When is spark plug fouling most likely to occur?  
a. In the climb if you have not adjusted the mixture  
b. Cruise power  
c. In the descent if you have not adjusted the mixture  
d. Max take-off power

1 Answer

Answer :

a. In the climb if you have not adjusted the mixture

Related questions

Description : When is spark plug fouling most likely to occur? a. In the climb if you have not adjusted the mixture b. Cruise power c. In the descent if you have not adjusted the mixture d. Max take-off power

Last Answer : a. In the climb if you have not adjusted the mixture

Description : When entering a steep turn, an IVSI is likely to show: a. No change in altitude b. A slight climb c. A slight descent d. A slight descent at high airspeed only

Last Answer : b. A slight climb

Description : The transition of altitude to flight level and vice versa is made: a. On the transition level in the climb and transition altitude in the descent b. At the transition altitude in the climb and transition level in the descent c. At the transition level only d. At the transition altitude only

Last Answer : b. At the transition altitude in the climb and transition level in the descent

Description : If cabin pressure is decreasing, the cabin VSI will indicate: a. Zero b. Climb c. Descent d. Reducing pressure

Last Answer : b. Climb

Description : Which of the following performance characteristics of a S.I engine is not affected by the front end volatility of the petrol used? (A) Vapour locking (B) Hot starting (C) Spark plug fouling (D) All 'a', 'b' & 'c'

Last Answer : (C) Spark plug fouling

Description : To give the best obstacle clearance on take-off, take-off should be made with: a. Flaps partially extended and at best rate of climb speed (Vy) b. Flaps partially extended and at best angle of climb ... at best rate of climb speed (Vy) d. Flaps retracted and at best angle of climb speed (Vx)

Last Answer : d. Flaps retracted and at best angle of climb speed (Vx)

Description : When does the first segment of the take-off climb begin? a. When V2 is reached b. When 35 feet is reached c. When flaps are up d. When gear and flaps are up

Last Answer : b. When 35 feet is reached

Description : Lowering the flaps during a landing approach: a. Increases the angle of descent without increasing the airspeed b. Decreases the angle of descent without increasing power c. Eliminates floating d. Permits approaches at a higher indicated airspeed

Last Answer : a. Increases the angle of descent without increasing the airspeed

Description : In the event of cabin depressurization, the actions of the pilot will be to: a. Immediately commence a diversion to a suitable alternate b. Increase engine power to provide additional ... a descent to an altitude where the supplemental oxygen supply is sufficient for all crew and passengers

Last Answer : d. Commence a descent to an altitude where the supplemental oxygen supply is sufficient for all crew and passengers

Description : Refer to CAP697 MRJT1 Fig. 4.2 & 4.5.3.2 Estimated take-off mass 57,000kg; ground distance 150nm; temperature ISA -10C; cruise at M0.74. What is the optimum cruise altitude and TAS? a. 25,000ft & 445kt b. 33,000ft & 420kt c. 25,000ft & 435kt d. 33,000ft & 430kt

Last Answer : c. 25,000ft & 435kt

Description : A constant rate of climb in an aeroplane is determined by: a. Wind speed b. The aircraft weight c. Excess engine power d. Excess airspeed

Last Answer : c. Excess engine power

Description : If the weight of an aircraft is increased the maximum gliding range: a. Decreases b. Increases c. Remains the same, and rate of descent is unchanged d. Remains the same, but rate of descent increases

Last Answer : d. Remains the same, but rate of descent increases

Description : If airbrakes are extended during a glide, and speed maintained, the rate of descent will: a. Increase and glide angle will be steeper b. Increase but glide angle will remain the same c. Decrease d. Remain the same

Last Answer : a. Increase and glide angle will be steeper

Description : On an ILS approach, you are told that the weather has dropped below company minima. When must you abort the approach? a. Start of the glide-slope descent b. FAF c. Inner marker d. Outer marker

Last Answer : d. Outer marker

Description : What factors affect descent angle in a glide? a. Configuration and altitude b. Configuration and angle of attack c. Mass and altitude d. Mass and configuration

Last Answer : b. Configuration and angle of attack

Description : An aircraft is travelling at 100kts forward speed on a 3° glidescope. What is its rate of descent? a. 500 ft/min b. 300 ft/min c. 250 ft/min d. 600 ft/min

