Description : The unit of pressure in S.I. units is (a) kg/cm2 (b) mm of water column (c) pascal (d) dynes per square cm (e) bars
Last Answer : Answer : c
Description : What is a Vacuum in kilo pascal?
Last Answer : Depends on If it's absolute or relative.Vacuum in any unit is zero in absolute pressure.Vacuum in any unit is -normal air pressure in relativepressure.
Description : Saturated steam at a pressure of 25 kg/cm2is throttled to attain 5 kg/cm2. Then the outcoming steam will be (A) Wet (B) Saturated (C) Superheated (D) None of these
Last Answer : C) Superheated
Description : The injection pressure of ic engine used on tractors is in range of kg/cm2 1. 0-6 2. 60-120 3. 120-200 4. 200-300
Last Answer : ans 3
Description : Motorized Knapsack sprayer develops pressure below a. 3.5 kg/cm2b. 2.5 kg/cm2 d. None of above
Last Answer : Ans- c. 1.5 kg/cm2
Description : Foot or pedal operated sprayer develops pressure a. 14 to 18kg/cm2 b. 15 to 21 kg/cm2 d. None of above
Last Answer : Ans- c. 17 to 21 kg/cm2
Description : Rocker sprayer develops pressure b. 15 to 20kg/cm2 c. 15 to 25 kg/cm2 d. None of above
Last Answer : Ans- a. 14 to 18kg/cm2
Description : In power-operated sprayer, the pump works at a pressure of: A. 2-5 Kg/cm2 B. 3-8.5 Kg/cm2 C. 4-12 Kg/cm2. D. 5-15 Kg/cm2
Last Answer : 3-8.5 Kg/cm2
Description : If the average bending stress is 6 kg/cm2 for M 150 grade concrete, the length of embedment of a bar of diameter d according to I.S. 456 specifications, is (A) 28 d (B) 38 d (C) 48 d (D) 58 d
Last Answer : Answer: Option D
Description : The amount of heat required to raise the temperature of the unit mass of gas through one degree at constant volume, is called A.specific heat at constant volume B.specific heat at constant pressure C.kilo Joule D.none of these
Last Answer : Answer: A
Description : Which of the following could be the unit of rotational inertia of a body in CGS system? a.cm4 b.gm-cm2 c.107 dynes d.kg-cm2 e.gm-cm4
Last Answer : b. gm-cm2
Description : The SI unit of pressure is the: w) Torr x) dyne per centimeter squared y) atmosphere z) pascal
Last Answer : ANSWER: Z -- PASCAL
Description : _________ is the unit of pressure and stress. a) Newton b) Pascal c) Hertz d) Joule
Last Answer : Pascal
Description : In a non-flow reversible process for which p = (- 3V+ 15) x 105N/m2,V changes from 1 m to 2 m3. The work done will be about (a) 100 xlOO5 joules (b) lxlO5 joules (c) 10 xlO5 joules (d) 10 xlO5 kilo joules (e) 10xl04ki\ojoules.
Description : Critical pressure of water is (A) 1 kg / cm2 (B) 100 kg / cm2 (C) 155 kg / cm2 (D) 213.8 kg / cm2 .
