Description : The convexity provided to the carriageway between the crown and edge of the pavement, is known as (A) Super-elevation (B) Camber (C) Height of the pavement (D) None of these
Last Answer : Answer: Option B
Description : Before providing super-elevation on roads, the portion of the carriageway between the crown and the outer edge is made (A) To have a reduced fall (B) Horizontal (C) To have slope of the camber on the other half of the carriageway (D) None of these
Last Answer : Answer: Option C
Description : On a pavement with parabolic camber, the angle of inclination of the vehicles will be (A) More at the crown (B) Less at the edges (C) More at the edges (D) Same at the edges as well as at the crown
Description : To prevent movement of moisture from sub-grade to road pavement at the same level as that of water-table, thickness of a cut off layer of coarse sand, is (A) 15 cm (B) 20 cm (C) 30 cm (D) 45 cm
Last Answer : Answer: Option A
Description : A district road with a bituminous pavement has a horizontal curve of 1000 m for a design speed of 75 km ph. The super-elevation is (A) 1 in 40 (B) 1 in 50 (C) 1 in 60 (D) 1 in 70
Description : The most commonly adopted method to provide super-elevation on roads, is by pivoting the road surface about (A) Outer edge so that the inner edge is lowered (B) Crown so that outer edge is raised and inner edge is lowered (C) Inner edge so that outer edge is raised (D) None of these
Description : To prevent movement of moisture from sub-grade to road pavement on embankments about 0.6 m to 1 m higher than water table, the thickness of cut off layer of coarse sand used, is (A) 15 cm (B) 20 cm (C) 30 cm (D) None of these
Last Answer : Answer: Option D
Description : If the designed speed on a circular curve of radius 1400 m is 80 km/hour, no super-elevation is provided, if the camber, is (A) 4 % (B) 3 % (C) 2 % (D) 1.7 %
Description : A reinforced concrete cantilever beam is 3.6 m long, 25 cm wide and has its lever arm 40 cm. It carries a load of 1200 kg at its free end and vertical stirrups can carry 1800 kg. Assuming concrete to carry one- ... beam, the number of shear stirrups required, is (A) 30 (B) 35 (C) 40 (D) 45
Description : The camber of shoulders in water bound macadam roads is (A) Equal to the cross slope of pavement (B) Less than the cross slope of pavement (C) Greater than the cross slope of pavement (D) Zero
Description : Road makers along roads from the edge of a kerb should not be less than (A) 40 cm (B) 45 cm (C) 50 cm (D) 60 cm
Description : If the rate of change of the super-elevation along a curved portion of a 7 metre wide road is 1 in 150 and the maximum super-elevation allowed is 1 in 15, the maximum length of the transition curve to be provided at either end, is (A) 65 m (B) 70 m (C) 75 m (D) 80 m
Description : The camber on pavements, is provided by (A) Straight line method (B) Parabolic method (C) Straight line and parabolic at crown (D) Elliptical method
Description : Camber in pavements is provided by (A) Straight line method (B) Parabola method (C) Straight at the edges and parabolic at the crown (D) All the above
Description : If the width of a pavement slab is 7.5 m, thickness 20 cm and working stress 1400 kg/cm2 , spacing of 10 mm tie bars for the longitudinal joint, is (A) 10 cm (B) 20 cm (C) 30 cm (D) 40 cm
Description : Depth of reinforcement below the surface of a concrete pavement, is generally kept (A) 5 cm (B) 6 cm (C) 7 m (D) 9 m
Description : If the width of carriage way is 12.5 metres, outer edge 50 cm higher than the inner edge, the required super elevation is (A) 50 cm (B) 1 in 25 (C) 1 in 400 (D) 1 in 40
Description : On concrete roads, the camber generally provided, is (A) 1 in 20 to 1 in 24 (B) 1 in 30 to 1 in 48 (C) 1 in 36 to 1 in 48 (D) 1 in 60 to 1 in 72
