Description : The speech coding rate in D-AMPS is ____. A. 8 kbps B. 13 kbps C. 15 kbps D. 20 kbps
Last Answer : A. 8 kbps
Description : What is the transmission rate of a GSM cellular system? A. 64 kbps B. 240 kbps C. 128 kbps D. 270 kbps
Last Answer : D. 270 kbps
Description : The modulation technique used by GSM cellular system A. Phase shift keying B. Frequency shift keying C. Gaussian minimum shift keying D. QAM
Last Answer : C. Gaussian minimum shift keying
Description : A multiple access technique used in GSM cellular system A. TACS B. FDMA C. TDMA D. CDMA
Last Answer : C. TDMA
Description : Refers to the first generation of local loop system in telecommunication technology. A. GSM B. DECT C. Analogue cellular D. TACS
Last Answer : C. Analogue cellular
Description : 12 voice channels are sampled at 8000 sampling rate and encoded into 8 bit PCM word. Determine the rate of the data stream. a. 354 kbps b. 750 kbps c. 768 kbps d. 640 kbps
Last Answer : c. 768 kbps
Description : Basic speed rate of digital system. A. 144 kbps B. 1,544 kbps C. 64 kbps D. 2,048 kbps
Last Answer : C. 64 kbps
Description : In ISDN, what is the basic access B channel data rate? A. 32 kbps B. 64 kbps C. 144 kbps D. 16 kbps
Last Answer : B. 64 kbps
Description : What is the data rate of the ISDN Basic access B channel? A. 192 kbps B. 32 kbps C. 64 kbps D. 144 kbps
Description : In cellular system, the average lead time to install a new base station is approximately ____ months to a year. A. 4 B. 5 C. 6 D. 10
Last Answer : C. 6
Description : The front-end of a television receiver, having a bandwidth of 7Mhz, and operating at a temperature of 27˚C , consists of an amplifier having a gain of 15 followed by a mixer whose gain is 20. The ... equivalent noise resistance for this television receiver. A. 8760 Ω B. 875Ω C. 8.76Ω D. 0.876Ω
Last Answer : B. 875Ω
Description : What bandwidth is needed to support a capacity of 128 kbps when the signal power to noise power ratio in decibels is 100? A. 19224 Hz B. 3853 Hz C. 19244 Hz D. 3583 Hz
Last Answer : B. 3853 Hz
Description : The range of speech power is ____. A. 1 – 10 watts B. 100 – 1000 milliwatts C. 10 – 100 milliwatts D. 10 – 1000 microwatts
Last Answer : 10 – 1000 microwatts
Description : Which of the following is the world’s first cellular system to specify digital modulation and network level architecture? a) GSM b) AMPS c) CDMA d) IS-54
Last Answer : a) GSM
Description : Which of the following is an enhancement of GSM including the GPRS? A. 1G B. 2.5G C. 2G D. 3G
Last Answer : B. 2.5G
Description : The wireless evolution is achieved through the GSM family of wireless technology platforms which include but except one of the following. Which one is NOT a member of the GSM family? A. GSM B. EDGE C. GPRS D. CDMA
Last Answer : D. CDMA
Description : Which of the following is standardized as part of GSM phase 2+ that can offer theoretical data speeds of upto 115 kbit/s? A. EDGE B. GPRS C. WAP D. Bluetooth
Last Answer : B. GPRS
Description : What is known as the final stage in the evolution of the GSM standard? A. WAP B. GPRS C. EDGE D. Bluetooth
Last Answer : C. EDGE
Description : How wide is the spectrum bandwidth of a single GSM carrier? A. 100 kHz B. 200 kHz C. 50 kHz D. 16 kHz
Last Answer : B. 200 kHz
Description : Calculate the reverberation time of a living room 8 ft high, 13 ft wide and 20 ft long. The total absorption of the building structure inside the room is 180.7 sabines with four persons present in the room. A. 0.5 ms B. 0.05 s C. 0.5 s D. 5 ms
Last Answer : C. 0.5 s
Description : If link transmits 4000 frames per second and each slot has 8 bits, the transmission rate of circuit of this TDM is ______. a. 64 Kbps b. 32 Mbps c. 32 Kbps d. 64 MbpS
Last Answer : c. 32 Kbps
Description : Suppose transmission rate of a channel is 32 kbps. If there are ‘8’ routes from source to destination and each packet p contains 8000 bits. Total end to end delay in sending packet P is _____. a. 2 sec b. 3 sec c. 4 sec d. 1 sec
Last Answer : a. 2 sec
Description : A sender uses the Stop-and-Wait ARQ protocol for reliable transmission of frames. Frames are of size 1000 bytes and the transmission rate at the sender is 80 Kbps (1Kbps = 1000 bits/second). Size of ... is lost, the sender throughput is __________ bytes/second. a. 2500 b. 2000 c. 1500 d. 500
Last Answer : a. 2500
Description : Suppose a digitized voice channel is made by digitizing 8 kHz bandwidth analog voice signal. It is required to sample the signal at twice the highest frequency (two samples per hertz). What is the bit rate required, if it ... sample requires 8 bits? (A) 32 kbps (B) 64 kbps (C) 128 kbps (D) 256 kbps
Last Answer : (C) 128 kbps
Description : Assume that we need to download text documents at the rate of 100 pages per minute. A page is an average of 24 lines with 80 characters in each line and each character requires 8 bits. Then the required bit rate of the channel is ... ...... (A) 1.636 Kbps (B) 1.636 Mbps (C) 2.272 Mbps (D) 3.272 Kbps
