Epoxy pressure grouting is suitable for
a) wide and deep crack
b) fine and deep crack
c) fine but not very deep crack*
d) None of the above

1 Answer

Answer :

c) fine but not very deep crack*

Related questions

Description : Cement pressure grouting is suitable for a) Very fine crack b) weathered concrete c) Active crack where cause of crack is known and remedial action has been taken* d) Crushed masonry

Last Answer : c) Active crack where cause of crack is known and remedial action has been taken

Description : In Epoxy pressure grouting, pressure is kept as a) 2 to 4 kg./sqcm. b) 3 to 6 kg./sqcm. c) 3 to 10 kg./sqcm. d) 3.5 to 7 kg./sqcm.*

Last Answer : d) 3.5 to 7 kg./sqcm.*

Description : Repairing by cement pressure grouting can be adopted in case of a) Honey comb concrete b) Hollow masonry, Dormant cracks c) Deep leached mortar joints d) all the above*

Last Answer : d) all the above*

Description : In cement pressure grouting G.I pipes of diameter …… and ……length, should be fixed in drilled holes a) 12 to 20 mm, 200 mm* b) 12 to 20 mm, 300 mm c) 12 to 25 mm, 500 mm d) 20 to 25 mm, 300 mm

Last Answer : a) 12 to 20 mm, 200 mm*

Description : In cement pressure grouting holes should be drilled at spacing in both direction at a) 150 – 500 mm b) 450 mm c) 500 – 750 mm* d) 1000 mm

Last Answer : c) 500 – 750 mm*

Description : In cement pressure grouting, water cement ratio is kept as a) 0.4 to 0.5* b) 0.3 to 0.4 c) 0.25 to 0.35 d) 0.35 to 0.5

Last Answer : a) 0.4 to 0.5*

Description : In cement pressure grouting, pressure is kept as a) 2 to 4 kg./sqcm.* b) 3 to 6 kg./sqcm. c) 3 to 10 kg./sqcm. d) 3.5 to 7 kg./sqcm.

Last Answer : a) 2 to 4 kg./sqcm.*

Description : Corrosion in Steel girder bridges may be prevented by : a) Protective coatings by painting b) Metallising c) Use of epoxy based paints d) All the above*

Last Answer : d) All the above*

Description : Side looking 700 2MHZ probe is tested for detecting. (i) Flaw in head (ii) Flaw in web (iii) Half moon crack in flange.* (iv) For all above.

Last Answer : iii) Half moon crack in flange

Description : If code of a fracture is OFW-422 then it means. (i) AT welding with transverse crack. (ii) Flash butt welding with transverse crack. (iii) At welding with horizontal crack.* (iv) None of the above.

Last Answer : (iii) At welding with horizontal crack.*

Description : Ultrasonic Pulse Velocity test is meant for a) Identifying the integrity of concrete* b) Finding the strength of concrete c) To know the crack in steel structure d) To know the flaw in rail

Last Answer : a) Identifying the integrity of concrete*

Description : The danger level should be marked with a bright red band …… wide centrally over a white band …… wide for a length of……… a) 5 cm, 10 cm, 60 cms* b) 10 cm, 20 cm, 60 cm c) 15 cm, 30 mm, 60 cm d) None of the above

Last Answer : a) 5 cm, 10 cm, 60 cms*

Description : The most suitable method for drainage of fine grained cohesive soils is (A) Well point system (B) Vacuum method (C) Deep well system (D) Electro-osmosis method

Last Answer : Answer: Option D

Description : When the railway crosses a deep vally without perinial water,it is called……. a)Aqueduct * b)Cause way c)Via-duct d)River crossing

Last Answer : a)Aqueduct *

Description : What is speed restriction on deep screening site done by BCM and tamped by machine followed with DGS? (a) 20 (b) 30 (c) 40* (d) 10

Last Answer : (c) 40*

Description : Deep screening of entire track must be done at least:- (a) Once in a quarter. (b) Once in a year. (c) Once in 5 years. (d) Once in 10 years.*

Last Answer : (d) Once in 10 years.*

Description : Epoxy resin transformers are more suitable in hazardous areas. Give reason.

Last Answer : Reason for Epoxy resin transformers are more suitable in hazardous areas :   1. Core used is of CRGO M4-M3 circular size, minimizes leakage reactance and hence core losses will be less. 2. Winding ... of oil there is no need of testing the dielectric strength of oil or no filtration of oil.

