Description : no super elevation is provided on a road along curves, pot holes may develop at (A) Inner edge of the road (B) Outer edge of the road (C) Centre of the road (D) Nowhere on the road
Last Answer : Answer: Option B
Description : The most commonly adopted method to provide super-elevation on roads, is by pivoting the road surface about (A) Outer edge so that the inner edge is lowered (B) Crown so that outer edge is raised and inner edge is lowered (C) Inner edge so that outer edge is raised (D) None of these
Last Answer : Answer: Option C
Description : If the width of carriage way is 12.5 metres, outer edge 50 cm higher than the inner edge, the required super elevation is (A) 50 cm (B) 1 in 25 (C) 1 in 400 (D) 1 in 40
Description : Before providing super-elevation on roads, the portion of the carriageway between the crown and the outer edge is made (A) To have a reduced fall (B) Horizontal (C) To have slope of the camber on the other half of the carriageway (D) None of these
Description : The convexity provided to the carriageway between the crown and edge of the pavement, is known as (A) Super-elevation (B) Camber (C) Height of the pavement (D) None of these
Description : Bottom bars under the columns are extended into the interior of the footing slab to a distance greater than (A) 42 diameters from the centre of the column (B) 42 diameters from the inner edge of ... ) 42 diameters from the outer edge of the column (D) 24 diameters from the centre of the column
Description : The difference in gradients after full super-elevation and the initial alignment of a road, is known as (A) Ruling gradient (B) Rising gradient (C) Compensated gradient (D) Differential gradient
Last Answer : Answer: Option D
Description : Along a hill road, a side drain is provided on (A) Outer side of a spur curve (B) Outer side of a re-entrant curve (C) Outer side of both (a) and (b) (D) Inner side of both (a) and (b)
Description : Formation width of a hill road is the distance between (A) Outer end of side drain to outer end of parapet wall (B) Outer end of side drain to inner end of parapet wall (C) Inner end of side drain to outer end of parapet wall (D) Inner end of side drain to inner end of parapet wall
Last Answer : Answer: Option A
Description : If the rate of change of the super-elevation along a curved portion of a 7 metre wide road is 1 in 150 and the maximum super-elevation allowed is 1 in 15, the maximum length of the transition curve to be provided at either end, is (A) 65 m (B) 70 m (C) 75 m (D) 80 m
Description : A district road with a bituminous pavement has a horizontal curve of 1000 m for a design speed of 75 km ph. The super-elevation is (A) 1 in 40 (B) 1 in 50 (C) 1 in 60 (D) 1 in 70
Description : If the coefficient of friction on the road surface is 0.15 and a maximum super-elevation 1 in 15 is provided, the maximum speed of the vehicles on a curve of 100 metre radius, is (A) 32.44 km/hour (B) 42.44 kg/hour (C) 52.44 km/hour (D) 62.44 km/hour
Description : An epithelial tissue which has thin flat cells, arranged edge to edge so as to appear like closely packed tiles, is found to be present at (a) outer surface of ovary (b) inner lining of Fallopian tube (c) inner lining of stomach (d) inner lining of cheeks.
Last Answer : (d) inner lining of cheeks.
