Description : The width of road pavements, depends upon (A) Width of traffic lane (B) Number of traffic (C) Width of median strip (D) All the above
Last Answer : Answer: Option D
Description : If the number of lanes on the carriageway of a road is more than two, the total width of lane ways is equal to 3.0 m (A) + 0.60 m (B) + 0.70 m (C) + 0.90 m (D) + 1.50 m
Last Answer : Answer: Option B
Description : According to Indian Road Congress, the width of carriageway, is (A) 3.75 m for single lane (B) 7.0 m for two lanes without raised kerbs (C) 7.5 m for two lanes with raised kerbs (D) All the above
Description : The width of pavement in addition to a gravelled berm 1 m on either side for a two directional traffic recommended by Nagpur Conference of Chief Engineers, is (A) 4.7 m (B) 5.7 m (C) 6.7 m (D) 7.7 m
Last Answer : Answer: Option C
Description : The normal road width of National and State highways (A) Is kept 45 m (B) In plain and rolling terrain built-up area, is 30 m (C) In mountainous built-up area is 20 m (D) All the above
Description : Road width 8.8 m of two lane National highways or State highways in mountainous terrain (A) Excludes the width of parapet (0.6 m) (B) Excludes the width of side drain (0.6 m) (C) Excludes the width of parapet and side drain (D) Includes the width of parapet and side drain
Description : The width formation of a road means the width of (A) Carriageway (B) Pavement and shoulders (C) Embankment at ground level (D) Embankment at the top level
Description : In the rightmost traffic lane. In a residential area, outside any residential area in the rightmost traffic lane. In any traffic lane.
Last Answer : In the far right lane. Explanation: This is clear from the right-of-way obligation in this case. This question can be varied in many ways, depending on whether there are road markings or not, whether ... test book! (cross test / Driving on the road / Driving on a road suitable for parallel traffic)
Description : Roadway width for a National highways and State highways (two-lanes) is (A) 12 m (B) 9 m (C) 9.5 m (D) 15 m
Last Answer : Answer: Option A
Description : Width of vehicles affects the width of (A) Lanes (B) Shoulders (C) Parking spaces (D) All the above
Description : Normal formation width of a hill road for one-way traffic, is (A) 3.6 m (B) 4.8 m (C) 6.6 m (D) 7.2 m
Description : The traffic carrying capacity of a single lane, depends on (A) Type of the vehicles (B) Level crossings (C) Road intersections (D) All the above
Description : The fundamental factor in the selection of pavement type is (A) Climatic condition (B) Type and intensity of traffic (C) Sub-grade soil and drainage conditions (D) Availability of funds for the construction project
Description : Roughness index of roads, is expressed as (A) Size of the stone on the pavement (B) Number of patches on the pavement (C) Cumulative deformation of surface per horizontal distance (D) Type of the road surface
Description : Thickness of broken line markings on multi-lane road for lanes is generally kept (A) 10 cm (B) 12 cm (C) 15 cm (D) 18 cm
Description : The width of the flange of a T-beam, which may be considered to act effectively with the rib depends upon (A) Breadth of the rib (B) Overall thickness of the rib (C) Centre to centre distance between T-beams (D) All the above
Description : The minimum width of the pavement of a National Highway should be (A) 4.7 m (B) 5.7 m (C) 6.7 m (D) 7.7 m
Description : Pick up the incorrect statement from the following. The super-elevation on roads is (A) Directly proportional to width of pavement (B) Directly proportional to velocity of vehicles (C) Inversely proportional to acceleration due to gravity (D) Inversely proportional to the radius of curvature
Description : Full amount of extra width of a pavement on the curve, is provided at (A) Beginning of the transition curve (B) Centre of the transition curve (C) Beginning of the circular curve (D) Centre of the circular curve
Description : If the width of a pavement slab is 7.5 m, thickness 20 cm and working stress 1400 kg/cm2 , spacing of 10 mm tie bars for the longitudinal joint, is (A) 10 cm (B) 20 cm (C) 30 cm (D) 40 cm
Description : For a 6.6 m wide two lane pavement, berms are provided on either side having a width of (A) 1.00 m (B) 1.25 m (C) 1.50 m (D) 1.75 m
Description : Area of steel required per metre width of pavement for a length of 20 m for design wheel load 6300 kg and permissible stress in steel 1400 kg/cm2 , is (A) 70 kg/sq cm (B) 80 kg/sq cm (C) 90 kg/sq cm (D) 100 kg/sq cm
Description : Following type of pavement is generally known as flexible pavement (A) Water-bound macadam roads (B) Stabilised soil roads (C) Road constructed with various layers of building material well compacted (D) All the above
Description : Concrete pavement is provided if daily traffic per lane exceeds (A) 500 tonnes (B) 750 tonnes (C) 1000 tonnes (D) 1250 tonnes
Description : Design of flexible pavement, involves (A) Wheel loads (B) Intensity of traffic (C) Climate of the region (D) Sub-grade conditions
