Description : If If the input signals are 180 degrees out of phase with each other and a combined output is taken between the two output terminals, what will the amplitude of the combined output signal be?
Last Answer : 200 millivolts.
Description : If the two input signals to a difference amplifier are equal in amplitude but neither in phase nor 180 degrees out of phase, what will the output signal be?
Last Answer : . A different shape than the input signals but larger in amplitude.
Description : If the two input signals to a difference amplifier are equal in amplitude and 180 degrees out of phase, what will the output signal be?
Last Answer : Equal in shape and frequency to each input signal and larger in amplitude by two times than
Description : If the input signals are in phase, what will be the peak-to peak amplitude of the output signals?
Last Answer : 0 volts (the input signals will "cancel out").
Description : . If the two input signals of a difference amplifier are in phase and equal in amplitude, what will the output signal be?
Last Answer : No output (the signals will "cancel out").
Description : If the single-input, differential-output, differential amplifier has an output signal taken between the two output terminals, what will the peak-to-peak amplitude of this combined output be?
Last Answer : 200 millivolts. A-18. a. Differential amplifier
Description : The advantage of using the illustrated circuit configuration is _________. EL-0045 A. high input resistance B. high current gain C. the best stability with an increase in temperature D. the input and output are 180 degrees out of phase
Last Answer : Answer: C
Description : Which transistor configuration provides a phase reversal between the input and output signals?
Last Answer : Common emitter.
Description : The input and output signals of a JFET amplifier have what phase relationship?
Last Answer : They are 180 degrees out of phase.
Description : The absolute value of a signal's highest intensity is called………. A. Peak Amplitude B. Frequency C. Phase D. Both a and c
Last Answer : A. Peak Amplitude
Description : If the inductance of a choke-input filter is increased, will the output ripple voltage amplitude (Er) increase or decrease?
Last Answer : Decrease.
Description : In the basic transistor amplifier discussed earlier, what is the relationship between the polarity of the input and output signals?
Last Answer : The signals are opposite in polarity or 180 degrees out of phase with each other.
Description : If the differential amplifier is configured with a single input and differential outputs, what will the output signals be?
Last Answer : Each output will be a sine wave with a peak-to-peak amplitude of 100 millivolts. The output signals will be 180 degrees out of phase with each other.
Description : In_____ transmission, the frequency of the carrier signal is modulated to follow the changing voltage level (amplitude)of the modulating signal. The peak amplitude and phase of the carrier signal remainconstant,but as ... of thecarrier changes correspondingly. A) AM B) PM C) FM D) none of the above
Last Answer : FM
Description : In________, the phase of thecarrier is varied to represent two or more different signal elements. Both peak amplitude and frequency remain constant. A) ASK B) PSK C) FSK D) QAM
Last Answer : PSK
Description : In a frequency-domain plot, thehorizontal axis measures the________. A) peak amplitude B) frequency C) phase D) slope
Last Answer : frequency
Description : In the inverting configuration, what is the voltage (for all practical purposes) at the inverting input to the operational amplifier if the input signal is a 1-volt, peak-to-peak sine wave?
Last Answer : 0 volts.
Description : Two waves of equal wavelength will interfere destructively most effectively under one of the following conditions. Will the interference be most effective when the waves are: w) in phase and have equal ... of phase and have equal amplitudes z) 180 degress out of phase and have unequal amplitudes
Last Answer : ANSWER: Y -- 180 DEGREES OUT OF PHASE AND HAVE EQUAL AMPLITUDES
Description : When paralleling two alternators, the synchronizing lamps remain lit as the synchroscope pointer approaches the 0°. This indicates the _____________. A. incoming alternator is running too fast B. alternator ... apart C. synchroscope is defective or broken D. alternator power factors are in phase
Description : The voltage at the reference electrode of the circuit shown in the illustration is applied to the input of a/an ______________. EL-0090 A. class A detector whose output drives an ... drives an 2-stage isolation transformer D. magnetic amplifier whose output controls a saturable reactor
Last Answer : Answer: D
Description : The term responsivity as it applies to a light detector is best described as ∙ A. the time required for the signal to go from 10 to 90 percent of maximum amplitude ∙ B. the ratio of the diode ... . the ratio of the input power to output power ∙ D. the ratio of output current to input current
Last Answer : the ratio of the diode output current to the input optical power
Description : The termresponsivityasit appliesto a light detectorisbest described as a. the time required for the signal to go from 10 to 90 percent of maximum amplitude b.the ratio ofthediode output currentto ... of output current to output power d. the ratio of output current to input current
Last Answer : b.the ratio ofthediode output currentto opticalinputpower
Description : What is used to bias a magnetic amplifier so that the control winding remains free to accept control (input) signals?
