Description : One ton of the refrigeration is (a) the standard unit used in refrigeration problems (b) the cooling effect produced by melting 1 ton of ice (c) the refrigeration effect to freeze 1 ton of water at ... ice at 0°C in 24 hours (d) the refrigeration effect to produce 1 ton of ice at NTP conditions
Last Answer : Ans: c
Description : Pick up the incorrect statement (a) lithium bromide used in vapour absorption cycle is nonvolatile (b) lithium bromide plant can't operate below 0°C (c) a separator is used in lithium ... of solution coming out of lithium bromide generator is more in comparison to that entering the generator
Description : The temperature of the top of a frozen lake is – 15°C. What is the temperature of the water in the lake in contact with the ice layer? (a) 0°C (b) 4°C (c) –15°C (d) –7.5°C
Last Answer : Ans:(a)
Description : What is the temperature at which the water vapour in the mixture of water vapour in air, starts condensing called? A. condensation temperature B. dew point temperature C. vaporization temperature D. all of the above
Last Answer : ANSWER : B
Description : The ratio of partial pressure of water vapour in a mixture to the saturation pressure of water at the same temperature of the mixture is called as A. humidity B. partial humidity C. specific humidity D. relative humidity
Last Answer : ANSWER : D
Description : When dry bulb temperature (DBT) and wet bulb temperature (WBT) are measured, greater the difference between DBT and WBT, A. greater the amount of water vapour held in the mixture B. smaller the amount of ... the mixture C. same the amount of water vapour held in the mixture D. none of the above
Description : What is the specific humidity? A. the ratio of the mass of water vapour to the mass of the total mixture of air and water vapour B. the ratio of the mass of dry air to the mass of the total mixture ... ratio of the mass of water vapour to the mass of dry air in a mixture of air and water vapour
Description : Water has maximum density at (a) Room temperature (b) 0°C (c) 4°C (d) 100°C
Last Answer : Ans:(c)
Description : At what temperature is the density of water the maximum? (1) 2°C (2) 4°C (3) 0°C (4) 1°C
Last Answer : (2) 4°C Explanation: An especially notable irregular maximum density is that of water, which reaches a density peak at 3.98 °C (39.16 °F).
Description : The freezing point of fresh water is - (1) 0°C (2) 4°C (3) 3°C (4) 5 C
Last Answer : (1) 0°C Explanation: Ocean water freezes just like freshwater, but at lower temperatures. Fresh water freezes at 32 degrees Fahrenheit but seawater freezes at about 28.4 degrees Fahrenheit, because of the salt in it.
Description : The freezing point of fresh water is - (1) 4°C (2) 3°C (3) 5°C (4) 0°C
Last Answer : (4) 0°C Explanation: The freezing point of water is the temperature at which water changes phase from a liquid to a solid. Under normal conditions, ordinary water freezes at 0°C, or 32°F. ... or if there are impurities present in the water which could cause freezing point depression to occur.
Description : The freezing point of fresh water is _______. (1) 4°C (2) 3°C (3) 5°C (4) 0°C
Last Answer : 0°C
Description : The condition of refrigerant before entering the expansion or throttle valve, in a vapour compression system (a) dry vapour (b) wet vapour (c)liquid-vapour mixture (d) high pressure saturated liquid
Last Answer : Ans: d
Description : The dew point is the: a. Dry bulb temperature on a psychrometer b. Temperature at which water vapour will start to be absorbed into the air c. Temperature below which water vapour will start to ... vapour will start to condense out of the air e. Temperature at which water will start to evaporate
Last Answer : Answer: C
Description : The temperature at which the air cannot hold all the water vapour mixed in it and some vapour starts condensing is called as A. humidification temperature B. dehumidification temperature C. dew point temperature D. none of the above
Last Answer : ANSWER : C
Description : Clapeyron equation is applicable for registration at (a) saturation point of vapour (b) saturation point of liquid (c) sublimation temperature (d) triple point.
