What term is used to identify the forward progress velocity of wavefronts in a waveguide?

What term is used to identify the forward progress velocity  of wavefronts in a waveguide?
by

1 Answer

Answer :

Group velocity.
by

Related questions

At what frequency compared to the cutoff frequency of a waveguide will the wavefronts be reflected back and forth across the guide (setting up standing waves) and no energy

Description : At what frequency compared to the cutoff frequency of a waveguide will the wavefronts be reflected back and forth across the guide (setting up standing waves) and no energy

Last Answer : UHF receiving antenna

What structure in the twt delays the forward progress of the traveling wave?

Description : What structure in the twt delays the forward progress of the traveling wave?

Last Answer : The helix.

Define the term w.r.t. waveguide: (i) Cut-OFF frequency (ii) Group Velocity

Description : Define the term w.r.t. waveguide: (i) Cut-OFF frequency (ii) Group Velocity

Last Answer : Group velocity: It is defined as the rate at which the wave propagates through the waveguide and is given by The group velocity is also can be defined as the velocity of energy flow ... rectangular waveguide at a frequency below fc TE1,0. This is absolute cut off frequency of the waveguide.

What is the most likely cause of losses in waveguide systems?

Description : What is the most likely cause of losses in waveguide systems?

Last Answer : Improperly connected joints or damaged inner surface.

What is the most common type of waveguide joint?

Description : What is the most common type of waveguide joint?

Last Answer : Choke joint.

A waveguide bend must have what minimum radius?

Description : A waveguide bend must have what minimum radius?

Last Answer : Greater than 2 wavelengths.

What is the result of an abrupt change in the size, shape, or dielectric of a waveguide?

Description : What is the result of an abrupt change in the size, shape, or dielectric of a waveguide?

Last Answer : Reflections.

When a waveguide is terminated in a resistive load, the load must be matched to what property of the waveguide?

Description : When a waveguide is terminated in a resistive load, the load must be matched to what property of the waveguide?

Last Answer : . Characteristic impedance.

What device is used to produce a gradual change in impedance at the end of a waveguide?

Description : What device is used to produce a gradual change in impedance at the end of a waveguide?

Last Answer : Horn.

What is the result of an impedance mismatch in a waveguide?

Description : What is the result of an impedance mismatch in a waveguide?

Last Answer : Standing waves that cause power losses, a reduction in power handling capability, and an increase in frequency and sensitivity.

Loose or inefficient coupling of energy into or out of a waveguide can be accomplished by the use of what method?

Description : Loose or inefficient coupling of energy into or out of a waveguide can be accomplished by the use of what method?

Last Answer : Slots and apertures.

What determines the frequency, bandwidth, and power handling capability of a waveguide probe?

Description : What determines the frequency, bandwidth, and power handling capability of a waveguide probe?

Last Answer : Size and shape

Which subscript, in circular waveguide classification, indicates the number of full-wave patterns around the circumference?

Description : Which subscript, in circular waveguide classification, indicates the number of full-wave patterns around the circumference?

Last Answer : First.

The electric field is perpendicular to the "a" dimension of a waveguide in what mode?

Description : The electric field is perpendicular to the "a" dimension of a waveguide in what mode?

Last Answer : TE.

How is the cutoff wavelength of a circular waveguide figured?

Description : How is the cutoff wavelength of a circular waveguide figured?

Last Answer : 1.71 times the diameter.

What field configuration is easiest to produce in a given waveguide?

Description : What field configuration is easiest to produce in a given waveguide?

Last Answer : . Dominant mode

incidence and reflection that are perpendicular to the waveguide walls?

Description : incidence and reflection that are perpendicular to the waveguide walls?

Last Answer : Cutoff frequency.

Assuming the wall of a waveguide is perfectly flat, what is the angular relationship between the angle of incidence and the angle of reflection

Description : Assuming the wall of a waveguide is perfectly flat, what is the angular relationship between the angle of incidence and the angle of reflection

Last Answer : The angles are equal.

When a wavefront is radiated into a waveguide, what happens to the portions of the wavefront that do not satisfy the boundary conditions?

Description : When a wavefront is radiated into a waveguide, what happens to the portions of the wavefront that do not satisfy the boundary conditions?

Last Answer : Decrease to zero.

What interaction causes energy to travel down a waveguide?

Description : What interaction causes energy to travel down a waveguide?

Last Answer : The interaction of the electric and magnetic fields.

When the frequency is decreased so that two quarter wavelengths are longer than the "a" (wide) dimension of the waveguide, what will happen?

Description : When the frequency is decreased so that two quarter wavelengths are longer than the "a" (wide) dimension of the waveguide, what will happen?