Last Answer : A bias winding and associated circuitry.
Description : Two tape recorders have signal-to-noise ratios (SNRs) of 25-dB RMS and 35-dB RMS respectively. Which of the SNRs can record and reproduce the widest range of input signals and why?
Last Answer : 35-dB RMS because the highest SNR can always record and reproduce the widest range of input signals.
Description : What is the average voltage (Eavg) Output of a full-wave rectifier with an output of 100 volts peak?
Last Answer : 63.7 volts.
Description : If the output of a half-wave rectifier is 50-volts peak, what is the average voltage
Last Answer : 15.9 volts.
Description : What is the average voltage (Eavg) output of a full-wave rectifier that has an output of 100 volts peak?
Last Answer : 63.6 volts.
Description : In the power amplifier shown in figure 2-10, what two signals are mixed to produce the output signal?
Last Answer : Local oscillator and coherent oscillator.
Description : Which set of truth table input signals will result in an output signal value of 1 from the 'AND' gate as shown in the illustration? EL-0035 A. 1-Jan B. Jan-00 C. 0-1 D. 0-0
Last Answer : Answer: A
Description : As shown in the illustration, which set of truth table input signals will result in an output signal at point 'Y'? EL-0035 A. 0-0 B. 0-1 C. Jan-00 D. 1-Jan
Description : One of the FM signal generator control which varies the phase of the modulating voltage applied to the oscillator of the sweep generator A. Band control B. Phase control C. Marker amplitude control D. Sweep output control
Last Answer : B. Phase control
Description : Amplitude of modulated wave is in phase with A. output B. system C. frequency D. signal
Last Answer : signal
Description : Why can phase-modulated signals be detected by fm detectors?
Last Answer : Because of the incidental frequency shift that is caused while phase-shifting a carrier wave that is similar to fm modulation.
Description : Which portion of a sine-wave input is retained in the output of a series-negative limiter?
Last Answer : Positive.
Description : Which portion of a sine-wave input is retained in the output of a series-positive limiter?
Last Answer : Negative.
Description : What would be the output of a negative clamper with a bias potential of −5 volts and an input voltage swing from +50 to −50 volts?
Last Answer : -5 volts.
Description : A two-input X-OR gate will produce a HIGH output when the inputs are at what logic levels?
Last Answer : . One or the other of the inputs must be HIGH, but not both at the same time.
Description : In a circuit such as that shown in figure 3-16, if R1 has a value of 50 ohms and R2 has a value of 250 ohms and the input signal has a value of +10 millivolts, what is the value of the output signal?
Last Answer : 60 millivolts.
Description : In a circuit such as that shown in figure 3-15, if R1 has a value of 100 ohms and R2 has a value of 1 kilohm and the input signal is at a value of + 5 millivolts, what is the value of the output signal?
Last Answer : 50 millivolts.
Description : select the correct response from the choices given in the parentheses. Q-20. In a closed-loop configuration the output signal is determined by (the input signal, the feedback signal, both).
Last Answer : Both the input signal and the feedback signal.
Description : If only one input signal is used with a difference amplifier, what will the output signal be?
Last Answer : Equal in shape and frequency to the input signal; larger in amplitude than the input signal; half as large in amplitude as when two input signals were used that were 180 degrees out of phase.
Description : What two transistor amplifier configurations are combined in the single-transistor, two-input, single-output difference amplifier?
Last Answer : Common emitter (CE) and common base (CB)
Description : When a series voltage regulator is used to control output voltages, any increase in the input voltage results in an increase/a decrease (which one) in the resistance of the regulating device.
Last Answer : An increase.
Description : When the input and output wipers of a balanced potentiometer are in the same angular position, what is the value of the error voltage?
Last Answer : Zero.
Description : What characteristic is determined by the time required for a voltage wave to travel from the input end of an artificial transmission line to the output end and back again?
Last Answer : Pulse width
Last Answer : Pulse width.
Description : When a series voltage regulator is used to control output voltages, any increase in the input voltage results in an increase/a decrease in the resistance of the regulating device.
Last Answer : Increase.
Description : Which type of optical splitter (Y-coupler or T-coupler) splits only a small amount of power from the input fiber to one of the output fibers?
Last Answer : T-coupler
Description : What is the logarithmic ratio between the input and output
Last Answer : dBm
Description : How are the input and output directional couplers in a twt connected to the helix?
Last Answer : The directional couplers are not physically connected to the helix.