Description : How many telegraph channels are there in the basic voice band channels? A. 24 B. 96 C. 48 D. 672
Last Answer : A. 24
Description : What frequency is 10 octaves above 30 Hz? A. 30.72 kHz B. 30 kHz C. 300 Hz D. 307.2 kHz
Last Answer : A. 30.72 kHz
Description : How many voice band channels are there in a superjumbo group? A. 600 B. 900 C. 10,800 D. 3,600
Last Answer : C. 10,800
Description : A frequency of 3000 Hz has how many octaves above 1000 Hz? A. 1.6 octaves B. 2.1 octaves C. 1 octave D. 3 octaves
Last Answer : A. 1.6 octaves
Description : ____ system transmits frequency-division-multiplexed voice band signals over a coaxial cable for distances up to 4000 miles. A. T carrier B. X carrier C. L carrier D. F carrier
Last Answer : C. L carrier
Description : What carrier system multiplexes 96 voice band channels into a single 6.312 Mbps data signal? A. T1 carrier system B. T2 carrier system C. T1C carrier system D. T3 carrier system
Last Answer : B. T2 carrier system
Description : In SPADE system, how many PCM-encoded voice band channels are there? A. 800 B. 600 C. 300 D. 240
Last Answer : A. 800
Description : ECE Board Exam March 1996 The number of voice band channels in master group per CCITT standard is __________. A. 300 B. 480 C. 600 D. 12
Last Answer : A. 300
Description : Determine from the following the basic mode of transmission system in the public data network in which data are transferred from the source to the network and from the network to the destination in the frame format. A. Voice mode B. Asynchronous mode C. Synchronous mode D. Packet mode
Last Answer : D. Packet mode
Description : What is the frequency range of C-band? A. 10.95 to 14.5 GHz B. 27.5 to 31 GHz C. 3.4 to 6.424 GHz D. 1.53 to 2.7 GHz
Last Answer : C. 3.4 to 6.424 GHz
Description : At what particular wavelength is solar flux measured? A. 10.7 mm band B. 10.7 m band C. 10.7 cm band D. 10.7 nm band
Last Answer : C. 10.7 cm band
Description : What is the channel spacing for MF-HF voice frequencies? A. 2.8 kHz B. 500 Hz C. 3.5 kHz D. 3 kHz
Last Answer : D. 3 kHz
Description : How many voice signals (4 kHz max.) would fit into a 5 MHz spectrum? A. 1250 B. 500 C. 1000 D. 1500
Last Answer : A. 1250
Description : What type of modulation is used on voice and video signals? A. AM B. FM C. SSB D. QPSK
Last Answer : B. FM
Description : Reference noise is ___________. A. a 1000 Hz, -90 dBm tone B. a noise that creates the same interfering effect as a 1000Hz, -90dBm tone C. a noise that creates zero dBrn in a voice channel D. B and C above
Last Answer : D. B and C above
Description : You are measuring noise in a voice channel with a Lenkurt 601A, F1A weighting network and a flat meter. Your meter reads -47dBm. What is this reading in dBa? A. 77 dBa B. 35 dBa C. 38 dBa D. 32 dBa
Last Answer : C. 38 dBa
Description : How do you transmit through multiplexing, a thousand of voice channel information over a single fiber optic using on e wavelength? A. Polar division B. Time division C. Fiber division D. Frequency division
Last Answer : B. Time division
Description : In telecommunications when we call data communications it means the transmission of________. A. Voice and video B. Voice C. Video D. Computer data
Last Answer : D. Computer data
Description : Which of the following is referred to as a radio emission without sidebands A. Analog B. Carrier C. Data D. Voice
Last Answer : B. Carrier
Description : Nominal voice channel A. 20 to 20 KHz B. 16 to 16 KHz C. 3 to 3 KHz D. 4 KHz
Last Answer : D. 4 KHz
Description : 12 voice channels are sampled at 8000 sampling rate and encoded into 8 bit PCM word. Determine the rate of the data stream. a. 354 kbps b. 750 kbps c. 768 kbps d. 640 kbps
Last Answer : c. 768 kbps
Description : You are measuring noise in a voice channel at 7 dB test point level. The meter reads -56 dBm (FIA weighted). What is the reading in dBrnc? A. 20 B. 32 C. 35 D. 25
Last Answer : C. 35
Description : What is the phase delay of an 800 Hz voice signal if the phase shift is 15 degrees? A. 1.25 µsec B. 52 µsec C. 83.33 µsec D. 26 µsec
Last Answer : B. 52 µsec
Description : A voice-grade circuit using the PTN has an ideal passband of A. 0 to 4 Hz B. 0 to 4 kHz C. 0 to 4 GHz D. 0 to 4 MHz
Last Answer : B. 0 to 4 kHz
Description : You are measuring a voice channel at a -4 dB test point level, the meter reads -73 dBm (pure test tone) convert the reading in dBmCO. A. 16 B. 18 C. 22 D. 12
Last Answer : C. 22
Description : One of the reasons why FDM is being replaced by TDM is A. noise is amplified with voice when an FDM system is used B. it is difficult to place channels side by side C. there is more time than frequency D. Most available frequencies has been used