Description : A sphere of radius 'R1 ' is enclosed in a sphere of radius 'R2 '. The view (or shape) factor for radiative heat transfer of the outer sphere with respect to the inner sphere is (A) 0 (B) R2 /(R1+R2 ) (C) 1 (D) (R1 /R2 )
Last Answer : (B) R2 /(R1+R2 )
Description : If the difference in elevation of an edge of the pavement 9 m wide and its crown is 15 cm, the camber of the pavement, is (A) 1 in 60 (B) 1 in 45 (C) 1 in 30 (D) 1 in 15
Description : Top bars are extended to the projecting parts of the combined footing of two columns Ldistance apart for a distance of (A) 0.1 L from the outer edge of column (B) 0.1 L from the centre edge of column (C) Half the distance of projection (D) One-fourth the distance of projection
Description : The increase in pressure at the outer edge of a drum of radius (r) completely filled up with liquid (A) 2 r2 (B) 2 2 r2 (C) 2 r2 /2 (D) 2 r2 /4
Description : The range of spread from the wall base to outer edge of a brick work foundation does not exceed (A) 1/2 horizontal to 1 vertical (B) 2/3 horizontal to 1 vertical (C) 1 horizontal to 1 vertical (D) 2 horizontals to 1 vertical
Description : The term string is used for (A) The underside of a stair (B) Outer projecting edge of a tread (C) A sloping member which supports the steps in a stair (D) A vertical member between two treads
Description : If the strain energy stored per unit volume in a hollow shaft subjected to a pure torque when t attains maximum shear stress fs the ratio of inner diameter to outer diameter, is 17/64 (fs/N) (A) 1/2 (B) 1/3 (C) 1/4 (D) 1/5
Last Answer : (C) 1/4
Description : The yield moment of a cross section is defined as the moment that will just produce the yield stress in (A) The outer most fibre of the section (B) The inner most fibre of the section (C) The neutral fibre of the section (D) The fibre everywhere
Last Answer : (A) The outer most fibre of the section
Description : Widening of the roads on curves in hilly region, is done (A) On the outer side (B) On the inner side (C) On the outer and inner sides equally (D) Less on outer side and more on inner side
Description : How investment banking firm helps in raising funds?
Last Answer : Investment banking is a stream of banking that primarily focuses on capital financing for global and local businesses, individuals, and even governments and other entities. Investment banking firm is best known ... of their customer base. The key function of an investment banking firm is to raise
Description : With usual notations, the expression V²/gR represents (A) Centrifugal force (B) Centrifugal ratio (C) Super elevation (D) Radial acceleration
Last Answer : (B) Centrifugal ratio
Description : If is the speed of a locomotive in km per hour, g is the acceleration due to gravity, is the distance between running faces of the rails and is the radius of the circular curve, the required super elevation is (A) gV²/GR (B) Rg/GV² (C) GR/gV² (D) GV²/gR
Last Answer : (D) GV²/gR
Description : Transition curves are introduced at either end of a circular curve, to obtain (A) Gradually decrease of curvature from zero at the tangent point to the specified quantity at the junction of the ... specified amount at the junction of the transition curve with main curve (D) None of these
Last Answer : (B) Gradual increase of super-elevation from zero at the tangent point to the specified amount at the junction of the transition curve with main curve
Description : The correct formula for calculating super-elevation for the hill roads, is (A) e = V²/254 R (B) e = V²/225 R (C) e = V²/278 R (D) e = V²/114 R
Description : Maximum super-elevation on hill roads should not exceed (A) 5 % (B) 7 % (C) 8 % (D) 10 %
Description : If x% is the gradient of an alignment and y% is the gradient after proper super-elevation along a curved portion of a highway, the differential grade along the curve, is (A) (x + y) % (B) (x - y) % (C) (y - x) % (D) (y + x) %
Description : Pick up the incorrect statement from the following. The super-elevation on roads is (A) Directly proportional to width of pavement (B) Directly proportional to velocity of vehicles (C) Inversely proportional to acceleration due to gravity (D) Inversely proportional to the radius of curvature
Description : If the designed speed on a circular curve of radius 1400 m is 80 km/hour, no super-elevation is provided, if the camber, is (A) 4 % (B) 3 % (C) 2 % (D) 1.7 %
Description : If V is speed in km/hour and R is radius of the curve, the super-elevation e is equal to (A) V²/125 R (B) V²/225 R (C) V²/325 R
Description : If V is speed of a moving vehicle, r is radius of the curve, g is the acceleration due to gravity, W is the width of the carriageway, the super elevation is (A) WV/gr (B) W²V/gr (C) WV²/gr (D) WV/gr²
Description : Design of horizontal and vertical alignments, super-elevation, sight distance and grades, is worst affected by (A) Width of the vehicle (B) Length of the vehicle (C) Height of the vehicle (D) Speed of the vehicle
Description : The minimum super-elevation in rolling terrain in plains, is limited to (A) 4 % (B) 5 % (C) 6 % (D) 7 %
Description : Super-elevation on roads in snow bound areas, should generally not exceed (A) 15 % (B) 12 % (C) 10 % (D) 7 %
Description : To ensure that bullock carts may not overturn on curves, the maximum value of super-elevation, recommended by I.R.C., is (A) 1 in 10 (B) 1 in 12 (C) 1 in 15 (D) 1 in 20
Description : The advantage of providing super-elevation on roads, is (A) Higher speed of vehicles (B) Increased volume of traffic (C) Reduced maintenance cost of the roads (D) All the above
Description : The length of a transition curve, is governed by (A) Rate of change of radial acceleration (B) Rate of change of super-elevation (C) Both (a) and (b) (D) Neither (a) nor (b)
Description : Which interrupt is not level sensitive in 8085? a) RST6.5 is a raising edge-trigging interrupt. b) RST7.5 is a raising edge-trigging interrupt. c) a & b.