Last Answer : Ans: D
Description : The fuel in diesel engine is normally injected at pressure of a. 5-10 kg/cm2 b. 20-25 kg/cm2 c 60-80 kg/cm2 d. 90-130 kg/cm2
Last Answer : ANSWER d. 90-130 kg/cm2
Description : Temperature and gage pressure maintained during the manufacture of hot SBR (styrene butadiene rubber) are (A) 50°C and 3 - 4 kg/cm2 (B) 50°C and 1 kgf/cm2 (C) 250°C and 10 kgf/cm2 (D) 250°C and 1 kgf/cm
Last Answer : (A) 50°C and 3 - 4 kg/cm
Description : Pressure maintained in the high pressure primary tower of a three stage crude oil distillation system is about __________ kg/cm2 . (A) 1.5 (B) 3 (C) 6 (D) 12
Last Answer : (B) 3
Description : The pressure (kg/cm2 ) and temperature (°C) maintained in electrical desalters for crude oil are respectively (A) 10 and 120 (B) 1 and 200 (C) 50 and 250 (D) 10 and 300
Last Answer : (B) 1 and 200
Description : Inflation pressure in the rear wheels of the tractor varies between a) 0.5 to 1.2 kg/cm2 b) 8 to 1.2 kg/cm2 c) 2 to 1.5 kg/cm2 d) 1.5 to 20 kg/cm2
Last Answer : b) 8 to 1.2 kg/cm2
Description : The maximum delivery pressure of a reciprocating compressor may be about __________ kg/cm2 . (A) 1000 (B) 2000 (C) 3000 (D) 4000
Last Answer : (D) 4000
Description : Power sprayers are operated at a pressure of — kg/cm2 a. 5 to 10 b. 10 to 20 c. 20 to 55 d. more than 55
Last Answer : c. 20 to 55
Description : Hand operated sprayers are operated at pressure— kg/cm2 a. 7 to 10 b. 10 to 20 c. 1 to 7 d. 20 to 25
Last Answer : c. 1 to 7
Description : Vinyl chloride (CH2 = CH.Cl) is produced by the thermal pyrolysis of ethylene dichloride at a pressure & temperature of (A) 4 kgf/cm2 & 500°C (B) 10 kgf/cm2 & 1000°C (C) 40 kg/cm2 & 200°C (D) 100 kgf/cm2 & 500°C
Last Answer : (A) 4 kgf/cm2 & 500°C
Description : Pick up the incorrect statement from the following regarding fire hydrants (A) Fire hydrants are fitted in water mains at 100 m to 150 m apart at fire (B) The minimum water pressure hydrants, is kept 1.5 kg/ ... to 1.5 kg/cm2 is made available for 4 to 5 hours for constant use (D) None of these
Last Answer : (D) None of these
Description : The maximum pressure to which cast iron pipes may be subjected to, is (A) 3 kg/cm2 (B) 5 kg/cm2 (C) 7 kg/cm2 (D) 10 kg/cm
Last Answer : (C) 7 kg/cm
Description : The gaseous form of chlorine gets converted into liquid form when subjected to a pressure of (A) 5 kg/cm2 (B) 6 kg/cm2 (C) 7 kg/cm2 (D) 10 kg/cm
Description : The difference in the reservoir level and the lowest point of the water mains is 180 m. The expected pressure due to water hammer is 7.5 kg/cm2 in a pressure conduit of diameter 1 m. Assuming the efficiency of the ... , is (A) 10 mm (B) 15 mm (C) 20 mm (D) 25 mm
Last Answer : (C) 20 mm
Description : The critical pressure at which the latent heat of vaporisation of steam becomes zero is __________ Kg/cm2. (A) 273.15 (B) 225.65 (C) 100.03 (D) 373.15
Last Answer : (B) 225.65
Description : A fire tube boiler is limited to a maximum steam pressure of about __________ kg/cm2. (A) 6 (B) 18 (C) 38 (D) 52
Last Answer : (B) 18
Description : high pressure boiler generates steam at a pressure greater than __________ kg/cm2. (A) 10 (B) 30 (C) 50 (D) 80
Last Answer : Option D
Description : n a chemical factory where dyes are made, wet cake at 30 OC consisting of 60% moisture is put in a dryer to obtain an output having only 5% moisture, at atmospheric pressure. In each batch about 120 ... dryer and the dryer efficiency is 80%. Latent heat of steam at 4 kg/cm2 is 520 kcal/kg.
Last Answer : Given that Qty of material dried per batch - 120 Kgs Moisture at inlet - 60% a. The quantity of moisture removed per batch. Water quantity in a wet batch - 120 x 0.6 = 72 Kgs. Quantity of bone dry ... - 48/0.95 = 50.5 Kgs. Equivalent water in a dry batch - 50.5 - 48 = 2.5 Kgs.
