# The impedance of a circuit is given by z=3+j4. Its conductance will be?

The impedance of a circuit is given by z=3+j4. Its conductance will be?

The impedance of a circuit is given by z=3+j4. Its conductance will be 3/25.

## Related questions

Description : The per unit impedance ofa circuit element is 0.15. If the base kV and base MVA are halved, then the new value of the per unit impedance of the circuit element will be?

Last Answer : The per unit impedance ofa circuit element is 0.15. If the base kV and base MVA are halved, then the new value of the per unit impedance of the circuit element will be 0.30.

Description : The square root of the ratio of line impedance and shunt admittance is called the (a) surge impedance of the line (b) conductance of the line (c) regulation of the line (d) none of the above

Last Answer : (a) surge impedance of the line

Description : The square root of the ratio of line impedance and shunt admittance is called the (a) surge impedance of the line (b) conductance of the line (c) regulation of the line (d) none of the above

Last Answer : (a) surge impedance of the line

Description : A loss less line terminated with its surge impedance has

Last Answer : A loss less line terminated with its surge impedance has flat voltage profile.

Description : A loss less transmission line having Surge Impedance Loading (SIL) of 2280 MW is provided with a uniformly distributed series capacitive compensation of 30%. Then, SIL of the compensated transmission line will be (A) 1835 MW (B) 2280 MW (C) 2725 MW (D) 3257 MW

Last Answer : A loss less transmission line having Surge Impedance Loading (SIL) of 2280 MW is provided with a uniformly distributed series capacitive compensation of 30%. Then, SIL of the compensated transmission line will be 2280 MW

Description : A 10 kVA, 400 V/200 V single phase transformer with 10% impedance draws a steady short-circuit line current of   (a) 250A (b) 50 A (c) 150 A (d) 350 A

Last Answer : A 10 kVA, 400 V/200 V single phase transformer with 10% impedance draws a steady short-circuit line current of 250A

Description : A lossless radial transmission line with surge impedance loading?

Last Answer : A lossless radial transmission line with surge impedance loading takes negative VAr at sending end and zero VAr at receiving end.

Description :  A single-phase transmission line of impedance j 0.8 ohm supplies a resistive load of 500 A at 300 V. The sending end power factor is?

Last Answer :  A single-phase transmission line of impedance j 0.8 ohm supplies a resistive load of 500 A at 300 V. The sending end power factor is 0.6 lagging.

Description : The formula for computing impedance in a series circuit containing resistance, capacitance, and inductance is _____________. [ NOTE: the symbol * stands for 'multiplied by' ] A. Z = RT + XL + XC B. Z = R + XL - XC C. Z * Z = R * R + (XL - XC) * (XL - XC) D. Z = R * R + (XL * XC) - (XL * XC)

Description : In AC Circuit Theory, the term that replaces the resistance is: w) inductance x) capacitance y) impedance z) reactance

Last Answer : ANSWER: Y -- IMPEDANCE

Description : The Weber and the Maxwell are units of measure of: w) conductance x) electrical current y) magnetic flux z) relative speed

Last Answer : ANSWER: Y -- MAGNETIC FLUX

Description : The Tesla and the Gauss are units of measure of: w) conductance x) magnetic field strength y) magnetic flux z) electrical current

Last Answer : ANSWER: X -- MAGNETIC FIELD STRENGTH

Description : Conductance is given by (where, x = thickness, A = heat flow area, K = thermal conductivity.) (A) x/KA (B) KA/x (C) K/Ax (D) A/Kx

Last Answer : (B) KA/x

Description : A large AC generator, supplying power to an infinite bus, has a sudden short-circuit occurring at its terminals. Assuming the prime mover input and the voltage behind the transient reactance to remain constant immediately after the fault, acceleration of the generator rotor is

Last Answer : A large AC generator, supplying power to an infinite bus, has a sudden short-circuit occurring at its terminals. Assuming the prime mover input and the voltage behind the transient reactance ... , acceleration of the generator rotor is inversely proportional to the moment of inertia of the machine

Description : A three-phase, 33 kV oil circuit breaker is rated 1200 A, 2000 MVA, 3 s. The symmetrical breaking current is  (A) 1200 A (B) 3600 A (C) 35 kA (D) 104.8 kA

Last Answer : A three-phase, 33 kV oil circuit breaker is rated 1200 A, 2000 MVA, 3 s. The symmetrical breaking current is 35 kA

Description : In parallel RLC resonance circuit at resonance the current will be  (1) Minimum (2) Maximum (3) Zero (4) Infinite

Last Answer : In parallel RLC resonance circuit at resonance the current will be Minimum

Description : An RLC series. circuit remains predominantly inductive

Last Answer : Above resonance frequency

Description : In order to check the performance of a transistor removed from its circuit, the instrument to be used should be a/an ____________. A. voltmeter or transistor tester B. impedance meter C. ohmmeter or transistor tester D. sensitive potentiometer

Description : What technique is used to solve load flow problems using Z-bus (Bus impedance matrix)?

Last Answer : The formulation of load flow problem using Zbus employs Diakoptics techniques which is actually the piecewise solution of the power system problem by using tearing off technique.

Description : What is the impedance of a one microfarad capacitor at 60 Hertz: w) 16,700 ohms x) 2,650 ohms y) 3.8x10-4 ohms z) 6x10-5 ohms

Last Answer : ANSWER: X -- 2,650 OHMS

Description : How to find total impedance Z, current I and Impedance angle ?