Last Answer : Answer: Marks given to all
Description : If link transmits 4000 frames per second and each slot has 8 bits, the transmission rate of circuit of this TDM is ............... (A) 64 Kbps (B) 32 Mbps (C) 32 Kbps (D) 64 Mbps
Last Answer : (C) 32 Kbps
Description : Which causes a quantization noise in PCM system? A. Serial transmission errors B. The approximation of the quantized signal C. The synchronization between encoder and decoder D. Binary coding techniques
Last Answer : B. The approximation of the quantized signal
Last Answer : The approximation of the quantized signal
Description : For a loudness level between 110 and 120 dB, the maximum daily exposure limit is ____ minute (s). A. 1 B. 60 C. 20 D. 45
Last Answer : A. 1
Description : What is the optimum volume per person of rooms for speech? A. 2.8 B. 3.1 C. 4.2 D. 5.1
Last Answer : A. 2.8
Description : Iridium satellites can provide data communications of up ____ bps data rate. A. 1200 B. 4800 C. 2400 D. 3840
Last Answer : C. 2400
Description : Sources of impulse noise induced in communication channels. A. Erroneous digital coding bit caused by an error on a transmission facility B. Transients due to relay operation C. Crosstalk from dc signaling systems D. All of these
Last Answer : D. All of these
Description : Steps to follow to produce PCM signal. A. Quantizing, sampling, and coding B. Sampling, quantizing, and coding C. Sampling, coding and quantizing D. Coding, quantizing and coding
Last Answer : B. Sampling, quantizing, and coding
Description : The transformer signal coding method for T1 carrier is A. Binary B. NRZ C. Manchester D. Bipolar
Last Answer : D. Bipolar
Description : Quantization noise is caused by A. binary coding techniques B. serial transmission errors C. the synchronization between encoder and decoder D. the approximation of the quantized signal
Last Answer : D. the approximation of the quantized signal
Description : What mathematical plane figure is ideal in cellular system design and engineering it graphically and functionally depicts overlapping radio coverage between and among adjacent cell base stations? A. Hexagon B. Octagon C. Pentagon D. Nonagon
Last Answer : A. Hexagon
Description : In cellular system, _____ defines the geographic distance that is required between cells using identical frequencies in order to avoid interference between the radio transmissions at these cells. A. frequency-reuse ratio B. distance-to-reuse ratio (D/R) C. reuse format plan ratio D. reuse factor
Last Answer : B. distance-to-reuse ratio (D/R)
Description : What is considered as the most advanced satellite system developed for cellular telephones? A. Iridium B. Globalstar C. ANIK D. Molniya
Last Answer : A. Iridium
Description : A digital identification associated with a cellular system A. SAT B. ESN C. MIN D. SIM
Last Answer : D. SIM
Description : A transmitter supplies 8 kW to the antenna when it is unmodulated, determine the total radiated power when modulated at 90%. A. 5 kW B. 20 kW C. 15 kW D. 8.36 kW
Last Answer : D. 8.36 kW
Description : Station A uses 32 byte packets to transmit messages to Station B using a sliding window protocol. The round trip delay between A and B is 80 milliseconds and the bottleneck bandwidth on the path between A and B ... What is the optimal window size that A should use? a. 20 b. 40 c. 160 d. 320
Last Answer : b. 40
Description : Station A uses 32 byte packets to transmit messages to station B using sliding window protocol. The round trip delay between A and B is 40 milli seconds and the bottleneck bandwidth on the path between A and B is 64 kbps. The optimal window size of A is (1) 20 (2) 10 (3) 30 (4) 40
Last Answer : (2) 10
Description : A coherent binary phase shift keyed BPSK transmitter operates at a bit rate of 20 Mbps with a carrier to noise ratio C/N of 8.8dB. Find Eb/No. A. 73 dB B. 62.4 dB C. 81.8 dB D. 8.8 dB
Last Answer : D. 8.8 dB
Description : A noiseless 3 KHz Channel transmits bits with binary level signals. What is the maximum data rate? A. 3 Kbps B. 6 Kbps C. 12 Kbps D. 24 Kbps
Last Answer : 6 Kbps
Description : Maximum data transfer rate of the optical fiber is……….? a. 50 kbps b. 1000 kbps c. 1000 Mbps d. None of the these
Last Answer : c. 1000 Mbps
Description : Broad Band ISDN handles data rate of about (A) 64 kbps (B) 100 mbps (C) 5.4 mbps (D) 2.048 mbps
Last Answer : (A) 64 kbps
Description : How much packet data rate per user is supported by W-CDMA if the user is stationary? a) 2.048 Kbps b) 100 Mbps c) 2.048 Mbps d) 1 Gbps
Last Answer : c) 2.048 Mbps
Description : What is the channel symbol rate in Bluetooth for each user? a) 270.833 Kbps b) 1 Gbps c) 100 Mbps d) 1 Mbps
Last Answer : d) 1 Mbps
Description : A multiplexer combines four 100-Kbps channels using a time slot of 2 bits. What is the bit rate? (A) 100 Kbps (B) 200 Kbps (C) 400 kbps (D) 1000 Kbps
Last Answer : (C) 400 kbps
Description : A cellular standard known as the cdmaOne. A. IS-95 B. IS-136 C. IS-54 D. IS-100
Last Answer : A. IS-95