Description : The principle of conservation of energy cannot be applied in case of a.Flow of water in a pipe b.A particle moving in gravitational field c.Frictional movement of a particle over a surface d.Frictionless movement of a principle over a surface e.Simple pendulum
Last Answer : c. Frictional movement of a particle over a surface
Description : What is a good estimate for the absolute roughness for epoxy lined carbon steel pipe?
Last Answer : The specific roughness for welded, seamless steel is .0002 ft. PVC has a specific roughness of 0.000005 ft. You may also want to consider using the Hazen-Williams formula, which lists a ... for cement-lined cast iron piping. You need to decide which is more conservative for your application.
Description : How do you calculate drops per minute?
Last Answer : Need answer
Description : The frictional resistance in laminar flow does not depend on the (A) Area of surface in contact (B) Flow velocity (C) Fluid temperature (D) Pressure of flow
Last Answer : (A) Area of surface in contact
Description : Actual lift of a pump is always less than the theoretical lift and is limited by the (A) Specific gravity & temperature of the liquid (B) Leakage & pressure decreasing at higher elevations (C) Frictional resistance through pipes, fittings & passages (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : When the water is warm, the height to which it can be lifted by a pump (A) Decreases due to reduced viscosity (B) Decreases due to reduced vapour pressure (C) Increases due to increased vapour pressure (D) Decreases due to increased frictional resistance
Last Answer : (B) Decreases due to reduced vapour pressure
Description : Steel pipe are (A) Suitable for withstanding high internal pressure (B) Connected by riveted or welded joints (C) Generally laid underground and no expansion joint is required (D) Likely to last 100 years under ordinary conditions
Last Answer : (D) Likely to last 100 years under ordinary conditions
Description : Assertion (A): In anti-friction bearings, the frictional resistance is very low as the shaft held by it remains in floating condition by the hydrodynamic pressure developed by the lubricant. [IES-2006] Reason (R): In hydrodynamic ... of A (c) A is true but R is false (d) A is false but R is true
Last Answer : (d) A is false but R is true
Description : Consider the following statements: [IES 2007] For a journal rotating in a bearing under film lubrication conditions, the frictional resistance is- 1. Proportional to the area of contact 2. Proportional to the viscosity of lubricant 3. ... 4 (b) 1 and 4 only (c) 2, 3 and 4 only (d) 2 and 3 only
Last Answer : (a) 1, 2, 3 and 4
Description : Petroff’s equation is used to find out (A) Load carrying capacity of the bearing (B) Frictional losses in the bearing (C) Unit bearing pressure on the bearing (D) Pressure distribution around the periphery of the journal
Last Answer : (B) Frictional losses in the bearing
Description : In damped vibrations, the amplitude of the resulting vibration gradually reduces. This is due to the reason that an amount of energy is always dissipated to overcome the ________ * 1 point (A) Frictional resistance (B) Work done(C) Fluid pressure (D) Air pressure
Last Answer : (A) Frictional resistance
Description : In damped vibrations, the amplitude of the resulting vibration gradually reduces. This is due to the reason that an amount of energy is always dissipated to overcome the ________ a) Frictional resistance b) Work done c) Fluid pressure d) Air pressure
Last Answer : a) Frictional resistance
Description : In order that flow takes place between two points in a pipeline, the differential pressure between these points must be more than (A) Frictional force (B) Viscosity (C) Surface friction (D) All of the above
Last Answer : Answer: Option D
Description : The fluid property which matters for falling rain drops to acquire spherical shape is its (A) Pressure (B) Height of descend (C) Viscosity (D) Surface tension
Last Answer : (D) Surface tension
Description : What is some good advice for specifying allowable pressure drops in shell and tube exchangers for heavy hydrocarbons?