Last Answer : How to find total impedance Z, current I and Impedance angle ?

Description : The impedance Z offered by transmission line for a travelling wave which damps out the low frequency oscillation rapidly is also called

Last Answer : The impedance Z offered by transmission line for a travelling wave which damps out the low frequency oscillation rapidly is also called Both surge and natural impedances.

Description : The transistors in the illustrated circuit are connected using what type of coupling? EL-0051 A. RC coupling B. transformer coupling C. impedance coupling D. direct coupling

Description : The transistors in the illustrated circuit are connected using what type of coupling? EL-0050 A. RC coupling B. transformer coupling C. Impedance coupling D. direct coupling

Description : To conduct an in-circuit test of a transistor, you should use a/an ____________. A. voltmeter or transistor tester B. impedance meter C. ohmmeter or transistor tester D. wattmeter

Description : Decreasing the frequency in a capacitive circuit while maintaining a constant circuit voltage, will result in a/an _____________. A. increase in apparent power B. decrease in circuit current C. decrease in capacitive reactance D. decrease in total impedance

Description : Which of the electrical properties listed will always be the same for each component in a parallel circuit? A. Impedance B. Current C. Resistance D. Voltage

Description : The combined effect of inductive reactance, capacitive reactance, and resistance in an AC series circuit is known as _____________. A. reactance B. total reactance C. impedance D. resonance

Description : The opposition to the establishment of magnetic lines of force in a magnetic circuit is called the circuit's _______. A. resistance B. reluctance C. impedance D. inductance

Description : Which of the following precautions should be taken when troubleshooting various power circuits using a common solenoid-type mechanical voltage tester (wiggins)? A. Never use this tester on circuits greater ... voltage expected in the circuit in order to prevent damage from an off-scale reading.

Description : When troubleshooting electronic equipment, you should use a high impedance multimeter ________________. A. to prevent excess current flow through the meter that would damage it B. for AC measurements only ... being tested D. so as not to load down the circuit and obtain erroneous voltage readings

Description : The purpose of a short circuit forcing module (short time trip) installed in a branch line is to provide ____________. A. high speed clearance of low impedance short circuits in the branch B. ... C. isolation of short circuits by selective tripping of branch circuit breakers D. all of the above

Description : A final amplifier of a radio transmitter draws 250 mA of plate current when the plate supply voltage is 1400 volts. If the plate circuit efficiency is 80% and the transmitter is connected to an antenna having a feed impedance of 70 ohms, ... at the feed-point? A. 4.0 A B. 2.2 A C. 1.25 A D. 2.0 A

Last Answer : D. 2.0 A

Description : ___________ is device that measures the internal open circuit voltage of an equivalent noise generator having an impedance of 600Ω and delivering noise power to a 600 Ω load. A. Psophometer B. Barometer C. Reflectometer D. Voltmeter

Last Answer : A. Psophometer

Description : Give equivalent resistance, reactance and impedance referred to secondary circuit.

Last Answer : Req = R2 +R1' = R2+ R1'/a² Xeq = X2 +X1' = X2+ X1'/a² Zeq = Z2 + Z1' = Z2+ Z1'/a² where a=T1/T2

Description : Give equivalent resistance, reactance and impedance referred to primary circuit.

Last Answer : Req = R1 +R2' = R1+a² R2' Xeq = X1 +X2' = X1+a² X2' Zeq = Z1 +Z2' = Z1+a² Z2' where a=T1/T2

Description : In 3 state gate third position termed as high impedance state which acts as. a. Open circuit b. — Close circuit c. None of these d. All of above

Last Answer : a. Open circuit

Description : If the output impedance of an amplifier circuit is decreased, what is the effect on the gain?

Last Answer : The gain decreases.

Description : In a parallel-resonant circuit, what is the relationship between impedance and current?

Last Answer : Maximum impedance, minimum current.

Description : In a series-RLC circuit, what is the condition of the circuit if there is high impedance, low current, and low reactance voltages

Last Answer : Nonresonant (circuit is either above or below resonance)

Description : . In an "ideal" resonant circuit, what is the relationship between impedance and current?

Last Answer : Impedance low Current high.

Description : What is the difference between calculating impedance in a series ac circuit and in a parallel ac circuit?

Last Answer : In a series circuit impedance is calculated from the values of resistance and reactance. In a parallel circuit, the values of resistive current and reactive current must be used to calculate total impedance.

Description : What type of impedance does the tank circuit have above resonance?

Last Answer : Inductive.

Description : The input impedance of your test equipment should exceed the impedance of the circuit under test by what ratio?

Last Answer : 10 to 1

Description : What impedance relationship between the output of one circuit and the input of another circuit will provide the maximum power transfer?

Last Answer : Equal impedance.

Description : Voltage measurement in a high impedance circuit requires a voltmeter with

Last Answer : high input impedance

Description : What happens to output when a tri-state circuit is selected for high impedance.

Last Answer : Output is disconnected from rest of the circuits by internal circuitry.

Description : Write equation of resultant impedance in R-L circuit.

Last Answer : The equation of resultant impedance in R-L circuit

Description : Draw a circuit diagram of R.C. series circuit. Draw impedance triangle and power triangle for same circuit.

Last Answer : Draw a circuit diagram of R.C. series circuit. Draw impedance triangle and power triangle for same circuit.

Description : Draw impedance triangle and voltage triangle for RL series circuit

Last Answer : impedance triangle and voltage triangle for RL series circuit