Last Answer : Ans: a
Description : Standard air is the: a. Mass of 1 cubic meter of dry air at 20°C and atmospheric pressure b. Mass of a cubic meter of air at atmospheric conditions c. Volume of air at ambient temperature and atmospheric pressure ... pressure at sea level or 101.325 kPa e. Volume of 1 kg of air at 15°C and 100 kPa
Last Answer : Answer: D
Description : One tonrefrigeration corresponds to (a) 50 kcal/min (b) 50 kcal/kr (c) 80 kcal/min (d) 80 kcal/hr
Description : Normal temperature and pressure (N.T.P.) corresponds to (A) 0°C and 760 mm Hg (B) 15°C and 760 mm Hg (C) 20°C and 760 mm Hg (D) 0°C and 1 kgf/cm2
Last Answer : (C) 20°C and 760 mm Hg
Description : If a certain amount of dry ice is mixed with same amount of water at 80°C, the final temperature of mixture will be (a) 80°C (b) 0°C (c) 40°C (d) 20°C (e) 60°C.
Last Answer : Answer : b
Description : Water has maximum density at _____? A. 0°C B. 4°c C. 40K D. 4.8°C
Last Answer : ANSWER: B
Description : What happens when water is cooled from 8°C to 0°C? 1. Its volume decreases uniformly, becoming minimum at 0°C. 2. Its density increases uniformly, attaining maximum value at 0°C. 3. Its volume decreases up to 4°C and then increases ... is/are correct? (a) Only 1 (b) Only 2 (c) 3 and 4 (d) 1 and 2
Description : Water has maximum density at – (1) -4°C (2) 0°C (3) 4°C (4) 100°C
Last Answer : (3) 4°C Explanation: When cooled from room temperature liquid water becomes increasingly dense, as with other substances, but at approximately 4 °C (39 °F), pure water reaches its maximum density.
Description : Specific gravity is defined as the ratio of – (1) density of the substance to the density of water (2) density of the substance to the density of water at 0°C (3) density of water at 4°C to the density of the substance (4) density of the substance to the density of water at 4°C
Last Answer : (1) density of the substance to the density of water Explanation: Specific gravity is the ratio of the density of a substance to the density (mass of the same unit volume) of a reference substance. The reference substance is nearly always water for liquids or air for gases.
Description : Water has maximum density at – (1) 100°C (2) 0°C (3) 4°C (4) 273°C
Last Answer : (3) 4°C Explanation: The maximum density of water occurs at 4 °C because at. this temperature, two opposing effects are in balance. Water is an exceptional compound that has a lower density in the ... due to the ion nature of water in the liquid phase, which packs the molecules tightly together.
Description : The density of water is 1 g/cc. This is strictly valid at – (1) 0°C (2) 4°C (3) 25°C (4) 100°C
Last Answer : (2) 4°C Explanation: Water never has an absolute density because its density varies with temperature. Water has its maximum density of 1 g/cm3 at 4 degrees Celsius. When the temperature changes from either greater or ... 1 g/cm3. Water has the maximum density of 1 g/cm3 only when it is pure water.
Description : Lakes freeze in cold countries in winter, leaving the water underneath at – (1) 0°C (2) 0°F (3) 4°C (4) 4°F
Last Answer : (3) 4°C Explanation: Lake ice cover is seasonal and occurs where average daily temperature is below the freezing point. Once formed the lake ice thickens over the course of the winter as the temperature ... 0 (zero) degrees Celsius water at the surface and denser 4 degrees Celsius at the bottom.