Description : For a 6.6 m wide two lane pavement, berms are provided on either side having a width of (A) 1.00 m (B) 1.25 m (C) 1.50 m (D) 1.75 m
Description : The danger level should be marked with a bright red band …… wide centrally over a white band …… wide for a length of……… a) 5 cm, 10 cm, 60 cms* b) 10 cm, 20 cm, 60 cm c) 15 cm, 30 mm, 60 cm d) None of the above
Last Answer : a) 5 cm, 10 cm, 60 cms*
Description : The aggregate impact value of the aggregate used in (A) Building concrete is less than 45 (B) Road pavement concrete is less than 30 (C) Runway concrete is less than 30 (D) All the above
Description : The drainage area of a town is 12 hectares. Its 40% area is hard pavement ( K = 0.85), the 40% area is unpaved streets (K = 0.20) and the remaining is wooded areas (K = 0.15). Assuming the time of concentration ... 60) the maximum run off is A. 0.10 cumec B. 0.12 cumec C. 0.15 cumec D. 0.20 cumec
Last Answer : ANS: C
Description : On earth roads, the camber should preferably be (A) 1 in 20 to 1 in 24 (B) 1 in 30 to 1 in 48 (C) 1 in 15 to 1 in 20 (D) 1 in 10 to 1 in 15
Description : Pick up the incorrect statement from the following. The super-elevation on roads is (A) Directly proportional to width of pavement (B) Directly proportional to velocity of vehicles (C) Inversely proportional to acceleration due to gravity (D) Inversely proportional to the radius of curvature
Description : A jet of water of cross-sectional area 20 sq. cm impinges on a plate at an angle of 60? with a velocity of 10 m/sec. Neglecting the friction between the jet and plate (density of water 1000/9.81 kgm-1 sec2 per cubic meter), the ... a.15 - 20 kg b.20 - 25 kg c.5 - 10 kg d.25 - 30 kg e.10 - 15 kg
Last Answer : a. 15 - 20 kg
Description : Minimum thickness of the base of a flexible pavement, is (A) 10 cm (B) 15 cm (C) 20 cm (D) 25 cm
Description : Define Camber and super-Elevation.
Last Answer : Camber: - The convexity provided to the surface of the carriage way is called as camber. Super-elevation: - The inward transverse inclination provided to the cross section of the carriage way at horizontal curved portion of a road is called as super-elevation.
Description : The bottom of side drains should be below the formation level by at least------------ a) 45 cm b )30 cm* c) 15 cm d) 60 cm
Last Answer : b )30 cm*
Description : When load is applied on concrete pavement (A) Away from edges, the maximum bending moment is negative (B) Away from edges, the maximum bending moment cause compression (C) On the edges, the maximum stress is parallel to the edge of the slab (D) None of these
Description : Area of steel required per metre width of pavement for a length of 20 m for design wheel load 6300 kg and permissible stress in steel 1400 kg/cm2 , is (A) 70 kg/sq cm (B) 80 kg/sq cm (C) 90 kg/sq cm (D) 100 kg/sq cm
Description : A rectangular beam 20 cm wide is subjected to a maximum shearing force of 10,000 kg, the corresponding maximum shearing stress being 30 kg/cm2 . The depth of the beam is (A) 15 cm (B) 20 cm (C) 25 cm (D) 30 cm
Last Answer : (C) 25 cm
Description : An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm2 , the beam (A) Is safe in shear (B) Is safe with stirrups (C) Is safe with stirrups and inclined bars (D) Needs revision of section
Description : In India, which one of the following should be considered the right combination of the age in days and live body weight in kg for a lamb for its weaning ? (A) 20 days to 30 days and 6 kg to 7 kg (B) 45 days to 60 ... (D) 75 days to 90 days and 12 kg to 15 kg (E) 55 days to 70 days and 9 kg to 11 kg
Last Answer : (C) 105 days to 120 days and 18 kg to 21 kg
Description : A gun fires shell with a muzzle velocity of 600 m/sec. The angle of inclination of the gun so that the shell hits a target at a distance of 32 km at level 100 m higher than the gun would be approximately? a.60? b.45? c.30? d.15? e.Either of (A) and (C)
