Description : Regenerators are normally provided in the (A) Glass melting furnace (B) Open hearth furnace (C) By product coke ovens (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : Regenerators are installed in (A) Coke ovens (B) Open hearth furnace (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : Regenerators are used for waste heat recovery in (A) By-product coke ovens (B) Beehive coke oven (C) Blast furnace stoves (D) Soaking pits
Last Answer : (A) By-product coke ovens
Description : An example of recuperative furnace is the (A) Soaking pit (B) Open hearth furnace (C) Coke ovens (D) None of these
Last Answer : (A) Soaking pit
Description : Which of the following is not a directly fired furnace? (A) By-product coke oven (B) Calcination kiln (C) Sintering furnace (D) Open hearth furnace
Last Answer : (A) By-product coke oven
Description : Which is a regenerative furnace? (A) Coke oven heating chamber (B) Open hearth furnace (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) and (B)
Description : Which is a continuous furnace? (A) Coke ovens (B) Annealing furnace (C) Glass tank furnace
Last Answer : (C) Glass tank furnace
Description : Which is not a hearth furnace? (A) Glass tank furnace (B) Open hearth furnace (C) Cupola
Last Answer : (C) Cupola
Description : Pick out the wrong statement. (A) Nitrogen is normally supplied in fertiliser either in Ammoniacal or the nitrate form, from which the soil takes it up in the form of ammonium ions ornitrate ... nitrate fertiliser is obtained as a by-product in an integrated steel plant having by-product coke ovens
Last Answer : (D) Ammonium nitrate fertiliser is obtained as a by-product in an integrated steel plant having by-product coke ovens
Description : Coke ovens in steel plant are heated by (A) Electricity (B) Blast furnace gas/mixed gas (C) Coke oven gas (D) Both (B) and (C)
Last Answer : (D) Both (B) and (C)
Description : Main use of hard coke produced by high temperature carbonisation is in the (A) Iron blast furnace (B) Cupola in foundries (C) Sinter making (D) Domestic ovens
Last Answer : (A) Iron blast furnace
Description : Neutral atmosphere is maintained in a/an __________ furnace. (A) Cold rolled steel coil annealing (B) Open hearth (C) Soaking pit (D) Walking beam reheating
Last Answer : (A) Cold rolled steel coil annealing
Description : Which furnace employs preheating, heating and soaking zones? (A) Soaking pit (B) Reheating furnace (C) Open hearth furnace (D) Cupola
Last Answer : (B) Reheating furnace
Description : __________ is an indirectly heated furnace. (A) Open hearth furnace (B) Muffle furnace (C) Soaking pit (D) Reheating furnace
Last Answer : (B) Muffle furnace
Description : Thermal efficiency of an open hearth furnace may be about __________ percent. (A) 5 (B) 20 (C) 50 (D) 80
Last Answer : (B) 20
Description : Coke oven regenerators are made of __________ bricks. (A) Fire clay (B) Silica (C) Low thermal conductivity (D) High electrical conductivity
Last Answer : (A) Fire clay
Description : Pick up the correct statement from the following: (A) In basic Bessemer process, the steel heats the converter (B) In open-hearth process, the furnace heats the steel (C) In Siemens process, the impurities of pig iron are oxidised by the oxygen of the ore (D) All the above
Last Answer : Answer: Option D
Description : Regenerator is widely used in: a) Reheating Furnaces b) heat treatment furnaces c) Baking Ovens d) glass melting furnaces
Last Answer : glass melting furnaces
Description : Beehive coke oven (A) Facilitates by-products recovery (B) Takes 2-3 days for coking of coal but requires no external fuel for heating (C) Gives larger yield of coke (around 85%) as compared to by-product ovens (D) Produces coke with very poor strength
Last Answer : (B) Takes 2-3 days for coking of coal but requires no external fuel for heating
Description : Coking time in narrow by-product coke ovens is around __________ hours. (A) 18 (B) 48 (C) 8 (D) 80
Last Answer : (A) 18
Description : Undercharging of coal in the by-product coke ovens results in (A) Decrease in the c.v. of coke oven gas (B) Increase in its throughput (C) Increase in the c.v. of coke oven gas
Last Answer : (A) Decrease in the c.v. of coke oven gas
Description : Coke made in narrower by-product coke ovens (as compared to wider ovens) is (A) Less reactive (B) Stronger (C) Smaller in size (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : Phenolic water generated in coke ovens & by-product plant attached to an integrated steel plant containing phenol in concentration of less than 100 mg/litre can be removed by (A) Chlorination (B) Treating in biological oxygen pond (C) Chemical coagulation (D) None of these
Last Answer : (B) Treating in biological oxygen pond
Description : Phenolic water generated in coke ovens & by-product plant of a steel plant are disposed off by (A) Quenching of hot coke (B) Discharging in the river stream (C) Filtration and recycling for cooling coke oven gas (D) None of these
Last Answer : (A) Quenching of hot coke
Description : Hearth furnaces are not used for (A) Roasting (B) Melting (C) Reheating (D) None of these
Last Answer : (D) None of these
Description : Large tonnage of refractory bricks are dried in a (A) Shaft furnace (B) Rotary hearth furnace (C) Tunnel kiln (D) Muffle furnace
Last Answer : (C) Tunnel kiln
Description : Unit of furnace loading is (A) Ton stock/hr/m2 hearth area (B) Ton stock/hr (C) Ton stock/m2 hearth area (D) Both (B) and (C)
