What factors affect descent angle in a glide?  
a. Configuration and altitude  
b. Configuration and angle of attack  
c. Mass and altitude  
d. Mass and configuration

1 Answer

Answer :

b. Configuration and angle of attack

Related questions

Description : What factors affect descent angle in a glide? a. Configuration and altitude b. Configuration and angle of attack c. Mass and altitude d. Mass and configuration

Last Answer : b. Configuration and angle of attack

Description : If airbrakes are extended during a glide, and speed maintained, the rate of descent will: a. Increase and glide angle will be steeper b. Increase but glide angle will remain the same c. Decrease d. Remain the same

Last Answer : a. Increase and glide angle will be steeper

Description : On an ILS approach, you are told that the weather has dropped below company minima. When must you abort the approach? a. Start of the glide-slope descent b. FAF c. Inner marker d. Outer marker

Last Answer : d. Outer marker

Description : In the event of cabin depressurization, the actions of the pilot will be to: a. Immediately commence a diversion to a suitable alternate b. Increase engine power to provide additional ... a descent to an altitude where the supplemental oxygen supply is sufficient for all crew and passengers

Last Answer : d. Commence a descent to an altitude where the supplemental oxygen supply is sufficient for all crew and passengers

Description : The transition of altitude to flight level and vice versa is made: a. On the transition level in the climb and transition altitude in the descent b. At the transition altitude in the climb and transition level in the descent c. At the transition level only d. At the transition altitude only

Last Answer : b. At the transition altitude in the climb and transition level in the descent

Description : When entering a steep turn, an IVSI is likely to show: a. No change in altitude b. A slight climb c. A slight descent d. A slight descent at high airspeed only

Last Answer : b. A slight climb

Description : When would the negative differential limits be reached/exceeded? a. Rapid descent when AC descends below cabin altitude b. During ground pressure testing c. Rapid ascent when aircraft climbs d. When changing to manual operation

Last Answer : a. Rapid descent when AC descends below cabin altitude

Description : What true airspeed and angle of attack should be used to generate the same amount of lift as altitude is increased? a. A higher true airspeed for any given angle of attack b. The same true ... c. A lower true airspeed and higher angle of attack d. A constant angle of attack and true airspeed

Last Answer : a. A higher true airspeed for any given angle of attack

Description : To maintain altitude, what must be done as Indicated Airspeeed (IAS) is reduced? a. Decrease angle of attack to reduce the drag b. Increase angle of attack to maintain the correct lift force c. Deploy the speed brakes to increase drag d. Reduce thrust

Last Answer : b. Increase angle of attack to maintain the correct lift force

Description : What is the effect of deploying leading edge flaps? a. Increased minimum glide angle b. Decreased minimum glide angle c. Increased glide range d. Decreased sink rate

Last Answer : d. Decreased sink rate

Description : What four factors affect night vision? a. Age, alcohol, altitude and smoking b. Age, altitude, instrument lights and smoking c. Instrument lights, altitude, alcohol and smoking d. Age, alcohol, altitude and instrument lights

Last Answer : a. Age, alcohol, altitude and smoking

Description : Lowering the flaps during a landing approach: a. Increases the angle of descent without increasing the airspeed b. Decreases the angle of descent without increasing power c. Eliminates floating d. Permits approaches at a higher indicated airspeed

Last Answer : a. Increases the angle of descent without increasing the airspeed

Description : A precision Approach Procedure is defined as: a. An approach using bearing, elevation and distance information b. An approach with a crew of at least 2 pilots trained for such ... An instrument approach procedure utilizing azimuth and glide path information provided by an ILS or a PAR

Last Answer : c. An instrument approach procedure utilizing azimuth and glide path information provided by an ILS or a PAR

Description : Refer to CAP697 MRJT1 Fig. 4.2 & 4.5.3.2 Estimated take-off mass 57,000kg; ground distance 150nm; temperature ISA -10C; cruise at M0.74. What is the optimum cruise altitude and TAS? a. 25,000ft & 445kt b. 33,000ft & 420kt c. 25,000ft & 435kt d. 33,000ft & 430kt

Last Answer : c. 25,000ft & 435kt

Description : At a constant mass and altitude, a lower airspeed requires: a. More thrust and a lower coefficient of lift b. Less thrust and a lower coefficient of lift c. More thrust and a lower coefficient of drag d. A higher coefficient of lift

Last Answer : d. A higher coefficient of lift

Description : If the weight of an aircraft is increased the maximum gliding range: a. Decreases b. Increases c. Remains the same, and rate of descent is unchanged d. Remains the same, but rate of descent increases

