Description : How would one squeeze more channels of communication into TDM frames of standard length? A. Shorten the time delay for each channel B. Raise the amplitude C. Add modulators D. Remove the synchronizing pulses
Last Answer : A. Shorten the time delay for each channel
Description : Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is __________. a. 400 bps b. 800 bps c. 1600 bps d. 3200 bps
Last Answer : d. 3200 bps
Description : Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is ............... (A) 400 bps (B) 800 bps (C) 1600 bps (D) 3200 bps
Last Answer : (D) 3200 bps Answer: D Explanation: The multiplexer is shown in the Figure. Each frame carries 1 byte from each channel; the size of each frame, therefore, is 4 bytes, or 32 bits. Because each ... channel, the frame rate must be 100 frames per second. The bit rate is 100 32 = 3200 bps.
Description : Compare FDM & TDM systems
Last Answer : Sr. No. FDM TDM 1 Divides the channel into the two or more frequency ranges that do not overlap. Divides and allocates certain Time periods to each channel. 2 Code word is ... Needs guard bands Needs guard time 4 Problem of crosstalk No problem of crosstalk
Description : __________ employs a set of screen across a flow channel for the separation of dirt/rust from a flowing liquid stream. (A) Thickener (B) Classifier (C) Strainer (D) Clarifier
Last Answer : (C) Strainer
Description : Two small diameter 10gm dielectric balls can slide freely on a vertical channel. Each carry a negative charge of 1μC. Find the separation between the balls if the lower ball is restrained from moving. a) 0.5 b) 0.4 c) 0.3 d) 0.2
Last Answer : c) 0.3
Description : Boundary layer separation occurs when the (A) Pressure reaches a minimum (B) Cross-section of the channel is reduced (C) Valve is closed in a pipeline (D) Velocity of sound is reached
Last Answer : (B) Cross-section of the channel is reduced
Description : Steady state equimolal counter diffusion is encountered in (A) Separation of a binary mixture by distillation (B) Absorption of NH3 from air by water (C) All liquid-liquid diffusion systems (D) All liquid-solid diffusion systems
Last Answer : (A) Separation of a binary mixture by distillation
Description : Multiplexing scheme use by baseband transmission. A. FDM B. Space multiplexing C. TDM D. Statistical multiplexing
Last Answer : C. TDM
Description : ____ is designed to use thehigh bandwidthcapabilityof fiber-optic cable. A) FDM B) TDM C) WDM D) None of the above
Last Answer : WDM
Description : In the North American TDM system, what is the transmission rate in Mbps of T3 carrier system? A. 44.736 B. 6.312 C. 3.152 D. 274.176
Last Answer : A. 44.736
Description : Which of the following describes a TDM frame? A. A 250-μs frame B. A 125-μs frame C. A 500-μs frame D. A 60-μs frame
Last Answer : B. A 125-μs frame
Description : Which of the following is oldest multiplexing scheme? A. Frequency Division Multiplexing (FDM) B. Time Division Multiplexing (TDM) C. Code Division Multiplexing (CDM) D. Space Division Multiplexing (SDM)
Last Answer : D. Space Division Multiplexing (SDM)
Description : One of the reasons why FDM is being replaced by TDM is A. noise is amplified with voice when an FDM system is used B. it is difficult to place channels side by side C. there is more time than frequency D. Most available frequencies has been used
Last Answer : A. noise is amplified with voice when an FDM system is used
Description : DMT is a modulation technique that combineselements of _______ and _______. A) FDM; TDM B) QDM; QAM C) FDM; QAM D) PSK; FSK
Last Answer : FDM; QAM
Description : The ______ technique expands the bandwidthof a signal by replacing each data bit with n bits. A) FDM B) DSSS C) FHSS D) TDM
Last Answer : DSSS
Description : The _______ technique uses M different carrier frequencies that are modulated by the source signal. At one moment, the sign modulates one carrier frequency; at the next moment, thesignal modulates another carrier frequency. A) FDM B) DSSS C) FHSS D) TDM
Last Answer : FHSS
Description : In ________ TDM, slots are dynamically allocated to improvebandwidth efficiency. A) synchronous B) statistical C) isochronous D) none of the above
Last Answer : statistical
Description : In ________ TDM, each input connection hasan allotment in the outputeven if it is not sendingdata. A) synchronous B) statistical C) isochronous D) none of the above
Last Answer : synchronous
Description : We candivide ____ into two different schemes: synchronousor statistical. A) FDM B) TDM C) WDM D) none of the above
Last Answer : TDM
Description : _____ isa digital multiplexing technique for combiningseveral low-ratechannels into onehigh-rate one. A) FDM B) TDM C) WDM D) None of the above
Description : _____ isa digitalprocess that allows several connections to share thehighbandwidth ofa link. A) FDM B) TDM C) WDM D) None of the above
Description : _____ isan analog multiplexing technique to combine optical signals. A) FDM B) TDM C) WDM D) None of the above
Description : Which multiplexing technique involves signals composed of light beams? A) FDM B) TDM C) WDM D) none of the above
Description : In TDM, the transmissionrate of the multiplexed path isusually_______ thesum of thetransmission rates of thesignal sources. A) greater than B) less than C) equal to D) not related to
Last Answer : greater than
Description : In synchronous TDM, forn signal sources of the same data rate, eachframe contains _______ slots. A) n B) n + 1 C) n- 1 D) 0to n
Last Answer : n
Description : Which multiplexing technique shifts each signal to a different carrier frequency? A) FDM B) TDM C) Both (a)and (b) D) None of the above
Last Answer : FDM
Description : Which multiplexing technique transmits digital signals? A) FDM B) TDM C) WDM D) None of the above
Description : Which multiplexing technique transmits analog signals? A) FDM B) TDM C) WDM D) (a) and (c)
Last Answer : (a) and (c)
Description : SONET is a _______ TDM system. A) asynchronous B) synchronous C) statistical D) none of the above
Last Answer : none of the above
Description : An ______signal is the optical modulation of an STS-n (or STM-n) signal. A) OC-n B) TDM-n C) FDM-n D) none of the above
Last Answer : TDM-n
Description : If link transmits 4000 frames per second and each slot has 8 bits, the transmission rate of circuit of this TDM is ______. a. 64 Kbps b. 32 Mbps c. 32 Kbps d. 64 MbpS
Last Answer : c. 32 Kbps
Description : TDM stands for: a) Task Division Multiplexing b) Time Division Multiplexing c) Testing Division Multiplexing d) None of These
Last Answer : b) Time Division Multiplexing
Description : How speech is transmitted in a digital switching environment using PCM/TDM?
