Description : Design of heterogamous catalytic reactor involves consideration of __________ steps. (A) Only chemical (B) Only physical (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : Which of the following is an example of stress corrosion? (A) Season cracking of brass (B) Caustic embrittlement of steel (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : Option C
Description : Electrochemical corrosion can occur, only if __________ is present in contact with metal. (A) Air (B) Oxygen (C) Liquid medium (D) Gaseous medium
Last Answer : (C) Liquid medium
Description : Chemical kinetics can predict the __________ of a chemical reaction. (A) Rate (B) Feasibility (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Rate
Description : Applicability of Bernoulli's equation is limited to a/an __________ fluid, that does not exchange shaft work with the surroundings. (A) Incompressible (B) Non-viscous (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) and (B)
Description : An isolated system can exchange __________ with its surroundings. (A) Matter (B) Energy (C) Neither matter nor energy (D) Both matter and energy
Last Answer : (C) Neither matter nor energy
Description : Though tin occurs lower than iron in the electrochemical series, yet it is coated on steel for corrosion protection, because of its (A) Lower cost (B) Abundant availability (C) Resistance to vegetable acids as the tin plate are commercially used in 'canning' industry (D) None of these
Last Answer : (C) Resistance to vegetable acids as the tin plate are commercially used in 'canning' industry
Description : Refrigeration cycle (A) Violates second law of thermodynamics (B) Involves transfer of heat from low temperature to high temperature (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (B) Involves transfer of heat from low temperature to high temperature
Description : For a solid catalysed chemical reaction, the effectiveness of solid catalyst depends upon the __________ adsorption. (A) Physical (B) Chemical (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (B) Chemical
Description : For multi-component multiple phases to be in equilibrium at the same pressure and temperature, the __________ of each component must be same in all phases. (A) Chemical potential (B) Fugacity (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : The chemistry of corrosion of iron is essentially an electrochemical phenomenon. Explain the reactions occurring during the corrosion of iron in the atmosphere. -Chemistry
Last Answer : The mechanism of corrosion is explained on the basis of electrochemical theory. By taking example of rusting of iron, we Refer tothe formation of small electrochemical cells on the surface of iron. The redox reaction involves ... net resultant Redox reaction is 2Fe(s) + O2 (g) + 4H+ → 2Fe2+ + 2H2O
Description : The deterioration of a metal by an electrochemical process is commonly termed as – (1) Erosion (2) Corrosion (3) Passivation (4) Abrasion
Last Answer : (2) Corrosion Explanation: Corrosion can be defined as the deterioration of materials by chemical processes.
Description : Define electrochemical corrosion.
Last Answer : Electrochemical corrosion:- The corrosion which is brought about through ionic reactions in the presence of moisture or solution as a conducting medium when two dissimilar metals are in contact with each other is called electro chemical corrosion.
Description : The deterioration of a metal by an electrochemical process is commonly termed as (1) Erosion (2) Corrosion (3) Passivation (4) Abrasion
Last Answer : Corrosion
Description : Name any four factors affecting electrochemical corrosion.
Last Answer : A) Nature of metal: 1) Position of metal in a galvanic series: A metal having higher position in a galvanic series has more chemical reactivity and therefore, it gets attacked by gaseous and ... as a conducting medium and promotes corrosion. e.g:- Rusting of Fe is promoted in humid atmosphere.
