Can the efficiency of a plate in the distillation tower be greater than
100%?
(A) Yes
(B) Normally not; but is possible if infinite number of plates are put
(C) Never
(D) Yes; if the reflux ratio is maximum
Description : Pick out the correct statement. (A) The slope of the stripping line is always less than unity (B) For a given separation in a binary distillation column, with increase in reflux ratio ( ... (D) Kremser-Brown-Souder's equation is used to calculate the efficiency of a plate tower
Last Answer : C) In Ponchon-Savarit method of no. of theoretical plate determination, the stripping and rectifying operating lines are vertical at total reflux
Description : For a distillation column operating at minimum reflux, the (A) Concentration of liquid and vapour leaving a plate will be same (B) Reflux ratio will be maximum (C) Number of plates required will be maximum
Last Answer : (C) Number of plates required will be maximum
Description : Pick out the wrong statement. (A) In solvent extraction, the distribution co-efficient should be as large as possible for solvent economy (B) With increase in pressure, the solubility of ... in distillation column (D) The capacity of a distillation column is maximum at total reflux
Last Answer : (D) The capacity of a distillation column is maximum at total reflux
Description : Pick out the wrong statement. (A) Different solids have different equilibrium moisture curves (B) Total condenser or reboiler is considered equivalent to one theoretical plate in McCabe-Thiele method of ... (D) Even a forced draft cooling tower cannot cool water below the wet bulb temperature
Last Answer : (C) Heat removal load on cooler remains constant, even with increase of the reflux ratio in a distillation column
Description : Pick out the correct statement. (A) Higher hold up of the solid in the rotary dryer results in better exposure of the solids to the gas (B) The 'Hatta number' is ... reflux in case of distillation operation requires infinite number of plates for a binary system separation
Last Answer : (C) For a non-reacting binary mixture of ideal gases, the partial pressure distribution of both components is linear in the case of steady state equimolal counter-diffusion
Description : In McCabe-Thiele method, at infinite reflux ratio (A) Number of plates is maximum (B) Overhead product is maximum (C) Both the operating lines coincide with the diagram (D) None of these
Last Answer : (C) Both the operating lines coincide with the diagram
Description : The operating cost of a distillation column at minimum reflux ratio is (A) Minimum (B) Maximum (C) Infinite (D) Zero
Last Answer : (A) Minimum
Description : Fenske equation determines the (A) Maximum number of ideal plates (B) Height of the distillation column (C) Minimum number of theoretical plates (D) Optimum reflux ratio
Last Answer : (C) Minimum number of theoretical plates
Description : When a multistage tray tower uses a minimum reflux ratio, it implies (A) Infinite trays and maximum reboiler heat load (B) Infinite trays and minimum reboiler heat load (C) Minimum trays and minimum reboiler heat load (D) Minimum trays and maximum reboiler heat load
Last Answer : (A) Infinite trays and maximum reboiler heat load
Description : The minimum number of theoretical plates is required for achieving a given separation in distillation column with (A) No reflux (B) Total reflux (C) Zero reflux ratio (D) Minimum reflux ratio
Last Answer : (B) Total reflux
Description : As the reflux ratio in a distillation column is increased from the minimum, the (A) Slope of the operating line in stripping section decreases (B) Number of plates decreases very slowly first ... decreases and then increases (D) Liquid flow increases while the vapor flow decreases for a system
Last Answer : (C) Total cost first decreases and then increases
Description : At what value of reflux ratio, number of theoretical plates in a distillation column is minimum? (A) 0 (B) 1 (C) ∞ (D) < 1
Last Answer : (C) ∞
Description : At __________ reflux, theoretical number of plates in a distillation coloumn is calculated using Fenske-Underwood equation. (A) Operating (B) Total (C) Minimum (D) Maximum permissible
Last Answer : (B) Total
Description : In case of binary distillation, increasing the reflux ratio above optimum does not result in the increase of (A) Area between operating line and 45° diagonal x-y diagram (B) Condenser and reboiler surfaces (C) Tower cross-section (D) None of these
Last Answer : (A) Area between operating line and 45° diagonal x-y diagram
Description : A distillation column with N plates is being operated under normal conditions. At some point of time, the operation is shifted to total reflux condition (i.e., no product and residue are ... and without total reflux (D) The top and bottom compositions correspond to the maximum enrichment available
Last Answer : (D) The top and bottom compositions correspond to the maximum enrichment available