Last Answer : Frequently process engineers specify 5 or 10 PSI for allowable pressure drop inside heat exchanger tubing. For heavy liquids that have fouling characteristics, this is usually not enough. There are ... the heat exchanger of approximately 40%. This savings offset the cost of the pumping power
Description : Calculate the rate of heat transfer by radiation from an unlagged steam pipe, 50 mm o.d. at 393K to air at 293K emissivity e = 0.9.
Last Answer : Rate of heat transfer by radiation Assume length of pipe = 1 m
Description : Material of construction of pipe generally used for conveying water in India is (A) Stainless steel (B) Cast iron (C) Wrought iron (D) Lead lined steel
Last Answer : (B) Cast iron
Description : Which of the following situations can be approximated to a steady state heat transfer system? (A) A red hot steel slab (having outside surface temperature as 1300°C) exposed to the atmospheric air at ... flowing at the rate of 6 Kg/minute through a copper pipe exposed to atmospheric air at 35°C
Last Answer : (B) 10 kg of dry saturated steam at 8 kgf/cm2 flowing through a short length of stainless steel pipe exposed to atmospheric air at 35°C
Description : _________ pipe is the most suitable for carrying sanitary drainage. (A) Stainless steel (B) Reinforced cement concrete (C) Cast iron (D) Asbestos cement
Last Answer : C) Cast iron
Description : Out of the following, the __________ pipe has the least corrosion resistance. (A) Mild steel (B) Copper (C) Cast iron (D) Wrought iron
Last Answer : D) Wrought iron
Description : Temperature of hot gases flowing in a pipe is measured by a thermocouple inserted in the thermal well. The thermal well made of __________ will facilitate the most accurate measurement of the temperature. (A) Copper (B) Steel (C) Aluminium (D) Brass
Last Answer : Option A
Description : In frictional fluid flow, the quantity, (P/ρ) + (V 2 /2gc) + gz/gc) is (A) Constant along a streamline (B) Not constant along a streamline (C) Increased in the direction of flow (D) None of these
Last Answer : (B) Not constant along a streamline
Description : Potential flow is characterised by the (A) Irrotational and frictionless flow (B) Irrotational and frictional flow (C) One in which dissipation of mechanical energy into heat occurs (D) Formation of eddies within the stream
Last Answer : (A) Irrotational and frictionless flow
Description : Good design of the casing of a centrifugal pump aims at minimising the (A) Cavitation (B) Frictional losses (C) Kinetic energy loss (D) Static head
Last Answer : Option C
Description : A mercury (specific gravity = 13.6) manometer connected across an orificemeter fitted in a pipe shows a manometer reading of 2 cms. If the manometer liquid is changed to carbon tetrachloride (specific gravity = 1.6), then ... new manometer reading will be __________ cms. (A) 17 (B) 42 (C) 84 (D) 1.8
Last Answer : __________ cms. (A) 17
Description : McCann's Steel Cut Oatmeal, Quick & Easy (Cooks in 5 minutes) vs. McCann's Steel Cut Oatmeal?
Last Answer : answer:I use regular Steel Cut from the Health food store. I simmer the same proportions (give or take) on stove top on v. low flame, stir a few times,for about 20 minutes..Then I refrigerate and reheat ... of easy breakfasts. What kind of processing is done to Q & E to make them not slow and hard?
Last Answer : The pacer may be reduced for various reasons. Such as overwork , anxiety , fear and nervous weakness etc. Low blood pressure can cause dizziness , nausea, loss of consciousness, nausea, palpitations , ... in keeping blood pressure normal. In this way you will get benefits by playing for a week.
Description : Rain drops are spherical because of (A) Viscosity (B) Air resistance (C) Surface tension forces (D) Atmospheric pressure
Last Answer : Answer: Option C
Description : An ideal gas of volume 1liter and pressure 10 bar undergoes a quasistatic adiabatic expansion until the pressure drops to 1 bar. Assume γ to be 1.4 what is the final volume? a. 3.18 l b. 4.18 l c. 5.18 l d. 6.18 l
Last Answer : 5.18 l
Description : The force responsible for drops of liquid assuming a spherical shape is known as: w) strong nuclear force x) Van der Waals attraction y) surface tension z) osmotic pressure
Last Answer : ANSWER: Y -- SURFACE TENSION
Description : What does 361 stainless steel pipe cost.?