Description : Water has maximum density at------? A. 0°C B. 4°C (Answer) C. 4° K D. 4.8°C
Last Answer : B. 4°C (Answer)
Description : Maximum density of water exists at (a) 0°C (b) 4°C (c) 40°C (d) 100°C
Last Answer : (b) 4°C
Description : Water has maximum density at (1) 100°C (2) 0°C (3) 4°C (4) 273°C
Last Answer : 4°C
Description : The density of water is 1 g/cc. This is strictly valid at (1) 0°C (2) 4°C (3) 25°C (4) 100°C
Description : Specific gravity is defined as the ratio of (1) density of the substance to the density of water (2) density of the substance to the density of water at 0°C (3) density of water at 4°C to the density of the substance (4) density of the substance to the density of water at 4°C
Last Answer : density of the substance to the density of water
Description : Lakes freeze in cold countries in winter, leaving the water underneath at (1) 0°C (2) 0°F (3) 4°C (4) 4°F
Description : A Mixture of dry air and water,the formation of fog starts when, A. air temperature is equal to the dew point temperature B. air temperature is greater than the dew point temperature C. both a. and b. D. none of the above
Last Answer : ANSWER : A
Description : For spark ignition engine, the equivalence ratio of mixture entering the combustion chamber has values (A) for idling and for peak power conditions (B) for both idling and peak power conditions (C) for idling and for peak power conditions (D) for both idling and peak power conditions
Last Answer : ANSWER (B) for both idling and peak power conditions
Description : Relative humidity is a) the ratio of water vapour in the air compared to the total amount water vapour the air could contain at a given temperature b) equal to the dry bulb temperature divided by the wet bulb ... of dry air e) the ratio of the mass of water vapour divided by the mass of wet air
Description : Reducing suction pressure in refrigeration cycle (a) lowers evaporation temperature (b) increases power required per ton of refrigeration (c) lowers compressor capacity because vapour is lighter (d) all of the above.
Description : For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphereis high, then (a) bigger cabinet should be used (b) smaller cabinet should ... tight vapour seal should be used (d) refrigerant with lower evaporation temperature should be used
Description : Where does the lowest temperature occur in a vapour compression cycle ? (a) condenser (b) evaporator (c) compressor (d) expansion valve
Last Answer : Ans: b
Description : One of the purposes of sub-cooling the liquid refrigerant is to (a) reduce compressor overheating (b) reduce compressor discharge temperature (c) increase cooling effect (d) ensure that only liquid and not the vapour enters the expansion (throttling) valve
Description : The higher temperature in vapour compression cycle occurs at (a) compressor discharge. (b) expansion valve (c) evaporator (d) condenser discharge
Description : Clapeyron equation is a relation between (a) temperature, pressure and enthalpy (b) specific volume and enthalpy (c) temperature and enthalpy (d) temperature, pressure, specific vapour and enthalpy.
Last Answer : Ans: D
Description : At NTP , 5.6 L of a gas weight 8 g . The vapour density of gas is :-
Last Answer : At NTP , 5.6 L of a gas weight 8 g . The vapour density of gas is :- A. 32 B. 40 C. 16 D. 8
Description : The Manufacturer of aeration devices reports the oxygen transfer rate of the device obtained through laboratory tests carried under standard conditions. Such standard condition are : (a) Wastewater at zero DO, 25°C and 760 mm ... DO, 20°C and 760 mm Hg (d) Wastewater at zero DO, 0°C and 700 mm Hg
Last Answer : (c) Tapwater at zero DO, 20°C and 760 mm Hg
Description : At equilibrium the concentration of water in vapour phase (C* ) in kg/m3 of air space and the amount of water (m) adsorbed per kg of dry silica gel are related by, C* = 0.0667m. To maintain dry conditions in a room ... which the temperature is maintained constant) is (A) 0.0 (B) 0.2 (C) 0.4 (D) 1.0
Last Answer : (C) 0.4
Description : When air passes through silica gel, A. it absorbs water vapour molecules B. latent heat of condensation is released C.dbt of air increases D. all of the mentioned
Description : The _____________ sensor, checks the temperature of the ambient air entering the engine for fine tuning the mixture strength. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: d Explanation: The air inlet temperature sensor, checks the temperature of the ambient air entering the engine for fine tuning the mixture strength whereas the engine temperature sensor senses the ... gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : The _____________ sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: a Explanation: The engine temperature sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting while the ... gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : The evolution of heat of solution takes place in ammonia absorption plant when (a) ammonia vapour goes into solution (b) ammonia vapour is driven out of solution (c) lithium bromide mixes with ammonia (d) weak solution mixes with strong solution
Description : The COP of a vapour compression plant in comparison to vapour absorption plant is (a) more (b) less (c) same (d) more/less depending on size of plant