Description : A spherical pressure vessel is made of thin magnesium plate 0.25 cm thick. The main diameter of the sphere is 600 cm and allowable stress in tension is 900 kg/cm2. The safe internal gas pressure for the vessel would be a) 0.5 kg/cm2 b) 1.5 kg/cm2 c) 4.5 kg/cm2 d) 5.7 kg/cm2
Last Answer : b) 1.5 kg/cm2
Description : Hand operated sprayer are operated at a pressure (kg/cm2) a) 1-7 b) 7-10 c)10-20 d) 20-55
Last Answer : a) 1-7
Description : Operating pressure of power operated sprayer E. 1-7 kg/cm2 F. 10-20 kg/cm2+ G. 20-55 kg/cm2 H. >55 kg/cm2
Last Answer : G. 20-55 kg/cm2
Description : Operating pressure of the hand operated sprayer is E. 20-55 kg/cm2 F. 1-7 kg/cm2 G. 10-20 kg/cm2 H. >55 kg/cm2
Last Answer : F. 1-7 kg/cm2
Description : Injection pressure of fuel nozzle in diesel engine is a) 30-45 kg/cm2 b) 50-100 kg/cm2 c) 120-200 kg/cm2 d) 200 kg/cm2
Last Answer : c) 120-200 kg/cm2
Description : Compression pressure in petrol engine cylinder is a) 6-10 kg/cm2 b) 10-20 kg/cm2 c) 20-35 kg/cm2 d) 35-40 kg/cm2
Last Answer : a) 6-10 kg/cm2
Description : Compression pressure in diesel engine cylinder is a) 6-10 kg/cm2 b) 10-20 kg/cm2 c) 20-35 kg/cm2 d) None of the above
Last Answer : c) 20-35 kg/cm2
Description : Pressure of compressed air is kept during preheating by CAPS? (i) 1 to 2 kg/cm2 (ii) .1 to .2 kg/cm2 (iii) 2 to 3 kg/cm2 (iv) 0.2 to 0.3 kg/cm2*
Last Answer : (iv) 0.2 to 0.3 kg/cm2*
Description : Hand compression sprayer , the pumping is required to maintain the normal pressure of a. 1-3.5kg/cm2.. b. 1.5-3.5kg/cm2. d. None of above
Last Answer : Ans- c. 2-3.5kg/cm2.
Description : One barometric pressure or 1 atmospheric pressure is equal to (a) 1 kgf/cnr2 (b) 1.033 kgf/cm2 (c) 0 kgf/cm2 (d) 1.0197 kgf/cm2 (e) 100 kgf/cm2.
Last Answer : Answer : b
Description : A 3.2 m diameter balloon is filled with Helium. The total weight of balloon, gas and pay load is 10 kg kg. In an isothermal atmosphere having conditions identical to N.T.P. the balloon will rise to a height of about a.6000 m b.1500 m c.3000 m d.2000 m e.1000 m
Last Answer : a. 6000 m
Description : __________ is the unit of force. a) Newton b) Pascal c) Hertz d) Joule
Last Answer : Newton
Description : The unit “pascal” is equivalent to ______. A. N/m^2 B. N/m C. N-m D. N-m^2
Last Answer : N/m^2
Description : The unit of power in S.I. units is (a) newton (b) pascal (c) erg (d) watt (e) joule.
Last Answer : Answer : d
Description : Steam pressures usually used in thermal power plants are (A) 5 kg/cm2 to 10 kg / cm2 (B) 50 kg/cm2 to 100 kg / cm2 (C) 110 kg/cm2 to 170 kg / cm2 (D) 200 kg/cm2 to 215 kg / cm2
Last Answer : Ans: C
Description : Which of the following situations can be approximated to a steady state heat transfer system? (A) A red hot steel slab (having outside surface temperature as 1300°C) exposed to the atmospheric air at ... flowing at the rate of 6 Kg/minute through a copper pipe exposed to atmospheric air at 35°C
Last Answer : (B) 10 kg of dry saturated steam at 8 kgf/cm2 flowing through a short length of stainless steel pipe exposed to atmospheric air at 35°C