Description : In case of grinding in a ball mill (A) Wet grinding achieves a finer product size than dry grinding (B) Its capacity decreases with increasing fineness of the products (C) Grinding cost and power requirement increases with increasing fineness of the products (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : The grinding in a hammer crusher takes place due to the (A) Attrition (B) Impact (C) Both (A) & (B) (D) Neither (A) nor (B
Last Answer : (C) Both (A) & (B)
Description : The mechanism of size reduction by a hammer mill is by impact and attrition between the (A) Grinding element & the housing (B) Feed particles (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) and (B)
Description : Close circuit grinding by a ball mill with air sweeping employs a (A) Classifier (B) Cyclone separator between mill & classifier (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : As the product becomes finer, the energy required for grinding (A) Decreases (B) Increases (C) Is same as for coarser grinding (D) Is 1.5 times that for coarser grinding
Last Answer : (B) Increases
Description : For grinding of softer materials, the grinding wheel should have __________ grain size. (A) Finer (B) Coarser (C) Medium (D) Any type of
Last Answer : (B) Coarser
Description : Finer grinding of cement (A) Affects only the early development of strength (B) Affects only the ultimate strength (C) Both (A) and (B) (D) Does not affect the strength
Last Answer : Answer: Option A
Description : The high strength of rapid hardening cement at early stage, is due to its (A) Finer grinding (B) Burning at high temperature (C) Increased lime cement (D) Higher content of tricalcium
Last Answer : Answer: Option C
Description : Early attainment of strength in rapid hardening cement is mainly due to (A) Gypsum (B) Finer grinding (C) Tri-calcium silicate (D) Tri-calcium aluminate
Last Answer : Answer: Option B
Description : In a grinding operation, the limiting particle size is the size of the __________ particle in the sample. (A) Smallest (B) Largest (C) Either (A) or (B) (D) Neither (A) nor (B)
Last Answer : (D) Neither (A) nor (B)
Description : Isothermal turbulent flow of a fluid results in decrease of its pressure, which depends on the (A) Wall roughness (B) Reynolds number (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Tube mill compared to ball mill (A) Produces finer products (B) Is long in comparison with its diameter (C) Uses smaller balls (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : In a roll crusher, the specific power consumption and the production rate is affected by the (A) Reduction ratio (B) Differential roll speed (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : The main function of a muffle in the muffle furnace is to (A) Protect the charge from the effects of the products of combustion (B) Smooth out temperature inequalities on the combustion side of the muffle wall (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Starting material for the production of SBR is (A) Ethyl alcohol (B) Ethylene (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Starting material for the production of styrene butadiene rubber (SBR) is (A) Ethyl alcohol (B) Ethylene (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The cake resistance increases steadily with the time of filtration in a plate and frame filter employing constant __________ filtration. (A) Rate (B) Pressure (C) Both (A) & (B) (D) Neither (A) nor (B
Description : Hydraulic mean depth (Dm) for a circular pipe of diameter 'D' flowing full is 0.25 D. For a circular channel, at Dm = 0.3 D, gives the condition for the maximum (A) Flow rate (B) Mean velocity (C) Both 'a' & 'b' (D) Neither 'a' nor 'b
Last Answer : (B) Mean velocity
Description : The rate of shear versus the shear stress curves are time dependent for __________ fluid. (A) Thixotropic (B) Rheopectic (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : Chemical kinetics can predict the __________ of a chemical reaction. (A) Rate (B) Feasibility (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (A) Rate
Description : In a CSTR __________ varies with time. (A) Reaction rate (B) Concentration (C) Both (A) & (B) (D) Neither (A) nor (B)
Description : The effect of friction on the flow of steam through a nozzle is to decrease the __________ of steam. (A) Wetness (B) Mass flow rate (C) Both 'a' & 'b' (D) Neither 'a' nor 'b'
Last Answer : (C) Both 'a' & 'b'
Description : Niche Marketing refer to 1. A strategy that specializes in limited or unique product category 2. A strategy that specializes Niche products 3. Both 1 & 2 4. Neither 1 nor 2 5. None of these
Last Answer : A strategy that specializes in limited or unique product category
Description : A channel strategy that limits availability of products to a few carefully selected outlets in a given market area is called ______________ 1. Selective channel 2. Intensive channel 3. Both 1 & 2 4. Neither 1 nor 2 5. None of these
Last Answer : Selective channel
Description : Niche Marketing refers to 1. a strategy that specializes in limited or unique product category 2. a strategy that specializes niche products 3. both 1 & 2 4. neither 1 nor 2 5. none of these
Last Answer : a strategy that specializes in limited or unique product category
Description : Benefits derived from social responsibility include; A. enhanced organizational efficiency B. producing better products C. attracting people who want to work for the firm D. both A & C
Last Answer : D. both A & C
Description : Use of 'grinding aids' is done in __________ grinding. (A) Dry (B) Wet (C) Ultrafine (D) Intermediate
