An ideal voltage amplifier should have A) Ri = 0, R0 = 0
B) Ri = 0, R0 =∞
C) Ri = ∞, R0 = 0
D) Ri = ∞, R0 = ∞.

1 Answer

Answer :

C) Ri = ∞, R0 = 0

Related questions

Description : In an amplifier the collector voltage equals the full V+ of 28 V instead of the normal 12 V which of the following can be the trouble? A) RL is open B) Cc is open C) RE is open D) CE is shorted.

Last Answer : B) Cc is open

Description : The ideal characteristic of a voltage stablizer is A) constant output voltage with low internal resistance B) constant output current with low internal resistance C) constant output voltage with high internal resistance D) constant internal resistance with variable output voltage.

Last Answer : A) constant output voltage with low internal resistance

Description : In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as A) Class A B) Class B C) Class C D) Class AB.

Last Answer : B) Class B

Description : Which of the following methods cannot be used to increase the bandwidth for cascaded RF amplifier stages? A) Wave traps in each stage B) Stagger tuning C) A shunt damping resistor across each tuned circuit D) Doubled tuned transformers with tighter coupling

Last Answer : A) Wave traps in each stage

Description : A push pull amplifier balances out A) Odd harmonics B) Even harmonics C) Both odd as well as even harmonics D) Neither odd nor even harmonics.

Last Answer : A) Odd harmonics

Description : Which amplifier will be preferred for highest gain? A) Darlington's pair B) Cascade amplifier C) Cascode amplifier D) Depends on the circuitry

Last Answer : C) Cascode amplifier

Description : In a resistance loaded amplifier, the gain decreases a high frequencies because A) Of decreasing reactance of the stray CT B) Increasing reactance of the stray CT C) Increasing reactance of CC D) Decreasing reactance of CC.

Last Answer : D) Decreasing reactance of CC.

Description : In a resistance loaded, RC coupled amplifier the dc component is blocked by A) Load resistance RL B) Coupling capacitor, CC C) RB D) The transistor.

Last Answer : B) Coupling capacitor, CC

Description : If the operating point of an NPN transistor amplifier is selected in saturation region, it is likely to result in A) Thermal runaway of transistor B) Clipping of output in the positive half of the ... for high dc collector supply D) Clipping of output in the negative half of the input signal

Last Answer : B) Clipping of output in the positive half of the input signal

Description : Which of the following circuit would be preferred for a 455 kHz IF amplifier? A) A resistance loaded B) Double tuned transformer C) Video amplifier D) Class C

Last Answer : B) Double tuned transformer

Description : As compared to a CB amplifier, a CE amplifier has A) Lower current amplification B) Higher current amplification C) Higher input resistance. D) Both (B) & (C)

Last Answer : D) Both (B) & (C)

Description : What conditions are required for an amplifier to oscillate A) There must be feedback B) The feedback must be in phase C) The gain must be greater than the loss D) All the above are regd.

Last Answer : B) The feedback must be in phase

Description : Which of the following is not true: A) An oscillator is a circuit that converts DC to AC B) An oscillator is an amplifier that supplies its own input signal C) All oscillators generate sine waves D) In phase feedback is called positive Feedback

Last Answer : C) All oscillators generate sine waves

Description : The Bandwidth of an RC-coupled amplifier is limited by: A) coupling capacitors at the low frequency end and bypass capacitors at the high frequency end B) coupling capacitors at the high frequency ... at the low frequency end and bypass as well as coupling capacitors at the high frequency end.

Last Answer : C) bypass and coupling capacitors at the low frequency end and shunt capacitors at the high frequency end and

Description : A crow bar is a power supply circuit that provides A) Conventional current limiting B) Foldback current. limiting C) Temperature control D) Voltage limiting.

Last Answer : D) Voltage limiting.

Description : Load regulation is a measure of a power supplies ability keep a constant output under conditions of changing A) Line voltage B) Current demand C) Temperature D) Oscillator frequency.

Last Answer : A) Line voltage

Description : The major function of transistor. Q2 is A) It provides voltage gain B) It provides the feedback signal C) It isolates the oscillator from loading effects D) It provides a phase shift.

Last Answer : ) It provides a phase shift.

Description : The change in base current will be A) 0.66 micro ampere B) 6.6 micro amperes C) 66 micro amperes D) 660 micro amperes.

Last Answer : A) 0.66 micro ampere

Description : Six (6) MHz crystal oscillator has a stability of 1 part in 106. The largest frequency error expected of this crystals A) 0.06 Hz B) 0.6 Hz C) 6 Hz D) 60 Hz.

Last Answer : C) 6 Hz

Description : Which distortion is least objectionable in case of audio amplifers? A) Phase distortion B) Frequency distortion C) Harmonic distortion D) Inter modulation distortion.

Last Answer : A) Phase distortion

Description : Which of the following contributes to harmonics distortion in amplifiers? A) Positive feedback B) Presence of noise C) Defective active device D) Non linearity in active device.

Last Answer : D) Non linearity in active device.

Description : A IGFET is a A) Linear device B) Square law device C) Half power device D) 3/2 power law device.

Last Answer : B) Square law device

Description : An FET has a gate source bias of 2 V. The ac input signal is ± 1.2 V. The class of operation is A) A B) B C) C D) AB

Last Answer : D) AB

Description : Which of the following combinations has no phase inversion of the signal? A) Two CE stages B) CE and CC stages C) Three CE stages D) CE stage and emitter follower.