Last Answer : d. Remains the same, but rate of descent increases

Description : If cabin pressure is decreasing, the cabin VSI will indicate: a. Zero b. Climb c. Descent d. Reducing pressure

Last Answer : b. Climb

Description : An aircraft is travelling at 100kts forward speed on a 3° glidescope. What is its rate of descent? a. 500 ft/min b. 300 ft/min c. 250 ft/min d. 600 ft/min

Last Answer : a. 500 ft/min

Description : When is spark plug fouling most likely to occur? a. In the climb if you have not adjusted the mixture b. Cruise power c. In the descent if you have not adjusted the mixture d. Max take-off power

Last Answer : a. In the climb if you have not adjusted the mixture

Description : What flight condition should be expected when an aircraft leaves ground effect? a. A decrease in parasite drag permitting a lower angle of attack b. An increase induced drag and a requirement ... increase in dynamic stability d. A decrease in induced drag requiring a smaller angle of attack

Last Answer : b. An increase induced drag and a requirement for a higher angle of attack

Description : By changing the angle of attack of a wing, the pilot can control the aeroplane’s: a. Lift and airspeed, but not drag b. Lift, gross weight and drag c. Lift, airspeed and drag d. Lift and drag, but not airspeed

Last Answer : c. Lift, airspeed and drag

Description : Which stall has the greatest angle of attack? a. Low speed stall b. High speed stall (shock stall) c. Deep stall d. Accelerated stall

Last Answer : c. Deep stall

Description : To recover from a spin, the elevators should be: a. Moved up to increase the angle of attack b. Moved down to reduce the angle of attack c. Set to neutral d. Allowed to float

Last Answer : b. Moved down to reduce the angle of attack

Description : If the angle of attack is increased beyond the critical angle of attack, the wing will no longer produce sufficient lift to support the weight of the aircraft: a. Unless the airspeed is greater ... below the natural horizon d. In which case, the control column should be pulled-back immediately

Last Answer : b. Regardless of airspeed or pitch attitude

Description : Which statement is true relative to changing angle of attack? a. A decrease in angle of attack will increase pressure below the wing and decrease drag b. An increase in angle of attack will ... of attack will increase drag d. An increase in angle of attack will decrease the lift coefficient

Last Answer : c. An increase in angle of attack will increase drag

Description : The angle of attack of a fixed pitch propeller: a. Depends on forward speed only b. Depends on forward speed and engine rotational speed c. Depends on engine rotational speed only d. Is constant for a fixed pitch propeller

Last Answer : b. Depends on forward speed and engine rotational speed

Description : What is the recommended technique to counter the loss of airspeed and resultant lift from wind shear? a. Maintain, or increase, pitch attitude and accept the lower-than-normal airspeed ... shaker, and apply maximum power d. Accelerate the aircraft to prevent a stall by sacrificing altitude

Last Answer : c. Avoid overstressing aircraft, pitch to stick shaker, and apply maximum power

Description : The stalling speed of an aeroplane is most affected by: a. Changes in air density b. Variations in aeroplane loading c. Variations in flight altitude d. Changes in pitch attitude

Last Answer : b. Variations in aeroplane loading

Description : Shortly after take-off, the altitude of the aeroplane suffers an abrupt pitch-up and IAS rapidly decreases followed quickly by a decrease in altitude. Engine indications are normal. You should suspect what ... to gain airspeed d. Local clear air turbulence; reduce speed to VRA and ride it out

Last Answer : b. Loss of head wind or an increase in tail wind; apply full power

Description : An aircraft has to communicate with a VHF station at a range of 300nm, if the ground station is situated 2,500ft amsl, which of the following is the lowest altitude at which contact is likely to be made? a. 190ft b. 1,378ft c. 36,100ft d. 84,100ft

Last Answer : c. 36,100ft

Description : Which constant pressure altitude chart is standard for a 30,065 ft pressure level (FL 300)? a. 200 hPa b. 700 hPa c. 500 hPa d. 300 hPa

Last Answer : d. 300 hPa

Description : You are cruising at FL 200, OAT is -40°C, sea level pressure is 1033 hPa. Calculate the true altitude. a. 20,660 ft b. 21,740 ft c. 18,260 ft d. 19, 340 ft

Last Answer : d. 19, 340 ft

Description : How does a pilot react to heavy freezing rain at 2,000ft/AGL, when he is unable to deice nor land? a. He ascends to the cold air layer above b. He continues to fly at the same altitude c. He turns back before the aircraft loses maneuverability d. He descends to the warm air layer below