Last Answer : a. 500 ft/min

Description : When would the negative differential limits be reached/exceeded? a. Rapid descent when AC descends below cabin altitude b. During ground pressure testing c. Rapid ascent when aircraft climbs d. When changing to manual operation

Last Answer : a. Rapid descent when AC descends below cabin altitude

Description : When entering a steep turn, an IVSI is likely to show: a. No change in altitude b. A slight climb c. A slight descent d. A slight descent at high airspeed only

Last Answer : b. A slight climb

Description : In the event of an act of unlawful interference, which of the following is the correct procedure to be taken by the pilot in command? a. Squawk 7700 if the situation requires and continue ... the flight plan, climb or descend to altitudes that differ from the normal cruising altitudes by 1000ft

Last Answer : c. Squawk 7500 (or 7700 if required) and broadcast a warning if the situation forces deviation from the cleared flight plan

Description : From a pre-flight briefing you know a jet stream is at 31,000ft whilst you are at FL270. You experience moderate CAT. What would be the best course of action? a. Stay level b. Descend c. Climb d. Reduce speed

Last Answer : b. Descend

Description : Maximum endurance: a. Can be achieved in level unaccelerated flight with minimum fuel consumption b. Can be achieved by flying at the best rate of climb speed in straight and level flight c. Can be achieved in a steady climb d. Can be achieved by flying at the absolute ceiling

Last Answer : a. Can be achieved in level unaccelerated flight with minimum fuel consumption

Description : An aircraft climbs from an airfield, elevation 1500ft, QNH 1023mb, to FL75. What height does the aircraft have to climb? (Assume 1mb=30ft) a. 6600 ft b. 7800 ft c. 6300 ft d. 6000 ft

Last Answer : c. 6300 ft

Description : Which of the following would give the greatest gliding performance? a. Flight at VMD b. Flight at 1.32VMD c. Flight at the best CL/CD ratio d. Flight close to CL MAX

Last Answer : d. Flight close to CL MAX

Description : Refer to CAP697 MRJT1 Fig. 4.3.1 Given: Estimated zero fuel mass 50t; estimated landing mass at destination 52t; final reserve fuel 2t; alternate fuel 1t; flight to destination distance 720nm, true course 030, W/V ... b. 4,400kg / 02hr 02min c. 4,750kg / 02hr 00min d. 4,600kg / 02hr 05min

Last Answer : a. 4,800kg / 01hr 45min

Description : How do you control power in a jet engine? a. By controlling the mixture ratio b. By controlling the fuel flow c. By controlling the airflow d. By controlling the bleed valves

Last Answer : b. By controlling the fuel flow

Description : The transition of altitude to flight level and vice versa is made: a. On the transition level in the climb and transition altitude in the descent b. At the transition altitude in the climb and transition level in the descent c. At the transition level only d. At the transition altitude only

Last Answer : b. At the transition altitude in the climb and transition level in the descent

Description : If cabin pressure is decreasing, the cabin VSI will indicate: a. Zero b. Climb c. Descent d. Reducing pressure

Last Answer : b. Climb

Description : Shortly after take-off, the altitude of the aeroplane suffers an abrupt pitch-up and IAS rapidly decreases followed quickly by a decrease in altitude. Engine indications are normal. You should suspect what ... to gain airspeed d. Local clear air turbulence; reduce speed to VRA and ride it out

Last Answer : b. Loss of head wind or an increase in tail wind; apply full power

Description : The EGT indication on a piston engine is used: a. To control the cooling air shutters b. To monitor the oil temperature c. To assist the pilot to adjust the fuel mixture d. To indicate cylinder head temperature

Last Answer : c. To assist the pilot to adjust the fuel mixture

Description : Why Joel's engine is unable to power his car the way it used to. The spark plug is working and the engine is compressing properly so what could be the problem?

Last Answer : Could be a fuel delivery problem such as a dirty fuelfilter.