Last Answer : A) Two CE stages

Description : The Darlington pair consists of the following two stages A) CE and CC B) Both C) Both CC D) CE and CB

Last Answer : C) Both CC

Description : Common base configuration is little used because A) It has low input impedance B) It has high input impedance C) It does not heat up D) It has very high gain.

Last Answer : A) It has low input impedance

Description : Foldback current limiting has the advantage of A) Better pass transistor protection for long term overloads B) A defined turn on point C) Circuit simplicity D) All of the above.

Last Answer : A) Better pass transistor protection for long term overloads

Description : Current limited power supplies can prevent damage to A) Rectifier diodes and power transformers. B) Pass transistors C) Other circuits in the system D) All of the above.

Last Answer : D) All of the above.

Description : In general, MOV devices are used to protect electronic equipment from dangerous operating conditions such as A) High temperatures B) Line transients C) Over current D) All of the above.

Last Answer : D) All of the above.

Description : What is the phase relationship of the signal at the collector of Q2 to the signal at the collector of Q, A) 0° B) 90° C) 180° D) 360°.

Last Answer : C) 180°

Description : A series mode crystal is marked 10.000 MHz., It is used in a circuit that operates the crystal in its parallel mode. The circuit can be expected to A) Run below 10 MHz B) Run at 10 MHz C) Run above 10 MHz D) Not oscillate.

Last Answer : C) Run above 10 MHz

Description : An oscillator that uses crystal control should be A) Frequency stable B) useful only at low frequencies C) AVFO D) none of the above.

Last Answer : A) Frequency stable

Description : What physical law gives the flux of energy of an idealized object above 0 K? (a) P = ρRT (b) So(r/r0) 2 (c) σT4 (d) hν

Last Answer : (c) σT4

Description : For an ideal fluid flow, Reynolds number is (A) 2100 (B) 100 (C) 0 (D) ∞

Last Answer : (D) ∞

Description : For an ideal plug flow reactor, the value of Peclet number is (A) 0 (B) 1 (C) 10 (D) ∞

Last Answer : (A) 0

Description : The exit age distribution of a fluid leaving a vessel (denoted by E) is used to study the extent of non-ideal flow in the vessel. The value of ∫∞ 0 E.dt is (A) 0 (B) 1 (C) ∞ (D) √2π

Last Answer : (B) 1

Description : The difference between isothermal compressibility and adiabatic compressibility for an ideal gas is (A) 0 (B) +ve (C) -ve (D) ∞

Last Answer : (B) +ve

Description : 4 kg moles of an ideal gas expands in vacuum spontaneously. The work done is (A) 4 J (B) ∞ (C) 0 (D) 8 J

Last Answer : (C) 0

Description : What is the value of Joule-Thomson co-efficient for an ideal gas? (A) +ve (B) -ve (C) 0 (D) ∞

Last Answer : (C) 0

Description : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across?

Last Answer : Two resistances Rl and Ri are connected in series across the voltage source where Rl>Ri. The largest drop will be across Rl.

Description : What is the location value of R0 and the content at that place? a) 45H, 4F b) 50H, 30H c) 30H, 50H d) 50H, 45H

Last Answer : c) 30H,

Description : Explain the following instructions. SWAP A ADD C MUL AB CJNE A, add, radd MOV A, R0 MOVX A, @ A + DPTR.

Last Answer : SWAP A Description: This instruction exchanges bits 0-3 of the Accumulator with bits 4-7 of the Accumulator. This instruction is identical to executing "RR A" or "RL A four times ... referred to as the base address and the accumulator value is referred to as the index address.

Description : In gas-liquid contact operation, the number of ideal stages, N = (xa - xb )/(xb - x *b ). This is true when the stripping factor 'S' is (A) S > 1 (B) S < 1 (C) S = 1 (D) S = ∞

Last Answer : (A) S > 1

Description : The Reynolds number for an ideal fluid flow is (A) 4 (B) 2100-4000 (C) 4000 (D) ∞

Last Answer : (D) ∞

Description : How should I get to Providence, RI by train or bus from New Jersey/NYC?

Last Answer : The train is great if you can afford it. You can get on in Trenton, Metropark or Newark.

Description : Where to go explore in RI?

Last Answer : Newport is beautiful, and Providence seemed decent too.

Description : Any recommendations for places to stay on Block Island, RI?

Last Answer : answer:I can see Block Island from my living room, but I've never spent the night :) The Hotel Manisses is supposed to be nice, as is the Springhouse Hotel. I wouldn't stay at Ballard's. The ... check that out if it's important to you. Yahoo Travel has a good summary of hotels and customer reviews.

Description : Could I transplant a fig tree from a pot to the ground in october in Providence RI

Last Answer : They will do freeze if your temps go under 32..............we tried doing this in NE PA.........we need a greenhouse.............it worked in 7a but not in 5a.............

Description : What is the full form of 'RI' ? -How To ?

Last Answer : The full form of 'RI' is Rigorous Improsonment

Description : Are there any party places that rent lawn flamingos in Newport, RI?

Last Answer : Lawn flamingos are relatively inexpensive, so it is difficult to find places that rent them. They can be purchased at Party City and similar supply stores at inexpensive prices. Yes! You can ... visiting http://www.flamingoed.com/flamingo/Delaware-lawn-greeting.php. They are great party decorations!