Last Answer : e. Either of (A) and (C)
Description : High strength of concrete requires a water cement ratio of [ A ] 0.10 to 0.15 [ B ] 0.25 to 0.30 [ C ] 0.45 to 0.60 [ D ] 0.75 to 0.90
Last Answer : [ B ] 0.25 to 0.30
Description : The distance between two cities A and B is 330 km. A train starts from A at 8 a.m. and travels towards B at 60 km/hr. Another train starts from B at 9 a.m. and travels towards A at 75 km/hr. At what time do they meet? A.10:30 am B.10:45 am C.11 am D.11:25 am E.None of these
Last Answer : Answer – C (11 am) Explanation – Suppose they meet x hrs after 8 a.m. Then, (Distance moved by first in x hrs) + [Distance moved by second in (x-1) hrs] = 330 60x + 75(x – 1) = 330 x = 3 So, they meet at (8 + 3), i.e. 11 a.m
Description : The raft slab is projected beyond the outer walls of the structure by (A) 5 to 10 cm (B) 15 to 20 cm (C) 25 to 30 cm (D) 30 to 45 cm
Description : From the Survey of India map, the distance of the critical point is 20 km and difference in elevation is 193 m. The over land flow time, is (A) 2 hours (B) 3 hours (C) 2 hours and 30 minutes (D) 4 hours
Description : Maximum distance between expansion joints in structures as per IS: 456 1978 is (A) 20 m (B) 30 m (C) 45 m (D) 60 m
Last Answer : (C) 45
Description : no super elevation is provided on a road along curves, pot holes may develop at (A) Inner edge of the road (B) Outer edge of the road (C) Centre of the road (D) Nowhere on the road
Description : Raising of outer edge of a road with respect to inner edge, is known (A) Super elevation (B) Cant (C) Banking (D) All the above
Description : A cubical box has each edge 10 cm and another cuboidal box is 12.5cm long, 10 cm wide and 8 cm high -Maths 9th
Last Answer : From the question statement, we have Edge of a cube = 10cm Length, l = 12.5 cm Breadth, b = 10cm Height, h = 8 cm (i) Find the lateral surface area for both the figures Lateral surface ... . Therefore, the total surface area of the cubical box is smaller than that of the cuboidal box by 10 cm2
Description : A 8 metre long simply supported rectangular beam which carries a distributed load 45 kg/m. experiences a maximum fibre stress 160 kg/cm2 . If the moment of inertia of the beam is 640 cm4 , the overall depth of the beam is (A) 10 cm (B) 12 cm (C) 15 cm (D) 18 cm
Last Answer : (A) 10 cm
Description : Finishing tolerances are measured by? (i) On 30 cm scale (ii) 1 MT straightedge or 10 CM straightedge.* (iii) On 15 cm straight edge (iv) On 30 cm straight edge
Last Answer : (ii) 1 MT straightedge or 10 CM straightedge.*
Description : Two concave lenses of 60 cm focal length are cemented on either side of a convex lens of 15 cm focal length. The focal length of the combination is (A) 10 cm (B) 20 cm (C) 30 cm (D) 40 cm
Last Answer : (C) 30 cm
Description : Pick up the incorrect statement from the following: (A) Tresguet did not provide the top camber for the drainage of surface water (B) Tresguet provided the top camber for the drainage of surface ... (D) Macadam provided a camber to the formation at the dug-up state, to drain percolated water
Description : Non-passing sight distance along a road is the longest distance at which the driver of a moving vehicle, may see an obstacle on the pavement (A) 10 cm high (B) 25 cm high (C) 50 cm high (D) 100 cm high
Description : To indicate proper control of consistency of a freshly mixed concrete for pavement construction, the slump should be between (A) 3 to 5 cm (B) 4 to 6 cm (C) 5 to 7 cm (D) 7 to 10 cm
Description : Which of the following correspond to the recommendations of IRC for pavement thickness determination by CBR Method ? 1. CBR tests are to be conducted in-situ 2. Static compression is best adopted 3. The top 50 cm of sub grade ... 1, 2 and 3 (b) 1 and 2 only (c) 2 and 3 only (d) 1 and 3 only
Last Answer : (c) 2 and 3 only