Last Answer : A. noise is amplified with voice when an FDM system is used
Description : In measuring noise in a voice channel at a 4 dB test point level, the meter reads -70 dBm (F1A weighted), convert the reading to pWp. A. 53 B. 93 C. 63 D. 83
Last Answer : B. 93
Description : What does the noise weighting curve shows? A. Noise signals measured with a 144 handset B. Power levels of noise found in carrier systems C. The interfering effect of other frequencies in a voice ... a reference frequency of one kilohertz D. Interfering effects of signals compared with a 3-kHz tone
Last Answer : C. The interfering effect of other frequencies in a voice channel compared with a reference frequency of one kilohertz
Description : ECE Board Exam March 1996 One type of pulse communications system uses pulse that appear as a group, and which vary in number according to the loudness of the voice. This type of ... A. pulse duration modulation B. pulse amplitude modulation C. pulse code modulation D. pulse position modulation
Last Answer : A. pulse duration modulation
Description : ECE Board Exam March 1996 What is the purpose of a beat frequency oscillator (BFO)? A. Aid in the reception of weak voice-modulated signals B. Generates a signal, whose frequency is the ... reception D. Generates an output, whose frequency differs from that of the intermediate frequency by 1 kHz
Last Answer : C. Generates a 1kHz note for Morse code reception
Description : What is the frequency range of C-band? A. 8.5 to 12.5 GHz B. 3.4 to 6.425 GHz C. 12.95 to 14.95 GHz D. 27.5 to 31 GHz
Last Answer : B. 3.4 to 6.425 GHz
Description : Which of the following are uplinks in the Ku band? A. 14 to 14.5 GHz B. 11.7 to 12.2 GHz C. 14 to 15.5 GHz D. 11 to 11.5 GHz
Last Answer : A. 14 to 14.5 GHz
Description : Which of the following is the uplink frequency in C-band? A. 5.925 GHz B. 4.2 GHz C. 7.425 GHz D. 3.7 GHz
Last Answer : A. 5.925 GHz
Description : TV channels 2, 4 and 5 are known as ________. A. Mid band UHF B. Low band UHF C. High band VHF D. Low band VHF
Last Answer : D. Low band VHF
Description : An FDM hierarchy which is formed by frequency – division multiplexing 10 super groups together for a combined capacity of 600 voice band message channels.
Last Answer : Mastergroup
Description : The band of light wavelengths that are too long to be seen by the human eye a. Amber b. Visible c. Infrared d. Ultraviolet
Last Answer : c. Infrared
Description : What is the typical bandwidth of a satellite band? A. 36 MHz B. 40 MHz C. 70 MHz D. 500 MHz
Last Answer : D. 500 MHz
Description : Most commercial satellite activity occurs in which band(s)? A. L B. C and Ku C. X D. S and P
Last Answer : B. C and Ku
Description : Most satellites operate in which frequency band? A. 30 to 300 MHz B. 300 MHz to 3 GHz C. 3 GHz to 30 GHz D. Above 300 GHz
Last Answer : C. 3 GHz to 30 GHz
Description : A method of multiple accessing where a given RF channel bandwidth is divided inot smaller frequency band. A. CDMA B. ANIK-D C. TDMA D. FDMA
Last Answer : D. FDMA
Description : The bandwidth of C-band satellite frequency band in U.S. A. 500 GHz B. 1000 GHz C. 1000 MHz D. 500 MHz
Description : The frequency of Ku band for satellite communications. A. 6/4 GHz B. 14/11 GHz C. 12/14 GHz D. 4/8 GHz
Last Answer : B. 14/11 GHz
Description : What band does VSAT first operate? A. L-band B. X-band C. C-band D. Ku-band
Last Answer : C. C-band
Description : What is the local oscillator (mixer) frequency of the satellite with an uplink frequency in GHz band? A. 3500 MHz B. 4500 MHz C. 2225 MHz D. 2555 MHz
Last Answer : C. 2225 MHz
Description : Where is the noise generated that primarily determines the signal-to-noise ratio in a VHF (150MHz) marine-band receiver? A. Man-made noise B. In the atmosphere C. In the receiver front end D. In the ionosphere
Last Answer : C. In the receiver front end
Description : Noise from random acoustic or electric noise that has equal energy per cycle over a specified total frequency band. A. Gaussian noise B. Whiter noise C. Thermal noise D. All of the above
Last Answer : D. All of the above
Description : What frequency band is referred to as the metric waves? A. VHF B. UHF C. HF D. SHF
Last Answer : A. VHF
Description : Which of the following systems uses frequency band 870-885 MHz as a transmit band of its base station? A. TACS B. NTT C. NMT D. AMPS
Last Answer : B. NTT
Description : What is the metric subdivision of VHF band? A. Metric B. Millimetric C. Decimetric D. Centimetric
Last Answer : A. Metric
Description : The band of frequencies least susceptible to atmospheric noise and interference is: A. 30 – 300 kHz B. 300 – 3000 kHz C. 3 – 30 MHz D. 300 – 3000 MHz
Last Answer : D. 300 – 3000 MHz