Please Log in or Register for more.


269 views

1 Answer

Answer :

In a single phase motor the centrifugal switch disconnects auxiliary winding of the motor.

Like 0 like

Please log in or register to answer this question.

Related Questions



Last Answer : A centrifugal switch is used to disconnect starting winding when motor has picked up about 50 to 70 per cent of rated speed.

Show More

875 views 1 answer








Last Answer : If the centrifugal switch of a two-value capacitor motor using two capacitors fails to open then Electrolytic capacitor will, in all probability, suffer break down.

Show More

165 views 1 answer








Last Answer : Centrifugal switch disconnects the auxiliary winding of the motor at about 70 to 80 percent of synchronous speed.

Show More

222 views 1 answer








Last Answer : Single phase induction motor usually operates on 0.6 power factor lagging.

Show More

126 views 1 answer







A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will?
Last Answer : A capacitor-start single phase induction motor is switched on to supply with its capacitor replaced by an inductor of equivalent reactance value. It will not start at all.

Show More

230 views 1 answer







The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be?
Last Answer : The running winding of a single phase motor on testing with meggar is found to be ground. Most probable location of the ground will be at the slot edge where coil enters or comes out of the slot.

Show More

116 views 1 answer







State suitable single phase motor for following applications: (i) Table fan (ii) Mixers and Grinders
Last Answer : Application Suitable Single Phase Motor Table Fan 1) Capacitor split phase motor 2) Capacitor start capacitor run motor Mixers and Grinders 1) Universal motor 2) A.C. Series motor

Show More

96 views 1 answer







Why is a capacitor used in a single phase motor and not in three phase motor ?
Last Answer : In 1-phase induction motor capacitor work is generate the auxiliary winding current than excite the main winding to rotor starts rotate. After rotor start rotating about 75% of their speed than auxiliary ... emf to start the motor.so,in 3-phase induction motor is self start induction motor.

Show More

259 views 6 answers







working principle of single phase motor
Last Answer : The Stator of single phase induction motor houses two windings  1. Main (Running) winding 2. Auxiliary (Starting ) winding Rotor of single phase induction motor is ... with starting winding or a capacitor may be permanently connected in series with Auxiliary (Starting ) winding.

Show More

167 views 1 answer







Explain the working of a single phase capacitor start induction motor. 
Last Answer : Single phase capacitor start induction motor https://youtu.be/31lvvzU5Puc

Show More

393 views 2 answers







What is the slip (as a percentage) when a 6 pole single phase induction motor operating on 220 V and 60 Hz is rotating at speed of 1140 rpm? A) 60% B) 5% C) 10% D) None of these
Last Answer : What is the slip (as a percentage) when a 6 pole single phase induction motor operating on 220 V and 60 Hz is rotating at speed of 1140 rpm? A) 60% B) 5% C) 10% D) None of these

Show More

125 views 1 answer














Last Answer : If a single phase induction motor runs slower than normal, the most likely defect is worn bearings.

Show More

170 views 1 answer








Last Answer : Starting winding of a single phase motor of a refrigerator is disconnected from the circuit by means of a magnetic relay.

Show More

215 views 1 answer







An unexcited single phase synchronous motor is ?
Last Answer : An unexcited single-phase synchronous motor is reluctance motor.

Show More

160 views 1 answer







How does a single phase induction motor work?
Last Answer : As we know that single phase induction is not self started because for self started we require atleast two revolving field but single phase induction motor has only one. So we provide extra ... 1phase IM classified as split phase IM, capacitor start capacitor run, capacitor start induction run.

Show More

124 views 1 answer







explain the working of single phase induction motor.
Last Answer : Stator has two winding namely main winding and auxiliary winding.when single phase ac supply is given to the motor,its produces alternating field.this field cut by a cage rotor.so some emf ... due to this emf,rotor flux produced.the interaction between two fluxes produce torque.so rotor rotates.

Show More

186 views 1 answer







Single Phase Induction Motor
Last Answer : Single Phase Induction Motor Single phase induction motor is mostly used in home, office, shop and many single phase appliances like pumps,  ... torque and silent operation. It is uses where silent operation is required.

Show More

528 views 1 answer







A switch tail ring counter is made by using a single D-FF. The resulting circuit is (A) T-FF (B) D-FF (C) SR-FF (D) JK-FF
Last Answer : A switch tail ring counter is made by using a single D-FF. The resulting circuit is T-FF

Show More

185 views 1 answer








Last Answer : Direction of rotation of a split phase motor can be reversed by reversing the connection of either running winding or starting winding.

Show More

357 views 1 answer








Last Answer : In a split phase motor the starting winding is connected through a centrifugal switch.

Show More

117 views 1 answer








Last Answer : In a capacitor start motor, the phase displacement between starting and running winding can be nearly 90°.

Show More

207 views 1 answer








Last Answer : In a split phase motor, the running winding should have low resistance and high inductance.

Show More

99 views 1 answer







SINGLE PHASE INDUCTION MOTORS MCQ
Last Answer : 101. After the starting winding of a single phase induction motor is disconnected from supply, it continues to run only on (a) running winding (b) rotor winding (c) field winding (d) compensating winding Ans: a ... motor is usually reduced by using (a) gearing (b) belts (c) brakes (d) chains Ans: a

Show More

22 views 3 answers







Draw single phase full wave mid-point converter for inductive load. Draw input and output waveforms for it. 
Last Answer : Circuit Diagram: Waveforms:

Show More

531 views 1 answer







Single phase transformer
Last Answer : Single phase Transformer Transformer

Show More

260 views 1 answer







Explain MCB and ELCB with connection diagram supplying single phase load. 
Last Answer : OR OR Explanation: * MCB provides short circuit protection. * MCB provides overload protection * ELCB provides earth fault protection. * MCB is in series with ... occurs, the ELCB cuts off the power within the time of 0.1 sec. automatically to protect the personnel. 