Last Answer : Energy will no longer pass through the waveguide.

What happens to the bus bar dimensions of the waveguide when the frequency is increased?

Description : What happens to the bus bar dimensions of the waveguide when the frequency is increased?

Last Answer : The bus bar becomes wider.

The frequency range of a waveguide is determined by what dimensions?

Description : The frequency range of a waveguide is determined by what dimensions?

Last Answer : . The "a" dimension.

The large surface area of a waveguide greatly reduces what type of loss that is common in two-wire and coaxial lines?

Description : The large surface area of a waveguide greatly reduces what type of loss that is common in two-wire and coaxial lines?

Last Answer : Copper loss.

The folded waveguide in a bwo serves the same purpose as what component in a twt?

Description : The folded waveguide in a bwo serves the same purpose as what component in a twt?

Last Answer : Helix.

How does a waveguide-type lens focus spherical wavefront microwave energy?

Description : How does a waveguide-type lens focus spherical wavefront microwave energy?

Last Answer : Some wavefronts are accelerated so that all wavefronts exit the lens at the same time

Which dispersion mechanism (material or waveguide) is a function of the size of the fiber's core relative to the wavelength of operation?

Description : Which dispersion mechanism (material or waveguide) is a function of the size of the fiber's core relative to the wavelength of operation?

Last Answer : Waveguide dispersion.

“Each point on a spherical wavefront may be considered a source of secondary spherical wavefronts”. This is known as the A. Snell’s law B. D’Alembert’s principle C. Appleton’s theory D. Huygen’s principle

Description : “Each point on a spherical wavefront may be considered a source of secondary spherical wavefronts”. This is known as the A. Snell’s law B. D’Alembert’s principle C. Appleton’s theory D. Huygen’s principle

Last Answer : D. Huygen’s principle

Visual-evoked response: a. is used primarily to detect visual loss due to retinal disease b. produces biphasic wavefronts c. may give falsely delayed latency if the patient is not concentrating d. produces responses in normal subjects with a latency of 100msec

Description : Visual-evoked response: a. is used primarily to detect visual loss due to retinal disease b. produces biphasic wavefronts c. may give falsely delayed latency if the patient is not concentrating d. produces responses in normal subjects with a latency of 100msec

Last Answer : produces responses in normal subjects with a latency of 100msec

The following cells contribute the wavefronts of the flash ERG: a. retinal pigment epithelium b. corneal endothelium c. photoreceptors d. ganglion cell

Description : The following cells contribute the wavefronts of the flash ERG: a. retinal pigment epithelium b. corneal endothelium c. photoreceptors d. ganglion cell

Last Answer : photoreceptors

.Diffractionof electromagneticwaves a. is caused by reflections from the ground b. arises only with spherical wavefronts c. will occur when the waves pass through a large slot d.may occuraroundthe edge of asharpobstacle

Description : .Diffractionof electromagneticwaves a. is caused by reflections from the ground b. arises only with spherical wavefronts c. will occur when the waves pass through a large slot d.may occuraroundthe edge of asharpobstacle

Last Answer : d.may occuraroundthe edge of asharpobstacle

Identify the appropriate graph between enthalpy and progress of physical adsorption.

Description : Identify the appropriate graph between enthalpy and progress of physical adsorption.

Last Answer : Identify the appropriate graph between enthalpy and progress of physical adsorption. A. B. C. D.

Identify the category of evaluation that assesses the learning progress to provide continuous feedback to the students during instruction. (A) Placement (B) Diagnostic (C) Formative (D) Summative

Description : Identify the category of evaluation that assesses the learning progress to provide continuous feedback to the students during instruction. (A) Placement (B) Diagnostic (C) Formative (D) Summative

Last Answer : (C) Formative

Which one from the following is highly associated activity of project planning? (A) Keep track of the project progress. (B) Compare actual and planned progress and costs (C) Identify the activities, milestones and deliverables produced by a project (D) Both (B) and (C)

Description : Which one from the following is highly associated activity of project planning? (A) Keep track of the project progress. (B) Compare actual and planned progress and costs (C) Identify the activities, milestones and deliverables produced by a project (D) Both (B) and (C)

Last Answer : (C) Identify the activities, milestones and deliverables produced by a project

What term is used to identify each of the many field configurations that can exist in waveguides?

Description : What term is used to identify each of the many field configurations that can exist in waveguides?

Last Answer : Mode of operation.

What term is used to identify the procedure of connecting one side of a circuit board with the other?

Description : What term is used to identify the procedure of connecting one side of a circuit board with the other?

Last Answer : Interfacial connections.

What is the term used to identify the amount of field strength required to cause the electrons to just miss the plate and return to the filament in a circular orbit?

