Description : Prime coking coal is always blended with medium or non- coking coal before carbonisation (A) To check against its excessive swelling during heating, which may exert high pressure and damage coke oven walls (B) Because, it alone produces unreactive coke (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) and (B)
Description : Which of the following is coking? (A) Vitrain (B) Fussain (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Vitrain
Description : Coking coals are invariably (A) Lignites (B) Bituminous coals (C) Semi-anthracites (D) Anthracites
Last Answer : (B) Bituminous coals
Description : In Lurgi coal gasifier, (A) Coking coals cannot be used (B) Low carbon conversion efficiency is achieved (C) Entrainment of solids is higher (D) Larger quantity of coal can be processed
Last Answer : (D) Larger quantity of coal can be processed
Description : Pick out the wrong statement. (A) Indian coals on an average contain 25-30% ash as against 10-12% ash in imported coking coal (B) Ammonia is recovered in the form of ammonium sulphate in direct ... indicates poor caking properties of coal (D) Wash oil is used for scrubbing Benzol from coke oven gas
Last Answer : (C) A high swelling index number of coking coal indicates poor caking properties of coal
Description : Pick out the wrong statement. (A) Cokes of high reactivity are obtained from weakly coking coals (B) Cokes of high reactivity are obtained from strongly coking coals (C) Reactivity of coke is inversely proportional to its absolute density (D) Abrasion index of the coke is a measure of its hardness
Last Answer : (B) Cokes of high reactivity are obtained from strongly coking coals
Description : In the Lurgi coal gasifier (A) Coking coals cannot be used (B) Low carbon conversion efficiency is achieved (C) Entrainment of solids is higher (D) Large quantity of coal can be processed
Last Answer : (D) Large quantity of coal can be processed
Description : Signal normally used to study non-ideal flow by stimulus response technique is __________ input. (A) Pulse (B) Step (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : The single parameter model proposed for describing non-ideal flow is the __________ model. (A) Tank in series (B) Dispersion (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Trouton's ratio of __________ liquids is calculated using Kistyakowsky equation. (A) Polar (B) Non-polar (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Non-polar
Description : Pick out the wrong statement. (A) Pulverised fuel can be completely burnt with less percentage of excess air compared to lump coal (B) Low grade coal can be used, but generally high volatile ... and atmosphere (oxidising or reducing) is easily possible with pulverised fuel firing (D) None of these
Last Answer : (D) None of these
Description : Fanning friction factor equation applies to the __________ fluid flow. (A) Non-isothermal condition of (B) Compressible (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (D) Neither (A) nor (B)
Description : Applicability of Bernoulli's equation is limited to a/an __________ fluid, that does not exchange shaft work with the surroundings. (A) Incompressible (B) Non-viscous (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : Work done may be calculated by the expression ∫ p dA for __________ processes. (A) Non-flow reversible (B) Adiabatic (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : In nuclear reactions, __________ number is conserved. (A) Mass (B) Atomic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The cake resistance increases steadily with the time of filtration in a plate and frame filter employing constant __________ filtration. (A) Rate (B) Pressure (C) Both (A) & (B) (D) Neither (A) nor (B
Description : Width and speed of a conveyor belt depends upon the __________ of the material. (A) Lump size (B) Bulk density (C) Both (A) & (B) (D) Neither (A) nor (B
Description : Size reduction of moulding powders, waxes, resins & gums are done in a __________ mill. (A) Cage (B) Hammer (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Use of baffles in agitators help in minimising the __________ tendency. (A) Swirling (B) Vortexing (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The important dimensional group involved in the power requirement calculation in mixing operation is the __________ number. (A) Reynold's (B) Froude (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Separation of isotopes is generally done using a/an __________ centrifuge. (A) Ultra (B) Disk-bowl (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Ultra
Description : Corrosion involves exchange of electrons in __________ corrosion. (A) Chemical (B) Electrochemical (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The damage/deterioration of metals by the __________ action of fluids is called 'erosion'. (A) Abrasive (B) Corrosive (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Abrasive