Description : During a slow decompression, passengers will occur: a. The cabin temperature will fall as pressure reduces b. Body cavities (sinuses, ears, etc.) will become pressurised and may require assistance in ... will operate d. No contra effects, as slow decompression has no effect on the human body

Last Answer : b. Body cavities (sinuses, ears, etc.) will become pressurised and may require assistance in venting

Description : An aircraft has to communicate with a VHF station at a range of 300nm, if the ground station is situated 2,500ft amsl, which of the following is the lowest altitude at which contact is likely to be made? a. 190ft b. 1,378ft c. 36,100ft d. 84,100ft

Last Answer : c. 36,100ft

Description : If you switch on the anti-collision light in IMC, what are the likely effects? a. Depth perception increases b. You can suffer from dizziness and disorientation c. You can suffer from Color Illusion d. Binocular vision is affected

Last Answer : b. You can suffer from dizziness and disorientation

Description : Disorientation is more likely when the pilot is: 1. flying in VMC 2. frequently changing between inside and outside references 3. flying from IMC to VMC 4. approaching over still water at night a. 1, 2 & ... 1, 2 & 4 only are correct c. 1, 2, 3 & 4 are correct d. 1 only is correct

Last Answer : b. 1, 2 & 4 only are correct

Description : The most likely cause of brake fade is: a. Oil or grease on the brake drums b. Worn stators c. The pilot reducing the brake pressure d. The brake pads overheating

Last Answer : d. The brake pads overheating

Description : If flaps are lowered during the take-off run: a. The lift would not change until the aircraft is airborne b. The lift would increase when the flaps are lowered c. The lift would decrease d. The acceleration would increase

Last Answer : b. The lift would increase when the flaps are lowered

Description : When does a pilot apply the limitations of the MEL? a. At parking before commencement of taxi b. Prior to take-off c. At any time in flight d. Any time up to coming to a complete stop and applying the parking brake

Last Answer : d. Any time up to coming to a complete stop and applying the parking brake

Description : To act as co-pilot for take-off or landing, you must have: a. Acted as PIC or co-pilot on type in the last 90 days b. Acted as PIC or co-pilot on type in the last 30 days c. Acted as PIC or co-pilot on type in the last 60 days d. Been at the controls for landing in the same type recently

Last Answer : a. Acted as PIC or co-pilot on type in the last 90 days

Description : The FMC position will be at its most inaccurate: a. On take-off b. At TOC c. At TOD d. On final approach

Last Answer : c. At TOD

Description : A flight is to depart from an airport with runway 09 and 27. Surface wind is 270/05; an inversion is reported at 300 feet with turbulence and wind shear. The wind just above the ... throttle during the passage through the inversion d. Depart runway 27 with as steep an ascent as possible

Last Answer : b. Depart on runway 09 with a tailwind

Description : DOM 33,510kt; Traffic load 7,600kg; Trip fuel 2040kg; Final reserve 983kg Alternative fuel 1100kg; Contingency 5% of trip fuel Which of the following is correct? a. Estimated landing mass at destination ... 43,295kg c. Estimated take-off mass 43,295kg d. Estimated take-off mass 45,233kg

Last Answer : b. Estimated landing mass at destination 43,295kg

Description : For a flight plan filed before flight, the indicated time of departure is: a. The time overhead the first reporting point after take-off b. The time at which the flight plan is filed c. The estimated off-block time d. The time of take-off

Last Answer : c. The estimated off-block time

Description : For take-off performance calculations, what is taken into account? a. OAT, pressure altitude, wind, weight b. Standard temperature, altitude, wind, weight c. Standard altitude, standard temperature, wind, weight d. Standard temperature, pressure altitude, wind, weight

Last Answer : a. OAT, pressure altitude, wind, weight

Description : What is the Total Elapsed Time on a VFR flight plan? a. From take-off to overhead destination b. From take-off to overhead destination + 15 mins c. From take-off to landing d. From taxi to arrival on the gate

Last Answer : a. From take-off to overhead destination

Description : If a jet engine fails during take-off before V1: a. The take-off can be continued or aborted b. The take-off should be aborted c. The take-off should be continued d. The take-off may be continued if the aircraft speed is above VMCG and lies between VGO and VSTOP

Last Answer : b. The take-off should be aborted

Description : What minimum ground visibility is required to enable a SVFR flight to take off from an aerodrome in a CTR? a. 1000m b. 1500m c. 2000m d. 3000m

Last Answer : b. 1500m

Description : A hand pump is usually fitted: a. For ground servicing purposes b. Lowering the landing gear in an emergency c. Pressurising the oleo struts in the air d. Retracting the gear after take-off

Last Answer : a. For ground servicing purposes

Description : If you are beset by hordes of chiggers, and are itching like mad, would grabbing a live spark plug wire on a lawn mower kill the suckers?

Last Answer : WTF is a chigger?

Description : Does a hotter spark on a spark plug mean that you will get better gas mileage?

Last Answer : Need Answer