Description : The frog of a brick is normally made on its (A) Top face (B) Bottom face (C) Longer face (D) Shorter side
Last Answer : Answer: Option A
Description : The frog of the brick in a brick masonry is generally kept on (A) Bottom face (B) Top face (C) Shorter side (D) Longer side
Last Answer : Answer: Option B
Description : The depth of frog in a brick is a) 15 mm b) 10 mm c) 6. 25 mm* d) 3 mm
Last Answer : c) 6. 25 mm*
Description : The term frog means (A) An apparatus to lift the stone (B) A depression on a face of brick (C) Vertical joint in a brick work (D) Soaking brick in water
Description : Marking on weld should be done (i) On centre of the rail head (ii) 10 mm below the top surface of rail head.* (iii) 10 mm above the bottom surface of rail head. (iv) None of the above
Last Answer : ii) 10 mm below the top surface of rail head.*
Description : Flood level gauge to be marked a) commencing from bed level to top b) commencing from bottom of girder towards bed level* c) commencing from Rail level d) commencing from Danger level
Last Answer : b) commencing from bottom of girder towards bed level*
Description : For Box Culverts Danger level is to be taken as a) at the top of slab b)one third height below bottom of slab c) at the bottom of slab* d) None of the above
Last Answer : c) at the bottom of slab*
Description : In shallow type girders, the rail level shall be a) 25mm above the top flange of girder* b) near the bottom of the girder c) near the middle of the girder d) below the girder
Last Answer : a) 25mm above the top flange of girder*
Description : Depth of construction in a girder bridge means the depth from a) RL to HFL b) RL to top of bed block * c) RL to bottom of bed block d) RL to Bed level
Last Answer : b) RL to top of bed block *
Description : The bottom of side drains should be below the formation level by at least------------ a) 45 cm b )30 cm* c) 15 cm d) 60 cm
Last Answer : b )30 cm*
Description : The position of a brick when laid on its side 9 cm × 9 cm with its frog in the vertical plane, is called (A) Brick on edge (B) Brick on end (C) Brick on bed (D) Brick held vertically
Last Answer : Option B
Description : Which of the following ingredients of Brick earth enables the brick to retain its shape a) Alumina b) Silica* c) Iron d) Magnesia
Last Answer : b) Silica*
Description : Marking on weld should be done which side? (i) Non gauge face side of A.T. weld * (ii) Gauge face side of A.T. weld (iii) On web of non gauge face side of A.T. weld (iv) On web of gauge face side of A.T. weld
Last Answer : (i) Non gauge face side of A.T. weld
Description : Which of the following constituents impart plasticity to brick earth a) Alumina* b) Silica c) Lime d) Magnesia
Last Answer : a) Alumina*
Description : Number of bricks required for 1 cubic meter of brick masonry is a)400 b) 450 c) 500* d) 550
Last Answer : c) 500*
Description : ormal size of brick used in India is a) 22 x 11.2 x 7 cm* b) 25 x 16 x 8 cm c) 19 x 12 x 9 cm d) 20 x 10 x 5 cm
Last Answer : a) 22 x 11.2 x 7 cm*
Description : A pug mill is used for a) Softening brick earth b) Moulding brick earth c) Tempering brick earth* d) Compacting brick earth
Last Answer : c) Tempering brick earth*
Description : If first class Brick is immersed in water for 24 hours it should not absorb water by weight more than a) 10% b) 15% c) 20% * d) 25%
Last Answer : c) 20% *
Description : he minimum compressive strength of first class brick should be a) 75 kg per centimeter square b) 90 kg per centimeter square c) 100 kg per centimeter square* d) 120 kg per centimeter square
Last Answer : c) 100 kg per centimeter square*
Description : Which one of the following impurity is not desirable in the soil used for brick formation a) Alkali b) Kankar c) Iron oxide d) Alkali & Kankar*
Last Answer : d) Alkali & Kankar*
Description : A woman is walking down a street night at a constant pace. As she passes the street light, she notices that her shadow becomes longer. Does the top of her shadow move faster, slower or the same when the shadow is longer as when it is shorter? -Riddles
Last Answer : This point maintains a constant speed, independent of the lenght of the shadow.
