165 views

1 Answer

Answer :

In a two value capacitor motor, the capacitor used for running purposes is paper spaced oil filled type.

Like 0 like

Please log in or register to answer this question.

Related questions

102 views

Last Answer : The value of starting capacitor of a fractional horse power motor will be 300 uF .

1 answer
244 views

Description : A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?

Last Answer : A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will not start at all.

1 answer
216 views

Last Answer : In a capacitor start motor, the phase displacement between starting and running winding can be nearly 90°.

1 answer
726 views

Last Answer : In a capacitor start and run motors the function of the running capacitor in series with the auxiliary winding is to improve power factor.

1 answer
234 views

Last Answer : In a capacitor start single-phase motor, when capacitor is replaced by a resistance motor will continue to run in same direction.

1 answer
106 views

Last Answer : If the capacitor of a single-phase motor is short-circuited the motor will not start.

1 answer
117 views

Description : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?

Last Answer : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be at the slot edge where coil enters or comes out of the slot.

1 answer
106 views

Last Answer : In a split phase motor, the running winding should have low resistance and high inductance.

1 answer
135 views

Last Answer : To reverse the direction of rotation of a capacitor start motor while it is running we should disconnect motor from the supply till it stops then reconnect it to supply with reversed connection of main or auxiliary winding.

1 answer
191 views

Last Answer : If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then Electrolytic capacitor will, in all probability, suffer break down.

1 answer
77 views

Last Answer : Two-value capacitor motor finds increased application as compressor motor in small home air-conditioners because it has low starting as well as running currents at relatively high power factor.

1 answer
94 views

Last Answer : The repulsion-start induction-run motor is used because of high starting torque.

1 answer
149 views

Last Answer : The motor used on small lathes is usually single-phase capacitor run motor.

1 answer
110 views

Last Answer : A shaded pole motor can be used for toys, hair dryers, circulators etc.

1 answer
892 views

Last Answer : A centrifugal switch is used to disconnect starting winding when motor has picked up about 50 to 70 per cent of rated speed.

1 answer
2.9k views

Description : Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

Last Answer : Which of the following can be used to measure the capacitance of a capacitor? A) Rheostat B) Schering bridge C) Wheatstone bridge D) None of these

1 answer
96 views

Last Answer : Commonly used standard capacitor is concentric cylindrical type.

1 answer
135 views

Last Answer : The capacitors used in single-phase capacitor motors have no polarity marking.

1 answer
81 views

Description : Which capacitor is used for high frequency?

0 answers
98 views

Description : Why shunt capacitor is used?

Last Answer : To improve voltage at receiving end and power factor

1 answer
172 views

Description : Why capacitor bank is used?

Last Answer : In industrial or factory used E.B Power supply must be maintained above 0.90 power factor is compulsory for avoid EB Penalty. So APFC ( automatic Power factor control ) panel is used to maintained balance the load and PF maintained.

3 answers
284 views

Description : Why is a capacitor used in a single phase motor and not in three phase motor ?

Last Answer : In 1-phase induction motor capacitor work is generate the auxiliary winding current than excite the main winding to rotor starts rotate. After rotor start rotating about 75% of their speed than auxiliary ... emf to start the motor.so,in 3-phase induction motor is self start induction motor.

6 answers
454 views

Description : Explain the working of a single phase capacitor start induction motor. 

Last Answer : Single phase capacitor start induction motor https://youtu.be/31lvvzU5Puc

2 answers
103 views

Last Answer : In a ceiling fan employing capacitor run motor secondary winding surrounds the primary winding.

1 answer
92 views

Description : Can we use the synchronous motor as the synchronous capacitor?

Last Answer : Yes, we can use the synchronous motor as the synchronous capacitor when the synchrnous motor is overexcited.

1 answer
147 views

Description : Write two applications of D.C. series motor. 

Last Answer : The applications of D.C. series motor: 1. Cranes 2. Hoists 3. Trolley and cars 4. Conveyors 5. For traction work i.e. electric locomotives 6. Elevator 7. Air compressor

1 answer
125 views

Last Answer : The operating speed of a synchronous motor can be changed to new fixed value by changing frequency.