Show More

581 views 1 answer



















Explain construction and working principle of single phase transformer.
Last Answer : A single phase transformers is an electrical device that accepts single-phase AC power and outputs single-phase AC. PRINCIPLE... The single-phase transformer works on the principle of ... and secondary windings. Thin steel laminations shall be employed to prevent power losses from the core.

Show More

1.1k views 4 answers







Give the operation of single phase full wave bridge controlled converter with RL load with a neat diagram. Also draw its waveform.
Last Answer : Single phase fully control bridge converter with RL load: 1. During positive half cycle of input voltage, T1 and T2 are forward biased and during negative half cycle, T3 and T4 are forward biased. Therefore, T1-T2 ... cycle till the firing of next pair of SCRs as shown in the waveform.

Show More

880 views 1 answer







State advantages of three phase over single phase.
Last Answer : Advantages of 3-phase system over 1-phase system: -  1. More output: For the same size, output of poly-phase machines is always higher than single phase machines.  2. Smaller size: For ... are self- starting: The three phase ac motors are self starting, while single phase induction motor are not.

Show More

2.9k views 4 answers







A single phase transformer has resistance and reactance of 0.2 pu and 0.6 pu respectively. Its pu voltage regulation at 0.8 pf lagging would he
Last Answer : A single phase transformer has resistance and reactance of 0.2 pu and 0.6 pu respectively. Its pu voltage regulation at 0.8 pf lagging would he 0.52

Show More

367 views 1 answer







What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these
Last Answer : What is the power factor when a single phase watt meter operating on 200 V and 5 A for 5 hours makes 2016 revolutions and the meter constant in revolution is 420? A) 0.04 B) 1.04 C) 0.96 D) None of these

Show More

207 views 1 answer







A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is (A) 28.2 mm (B) 26.4 mm (C) 24.4 mm (D) 22.0 mm
Last Answer : A single core cable is designed to work for a single phase system with a peak voltage of 220 kV. The maximum permissible stress in the dielectric is not to exceed 20 kV/mm. For economical size, the overall core diameter of the cable is 22.0 mm

Show More

755 views 1 answer







The disc of a single phase Induction-type energy meter makes 60 revolutions in 6 minutes. Meter Constant is 1200 rev/kWh. Power consumption in the load is (A) 1.2 kW (B) 1 kW (C) 600 W (D) 500 W
Last Answer : The disc of a single phase Induction-type energy meter makes 60 revolutions in 6 minutes. Meter Constant is 1200 rev/kWh. Power consumption in the load is 500 W

Show More

219 views 1 answer







The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is (A) 11% (B) 9% (C) 1.1% (D) 3%
Last Answer : The potential coil of a single phase dynamometer wattmeter has 4840 Ohm resistance. Voltage across the load is 220 V. With the potential coil connected on the load side, the meter indicates 100 W. Approximate percentage error due to wattmeter connection is 11%

Show More

319 views 1 answer








Last Answer : The power factor of a single phase load can be calculated if the instruments available are three ammeters or three voltmeters.

Show More

296 views 2 answers








Last Answer : In a single phase power factor meter the phase difference between the currents in the two pressure coils is exactly 90°.

Show More

352 views 1 answer








Last Answer : The two pressure coils of a single phase power factor meter have the same dimensions and the same number of turns.

Show More

158 views 1 answer








Last Answer : Induction type single phase energy meters measure electric energy in kWh.

Show More

478 views 1 answer








Last Answer : Necessary conditions required to be satisfied in order to ensure successful parallel operation of single phase transformers:  1. Only transformers having the same phase displacement between primary and secondary ... . 7. The phase sequence must be followed strictly on HV and LV side connection.

Show More

196 views 2 answers







What are the five types of single phase motors used in the industry?

Show More

79 views 0 answers







Explain power in single phase AC circuit.

Show More

82 views 0 answers







Describe the gate circuit for a single phase full converter.

Show More

70 views 0 answers







write short notes on single phase system.
Last Answer : A "phase" in an electrical system is often referred to as the waveform (may be voltage or the current) of the power supply. The waveform in an AC system is typically ... domestic household or commercial supplies and street lighting. Industrial supplies requires three phase electrical supply .

Show More

107 views 1 answer







three phase to single phase cycloconverter
Last Answer : three phase to single phase cycloconverter

Show More

514 views 1 answer







single phase full converter
Last Answer : single phase full converter

Show More

121 views 1 answer







List different starting methods of three phase synchronous motor. Explain any one of them.
Last Answer : Different Starting Methods of Three Phase Synchronous Motor: As synchronous motor is not self starting, different methods of starting are as follows: 1) By using an Induction (Pony) motor 2) ... . The rotor gets pulled into synchronism and starts running at constant speed as a synchronous motor. 

Show More

156 views 1 answer







Explain with neat circuit diagrams the procedures to perform no load and blocked rotor tests on three phase induction motor.

Show More

127 views 0 answers






Show More⇦ PreviousNext ⇨