Description : Dumpy level is most suitable when (a) The instrument is to be shifted frequently (b) Fly leveling is being done over long distance (c) Many readings are to be taken from a single setting of the instrument* (d) All of the above

Last Answer : (c) Many readings are to be taken from a single setting of the instrument*

Description : Granite is not suitable for ordinary building purpose because a) It cannot be polished b) It is not fireproof c) It is costly*

Last Answer : c) It is costly*

Description : The uplift pressure on a dam can be controlled by (i) Constructing cut-off under upstream face (ii) Constructing drainage channels between the dam and its foundation (iii) By pressure grouting in foundation The correct answer is ... ) and (ii) (C) Both (i) and (iii) (D) (i), (ii) and (iii)

Last Answer : Answer: Option D

Description : Let us travel the world with the trivia questions ever regarding world geography. Earth inhabitants a wide diversity of people in numerous countries. Do you know all about them? Test your knowledge ... trivia questions. Let's see if you can answer these country based hardest trivia crack questions.

Last Answer : In which continent does the country Argentina reside?

Description : Pick up the correct statement from the following: (A) The plywoods do not split or crack due to changes in atmosphere (B) The commercial plywoods are available upto 150 cm wide and upto 300 cm long (C) The plywoods possess uniform tensile strength in all directions (D) All the above

Last Answer : Answer: Option D

Description : A concrete dam 15 m deep and 2 m wide containing water to a depth of 10 m .Find total hydrostatic pressure per meter run and centre of pressure on upstream face.

Last Answer : A concrete dam 15 m deep and 2 m wide containing water to a depth of 10 m .Find total hydrostatic pressure per meter run and centre of pressure on upstream face.

Description : Flash distillation is suitable for separating the constituents of a binary system, which (A) Form minimum boiling azeotrope (B) Have very wide boiling points (C) Have very close boiling points (D) Form constant boiling azeotrope

Last Answer : (B) Have very wide boiling points

Description : Flash distillation is suitable for the separation of components (A) Having very close boiling points (B) Which form maximum boiling azeotrope (C) Having very wide boiling points (D) Which form minimum boiling azeotrope

Last Answer : (C) Having very wide boiling points

Description : Piping in a soil mass is a) Erosion of subsoil by the high velocities of flow of water through it when such velocities exceed a certain limit* b) Caused due to very low exit gradient c) ... connected pores d) Due to loss of the strength of cohesion less soil because of upward flow of of water

Last Answer : a) Erosion of subsoil by the high velocities of flow of water through it when such velocities exceed a certain limit*

Description : A filter press is (A) A batch filter (B) Not suitable, if the liquid is the main product (C) Having prohibitively high maintenance cost (D) Not suitable for wide range of materials under varying operating conditions of cake thickness and pressure

Last Answer : (A) A batch filter

Description : Pressure of Oxygen during pre-heating shall be? (i) 4.0 – 5.0 kg/ sq cm (ii) 5.0 – 6.0 kg/ sq cm (iii) 6.0 – 7.0 kg/ sq cm (iv) 7.0 – 8.0 kg/ sq cm *

Last Answer : (iv) 7.0 – 8.0 kg/ sq cm *

Description : Pressure of compressed air is kept during preheating by CAPS? (i) 1 to 2 kg/cm2 (ii) .1 to .2 kg/cm2 (iii) 2 to 3 kg/cm2 (iv) 0.2 to 0.3 kg/cm2*

Last Answer : (iv) 0.2 to 0.3 kg/cm2*

Description : The maximum pressure which the soil can carry safely without the risk of shear failure is called a) Safe bearing capacity b) Ultimate bearing capacity* c) Allowable bearing capacity d) Shear bearing capacity

Last Answer : b) Ultimate bearing capacity*

Description : The pressure on soil worked out shall be ……… the SBC of the soil. a) more than b) equal to c) not equal to d) less than*

Last Answer : d) less than*

Description : any tips on re-grouting bathroom shower tiles?