1 answer
416 views

Description : Explain the need and steps to conduct the reduced voltage running up test on the three phase induction motor.

0 answers
697 views

Last Answer : Energy conservation technique in induction motor by minimizing idle and redundant running of motor: 1) Loss of energy as the no load power drawn is approximately about 12% to 16% of rated ... to unnecessary line losses. 4) Reduction in overall system energy efficiency over period of time.

1 answer
358 views

Description : A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is

Last Answer : A 200 V dc shunt motor is running at 1000 rpm and drawing a current of 10 A. Its armature winding resistance is 2 Ohm. It. is braked by plugging. The resistance to be connected in series with armature to restrict armature current to 10 A, is 36 Ohm

1 answer
583 views

Description : The effect of increasing load on a synchronous motor running with normal excitation is (A) Increase both its Ia and power factor. (B) Decrease Ia, but increase power factor. (C) Increase Ia, but decrease power factor (D) Decrease both Ia and power factor.

Last Answer : The effect of increasing load on a synchronous motor running with normal excitation is Increase Ia, but decrease power factor

1 answer
204 views

Last Answer : A synchronous motor running with normal excitation adjusts to load increases essentially by increase in armature current.

1 answer
121 views

Last Answer : If the synchronous motor, properly synchronised to the supply is running on no load and is having negligible loss then the stator current will be zero.

1 answer
105 views

Last Answer : In capacitor start single-phase motors current in the starting winding leads the voltage.

1 answer
217 views

Description : State the insulating materials used in motor. Write temperature class and withstand temperature ranges for them. 

Last Answer : The insulating materials used in motor are as belows: 1. Cotton, 2. Silk, or paper, 3. Press board, 4. Resins 5. PVC 6. Cellulose-Fiber, 7. Enameled coating, etc  ... Over 180° Mica, porcelain, ceramics, glass quartz, asbestos, treated glass fiber or treated asbestos. etc.

1 answer
156 views

Description : State starters used for i) 3-Ph squirrel cage induction motor (3HP) ii) D.C. motor 

Last Answer : Name the starters used for following motors : i) 3 H.P. 3-Ph squirrel cage I.M: i) DOL starter OR ii) Star-Delta Starter OR ii) Auto transformer starter OR iii) Soft start starter.  ii) D.C Shunt Motor : 1) Armature resistance starter (Three Point Starter) OR 2) Four Point Starter 

1 answer
1.1k views

Description : The motor used for electric traction is  (1) D.C. shunt motor (3) D.C. series motor  (2) D.C. compound motor (4) Synchronous motor

Last Answer : The motor used for electric traction is D.C. series motor

1 answer
65 views

Last Answer : The motor used for the compressors is capacitor-start capacitor-run motor.

1 answer
67 views

Last Answer : The shaded pole motor is used for low starting torque.

1 answer
105 views

Last Answer : The speed control of universal motor used for sewing machines is by varying the resistance.

1 answer
57 views

Last Answer : The electric motor used in portable drills is universal motor.

1 answer
163 views

Description : The damping winding in synchronous motor is generally used to?

Last Answer : The damping winding in synchronous motor is generally used to provide starting torque and prevent hunting.

1 answer
77 views

Description : Which type of starter is used to start the DC motor?

0 answers
81 views

Description : Which type of motor is used in lift?

Last Answer : Synchronous motor

1 answer
81 views

Description : Why DC motor is used for traction?

0 answers
78 views

Description : Which motor is used in traction system?

0 answers
149 views

Description : The number of poles in a phase induction motor at 50 Hz and running at 1500 rpm will be?

Last Answer : The number of poles in a phase induction motor at 50 Hz and running at 1500 rpm will be 4.

1 answer
116 views

Last Answer : Short-circuiter is used in repulsion start induction run motor.

1 answer
121 views

Last Answer : When a D.C. series motor is connected to A.C. supply, the power factor will be low because of high inductance of field and armature circuits.

1 answer
97 views

Last Answer : The speed of a universal motor is generally reduced by using gear trains.

1 answer
...