Last Answer : A digital carrier system is a communications system that uses digital pulses rather than analogue signals to encode information. Fig shows the block diagram for a digital carrier system. This digital ... to maintain frame and sample synchronization between the TDM transmitter and receiver.
Description : Using_________each connected device is assigned a time slot whether or not the device has any thing to send. (A) WDM (B) FDM (C) TDM (D) STDM
Last Answer : (C) TDM
Description : Time synchronization is necessary in (A) FDM. (B) TDM. (C) WDM. (D) Quadrature multiplexing
Last Answer : (B) TDM.
Description : It is the most prevalent encoding technique used for TDM signals:
Last Answer : PCM
Description : The time it takes to transmit one TDM frame is called ______
Last Answer : Frame time
Description : Which of the following drug is not needed to be TDM? a) Carbamazepine. b) Penicillin. c) Digoxin. d) Gentamicin.
Last Answer : b) Penicillin.
Description : Given the following statements: (a) Frequency Division Multiplexing is a technique that can be applied when the bandwidth of a link is greater than combined bandwidth of signals to be transmitted. (b) Wavelength Division Multiplexing (WDM) ... c) is true. (D) (a), (b) and (d) are true; (c) is false.
Last Answer : (D) (a), (b) and (d) are true; (c) is false.
Description : If link transmits 4000 frames per second and each slot has 8 bits, the transmission rate of circuit of this TDM is ............... (A) 64 Kbps (B) 32 Mbps (C) 32 Kbps (D) 64 Mbps
Last Answer : (C) 32 Kbps
Description : Explain TDM technique with relevant diagram.
Last Answer : TIME DIVISION MULTIPLEXING (TDM): TDM is a digital multiplexing technique in which many signals are transmitted for very short time (time slot) over common transmission channel. Here each signal ... sample (or word) synchronization is necessary to properly separate the samples within each frame.
Description : What is the channel capacity of a noisy channel with conditional probability of error p = 1/2? A) 0 B) 1 C) Infinity D) 2
Last Answer : What is the channel capacity of a noisy channel with conditional probability of error p = 1/2? A) 0 B) 1 C) Infinity D) 2
Description : As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel which is bandlimited to ‘B’ Hz. The number of samples ‘n’ is given by (symbols/notations carry their usual meaning) A) B/T B) T/B C) 2BT D) BT/2
Last Answer : As per Shannon’s channel capacity theorem, if samples are transmitted in ‘T’ seconds over a noisy channel which is bandlimited to ‘B’ Hz. The number of samples ‘n’ is given by ( ... /notations carry their usual meaning) A) B/T B) T/B C) 2BT D) BT/2
Last Answer : The capacity of a channel is maximum rate of information transmission.
Description : When portable cords are connected to devices such as portable tools, you must eliminate direct tension on the joints or terminal screws. Coast Guard Regulations (46 CFR), allow this to be done by ... the plugs together C. installing a special fitting to eliminate plug separation D. all of the above
Last Answer : Answer: D
Description : The study on washability of coal is done by using the __________ technique. (A) Tabling (B) Elutriation (C) Heavy media separation (D) None of these
Last Answer : (C) Heavy media separation
Description : Separation of isotopes is generally done using a/an __________ centrifuge. (A) Ultra (B) Disk-bowl (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Ultra
Description : Pick out the wrong statement. (A) Critical moisture content is not a property of the material itself (B) A sharp increase in pressure drop gives an indication of the flooding in a ... unity (D) Dehydration of ethyl alcohol is most economically done by molecular distillation at very high vacuum
Last Answer : (D) Dehydration of ethyl alcohol is most economically done by molecular distillation at very high vacuum
Description : Separation of the isotopes of helium for scientific investigations is done by (A) Reverse osmosis (B) Thermal diffusion (C) Leaching (D) Solvent extraction
Last Answer : (B) Thermal diffusion