Description : In McCabe-Thiele method of theoretical plate calculation for a distillation column, the operating lines of stripping and rectifying sections coincide with the diagonal at __________ reflux. (A) Total (B) Minimum (C) Operating (D) Maximum permissible
Last Answer : (A) Total
Description : Overall efficiency of the distillation column is (A) The ratio of number of ideal plates to actual plates (B) The ratio of number of actual plates to ideal plates (C) Same as the Murphree efficiency (D) Always more than the point efficiency
Last Answer : (A) The ratio of number of ideal plates to actual plates
Description : Total reflux in a distillation operation requires minimum (A) Reboiler load (B) Number of plates (C) Condenser load (D) All (A), (B) and (C)
Last Answer : (B) Number of plates
Description : Fenske-Underwood equation used for calculating the minimum number of theoretical plates in distillation column is valid for (A) Constant molal overflow (B) Total reflux (C) Constant relative volatility (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : Pick out the wrong statement: (A) Reboiler is not used in open steam distillation (B) The separation of solutes of different molecular sizes in a liquid solution by use of a ... is used for calculating theoretical number of plates in a distillation column at normal operating reflux condition
Last Answer : (D) Fenske-Underwood equation is used for calculating theoretical number of plates in a distillation column at normal operating reflux condition
Description : The slope of 9-line is determined by the (A) Reflux ratio (B) Plate efficiency to be achieved (C) Thermal condition of the feed (D) Relative volatility
Last Answer : (C) Thermal condition of the feed
Description : For a fixed number of ideal stages in a distillation column, as the reflux ratio is increased, the difference in composition between the top and bottom product streams (A) Increases (B) Decreases (C) Remain unaffected (D) Passes through a maximum
Last Answer : (A) Increases
Description : Minimum reflux ratio in a distillation column results in (A) Optimum number of trays (B) Minimum reboiler size (C) Maximum condenser size (D) Minimum number of trays
Last Answer : (C) Maximum condenser size
Description : Steam distillation is used to (A) Reduce the number of plates (B) Avoid thermal decomposition of a component (C) Increase the efficiency of separation (D) Increase the total pressure of distillation
Last Answer : (B) Avoid thermal decomposition of a component
Description : The reason for preferring packed towers over plate towers in distillation practice is that the packed tower operation gives (A) Low pressure drop and high hold up (B) High pressure drop and low hold ... C) Low pressure drop and low hold up (D) High pressure drop and high hold up
Last Answer : (C) Low pressure drop and low hold up
Description : Pick out the wrong statement. (A) In the McCabe-Thiele diagram for binary distillation, vertical feed line represents saturated liquid feed and horizontal feed line represents saturated vapour feed (B) In ... layers over a flat plate are of equal thickness, if Schmidt number is equal to unity
Last Answer : (C) For Laminar flow over a plate of length L, the local mass transfer coefficient at a distance L from the leading edge is 1.5 × 10 -2m/s. Then the average mass transfer co-efficient for the plate is 2 × 10 -2m/s
Description : In a horizontal plate type planter maximum obtainable value of cell fill is : A.Greater then 100% B.Less than 100% C.200% D.None of the above
Last Answer : A.Greater then 100%
Description : Pick out the wrong statement. (A) Packed towers are preferred for vacuum operation, because the pressure drop through the packing is less and they (packings) also lessen the ... of liquid, problem of channelling, loading & flooding is generally encountered in packed towers
Last Answer : (C) Diameter of randomly packed tower is normally more than 1.2 metres
Description : In McCabe-Thiele method, at infinite reflux ratio (A) The overhead product is minimum (B) Both the operating lines coincide with diagonal (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (A) The overhead product is minimum
Description : As the reflux ratio decreases, the (A) Separation becomes more efficient (B) Number of plates increases (C) Column diameter increases (D) None of these
Last Answer : (B) Number of plates increases
Description : At minimum reflux ratio for a given separation (A) Number of plates is zero (B) Number of plates is infinity (C) Minimum number of the theoretical plates is required (D) Separation is most efficient
Last Answer : (B) Number of plates is infinity
Description : For the same process conditions, the reflux ratio of an unlagged distillation column (A) Decreases in winter (B) Increases in winter (C) Increases in summer (D) None of these
Last Answer : (B) Increases in winter