Last Answer : c. He turns back before the aircraft loses maneuverability

Description : The isobars drawn on a surface weather chart represent lines of equal pressure: a. At flight level b. At height of observatory c. At a determined density altitude d. Reduced to sea level

Last Answer : d. Reduced to sea level

Description : Generally, as altitude increases: a. Temperature decreases and density increases b. Temperature, pressure and density decreases c. Temperature and pressure increase and density decreases d. Temperature decreases and pressure and density increase

Last Answer : b. Temperature, pressure and density decreases

Description : A pilot suffering from decompression sickness should: a. Descend to a lower level where the symptoms will disappear and continue the flight at this or a lower level b. Decrease the cabin pressure ... the pain in the affected site d. Land as soon as possible and seek medical assistance

Last Answer : d. Land as soon as possible and seek medical assistance

Description : The effects of carbon monoxide: a. Increases with altitude b. Decreases with altitude c. Increases with increase of density d. Decreases with pressure loss

Last Answer : a. Increases with altitude

Description : For take-off performance calculations, what is taken into account? a. OAT, pressure altitude, wind, weight b. Standard temperature, altitude, wind, weight c. Standard altitude, standard temperature, wind, weight d. Standard temperature, pressure altitude, wind, weight

Last Answer : a. OAT, pressure altitude, wind, weight

Description : What action should be taken when, during an IFR flight in VMC, you suffer a radio failure? a. Return to the aerodrome from which you departed b. Continue flying in VMC and land as ... there are VMC conditions d. Continue flying at your assigned altitude and start your approach at your ETA

Last Answer : b. Continue flying in VMC and land as soon as possible

Description : The excess cabin altitude alerting system must operate to warn the crew at: a. 8,000ft b. 10,000ft c. 13,000ft d. 14,000ft

Last Answer : b. 10,000ft

Description : An aircraft is flying at constant indicated altitude over a warm airmass. The altimeter reading will be: a. Correct b. Greater than the real altitude c. Less than the real altitude d. Oscillating around the correct altitude

Last Answer : c. Less than the real altitude

Description : Cabin altitude in pressured flight is: a. The altitude corresponding to cabin pressure regardless of aircraft height b. Is presented on a second needle on the aircraft altimeter c. ... equals ambient pressure d. Altitude corresponding to cabin pressure in relation to MSL ISA conditions

Last Answer : a. The altitude corresponding to cabin pressure regardless of aircraft height b. Is presented on a second needle on the aircraft altimeter

Description : The transition of altitude to flight level and vice versa is made: a. On the transition level in the climb and transition altitude in the descent b. At the transition altitude in the climb and transition level in the descent c. At the transition level only d. At the transition altitude only

Last Answer : b. At the transition altitude in the climb and transition level in the descent

Description : When entering a steep turn, an IVSI is likely to show: a. No change in altitude b. A slight climb c. A slight descent d. A slight descent at high airspeed only

Last Answer : b. A slight climb

Description : When would the negative differential limits be reached/exceeded? a. Rapid descent when AC descends below cabin altitude b. During ground pressure testing c. Rapid ascent when aircraft climbs d. When changing to manual operation

Last Answer : a. Rapid descent when AC descends below cabin altitude

Description : If the ailerons are deflected to 10°, compared to 5°, this will cause: a. An increased angle of bank b. An increased rate of roll c. No change to either bank angle or roll rate d. A reduction in the adverse yawing moment

Last Answer : b. An increased rate of roll

Description : Which statement best describes the operating principle of a constant-speed propeller? a. As throttle setting is changed by the pilot, the prop governor causes pitch angle of the propeller blades to ... the pilot, the RPM of the engines remains constant as the pitch angle of the propeller changes

Last Answer : b. The propeller control regulates the engine RPM and in turn the propeller RPM

Description : To give the best obstacle clearance on take-off, take-off should be made with: a. Flaps partially extended and at best rate of climb speed (Vy) b. Flaps partially extended and at best angle of climb ... at best rate of climb speed (Vy) d. Flaps retracted and at best angle of climb speed (Vx)

Last Answer : d. Flaps retracted and at best angle of climb speed (Vx)

Description : Which of the following increases the stall angle? a. Slats b. Flaps c. Spoilers d. Ailerons

Last Answer : a. Slats

Description : The method of alighting the aeroplane on water during a ditching is to: a. Carry out a normal approach with flaps and gear selected as normal but to calculate all speeds plus 10kts b. Reduce ... d. Fly a normal approach to stalling speed and then drop the aeroplane vertically onto the water

Last Answer : c. Fly a normal approach but keep the gear up and land at lowest possible speed with the nose raised for the tail to strike first