Last Answer : i think you are looking for 316 stainless steel pipe.
Description : What examines the inside of a weld in a steel oil pipe?
Description : The steel pile which is generally sunk in soft clay or loose sand of low bearing capacity, is (A) H-pile (B) Pipe pile (C) Screw pile (D) Disc pile
Description : In soft clay of low bearing capacity, the type of steel pile generally used, is (A) H-pile (B) Screw pile (C) Disc pile (D) Pipe pile
Last Answer : Answer: Option B
Description : The main problem with such a heat treatment of stainless steel pipe spools and the reason why it is not regularly employed is: a) Controlling the rate of the temperature rise b) Controlling the cooling c) The length of the soak period d) High risk of distortion
Last Answer : d) High risk of distortion
Description : Which Is Stronger Solid Steel Rod Or Hollow Steel Pipe?
Last Answer : Answer :On a per pound basis, steel pipe is stronger in bending and is less likely to buckle in axial compression.
Description : Bleaching powder is prepared by passing – (1) Chlorine over slaked lime (2) Oxygen over slaked lime (3) Carbon dioxide over slaked lime (4) Chlorine over quick lirne
Last Answer : (1) Chlorine over slaked lime Explanation: Calcium hypochlorite (bleaching powder) is manufactured by the calcium process: 2Cl2 + 2Ca(OH)2 (slaked lime) Ca(OCl)2 + CaCl2 + 2H2O. Bleaching powder is actually a mixture of calcium hypochlorite and the basic chloride with some slaked lime.
Description : When quick lime is mixed with Carbon dioxide it turns into?
Last Answer : Milky colour
Description : Quick lime (A) Generates heat when added to water (B) Reacts with carbon dioxide (C) May be used for white-washing (D) All the above
Description : Bleaching powder is prepared by passing : (1) Chlorine over slaked lime (2) Oxygen over slaked lime (3) Carbon dioxide over slaked lime (4) Chlorine over quick lirne
Last Answer : Chlorine over slaked lime
Description : If the distance to electric train is given by Fr = a + bv + cv2 In this equation constant c is likely to cover a.air resistance b.track resistance c.frictional resistance d.flange resistance e.107 dynes
Last Answer : a. air resistance
Description : The angle of friction is a.The angle which frictional force makes with the normal b.The anle at which the force applied from external souce will cause movement c.The angle at which fictional ... the normal reaction and the resultant of normal reaction and the limiting friction e.None of the above
Last Answer : d. The angle between the normal reaction and the resultant of normal reaction and the limiting friction
Description : Kinetic friction is a.Maximum value of frictional force when a body is about to move b.Friction between two well lubricated bodies c.Friction force acting when the body is in motion d.Driction force which keeps a body in motion e.None of the above
Last Answer : c. Friction force acting when the body is in motion
Description : The maximum frictional force which comes into play when a body just begins to slide over the surface of another body is known as a.Kinetic friction b.Rolling friction c.Dynamic friction d.Limiting friction e.Sliding friction
Last Answer : d. Limiting friction
Description : What type of frictional force works when parachuting ?
Last Answer : Flowing friction force works when parachuting down.
Description : When the speed of a rear-drive car is increasing on a horizontal road the direction of the frictional force on the tires is:
Last Answer : When the speed of a rear-drive car is increasing on a horizontal road the direction of the ... the front tires and forward for the rear tires
Description : Frictional unemployment is temporary in nature.
Last Answer : State with reasons whether you agree or disagree with the following statements: Frictional unemployment is temporary in nature.
Description : Frictional Unemployment and Structural Unemployment.
Last Answer : Distinguish Between: Frictional Unemployment and Structural Unemployment.