Description : . In a distillation column, with increase in the reflux ratio, the heat removed in the cooler (A) Increases (B) Decreases (C) Remains unaffected (D) And the heat required in reboiler decreases
Description : The reflux to a distillation column is 100 moles/hr, when the overhead product rate is 50 moles/hr. The reflux ratio is (A) 2 (B) 0.5 (C) 50 (D) 150
Last Answer : (A) 2
Description : Pick out the wrong statement. (A) With decrease in feed temperature, the number of plates required for binary distillation decreases for a given L/V' ratio (B) The extraction per unit ... and its crosssection is wider at the bottom (D) Vander wall adsorption is also called chemisorption
Last Answer : (D) Vander wall adsorption is also called chemisorption
Description : Flooding in a distillation column is detected by a sharp (A) Increase in Murphree plate efficiency (B) Decrease in pressure drop (C) Decrease in liquid hold up in the column (D) Increase in pressure drop
Last Answer : (D) Increase in pressure drop
Description : Plate efficiency in a distillation column is reduced due to the __________ of liquid. (A) Entrainment (B) Foaming (C) Weeping & dumping (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : Tower diameter may be decreased by (A) Using higher reflux ratio (B) Use of increased tray spacing (C) Increasing the liquid flow rate (D) Increasing the vapour flow rate
Last Answer : (B) Use of increased tray spacing
Description : Pick out the correct statement. (A) For identical gas flow rates, less pressure drop occurs through a plate tower than through a packed tower (B) Plate column can handle greater liquid loads without flooding than packed ... duty, plate columns weigh less than packed columns (D) All (A), (B) and (C)
Description : If the path of liquid across the plate is very long as in case of large diameter tower, Murphree efficiency can be __________ percent (A) 100 (B) > 100 (C) < 100 (D) None of these
Last Answer : (B) > 100
Description : Pick out the wrong statement. (A) For a pressure vessel to be classified as 'thin vessel', the ratio of wall thickness to mean radius is less than 0.1 (B) For calculating forces and ... Maximum diameter of the opening provided in a pressure vessel, which does not require any compensation is 200 mm
Last Answer : Option B
Description : In a plate type heat exchanger, heat transfer plates are never made of (A) Stainless steel (B) Cast iron (C) Titanium (D) Hastelloy C
Last Answer : (B) Cast iron
Description : In a distillation operation, what is the effect of the temperature of the reflux stream (given below) on the condenser and reboiler loads? Reflux conditions: (i) Reflux stream is completely liquid ... D) Both condenser and reboiler loads are higher in case (ii) as compared to case (i)
Last Answer : (D) Both condenser and reboiler loads are higher in case (ii) as compared to case (i)
Description : Pick out the wrong statement. (A) In process heat exchangers, saturated steam is preferred over the superheated steam (B) The maximum is the emissive power of a surface at a temperature T1 ... under natural convection conditions, the velocity profile in air, normal to the plate, exhibits a maximum
Last Answer : (B) The maximum is the emissive power of a surface at a temperature T1 occurs at a wavelength of λ1 . If the surface temperature is halved, the maximum in the emissive power would occur at a wavelength of 0.5 λ1
Description : In batch distillation with constant reflux, overhead product composition __________ with time. (A) Increases (B) Decreases (C) Does not vary (D) May increase on decrease, depends on the system
Last Answer : (B) Decreases
Description : With lapse of time, the overhead composition of light component in case of batch distillation with constant reflux (A) Increases (B) Decreases (C) Remain same (D) May increase or decrease; depends on system
Description : Which of the following provides maximum contact surface for a liquidvapour system? (A) Packed tower (B) Bubble-cap plate column (C) Sieve-plate column (D) Wetted wall column
Last Answer : (A) Packed tower
Description : . For the same feed, feed quality and separation (in a distillation column), with the increase of total pressure, the number of ideal plates will (A) Increase (B) Decrease (C) Remain same (D) Data insufficient, can't be predicted
Last Answer : (A) Increase
Description : According to the Fenske equation, what will be the minimum number of plates required in a distillation column to separate an equimolar binary mixture of components A and B into an overhead fraction containing 99 mol% A and a ... in the column. (A) 5 (B) 9 (C) 12 (D) 28
Last Answer : (C) 12
Description : Can a cooling tower cool water below the wet bulb temperature of inlet air? (A) Yes (B) No (C) Yes; but height of cooling tower will be prohibitively high (D) Yes; but the air flow rate should be excessively high
Last Answer : (B) No