Description : A dumper is normally filled in 18 hours but takes 6 hours longer to fill because of a leak in the bottom of the dumper. If the dumper is full the leak will empty it in how many hours? A) 76 hours B) 78 hours C) 72 hours D) 74 hours
Last Answer : C Work done by leak in 1 hr=(1/18-1/24) =>4-3/72 =>1/72 Leak will empty the dumper in 72 hours
Description : Rails used for A T Welding shall not normally be welded? (i) 20 years old . (ii) 30 years old (iii) 40 years old (iv) 50 years old*
Last Answer : iv) 50 years old*
Description : What is the validity after supervisors course (TW-3)? (i) Normally, supervisors shall not be required to undergo the course again. However, they may be sent for course on performance basis.* (ii) 2 years (iii) 5 Years (iv) 10 Years
Last Answer : (i) Normally, supervisors shall not be required to undergo the course again. However, they may be sent for course on performance basis.*
Description : centre to centre spacing of pile should not be more than __where d is the dia of pile shaft
Last Answer : 4d
Description : Callendar Hamilton spans are normally available maximum up to a) 60 ft. b) 100 ft. c) 150 ft. d) 200 ft.*
Last Answer : d) 200 ft.*
Description : Check rails should normally be provided where the radius is …. M or less in B.G. (a) 150m (b) 200m (c) 218m* (d) 240m
Last Answer : (c) 218m*
Description : Check rails should normally be provided where the radius is ……. M or less in B.G. (a) 150m (b) 200m (c) 208m* (d) 225m
Last Answer : (c) 208m*
Description : Maximum distance covered in a day by a Patrolman should not normally exceed q. 2 km. r. 5 km. s. 10 km. t. 20 km .*
Last Answer : t. 20 km
Description : n Girder and Slab Bridges Danger level should be marked below bottom of girders/slabs for water way is > 12.20 < 30.5 m a) 300 mm b) 600 mm* c) 500 mm d) 450 mm
Last Answer : b) 600 mm*
Description : In Girder and Slab Bridges Danger level should be marked below bottom of girders/slabs for water way is > 6.10 < 12.2 m a) 300 mm b) 600 mm c) 450 mm* d) 500 mm
Last Answer : c) 450 mm*
Description : At FOBs in electrified section the electrocution by live OHE wires is prevented by providing a) smoke gaurds b) Roofing c) Bottom lateral bracings d) protective screens*
Last Answer : d) protective screens*
Description : The minimum vertical clearance above R.L. to bottom of ROB near the yard shall be a) 6525 mm* b) 5870 mm c) 2360 mm d) 6250 mm
Last Answer : a) 6525 mm*
Description : The vertical clearance of bottom most foot over bridge structure above rail level is a) 6525 mm* b) 3660 mm c) 5330 mm d) 6250 mm
Description : The load transferred from rails to bottom flanges is in a) deck type girder b) through type girder* c) semi-through type girder d) plate girder
Last Answer : b) through type girder*
Description : Vertical Clearance (VC) in water way bridges is the level difference between a) HFL and Formation level b) Bed level and bottom of superstructure c) HFL and bottom of superstructure* d) Rail level and Formation level
Last Answer : c) HFL and bottom of superstructure*
Description : While taking sample of water from well, sample is collected a)About 2 metre above the bottom of wel b) About 1 metre above the bottom of well * c)About 1 metres below the bottom of well d) none of the above
Last Answer : b) About 1 metre above the bottom of well *
Description : Minimum depth of ballast cushion below the bottom of sleeper at the rail seat on BG group A route should be :- (a) 350 mm. (b) 250 mm. (c) 300 mm.* (d) 325 mm.
Last Answer : (c) 300 mm.*
Description : The 9 cm × 9 cm side of a brick as seen in the wall face, is generally known as (A) Stretcher (B) Face (C) Front (D) Heade
Last Answer : Answer: Option D
Description : The 19 cm × 9 cm side of a brick as seen in the wall face, is generally known as (A) Stretcher (B) Face (C) Front (D) Header
Description : A fence is made of four parts each 32 cm long is the fence longer or shorter than a meter?
Last Answer : it is shorter because 128 centimetres is not a meter yet
Description : The gap between probing face and probing shoe should be. (i) 0.4 mm (ii) 0.2mm * (iii) 3mm (iv) 1mm.
Last Answer : (ii) 0.2mm *
Description : The horizontal clearance of edge of foot over bridge structure from face of platform is a) 6525 mm b) 3660 mm* c) 5330 mm d) 5300 mm
Last Answer : b) 3660 mm*
Description : The minimum horizontal distances form centre of track to face of passenger platform coping for B.G. is ……. Mm (A) 1650 MM. (B) 1670 MM* (C)1676 MM (D) 1685 MM
Last Answer : (B) 1670 MM*
Description : A Web page normally consists of (a) head and body (b) top and bottom -Technology
Last Answer : (a) From the given options, a Web page normally consists of head and body.
Description : Which of the following is expected of AASC to do? a. AASC should normally expose its opinion on specific queries from a practicing CPA. b. AASC should normally expose a proposed ... of statements, the exposure period is understandably shorter than those of the regular drafts of standards
Last Answer : To make the statements on Philippine Standards on Auditing operative, the final statement shall be submitted to the Board of Accountancy for approval.
Description : The side slope of formation in embankment /cutting depends on a) Shearing strength of soil and its angle of repose* b) Angle of repose c) Bearing capacity of the soil d) Optimum moisture content of the soil
Last Answer : a) Shearing strength of soil and its angle of repose*
Description : Which of the following are advantages normally associated with B2B e‐commerce? a. Shorter cycle times b. Reduction in costs c. Reaches wider audiences d. all of the above
Last Answer : d. all of the above
Description : Maximum height of low level cistern from top of W.C. pan should be (a) 65 cm. (b) 30 cm. (c) 8 (d) 120 cm. (e) 80 cm.
Last Answer : b) 30 cm. (c) 8