Description : Dry bulb temperature of unsaturated air is more than its __________ temperature. (A) Dew point (B) Wet bulb (C) Both 'a' & 'b' (D) Neither 'a' nor 'b
Last Answer : (C) Both 'a' & 'b
Description : Diffusion in concentrated solutions differs from that in dilute solutions, because of the change in the __________ with the concentration of the solution. (A) Degree of ideality (B) Viscosity (C) Both 'a '& 'b' (D) Neither 'a' nor 'b'
Last Answer : (C) Both 'a '& 'b
Description : In the desorption of highly soluble gas from the liquid, the main resistance will be in the __________ phase. (A) Gas (B) Liquid (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Liquid
Description : In the absorption of ammonia in water, the main resistance to absorption is by the __________ phase. (A) Liquid (B) Gas (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Gas
Description : The ratio of Murphree plate efficiency to point efficiency is always > 1 in a __________ flow model. (A) Plug (B) Perfectly mixed (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Plug
Description : The ratio of Murphree plate efficiency to point efficiency is 1 in a __________ flow model. (A) Plug (B) Perfectly mixed (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Perfectly mixed
Description : Packed column distillation is limited to the column __________ metres. (A) Height < 6 (B) Diameter < 0.6 (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : In case of constant underflow extraction operation, the __________ atall solute concentration. (A) Solids are drained to the same extent (B) Ratio of the insoluble to solution is constant (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Nusselt number (for forced convection heat transfer) is a function of the __________ number. (A) Prandtl (B) Reynolds (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Kirchoff’s law applies to __________ radiation. (A) Total (B) Monochromatic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : . A perfect black body is a perfect __________ of radiation. (A) Absorber (B) Emitter (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : With increase in the oxygen content of the coal, its __________ decreases. (A) Calorific value (B) Caking power (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Bomb calorimeter can be used to determine the __________ of the coal. (A) Sulphur content (B) Calorific value (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The rate of shear versus the shear stress curves are time dependent for __________ fluid. (A) Thixotropic (B) Rheopectic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : . A Rotameter works on the principle of __________ pressure drop. (A) Constant (B) Variable (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Constant
Description : Velocity head on sudden enlargement in a horizontal pipe is converted into __________ head. (A) Elevation (B) Pressure (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Pressure
Description : With increase in temperature, the equilibrium __________ rises in case of endothermic reaction. (A) Constant (B) Conversion (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Conversion
Description : Design of heterogamous catalytic reactor involves consideration of __________ steps. (A) Only chemical (B) Only physical (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Chemical kinetics can predict the __________ of a chemical reaction. (A) Rate (B) Feasibility (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Rate
Description : In a CSTR __________ varies with time. (A) Reaction rate (B) Concentration (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Sodium bisulphite is used for __________ water. (A) Deaeration (B) Dechlorination (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : If an ideal solution is formed by mixing two pure liquids in any proportion, then the __________ of mixing is zero (A) Enthalpy (B) Volume (C) Both 'a' & 'b' (D) Neither 'a' nor 'b'
Last Answer : (C) Both 'a' & 'b'
Description : In any spontaneous process, the __________ free energy decreases. (A) Helmholtz (B) Gibbs (C) Both ‘a’ & ‘b’ (D) Neither 'a' nor 'b'
Last Answer : (C) Both ‘a’ & ‘b’
Description : For a constant volume process __________ by the system is used only to increase the internal energy. (A) Heat absorbed (B) Work done (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Work done
Description : he gas law (PV = RT) is true for an __________ change. (A) Isothermal (B) Adiabatic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Optical activity is a/an __________ property. (A) Additive (B) Constitutive (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Work study deals with the __________ study. (A) Time (B) Motion (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : C) Both (A) & (B)