Last Answer : b) RST7.5 is a raising edge-trigging interrupt.
Description : The cross-section of a road partly in banking and partly in cutting is shown in the given figure. The area of the shaded portion is (A) b - rd)²/(r - s) (B) b - rd)²/(r + s) (C) ½ × (b + rd)²/(r - s) (D) b - rd)²/(s - r)
Last Answer : (A) b - rd)²/(r - s)
Description : The area of the cross-section of a road fully in banking shown in the given figure, is (A) [sb² + r² (2bd + sd)²]/(r² - s²) (B) [sb² + r² (2bd + sd)²]/(r² - s5 ) (C) [sb² + r² (2bd + sd)²]/(r - s) (D) None of these
Last Answer : (A) [sb² + r² (2bd + sd)²]/(r² - s²)
Description : Road makers along roads from the edge of a kerb should not be less than (A) 40 cm (B) 45 cm (C) 50 cm (D) 60 cm
Description : In highway construction on super-elevated curves, the rolling shall proceed from (A) Sides towards the centre (B) Centre towards the sides (C) Lower edge towards the upper edge (D) Upper edge towards the lower edge
Description : The slope on the road generally provided on the curves is known as a.Angle of repose b.Angle of friction c.Angle of banking d.Angle of reaction e.None of the above
Last Answer : c. Angle of banking
Description : Which of the following is FALSE with respect to rain water harvesting? (1) It is a device of water conservation. (2) It helps raising water table. (3) It helps meet rising water demand. (4) It increases run-off losses.
Last Answer : (4) It increases run-off losses. Explanation: Rainwater harvesting is a technique used for collecting, storing, and using rainwater for landscape irrigation and other uses. It, reduces water runoff, ... water on the roads, improves the quality of water and reduces the chances of soil erosion.
Description : As far as surgical removal of wisdom teeth is concerned which of the following is true? a- Prophylactic prescription of antibiotic reduces dramatically the chances of infection. b- Raising a lingual ... e- The use of vasoconstrictors in local anaesthetics will increase the chances of infection.
Last Answer : b- Raising a lingual flap will increases the incidence of neurapraxia but will reduce the incidence of neurotmesis with respect to the lingual nerve.
Description : As far as surgical removal of wisdom teeth is concerned, which of the following is true?**CHECK A. Prophylactic prescription of antibiotic reduces dramatically the chances of infection B. Raising ... root E. The use of vasoconstrictors in local anaesthetics will increase the chances of infection.
Last Answer : C. Prophylactic prescription of dexamethasone will dramatically reduces post operative swelling
Description : Which of the following is FALSE with respect to rain water harvesting ? (1) It is a device of water conservation. (2) It helps raising water table. (3) It helps meet rising water demand. (4) It increases run-off losses.
Last Answer : It increases run-off losses.
Description : In June why does the outer edge of the atmosphere at the equator receive?
Last Answer : Need answer