Last Answer : (A) Dry
Description : Pick out the wrong statement. (A) Close circuit grinding is more economical than open circuit grinding (B) Cod oil, beef tallow or aluminium stearates are used as grinding aids in cement ... is called a classifier (D) Size enlargement is a mechanical operation exemplified by medicinal tablet making
Last Answer : (C) The equipment used for the removal of traces of solids from a liquid is called a classifier
Description : In Hydrofining catalytic desulphurisation process for sweetening of petroleum products, use of hydrogen (A) Enhances the desulphurisation process (B) Minimises coke formation (C) Both (A) and (B) (D) Neither (A) nor (B
Description : For multiple reactions, the flow pattern within the vessel affects the (A) Size requirement (B) Distribution of reaction products (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : Nicotine is(A) A volatile alkaloid (B) Obtained by treating by-products of the tobacco processing industry (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : In closed circuit grinding as compared to open circuit grinding, the (A) Specific surface of product is more (B) Product has lesser size uniformity (C) Production rate at a given limiting size is lower (D) Operation is economical
Last Answer : (D) Operation is economical
Description : __________ mill is not used for grinding wheat into flour and for milling of cereals & other vegetable products. (A) Buhrstone (B) Roller (C) Attrition (D) Pebble
Last Answer : (D) Pebble
Description : In the photorespiratory pathway, there is neither synthesis of (A)_____ nor of (B)____. Tather it results in the release of (C)_____ with the utilzati
Last Answer : In the photorespiratory pathway, there is neither synthesis of (A)_____ nor of (B)____. ... )____. Therefore, photorespiration is a wasteful process.
Description : The organophosphates produce irreversible inhibition of cholinesterase because: A. They bind to an allosteric site of the enzyme resulting in unfavourable conformation of esteratic site to bind ... degradation of enzyme molecules D. They are neither metabolized nor excreted from the body
Last Answer : B. Regeneration time of the phosphorylated enzyme is longer than the turnover time of the enzyme molecules
Description : For __________ drying, the effects of velocity, temperature and humidity of the gas and the thickness of the solid are the same. (A) Unsaturated surface (B) Constant rate (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : During constant rate period, the rate of drying decreases with the (A) Decrease in air temperature (B) Increase in air humidity (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : With increase in temperature, the leaching rate increases because of the (A) Increased diffusivity (B) Decreased viscosity of liquid (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : With increase in temperature, the leaching rate increases due to (A) Decreased liquid viscosity (B) Increased diffusivity (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : Economy of a multiple effect evaporator depends upon the (A) Heat balance consideration (B) Rate of heat transfer (C) Both (A) and (B) (D) Neither (A) nor (B
Last Answer : (A) Heat balance consideration
Description : Fluid resistance to shear depends upon its (A) Rate of transfer of molecular momentum (B) Cohesion (C) Both (A) and (B) (D) Neither (A) nor (B)
Description : The function of gypsum addition during cement making is to (A) Increase the density of cement (B) Decrease the cement setting rate (C) Both (A) and (B) (D) Neither (A) nor (B)
Last Answer : (B) Decrease the cement setting rate
Description : A situation whereby market is expanded by developing new products to satisfy new consumer needs is called _____________________ 1. Market development 2. Diversification 3. Both 1 and 2 4. Neither 1 nor 2 5. None of these
Last Answer : Diversification
Description : Consider the following statements: 1. Chikmagalur is well-known for sugar production. 2. Mandya is well-known as a coffee-producing region. Which of the statements given above is/are correct? [IAS 2008] (a) 1 only (b) 2 only (c) Both 1and 2 (d) Neither 1 nor 2
Last Answer : Ans: (d)
Description : Consider the following statements: 1. India ranks first in the world in fruit production. 2. India ranks second in the world in the export of tobacco. Which of these statements is/are correct? [IAS 2003] (a) Only 1 (b) Only 2 (c) Both 1 and 2 (d) Neither 1 nor 2
Last Answer : Ans: (c)
Description : Consider the following statements: 1. India is the original home of the cotton plant. 2. India is the first country in the world to develop hybrid cotton variety leading to increased production. Which of these statements is/are correct ... ] (a) Only 1 (b) Only 2 (c) Both 1 and 2 (d) Neither 1 nor 2
Description : Eutrophication of a water body enhances – (1) Organic matter production (2) Biological oxygen demand (3) Both (1) and (2) (4) Neither (1) nor (2)
Last Answer : (3) Both (1) and (2) Explanation: Eutrophication is the ecosystem response to the addition of artificial or natural substances, such as nitrates and phosphates, through fertilizers or sew-age. It leads not only to increased levels of nutrients, but increased Biological Oxygen Demand as well.
Description : Eutrophication of a water body enhances (1) Organic matter production (2) Biological oxygen demand (3) Both (1) and (2) (4) Neither (1) nor (2)
Last Answer : Both (1) and (2)
Description : Use of baffles in agitators help in minimising the __________ tendency. (A) Swirling (B) Vortexing (C) Both (A) & (B) (D) Neither (A) nor (B)