC stands for: a. Complex Instruction System Computer b. Complex Instruction Set Car c. Complex Instruction Set Computer d. None of these

Last Answer : c. Complex Instruction Set Computer

Description : MSI stands for a. Medium Scale Integrated Circuits b. Medium System Integrated Circuits c. Medium Scale Intelligent Circuit d. Medium System Intelligent Circuit

Last Answer : b. Medium System Integrated Circuits

Description : CISC stands for: a. Complex instruction set computer b. Camper instruct set of computer c. Compared instruction set computer d. None of these

Last Answer : a. Complex instruction set computer

Description : RISC stands for: a. Reduced Instruction set computer b. Reduced Instruct set compare c. Reduced instruction stands computer d. All of these 107. DEC stands for:

Last Answer : a. Reduced Instruction set computer

Description : ISA stands for: a. Instruct set area b. Instruction set architecture c. Both a and b d. None of these

Last Answer : b. Instruction set architecture

Description : VGA stands for: a. Visual graph area b. Visual graphics array c. Visual graph accept d. All of these

Last Answer : b. Visual graphics array

Description : GUI stands for: a. Graphical user interface b. Graph used Intel c. Graphical use inter d. None of these

Last Answer : a. Graphical user interface

Description : CAD stands for: a. Computer aided drafting b. Compare aided drafting c. Both A and B d. None of these

Last Answer : a. Computer aided drafting

Description : BCD stands for: a. Binary coded decimal b. Based coded decimal c. Both A and B d. None of these

Last Answer : a. Binary coded decimal

Description : MOSFET stands for? a. Metal-oxide-semiconductor field effect transistor b. Metal-oxide-semiconductor fan effort transistor c. Both A and B d. None of these

Last Answer : a. Metal-oxide-semiconductor field effect transistor

Description : HMOS stands for: a. High performance metal oxide semiconductor b. High processor metal oxide semiconductor c. Both A and b d. None of these

Last Answer : a. High performance metal oxide semiconductor

Description : NMOS stands for: a. N-channel metal-oxide-semiconductor b. P-channel metal-oxide-semiconductor c. N-channel memory-oxide-semiconductor d. All the above

Last Answer : a. N-channel metal-oxide-semiconductor

Description : PMOS stands for: a. P-channel metal-oxide-semiconductor b. P-channel memory –oxide-semiconductor c. Both A and B d. None of these

Last Answer : a. P-channel metal-oxide-semiconductor

Description : CAD stands for a. Computer aided design b. Computer algorithm for design c. Computer application in design d. All of the above

Last Answer : a. Computer aided design

Description : ASCII stands for a. American Stable Code for International Interchange b. American Standard Case for Institutional Interchange c. American Standard Code for Information Interchange d. American Standard Code for Interchange Information

Last Answer : c. American Standard Code for Information Interchange

Description : EBCDIC stands for a. Extended Binary Coded Decimal Interchange Code b. Extended Bit Code Decimal Interchange Code c. Extended Bit Case Decimal Interchange Code d. Extended Binary Case Decimal Interchange Code

Last Answer : a. Extended Binary Coded Decimal Interchange Code