Description : What is the term used to identify the amount of field strength required to cause the electrons to just miss the plate and return to the filament in a circular orbit?

Last Answer : The critical value of field strength

What is the term used to identify the points of minimum current and minimum voltage on an antenna?

Description : What is the term used to identify the points of minimum current and minimum voltage on an antenna?

Last Answer : Current and voltage nodes.

What is the term used to identify the points of high current and high voltage on an antenna?

Description : What is the term used to identify the points of high current and high voltage on an antenna?

Last Answer : Current and voltage loops.

When an SCR is forward biased, what is needed to cause it to conduct?

Description : When an SCR is forward biased, what is needed to cause it to conduct?

Last Answer : A gate signal.

When a PN junction is forward biased, what happens to the depletion region?

Description : When a PN junction is forward biased, what happens to the depletion region?

Last Answer : The depletion region decreases.

A, when there is an increase in the input voltage, the forward bias of Q1 increases/decreases (which one).

Description : A, when there is an increase in the input voltage, the forward bias of Q1 increases/decreases (which one).

Last Answer : Increases.

What is the typical back-to-forward resistance ratio of a good-quality diode?

Description : What is the typical back-to-forward resistance ratio of a good-quality diode?

Last Answer : 10-to-1 ratio.

How do dual-motor dual capstan drives maintain a constant tape tension while operating in either a forward or reverse direction?

Description : How do dual-motor dual capstan drives maintain a constant tape tension while operating in either a forward or reverse direction?

Last Answer : Each capstan is driven by its own motor. It maintains tape tension by slowing down one of the motors. When the tape motion is reversed, the opposite motor is slowed down.

As a rule of thumb, what is an acceptable ratio of back-to forward resistance for a diode?

Description : As a rule of thumb, what is an acceptable ratio of back-to forward resistance for a diode?

Last Answer : Greater than 10 to 1

Once the logic of a network is laid out, the project manager will conduct a forward pass and a backward pass through the network. This will provide information regardiC. Resource shortages, high risk activities D. The high risk activities, non-critical pathng ______ and will identify the________. A. The total duration of the project, critical path B. The slack for each activity, high risk activities

Description :  Once the logic of a network is laid out, the project manager will conduct a forward  pass and a backward pass through the network. This will provide information regarding  ______ and will identify ... C. Resource shortages, high risk activities D. The high risk activities, non-critical path

Last Answer : A. The total duration of the project, critical path

Identify the INCORRECT statement below regarding chemical equilibrium. A All chemical reactions are, in principle, reversible. B Equilibrium is achieved when the forward reaction rate equals the reverse reaction rate. C Equilibrium is achieved when the concentrations of species become constant. D Equilibrium is achieved when the reaction quotient, Q, equals the equilibrium constant. E Equilibrium is achieved when reactant and product concentrations are equal.

Description : Identify the INCORRECT statement below regarding chemical equilibrium. A All chemical reactions are, in principle, reversible. B Equilibrium is achieved when the forward reaction rate equals the ... equilibrium constant. E Equilibrium is achieved when reactant and product concentrations are equal.

Last Answer : E Equilibrium is achieved when reactant and product concentrations are equal.

Competition or Collaboration, which one is better for humanity/mankind's long-term progress?

Description : Competition or Collaboration, which one is better for humanity/mankind's long-term progress?

Last Answer : It has to be both collaboration and competition. In the science community, the more that work together, the better the results. With different groups doing the same project, competition becomes ... think of a profession where people aren't inspired by others to make their performance better.

Define the term ‘evolution’. “Evolution cannot be equated with progress”. Justify this statement. -Biology

Description : Define the term ‘evolution’. “Evolution cannot be equated with progress”. Justify this statement. -Biology

Last Answer : Evolution is the sequence of gradual change which takes place in primitive organisms over millions of years and new organisms are formed. Evolution cannot be equated to progress from lower forms to ... . For example, human beings have not evolved from chimpanzees, but both have common ancestor.

Which of the following is true about management meetingc. They are purely fact-based meetings with a left-brain type focus. d. They have very little dialogue except to ask clarification questions. e. They are oriented toward developing plans, tracking progress of existing plans, and making adjustments to plans in response to new information.s? Select one: a. They are short meetings to develop a common understanding of what the short-term priorities are for the project. b. They focus on short-term activities, usually less than a week in duration.

Description : Which of the following is true about management meetings? Select one: a. They are short meetings to develop a common understanding of what the short-term  priorities are for the project. ... , tracking progress of existing plans, and  making adjustments to plans in response to new information.

Last Answer : e. They are oriented toward developing plans, tracking progress of existing plans, and  making adjustments to plans in response to new information.