Last Answer : (A) Ton stock/hr/m2 hearth area
Description : If the flame is produced under the hearth and then sweeps up into the heating chamber, this is called a/an __________ furnace. (A) Sidefired (B) Underfired (C) Covered (D) Recirculating
Last Answer : (B) Underfired
Description : An improved and fuel efficient version of the pusher type reheating furnace is the __________ furnace. (A) Walking beam (B) Shaft (C) Tunnel (D) Rotary hearth
Last Answer : (A) Walking beam
Description : The heating capacity of continuous reheating furnace depends upon the (A) Hearth area and furnace temperature (B) Emissivity of the stock (C) Ratio of wall surface to stock surface (D) All (A), (B) and (C)
Description : Tank furnace used for melting of glass is made of (A) Mild steel (B) Cast iron (C) Refractory blocks (D) Stainless steel
Last Answer : (C) Refractory blocks
Description : An example of shaft furnace is the (A) L.D. converter (B) Glass melting tank (C) Blast furnace (D) Soaking pit
Last Answer : (C) Blast furnace
Description : Typical waste gases temperature from glass melting furnace a) 1000-1550 oC b) 800-950 oC c) 650–750 oC d) 760-815 oC
Last Answer : 1000-1550 oC
Description : An important requirement for successful transmission system using light ∙ a. Powerful, reliable light source ∙ b. Strong glass ∙ c. Reliable, high cost transmission medium ∙ d. Powerful regenerators
Last Answer : a. Powerful, reliable light source
Description : Beehive coke ovens are made of __________ bricks. (A) Silica (B) Fireclay (C) Silicon carbide (D) Corundum
Last Answer : (A) Silica
Description : In regenerative air preheater (as practised in heating of coke ovens), the heat is transferred (A) Through a metallic wall (B) By direct contact of hot flue gas with air (C) By ... material (like chequor bricks) and then heating the air from this hot material (D) None of these
Last Answer : (C) By heating an intermediate material (like chequor bricks) and then heating the air from this hot material
Description : Narrow coke ovens as compared to wider coke ovens (A) Produce smaller coke (B) Produce stronger coke (C) Require less time of carbonisation (D) All (A), (B) and (C)
Description : Flue gas from the heating chamber of byproduct coke ovens is removed by (A) Forced draft fan (B) Induced draft fan (C) Steam ejector (D) Natural draft
Last Answer : (D) Natural draft
Description : Coke ovens in steel plant are heated by (A) Electricity (B) Coke oven gas (C) Mixed gas (D) Both (B) & (C)
Last Answer : (D) Both (B) & (C)
Description : Heat penetration rate in narrow coke ovens in high temperature carbonisation of coal is around __________ cm/hr. (A) 2.5 (B) 0.5 (C) 10 (D) 20
Last Answer : (A) 2.5
Description : High rate of heating of coke ovens (A) May damage its walls due to abrupt excessive swelling of coal (B) Produces larger size coke (C) Increases the time of carbonisation (D) None of these
Last Answer : (A) May damage its walls due to abrupt excessive swelling of coal
Description : Compound coke ovens are those which can be heated by (A) Both steam and electrical power (B) Lean gas (e.g., B.F. gas) (C) Rich gas (e.g., coke oven gas) (D) Both (B) and (C)
Description : Preheating of coal charge for the coke ovens reduces the (A) Time of carbonisation (B) Yield of gas and tar (C) Fuel consumption in coking (D) All (A), (B) and (C)
Description : Presence of free moisture in coal during its high temperature carbonisation (A) Reduces the coking time (B) Protects the volatile products from pyrolysis (cracking) in the presence of hot coke and hot oven walls (C) Increases the loss of fine coal dust from the ovens when charging (D) None of these
Last Answer : (B) Protects the volatile products from pyrolysis (cracking) in the presence of hot coke and hot oven walls
Description : Which of the following is not a by-product fuel? (A) Producer gas (B) Blast furnace gas (C) Coke oven gas (D) Refinery gas
Last Answer : (A) Producer gas
Description : In a 100 TPD Sponge Iron plant, the sponge iron is fed to the Induction melting furnace, producing molten steel at 88% yield. The Energy consumption details are as follows: Coal Consumption : 130 ... molten steel (product). 3. Total Energy Consumption of Plant in Tons of Oil Equivalent (TOE )
Last Answer : a) Specific Energy Consumption of Induction Melting Furnace Molten Steel Production from the Induction melting furnace per day = 100 x 88/100 = 88 TPD Total Energy Consumption of the Plant = 82400 kWh ... mark c) Total Energy consumption of Plant in ToE = 655864000/107 = 65.586 ToE
Description : In India the rails are manufactured by A. Open hearth process B. Duplex process C. Both A & B D. None of These
Last Answer : C [Both A & B]
Description : Softer variety of steel may be obtained by (A) Cementation process (B) Crucible process (C) Bessemer process (D) Open hearth
Last Answer : Answer: Option C
Description : The steel which contains fissures and cavities, is manufactured by (A) Cementation process (B) Crucible process (C) Bessemer process (D) Open hearth process
Last Answer : Answer: Option A
Description : Pick up the correct statement from the following: (A) Steel produced by open hearth process is milder than that obtained by the Bessemer process (B) Engineers prefer open hearth steel ... is suitable for converting poor ore containing a large proportion of sulphur and phosphorus into steel