Description : The efficiency of the brakes of a vehicle depends upon (A) Condition of road surface (B) Condition of the tyres (C) Presence of the show moisture (D) All the above
Description : Non-passing sight distance along a road is the longest distance at which the driver of a moving vehicle, may see an obstacle on the pavement (A) 10 cm high (B) 25 cm high (C) 50 cm high (D) 100 cm high
Description : To prevent movement of moisture from sub-grade to road pavement at the same level as that of water-table, thickness of a cut off layer of coarse sand, is (A) 15 cm (B) 20 cm (C) 30 cm (D) 45 cm
Description : For the design of cement concrete pavement for corner loading, Indian Road Congress recommends the use of (A) Westergaard's formula (B) Kelly's formula (C) Goldbeck's formula (D) Picker's formula
Description : To prevent movement of moisture from sub-grade to road pavement on embankments about 0.6 m to 1 m higher than water table, the thickness of cut off layer of coarse sand used, is (A) 15 cm (B) 20 cm (C) 30 cm (D) None of these
Description : A district road with a bituminous pavement has a horizontal curve of 1000 m for a design speed of 75 km ph. The super-elevation is (A) 1 in 40 (B) 1 in 50 (C) 1 in 60 (D) 1 in 70
Description : The aggregate impact value of the aggregate used in (A) Building concrete is less than 45 (B) Road pavement concrete is less than 30 (C) Runway concrete is less than 30 (D) All the above
Description : Why do some drivers in the carpool lane driver slower than the traffic in the regular lanes?
Last Answer : Passive agression?
Description : Can a school bus stop four lanes of traffic?
Last Answer : Seems like it would be a good idea. Is there a rush?
Description : If carpool lanes are reserved to encourage people to commute together and as a result have fewer drivers on the road, shouldn't the number of people needed for the carpool lane include licensed drivers only?
Last Answer : How are you going to determine if everyone in a car is a legal driver, even if they are all of age? Stopping every car to check IDs would defeat one purpose of the lanes which is to reduce ... to work. Not to mention it would probably not be legal to check every ID without probable cause anyway.
Description : Are bicyclists allowed to ride in road lanes?
Last Answer : You betcha.
Description : I was in a no fault fender bender yesterday in which the car behind me hit me as I avoided another car. I was skidding on ice and was sliding down the road perpendicular to the lanes. Will my insurance go up?
Last Answer : no.. (i think not) well.. it depends on what the inspector sent by the insurance company thinks about it.
Description : Width and speed of a conveyor belt depends upon the __________ of the material. (A) Lump size (B) Bulk density (C) Both (A) & (B) (D) Neither (A) nor (B
Last Answer : (C) Both (A) & (B)
Description : A thin film is observed in white light. The color of the film seen at a particular point depends upon (a)Location of observer (b)Width of the source (c) Distance of the source (d) Brightness of the source
Last Answer : (a)Location of observer
Description : Why do road bikes ride differently than mountain bikes (on pavement)
Last Answer : answer:Yikes, sorry! I think the main difference is they are much lighter, and the wheels are thinner (less traction with the ground).
Description : Maximum number of passenger cars that can pass a given point on a road during one hour under the most ideal road way and traffic conditions, is known as (A) Traffic density (B) Basic capacity of traffic lane (C) Possible capacity of traffic lane (D) All the above
Description : On the recommendations of Nagpur Conference, the minimum width of a village road may be (A) 2.45 m (B) 2.75 m (C) 3.66 m (D) 4.90 m
Description : If At is the area of steel cross-section, t is working stress, L is width of road and W is weight of slab per square metre, the spacing of the tie bars for a longitudinal joint, is (A) (100 At × t)/WL (B) 100 At/tWL (C) (100 WAt × t)/tL (D) 100 WL/At t
Description : The normal road land width for a major district road in open area, is (A) 45 m (B) 25 m (C) 15 m (D) 12 m
Description : The minimum road width is taken (A) 9 m (B) 12 m (C) 16 m (D) 20 m
Description : Width of a rotary round should be equal to (A) Twice the width of narrowest radial road (B) Width of the widest road (C) Width of the widest road plus the width of one lane (D) Width of the widest road plus 2 metres
Description : The width of the right of way, is influenced by (A) Formation width (B) Shoulders or berms (C) Classification of road (D) All the above
Description : The normal road land width for a National or State highway, in open areas should be (A) 45 m (B) 30 m (C) 24 m (D) 20 m
Description : According to IRC : 52-1973, for a single lane National Highway in hilly region, (A) Width of the carriageway must be 3.75 m (B) Shoulders on either side must be 1.25 m (C) Total width of the road-way must be 6.25 m (D) Total of the above
Description : The aggregates required for one kilometre length of water bound macadam road per meter width and for 10 mm thickness is (A) 8 cubic meter (B) 10 cubic meter (C) 12 cubic meter (D) 15 cubic meter