Description : Enzymes are organic catalysts used in the __________ reactions. (A) Chemical (B) Biochemical (C) Photochemical (D) Electrochemical
Last Answer : (B) Biochemical
Description : In nuclear reactions, __________ number is conserved. (A) Mass (B) Atomic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The cake resistance increases steadily with the time of filtration in a plate and frame filter employing constant __________ filtration. (A) Rate (B) Pressure (C) Both (A) & (B) (D) Neither (A) nor (B
Description : Width and speed of a conveyor belt depends upon the __________ of the material. (A) Lump size (B) Bulk density (C) Both (A) & (B) (D) Neither (A) nor (B
Description : Size reduction of moulding powders, waxes, resins & gums are done in a __________ mill. (A) Cage (B) Hammer (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Use of baffles in agitators help in minimising the __________ tendency. (A) Swirling (B) Vortexing (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The important dimensional group involved in the power requirement calculation in mixing operation is the __________ number. (A) Reynold's (B) Froude (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Separation of isotopes is generally done using a/an __________ centrifuge. (A) Ultra (B) Disk-bowl (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Ultra
Description : The damage/deterioration of metals by the __________ action of fluids is called 'erosion'. (A) Abrasive (B) Corrosive (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Abrasive
Description : Dry bulb temperature of unsaturated air is more than its __________ temperature. (A) Dew point (B) Wet bulb (C) Both 'a' & 'b' (D) Neither 'a' nor 'b
Last Answer : (C) Both 'a' & 'b
Description : Diffusion in concentrated solutions differs from that in dilute solutions, because of the change in the __________ with the concentration of the solution. (A) Degree of ideality (B) Viscosity (C) Both 'a '& 'b' (D) Neither 'a' nor 'b'
Last Answer : (C) Both 'a '& 'b
Description : In the desorption of highly soluble gas from the liquid, the main resistance will be in the __________ phase. (A) Gas (B) Liquid (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Liquid
Description : In the absorption of ammonia in water, the main resistance to absorption is by the __________ phase. (A) Liquid (B) Gas (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Gas
Description : The ratio of Murphree plate efficiency to point efficiency is always > 1 in a __________ flow model. (A) Plug (B) Perfectly mixed (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Plug
Description : The ratio of Murphree plate efficiency to point efficiency is 1 in a __________ flow model. (A) Plug (B) Perfectly mixed (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Perfectly mixed
Description : Packed column distillation is limited to the column __________ metres. (A) Height < 6 (B) Diameter < 0.6 (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : In case of constant underflow extraction operation, the __________ atall solute concentration. (A) Solids are drained to the same extent (B) Ratio of the insoluble to solution is constant (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Nusselt number (for forced convection heat transfer) is a function of the __________ number. (A) Prandtl (B) Reynolds (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Kirchoff’s law applies to __________ radiation. (A) Total (B) Monochromatic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : . A perfect black body is a perfect __________ of radiation. (A) Absorber (B) Emitter (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : With increase in the oxygen content of the coal, its __________ decreases. (A) Calorific value (B) Caking power (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Very __________ coals are completely devoid of cokability i.e., it is non-coking. (A) Young (B) Mature (C) Both 'a' & 'b' (D) Neither 'a' nor 'b
Last Answer : (C) Both 'a' & 'b'
Description : Bomb calorimeter can be used to determine the __________ of the coal. (A) Sulphur content (B) Calorific value (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The rate of shear versus the shear stress curves are time dependent for __________ fluid. (A) Thixotropic (B) Rheopectic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : . A Rotameter works on the principle of __________ pressure drop. (A) Constant (B) Variable (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Constant
Description : Velocity head on sudden enlargement in a horizontal pipe is converted into __________ head. (A) Elevation (B) Pressure (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Pressure
Description : With increase in temperature, the equilibrium __________ rises in case of endothermic reaction. (A) Constant (B) Conversion (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Conversion
Description : Signal normally used to study non-ideal flow by stimulus response technique is __________ input. (A) Pulse (B) Step (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The single parameter model proposed for describing non-ideal flow is the __________ model. (A) Tank in series (B) Dispersion (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : In a CSTR __________ varies with time. (A) Reaction rate (B) Concentration (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (D) Neither (A) nor (B)
Description : Sodium bisulphite is used for __________ water. (A) Deaeration (B) Dechlorination (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : If an ideal solution is formed by mixing two pure liquids in any proportion, then the __________ of mixing is zero (A) Enthalpy (B) Volume (C) Both 'a' & 'b' (D) Neither 'a' nor 'b'
Description : In any spontaneous process, the __________ free energy decreases. (A) Helmholtz (B) Gibbs (C) Both ‘a’ & ‘b’ (D) Neither 'a' nor 'b'
Last Answer : (C) Both ‘a’ & ‘b’
Description : For a constant volume process __________ by the system is used only to increase the internal energy. (A) Heat absorbed (B) Work done (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (B) Work done
Description : he gas law (PV = RT) is true for an __________ change. (A) Isothermal (B) Adiabatic (C) Both (A) & (B) (D) Neither (A) nor (B)