Last Answer : Getting the old grout out is the worst. I bought a dremmel tool with a special attachment for removing grout. It takes a while, but it works. I've completely stopped using sanded grout cause I've ... already has the sealer included in the mix (I'm sorry, I've completely forgotten what it's called)

Description : The fluid generally used for grouting is (A) Cement and water mix (B) Clay suspension (C) Sodium silicate (D) All the above

Last Answer : (D) All the above

Description : Pick up the correct statement from the following: (A) The permeability of the coarse-grained soils may be reduced by grouting (B) The process of injecting fluids (i.e. grouts) into the pores space of the soil is called grouting (C) The grouting increases the soil strength (D) All the above

Last Answer : Answer: Option D

Description : __________ is used for tying the steel columns to concrete foundation. (A) Grouting (B) Eyebolt (C) Anchor bolts (D) Refractory castables

Last Answer : C) Anchor bolts

Description : The recommended grade of tar for grouting purpose is (A) RT-1 (B) RT-2 (C) RT-3 (D) RT-5

Last Answer : Answer: Option D

Description : The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as (A) Trowelling (B) Laying (C) Grouting (D) Placing

Last Answer : Answer: Option B

Description : The bearing capacity of a water logged soil, may be improved by (A) Grouting (B) Chemical action (C) Drainage (D) Compaction

Last Answer : Answer: Option C

Description : The bearing capacity of a water logged soil can be improved by (A) Compacting the soil (B) Draining the soil (C) Increasing the depth of foundation (D) Grouting

Last Answer : Option B

Description : Explain in brief Guniting and Grouting.

Last Answer : Guniting-Process of applying cement and sand (1:3) mixture under pressure (20 -30N/cm2)on concrete surface in order to repair concrete work. It is a process of repairing concrete work or ... masonry. The process of placing a grout material into cavities of concrete or masonry is called grouting.

Description : Where can I find a cylindrical stainless steel container that is about 4" wide by 5 1/2" deep?

Last Answer : Any friends in the military? I bet some of the military shops have food or coffee in cans that size

Description : How deep and wide to Clematis roots go?

Last Answer : tHEY ARE NOT TOO DEEP, THEY LIKE TO BE UNDER COOL PLACES FOR THE ROOTS AND BRIGHT TO SUNNY PLACES FOR THE FLOWERS.

Description : How much dirt is in a hole that was dug 5m deep and 6m wide? -Riddles

Last Answer : There is no dirt because it was dug out.

Description : A cuboidal water tank is 6m long, 5m wide and 4.5m deep. How many litres of water can it hold? -Maths 9th

Last Answer : Dimensions of a cuboidal water tank are: l = 6 m and b = 5 m and h = 4.5 m Formula to find volume of tank, V = l b h Put the values, we get V = (6 5 4.5) = 135 ... water, 135 m3volume hold = (135 1000) litres = 135000 litres Therefore, given cuboidal water tank can hold up to135000 litres of wate

Description : The number of planks of dimensions (4 m x 50cm x 20cm) that can be stored in a pit which is 16 m long, 12 m wide and 40 m deep is -Maths 9th

Last Answer : Length of the plank=4m=400cm Breadth=50cm Height=20cm Volume of the plank=L*B*H =400*50*20 =400000cm^3 Length of the pit=16m=1600cm Breadth=12m=1200cm Height=4m=400cm Volume of the pit= L ... *1200*400 =768000000cm^3 Number of planks that can be fitted= 768000000/400000 =1920 planks is the answer.

Description : The number of planks of dimensions (4 m x 50cm x 20cm) that can be stored in a pit which is 16 m long, 12 m wide and 40 m deep is -Maths 9th

Last Answer : Solution of this question

Description : A river 3 m deep and 40 m wide -Maths 9th

Last Answer : Length of water canal in one minute = 2 x 1000 m/60 = 100/3 m Volume of water flowing into the sea in one minute = l x b x h = (100 x 40 x 3)/3 = 4000 m 3 = 4000 x 1000 L = 4000000 L ( Since,1 m3 = 1000 L)

Description : A closed iron tank 12 m long 9 m wide and 4 m deep is to be made . Determine the cost of iron sheet used at the rate of rs 5 per meter , sheet being 2 m wide. -Maths 9th

Last Answer : This answer was deleted by our moderators...

Description : What term is used to describe a wide straight or Waterway between two land masses and is generally deep enough to provide a passageway for vessels channel estuary or gulf?

Last Answer : Need answer

Description : A uniform body 3 m long, 2 m wide and 1 m deep floats in water. If the depth of immersion is 0.6 m, then the weight of the body is (A) 3.53 kN (B) 33.3 kN (C) 35.3 kN (D) None of these

Last Answer : Answer: Option C